嫁接对茄子根际微生物种群数量的影响

研究了不同砧木、不同土壤茬口条件下嫁接茄子根际微生物的种群数量变化。结果表明: 嫁接增加了茄子根际放线菌数量(A)和真菌的数量(F),减少了细菌的数量(B),A/F比值增高,B/ F比值降低;同时,嫁接茄子根际微生物总量增加。在正茬和重茬两种耕作体系中,嫁接处理根际放线 菌数量都极显著高于对照,而细菌数量极显著低于对照;连作(重茬)条件下,茄子根际细菌和放线菌 的数量减少,真菌的数量增加。

Dinoflagellate Cysts as Indicators of Cultural Eutrophication in the Oslofjord, Norway

Dinoflagellate cyst records were analysed from four sediment cores from the inner Oslofjord. The cores covered the pre-industrial period, and the most important period of human population growth associated with industrial development of the region, from the mid-1800s to the present, including the reported development of cultural eutrophication. Comparisons between the cyst records and the known history of eutrophication suggest cyst signals that should prove useful for tracing the development of eutrophication. The eutrophication signal consisted of a doubling of total cyst concentration, and a marked increase in one species in particular,Lingulodinium machaerophorum(from <5 to around 50% of the assemblages) with increased eutrophication. In the core considered most representative of general water quality in the inner fjord, these trends reversed back to pre-industrial levels during the 1980s and 1990s when improved sewage treatment took effect.

Validation and in situ application of an automated dissolved nickel monitor for estuarine studies

The validation of a fully automated dissolved Ni monitor for in situ estuarine studies is presented, based on adsorptive cathodic stripping voltammetry (AdCSV). Dissolved Ni concentrations were determined following on-line filtration and UV digestion, and addition of an AdCSV ligand (dimethyl glyoxime) and pH buffer (N-2-hydroxyethylpiperazine-N′-2-ethanesulphonic acid). The technique is capable of up to six fully quantified Ni measurements per hour. The automated in situ methodology was applied successfully during two surveys on the Tamar estuary (south west Britain). The strongly varying sample matrix encountered in the estuarine system did not present analytical interferences, and each sample was quantified using internal standard additions. Up to 37 Ni measurements were performed during each survey, which involved 13 h of continuous sampling and analysis. The high resolution data from the winter and summer tidal cycle studies allowed a thorough interpretation of the biogeochemical processes in the studied estuarine system.

长期施肥对黄土旱塬区土壤—植物系统中氮、磷养分的影响

对1984年建立的长期试验田,分析了2005年小麦产量、养分吸收及土壤养分变化。结果表明,单施磷肥增产25.6%,单施氮肥增产48.1%,其吸氮、磷量也相应增加,但收获指数显著低于对照;氮磷配施增产幅度为101.3%3~02.8%,养分吸收量增加显著,最佳施肥量为N2P2(N 90 kg/hm2、P 56.4 kg/hm2)。施肥明显改变了耕层土壤养分的含量,也影响了养分在土壤剖面的分布。氮磷配施是培肥土壤的有效途径,耕层土壤全磷增加了8.3%~45.2%,速效磷增加54.8%9~17.8%。中等施氮(N 90 kg/hm2)水平下,随着磷的增加,耕层土壤全磷累积和施磷量的关系为y=0.002x-0.112。速效磷含量增加和磷肥用量的关系为y=9.6537Ln(x)-35.371,施肥对60 cm以下磷素影响较小。

黄土高原旱地施肥对小麦与苜蓿土壤水分养分含量的影响

研究黄土高原旱地小麦(Wheat)和苜蓿(Alfalfa)连作20年后的产量、土壤水分及养分的变化。结果表明:磷肥对小麦增产不显著,而对苜蓿则增产显著(增产183.5%);施肥可以延缓苜蓿的衰老,提高产草量;苜蓿地土壤干燥化明显,施用氮磷有机肥后小麦地也出现干燥化趋势;长期施磷肥有利于改善土壤磷素有效性,其中苜蓿地全磷和有效磷含量,增加了13.6%和83.8%,小麦土壤增加了22.9%和367.9%;苜蓿土壤全氮和速效氮均呈增加,而小麦地则减少;平衡施用氮磷有机肥能培肥土壤,使产量大幅度提高;在该区采取合理的轮作方式和培肥措施能有效地改善农田生态系统的生产力。

Impacts of socio-economic factors on sediment yield in the Upper Yangtze River

In recent years, the role of human activities in changing sediment yield has become more apparent for the construction of hydraulic engineering and water conservation projections in the Upper Yangtze River, but it has not been evaluated at the macro scale. Taking Sichuan Province and Chongqing City as an example, this paper studies the relationship between socio-economic factors and sediment yield in the Upper Yangtze River based on section data in 1989 and 2007. The results show that sediment yield is significantly correlated with population density and cultivated area, in which the former appears to be more closely related to sediment yield. Moreover, in the relation of sediment yield vs. population density, a critical value of population density exists, below which the sediment yield increases with the increase of population density and over which the sediment yield increases with the decrease of population density. The phenomenon essentially reflects the influence of natural factors, such as topography, precipitation and soil property, and some human activities on sediment yield. The region with a higher population density than critical value is located in the east of the study area and is characterized by plains, hills and low mountains, whereas the opposite is located in the west and characterized by middle and high mountains. In the eastern region, more people live on the lands with a low slope where regional soil erosion is slight; therefore, sediment yield is negatively related with population density. In contrast, in the western region, the population tends to aggregate in the areas with abundant soil and water resources which usually lead to a higher intensity of natural erosion, and in turn, high-intensity agricultural practices in these areas may further strengthen local soil erosion. It is also found that population tends to move from the areas with bad environment and high sediment yield to the areas with more comfortable environment and less sediment yield. The natural factors have greater influence on sediment yield of western region than that of eastern region. Generally, the natural factors play a dominant role on sediment yield in the Upper Yangtze River.

Successful establishment of MEKC with electrochemiluminescence detection based on one functionalized ionic liquid

Herein, one water-soluble functionalized ionic liquid, 1-butyl-3-methylimidazolium dodecyl sulfate ([BMIm(+)][C12H25SO4-]), was designed and its superiorities either used as supporting electrolytes or as additives for successful establishment of MEKC with electrochemiluminescence (ECL) detection (MEKC-ECL) method were investigated. Compared with the common supporting electrolytes such as phosphate solution, 1-butyl-3-methylimidazolium dodecyl sulfate solution used as running buffers led to greatly enhanced ECL intensities and column efficiencies for negative targets, a little increase for neutral-charge ones while maintained nearly unchanged for positive ones due to the electrostatic forces between the large cation BMIm(+) and the solutes and the hydrophobic interactions resulting from the large anion C12H25SO4.

Shape-memory and biocompatibility properties of segmented polyurethanes based on poly(L-lactide)

A series of segmented poly (L-lactide)-polyurethanes (PLA-PU) were synthesized by a two-step method, with oligo-poly(L-lactide) (PLA) as the soft segments and the reaction product of 2,4-toluene diisocyanate(TDI) and ethylene glycol(EG) as the hard segments. The shape memory properties of PLA-PUs were examined. The processed PLA-PUs could recover almost 100% to their original shape within 10 degrees C from the lowest recovery temperature. In the recovery process, the PLA-PUs showed a maximum contracting stress of shape change in the range of 1.5-4 MPa depending on the PLA segmental length and the hard-segmental content and higher than that of poly (e-caprolactone polyurethane) (PCL-PU). Besides, the influence of deforming and fixing temperatures on shape memory properties of PLA-PU was studied in detail. They could affect not only the recovery temperature but also the maximum contracting stress. The experiments of cell incubation were used to evaluate the biocompatibility of PLA-PU. The results show that the biocompatibility of PLA-PU is comparable to that of the pure PLA. This kind of polyurethane can be used as implanted medical devices with a shape memory property.

Hydrothermal synthesis of ZrW2O8 nanorods

Negative thermal expansion ZrW2O8 nanorods were synthesized by a rapid low-temperature hydrothermal route, followed with a heat treatment at 500 degrees C for 6h. Acidity of the HCl addition to the mixed solution in the hydrothermal condition strongly affects the formation of the precursor ZrW2O7(OH)(2)(H2O)(2). High acidity of HCl in the range of 5-10 N facilitates the nucleation of ZrW2O7(OH)(2)(H2O)(2), but constrains its growth. Low acidity of HCl addition (< 5 N) only obtained the products ZrO2 and WO3 by firing the precursors. FE-SEM images revealed that the shape and size of ZrW2O8 were modeled after its precursor ZrW2O7(OH)(2)(H2O)(2).

Polyimides derived from 3,3 '-bis(N-aminophthalimide)

A novel diamine, 3,3'-bis(N-aminophthalimide) (BAPI), was prepared from 3,3'-bis(N-phenylphthalimide). Its structure was determined via IR, H-1 NMR, N-15 NMR, elemental analysis, and single-crystal X-ray diffraction analysis. A series of homo- and copolyimides were synthesized by a conventional one-step method in p-chlorophenol. The characteristic IR absorption bands of hydrazine-based imide groups were near 1780, 1750, 1350, 1100, and 730 cm(-1). The polymers showed good solubility in polar aprotic solvents and phenols at room temperature. The temperatures of 5% weight loss (T-5%) of the polyimides ranged from 495 to 530 degrees C in air. DMTA analyses indicated that the glass-transition temperatures (Tgs) of the polyimides were in the range 371-432 degrees C. These polymers had cutoff wavelengths between 350 and 400 nm. The polyimide films of 6FDA/BAPI and 4,4'-HQPDA/BAPI were colorless; other films were pale yellow or yellow.

Complex aggregates of silica microspheres by the use of a polymer template

Evaporation of a droplet of silica microsphere suspension on a polystyrene and poly(methyl methacrylate) blend film with isolated holes in its surface has been exploited as a means of particles self-assembly. During the retraction of the contact line of the droplet, spontaneous dewetting combined with the strong capillary force pack the silica microspheres into the holes in the polymer surface. Complex aggregates of colloids are formed after being exposed to acetone vapor. The morphology evolution of the underlying polymer film by exposure to acetone solvent vapor is responsible for the complex aggregates of colloids formation.

高分子量的聚L-谷氨酸的合成与表征

采用三乙胺为催化剂经过氨基酸羧酸酐单体的开环聚合和脱保护基,制备了高分子量聚L-谷氨酸.实验结果表明,合成的高分子量聚L-谷氨酸黏均分子量控制在70 000~350 000左右.单体和引发剂的摩尔比n(A)/n(I)大于50时,分子量与n(A)/n(I)无关.

Structure of Cyclic Aryl Thioester Dimer Based on o-Phthaloyl Dichloride and Bis(4-mercaptophenyl) Sulfide

A cyclic aryl thioester dimer was prepared by the reaction of o-phthaloyl dichloride and his (4-mercaptophenyl) sulfide in good yield under pseudo-high dilution conditions via interfacial polycondensation. The structure of the cyclic dimer was confirmed by a combination of MALDI-TOF-MS, FTIR, gel permeation chromatography and MM analyses. The X-ray diffraction study of the single crystal of cyclic thioester dimer obtained from two solutions reveals no severe internal strain on the cyclic structure.

Sol-gel fabrication, patterning and photoluminescent properties of LaPO4 : Ce3+, Tb3+ nanocrystalline thin films

Ce3+ and/or Tb3+-doped LaPO4 nanocrystalline thin films and their patterning were fabricated by a sol-gel process combined with soft lithography on silicon and quartz glass substrates. The results of XRD indicated that the films began to crystallize at 700 degreesC. The 1000 degreesC annealed single layer films are transparent by eyes, uniform and crack-free with a thickness of about 200 nm and an average grain size of 100 nm. Patterned thin film with different band widths (5-50 mum) were obtained by micro-molding in capillaries technique. The luminescence and energy transfer properties of Ce3+ and Tb3+ were studied in LaPO4 films.

Study on the reduction of Eu3+ -> Eu2+ in Sr4Al14O25: Eu prepared in air atmosphere

Compounds of Sr4Al14O15: Eu were prepared in air atmosphere by high temperature solid state reaction. The reduction of Eu3+--> Eu2+ was firstly observed in the aluminate phosphor of Sr4Al14O25: Eu synthesized in air condition. This made aluminate a new family and Sr4Al14O25 a new member of compounds in which Eu3+ ion could be reduced to Eu2+ form when fired in air atmosphere. The reduction of Eu3+ --> Eu2+ in Sr4Al14O25: Eu was explained by means of a charge compensation model. Experiments based on the model were designed and carried out, and the results supported this model.