Possible shunt compensation strategies based on Conservative Power Theory

Considering the Conservative Power Theory (CPT), this paper proposes some novel compensation strategies for shunt passive or active devices. The CPT current decompositions result in several current terms (associated with specific physical phenomena), which were used for the definition of different selective current compensators, in terms of minimizing particular disturbing effects. Simulation results have been demonstrated in order to validate the possibilities and performance of the proposed strategies for single and three-phase four wired circuits.

Fiber Post Cementation Strategies: Effect of Mechanical Cycling on Push-out Bond Strength and Cement Polymerization Stress

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Photoacclimation in three species of freshwater red algae

Three freshwater Rhodophyta species (Audouinella eugenea, A. hermannii and Compsopogon coeruleus) were tested as to their responses (photosynthesis, growth and pigment concentration) to two irradiances (low light, LL, 65 μmol m -2 s-1 and high light, HL, 300 μmol m-2 s-1) and two periods (short time, ST, 4 d, and long time, LT, 28 d). Higher growth rates were consistently observed at LL but significant differences were observed only for A. hermannii. Higher values of photoinhibition at LL were found for the three species, which is consistent with the dynamic photoinhibition as a reversible photoprotective mechanism against high irradiance. Light-induced decreases of effective quantum yield (EQY) were observed in the three species consisting of pronounced decreases from LL to HL. Rapid increases of non-photochemical quenching (NPQ) were observed mainly at LL, indicating energy dissipation by reaction centers. Results revealed distinct photoacclimation strategies to deal with high irradiances: the two Audouinella species had only characteristics of shade-adapted algae: acclimation by changes of size of photosy stem units (PSU) under LT and by PSU number under ST; higher values of the photoinhibition parameter (β) and NPQ, and lower values of EQY at LL; higher recovery capacity of potential quantum yield (PQY) at LL and under ST; highly significant positive correlation of electron transport rate (ETR) with NPQ. In addition, C. coeruleus mixed some characteristics of sun-adapted algae: acclimation by changes of PSU number under LT and by PSU size under ST; higher recovery capacity of EQY than the other two species; weak or no correlation of ETR with NPQ. Thus, these characteristics indicate that C. coeruleus cope with high irradiances more efficiently than the Audouinella species.

A true programmable HPF hybrid three-phase rectifier

In this paper is proposed and analyzed a digital hysteresis modulation using a FPGA (Field Programmable Gate Array) device and VHDL (Hardware Description Language), applied at a hybrid three-phase rectifier with almost unitary input power factor, composed by parallel SEPIC controlled single-phase rectifiers connected to each leg of a standard 6-pulses uncontrolled diode rectifier. The digital control allows a programmable THD (Total Harmonic Distortion) at the input currents, and it makes possible that the power rating of the switching-mode converters, connected in parallel, can be a small fraction of the total average output power, in order to obtain a compact converter, reduced input current THD and almost unitary input power factor. The proposed digital control, using a FPGA device and VHDL, offers an important flexibility for the associated control technique, in order to obtain a programmable PFC (Power Factor Correction) hybrid three-phase rectifier, in agreement with the international standards (IEC, and IEEE), which impose limits for the THD of the AC (Alternate Current) line input currents. Finally, the proposed control strategy is verified through experimental results from an implemented prototype. ©2008 IEEE.

Possible shunt compensation strategies based on conservative power theory

Considering the Conservative Power Theory (CPT), this paper proposes some novel compensation strategies for shunt passive or active devices. The CPT current decompositions result in several current terms, which are associated with specific physical phenomena (average power consumption P, energy storage Q, load and source distortion D, unbalances N). These current components were used in this work for the definition of different current compensators, which can be selective in terms of minimizing particular disturbing effects. Compensation strategies for single and three-phase four-wire circuits have also been considered. Simulation results have been demonstrated in order to validate the possibilities and performance of the proposed strategies. © 2010 IEEE.

Innovation and technology policy (ITP) for catching up: a three phase life cycle framework for industrializing economies

Includes bibliography

Silica coating on alumina ceramic: comparison of three chairside air-abrasion devices working for different times and distances.

This study evaluated, by scanning electron microscope (SEM) and EDS, the effect of different strategies for silica coating (sandblasters, time and distance) of a glass-infiltrated ceramic (In-Ceram Alumina). Forty-one ceramic blocks were produced. For comparison of the three air-abrasion devices, 15 ceramic samples were divided in three groups (N.=5): Bioart, Microetcher and Ronvig (air-abrasion parameters: 20 s at a distance of 10 mm). For evaluation of the time and distance factors, ceramic samples (N.=5) were allocated in groups considering three applied times (5 s, 13 s and 20 s) and two distances (10 mm and 20 mm), using the Ronvig device. In a control sample, no surface treatment was performed. After that, the micro-morphologic analyzes of the ceramic surfaces were made using SEM. EDS analyzes were carried out to detect the % of silica on representative ceramic surface. ANOVA and Tukey tests were used to analyze the results. One-way ANOVA showed the silica deposition was different for different devices (P=0.0054). The Ronvig device promoted the highest silica coating compared to the other devices (Tukey test). Two-way ANOVA showed the distance and time factors did not affect significantly the silica deposition (application time and distance showed no statistical difference). The Ronvig device provided the most effective silica deposition on glass-infiltrated alumina ceramic surface and the studied time and distance for air-abrasion did not affect the silica coating.

Post-conflict peacebuilding: strategies and lessons from Bosnia and Herzegovina, El Salvador and Sierra Leone

Includes bibliography

An analysis of Generalized Symmetrical Components in non sinusoidal three phase systems

This paper presents the study of the so called Generalized Symmetrical Components, proposed by Tenti et. al. to the analysis of unbalanced periodic non sinusoidal three phase systems. As a result, it was possible to establish a proper relationship between such of generalized symmetrical components and Fortescue symmetrical components to the harmonic frequencies that compose a generic periodic non sinusoidal three phase system. © 2011 IEEE.

Comparison of the ant assemblages in three phytophysionomies: Rocky field, secondary forest, and riparian forest - A case study in the state park of Ibitipoca, Brazil

Ant assemblages are almost all related with the vegetation composition and so can provide us important information for conservation strategies, which are especially relevant to an environmentally protected area. We sampled the ant fauna in three different phytophysionomies in order to verify if the composition of ant species is different among the areas, especially because one of the areas is a Rocky Field and there is little information about the ant fauna in this habitat. A total of 8730 individuals were registered and an NMDS analysis showed that the ant assemblies are different at the three phytophysionomies (Rocky Field, Riparian Forest, and Secondary Forest). This study shows that the species that compose the ant assemblies in different phytophysionomies are a reflex of the environment, supporting the hypothesis that the vegetational composition results in different compositions in the ant assembly. Vegetal composition is determinant in the formation of the litter and consequently in the occurrence of ant species that depend on this layer of organic matter for nesting and foraging. © 2012 Juliane Floriano Santos Lopes et al.

Coping strategies among brazilian professional and amateur football players

To identify coping strategies used among professional and amateur Brazilian football players. The Ways of Coping Scale (WOCS) was completed by 134 male football players (71 professionals: mean age = 22.77 ± 3.98 years; 63 amateurs: mean age = 17.18 ± 0.84 years) from three teams that participated in the Campeonatos Estaduais da Primeira Divisão (the state championships for the first division of football). There was no significant difference between the two groups in the type of coping strategy they used (e.g., problem-focused, emotion-focused, fantasy thoughts, religious practices and social support). Problem-focused coping was the most frequently used strategy by all of the players and social support was the least frequently used strategy. Both professional and amateur players failed to focus on the development of adequate coping strategies. Further studies are needed to better understand the impact that Brazilian athletes experience has on their choice of coping strategies during pre-competitive and competitive phases of their sport. © JPES.

Three-dimensional modeling and highly refined mesh generation of the aorta artery and its tunics

This paper describes strategies and techniques to perform modeling and automatic mesh generation of the aorta artery and its tunics (adventitia, media and intima walls), using open source codes. The models were constructed in the Blender package and Python scripts were used to export the data necessary for the mesh generation in TetGen. The strategies proposed are able to provide meshes of complicated and irregular volumes, with a large number of mesh elements involved (12,000,000 tetrahedrons approximately). These meshes can be used to perform computational simulations by Finite Element Method (FEM). © Published under licence by IOP Publishing Ltd.

Relative growth, sexual maturity, and breeding season of three species of the genus Persephona (Decapoda: Brachyura: Leucosiidae): A comparative study

The relative growths of Persephona lichtensteinii, P. mediterranea, and P. punctata were investigated on the south-eastern Brazilian coast, focusing on differences in the growth rates between immature and mature phases, the onset of morphological sexual maturity, and the breeding seasons of these species. Crabs were collected every two months from January 1991 through to November 1992, from a shrimp fishing boat equipped with two otter-trawl nets. Significant differences in the patterns of body growth were observed between immature and mature phases of all three species. Changes in the growth rates of the chelipeds (males) and abdomen (females) observed for P. lichtensteinii, P. mediterranea, and P. punctata, seem to be related to the puberty moult for both sexes. Males of P. mediterranea and P. punctata reached larger mean sizes of carapace width than females, whereas no difference was recorded for P. lichtensteinii. The body size at which 50% of males attained sexual maturity was also larger in P. mediterranea and P. punctata, and smaller in P. lichtensteinii. The absence of a pronounced sexual dimorphism and the size at the onset of sexual maturity observed only for P. lichtensteinii might be explained by distinct reproductive strategies of males. The presence of ovigerous females during the entire sampling period suggests that all three species have a continuous reproduction pattern at the Ubatuba region. Future studies on the population structure, functional maturity, and mating system should improve the understanding of factors driving the biology and ecology of these species at a subtropical region. © Marine Biological Association of the United Kingdom 2013.

Lei dos genéricos e concorrência na indústria farmacêutica brasileira: estudo de casos sobre a atuação das empresas transnacionais

Pós-graduação em Economia - FCLAR

Development strategies for the information and communications technology sector in the Caribbean: A global perspective

This occasional paper examines the experiences of three leading global centres of the ICT industry – India, Silicon Valley, and Estonia – to reflect on how the lessons of these models can be applied to the context of countries in the Caribbean region.Several sectors of the technology industry are considered in relation to the suitability for their establishment in the Caribbean. Animation is an area that is showing encouraging signs of development in several countries, and which offers some promise to provide a significant source of employment in the region. However, the global market for animation production is likely to become increasingly competitive, as improved technology has reduced barriers to entry into the industry not only in the Caribbean, but around the world. The region’s animation industry will need to move swiftly up the value chain if it is to avoid the downsides of being caught in an increasingly commoditized market. Mobile applications development has also been widely a heralded industry for the Caribbean. However, the market for consumer-oriented smartphone applications has matured very quickly, and is now a very difficult sector in which to compete. Caribbean mobile developers would be better served to focus on creating applications to suit the needs of regional industries and governments, rather than attempting to gain notice in over-saturated consumer marketplaces such as the iTunes App Store and Google Play. Another sector considered for the Caribbean is “big data” analysis. This area holds significant potential for growth in coming years, but the Caribbean, which is generally considered to be a datapoor region, currently lacks a sufficient base of local customers to form a competitive foundation for such an industry. While a Caribbean big data industry could plausibly be oriented toward outsourcing, that orientation would limit positive externalities from the sector, and benefits from its establishment would largely accrue only to a relatively small number of direct participants in the industry. Instead, development in the big data sector should be twinned with the development of products to build a regional customer base for the industry. The region has pressing needs in areas such as disaster risk reduction, water resource management, and support for agricultural production. Development of big data solutions – and other technology products – to address areas such as these could help to establish niche industries that both support the needs of local populations, and provide viable opportunities for the export of higher-value products and services to regions of the world with similar needs.