Chemical composition of hydrothermal deposits and vulcanites from the Menez Gwen vent field, Mid-Atlantic Ridge

Surface hydrothermal deposits of the shallow-water Menez Gwen vent field located in the rift zone of the Mid-Atlantic Ridge are mostly composed of nonmetalliferous minerals in contrast to sulfide deposits of deep-water fields. Here sulfide minerals occur only in dispersed form. High-temperature sulfide deposits strongly enriched in copper and zinc occur only immediately below the surface of the bottom. This is related to subsurface boiling and phase separation of initial high-temperature hydrothermal ore-bearing solution that ascends from the interior to the floor surface.

(Table 3) Contents of phosphorus, iron, and manganese in various zones of Fe-Mn nodules from the Pacific radiolarian belt

Phosphorus content in the surface layer of bottom sediments varies from 0.07% to 0.73%. Clayey radiolarian and radiolarian clayey oozes contain 0.12% P, miopelagic clays 0.21% P, and sediments with high iron and manganese concentrations 0.46% P (average contents). Phosphorus content of iron-manganese nodules varies from 0.14% to 0.39%, average 0.19%. Correlation between phosphorus contents in nodules and surrounding sediments is indicated indirectly by P/Fe ratio. Phosphorus is non-uniformly distributed in some nodules and sometimes correlates with iron. Accumulation of phosphorus in iron-manganese nodules is governed by a degree of manganese predominance in ore components.

Hydrography and water chemistry of the open Mediterranean Sea

On a cruise from the eastern into western Mediterranean Sea in November/December 1978 a total of 126 samples were collected from 8 vertical profiles and 7 coastal stations for trace metal analysis. The sampling, processing and analysis was performed under strict "clean room" conditions. The concentration of the open-sea samples are close to oceanic results gathered under similar conditions. The grand averages from all profiles (± st. dev. of the individual samples) of 0.40 ± 0.16 µg/l Zn, 17.4 ± 7.4 ng/l Cd, 0.21 ± 0.07 µg/l Cu, 0.21 ± 0.13 µg/l Mn and 0.25 ± 0.09 µg/l Fe indicate that a "metal problem" does not exist in the open Mediterranean. A biologically mediated deplition in surface waters or correlation with nutrients have not been observed under the conditions established on this cruise. This is probably due top low primary production and seasonal advection processes prevailing in this sea. The data for manganese show generally higher values in the surface layer (0-75 m) than in deep waters. This could evidently proved in the nearshore profile indicating a terrigenous source for manganese.

Geochemistry and petrology of basalts from Celebes Sea

Major-, trace-, and rare-earth element analyses are presented from a suite of basaltic rocks from the basement of the Celebes Sea. The major elements and trace-elements were determined by X-ray fluorescence techniques, and the rare-earth elements were analyzed by instrumental neutron activation analysis. Compositionally the Celebes Sea basalts are very similar to typical normal mid-ocean ridge basalts, such as those described from the Indian Ocean triple junction. Petrogenetic modeling shows that all of the basalts analyzed can be formed by 10% to 20% partial melting of a light rare-earth element-depleted spinel lherzolite followed by fractional crystallization of mixtures of olivine, Plagioclase, and iron oxide. The Celebes Sea is interpreted as a fragment of the basement of the Jurassic Argo abyssal plain trapped during the Eocene to the north of Australia.

Minerals, geochemistry and x-ray power characteristics at DSDP Sites 54-424, 60-458 and 60-459

Secondary minerals filling veins and vesicles in volcanic basement at Deep Sea Drilling Project Sites 458 and 459 indicate that there were two stages of alteration at each site: an early oxidative, probably hydrothermal, stage and a later, low-temperature, less oxidative stage, probably contemporaneous with faulting in the tectonically active Mariana forearc region. The initial stage is most evident in Hole 459B, where low-Al, high Fe smectites and iron hydroxides formed in vesicles in pillow basalts and low-Al palygorskite formed in fractures. Iron hydroxides and celadonite formed in massive basalts next to quartz-oligoclase micrographic intergrowths. Palygorskite was found in only one sample near the top of basement in Hole 458, but it too is associated with iron hydroxides. Palygorskite has previously been reported only in marine sediments in DSDP and other occurrences. It evidently formed here as a precipitate from fluids in which Si, Mg, Fe, and even some Al were concentrated. Experimental data suggest that the solutions probably had high pH and somewhat elevated temperatures. The compositions of associated smectites resemble those in hydrothermal sediments and in basalts at the Galapagos mounds geothermal field. The second stage of alteration was large-scale replacement of basalt by dioctahedral, trioctahedral, or mixed-layer clays and phillipsite along zones of intense fracturing, especially near the bottom of Holes 458 and 459B. The basalts are commonly slickensided, and there are recemented microfault offsets in overlying sediments. Native copper occurs in one core of Hole 458, but associated smectites are dominantly dioctahedral, unlike Hole 459B, where they are mainly trioctahedral, indicating nonoxidative alteration. The alteration in both holes is more intense than at most DSDP ocean crust sites and may have been augmented by water derived from subducting ocean crust beneath the fore-arc region.