Two-phase flow patterns in a 90 degrees bend at microgravity

Bends are widely used in pipelines carrying single- and two-phase fluids in both ground and space applications. In particular, they play more important role in space applications due to the extreme spatial constraints. In the present study, a set of experimental data of two-phase flow patterns and their transitions in a 90degrees bend with inner diameter of 12.7 mm. and curvature radius of 76.5 mm at microgravity conditions are reported. Gas and liquid superficial velocities are found to range from (1.0 similar to 23.6) m/s for gas and (0.09 similar to 0.5) m/s for liquid, respectively. Three major flow patterns, namely slug, slug-annular transitional, and annular flows, are observed in this study. Focusing on the differences between flow patterns in bends and their counterparts in straight pipes, detailed analyses of their characteristics are made. The transitions between adjoining flow patterns are found to be more or less the same as those in straight pipes, and can be predicted using Weber number models satisfactorily. The reasons for such agreement are carefully examined.

On the velocity of buckle propagation in a beam on a nonlinear elastic-foundation

The paper revisits a simple beam model used by Chater et al. (1983, Proc. IUTAM Symp. Collapse, Cambridge University Press) to examine the dynamics of propagating buckles on it. It was found that, if a buckle is initiated at a constant pressure higher than the propagation pressure of the model (P-p), the buckle accelerates and gradually reaches a constant velocity which depends upon the pressure, while if it is initiated at P-p, the buckle propagates at a velocity which depends upon the initial imperfection. The causes for the difference are also investigated.

Kinetic theory for particle concentration distribution in two phase flow

The results of experiments in open channels and closed pipelines show two kinds of patterns for the vertical distribution of particle concentration (i.e., pattern I and pattern II). The former shows a pattern of maximum concentration at some location above the bottom and the downward decay of the concentration below the location. The latter always shows an increase of the particle concentration downward over the whole vertical, with the maximum value at the bottom. Many investigations were made on the pattern II, but few were made on pattern I. In this paper, a particle velocity distribution function is first obtained in the equilibrium state or in dilute steady state for the particle in two-phase flows, then a theoretical model for the particle concentration distribution is derived from the kinetic theory. More attention is paid to the predictions of the concentration distribution of pattern I and comparisons of the present model are made with the data measured by means of laser doppler anemometry (LDA). Very good agreements are obtained between the measured and calculated results.

单向海流载荷下海底管道局部冲刷试验研究

采用量纲分析法建立了海底管道局部冲刷的相似准则，利用模型实验研究了管道局部冲刷的物理过程，以及极限平衡冲刷深度的影响因素。实验观测发现，对于初始嵌入深度较小的管道而言，局部冲刷一般可分为管道悬空、间隙冲刷、尾迹冲刷和平衡冲刷四个特征阶段。在亚临界流动范围内，管道极限平衡冲刷深度与雷诺数的相关性较小。在清水冲刷条件下，无量纲极限平衡冲刷深度随希尔兹数的增加而增大；在所研究的初始间隙比范围内（-0．25〈e_0／D〈0．55），极限平衡冲刷深度与初始间隙比之间大致呈线性递减关系。

考虑海床变形的裸露悬跨海底管道静力分析

针对裸露悬跨海底管道,考虑线弹性海床刚度,利用梁的小挠度理论,研究管道在自重作用下的变形和内力,推导给出了未脱离海床的管道段和悬跨管道段的变形和内力公式。在跨度较大的悬跨情况下,悬跨管道段较大的向下弯曲变形可能引起海床上管道脱离海床而翘起。建立管道翘起的判定准则,对于翘起情况推导相应的计算公式,通过算例给出翘起情况下管道的变形和内力。通过计算分析发现：工程上多数悬跨是翘起情况,没有翘起的计算公式只适应于跨度较小的悬跨管道。同时翘起情况下不同海床刚度对悬跨管道无量纲内力影响不大。

Seasonal cycles of phytoplankton in relation to the hydrography of Monterey Bay

Annual cycles of relative abundance are described for phytoplankton species collected from Monterey Bay, California, from July 1974 to June 1976, and the population dynamics related to the annual hydrographic cycle. Neritic diatom species dominated the population during the Upwelling and Oceanic periods, with dinoflagellate species becoming numerically more important during the Davidson period. Recurrent species groups identified using Fager's regroup analysis revealed the presence of a large neritic group of overwhelming numerical importance. This group is composed of indigenous species and is present in the bay during most of the year. Conspicuous changes in the phytoplankton population occurred predominantly among species within this group. During the Davidson period, the advection of southern waters into the bay may temporarily displace the endemic species with dinoflagellates becoming numerically more important. A red tide bloom of Gonyaulax polyedra occurred during this period in 1974, which dominated the phytoplankton population for a period of six weeks. The population dynamics of two hydrographically different stations were compared. A station located over the deep waters of the submarine canyon exhibited much lower phytoplankton standing stocks than a station located over the shelf area in the south of the bay, but seasonal changes in relative abundance and species composition were similar. Physical and chemical differences observed between the two stations appear to be the result of the presence of more recently upwelled water in the canyon area, and higher biological utilization in the south of the bay. A close correlation of species diversity with the depth of the mixed layer was observed, with diversity rising with the shoaling of the thermocline. It is suggested that this may reflect the introduction of new species from below the thermocline into the mixed layer as a result of upwelling activity. It is also suggested that this may be an artifact due to sampling problems associated with internal waves. (Document contains 100 pages.)

基于插值函数的海底管道多点提升分析

建立海管点提升的力学模型，用多项式插值得到各种提升状态下的变形和内力.和现有方法相比，该法编程简单，易于实现，能满足工程的计算精度.

多作业状态下近海油气管线的力学分析及软件

在近海管线的铺设、安装、使用过程中有多种作业状态：在位、悬跨、挖沟、提吊、铺管等。各种状态下管线的受力特点不同，加上管线结构、海况和海底土壤等因素又都很复杂，所以近海管线的强度分析难度大、内容多。分别采用解析方法、数值方法（有限元法、打靶法）和二者结合来解决理论上的（如几何非线性、动边界等）、实用性方面的难点。在理论分析的基础上，编制了符合产业部门工程师使用要求的近海管线强度分析软件。介绍了该软件进行力学分析时采用的理论以及软件界面。

Pipeline Corrosion Analyzed by Fuzzy Reliability Methods

Fuzzy reliability methods are used to study the corrosion of pipelines. Three methods are used. They consist of using fracture failure modes, failure assessment diagram (FAD) and residual strength for establishing fuzzy reliability. Calculations are made by application of JC, improved GA-JC and Mente-carlo methods. Examples for oilfield injecting water pipeline show the residual strength well agree with field data. Mente-carlo methods appear to yield results that have better agreement with field data.

Oscillatory Flow Induced Hydrodynamic Forces upon a Pipeline near Erosive Sandy Seabed

An experimental study of the properties of hydrodynamic forces upon a marine pipeline is presented in this paper, in the equilibrium scour conditions for various Keulegan-Carpenter numbers and various initial relative gaps between pipeline and the erosive sandy seabed. The tests are conducted in a U-shaped oscillatory water tunnel with a sand box located at the bottom of the test section. According to the experimental results, the maximum horizontal forces on the pipelines with an initial gap to seabed will decrease to some extent due to scouring process. For engineering appliances, it seems safer to estimate wave induced forces on pipelines under the assumption that seabed is plane. However, it should be noticed that great changes would be brought to the frequency properties of lift forces because of the sandy scour beneath the pipeline, which occurs for certain KC numbers.

The Effects of Backfill Soil Properties on Wave-induced Pore Pressures around a Trenched Pipeline

Offshore pipelines are always trenched into seabed to reduce wave-induced forces and thereby to enhance their stability. The trenches are generally backfilled either by in-site sediments or by depositing selected backfill materials over the pipeline from bottom-dump barge. The actual waves in shallow water zone are always characterized as nonlinear. The proper evaluation of the wave-induced pressures upon pipeline is important for coastal geotechnical engineers. However, most previous investigations of the wave–seabed–pipe interaction problem have been concerned only with a single sediment layer and linear wave loading. In this paper, based on Biot’s consolidation theory, a two-dimensional finite element model is developed to investigate non-linear wave induced pore pressures around trenched pipeline. The influences of the permeability of backfill soil and the geometry profiles of trenches upon soil responses around pipeline are studied respectively.

Analytical Methods of Residual Strength in Injecting Water Pipeline

In this paper, common criterions about residual strength evaluation at home and abroad are generalized and seven methods are acquired, namely ASME-B31G, DM, Wes-2805-97, CVDA-84, Burdekin, Irwin and J integral methods. BP neural network are Combined with Genetic Algorithm (GA) named by modified BP-GA methods to successfully predict residual strength and critical pressure of injecting water, corrosion pipelines. Examples are shown that calculation results of every kind of method have great difference and calculating values of Wes-2805-97 criterion, ASME-B31G criterion, CVDA-84 criterion and Irwin fracture mechanics model are conservative and higher than, those of J integral methods while calculating values of Burdiken model and DM fracture mechanics model are dangerous and less than those of J integral methods and calculating values of modified BP-GA methods are close and moderate to those of J integral methods. Therefore modified BP-GA methods and J integral methods are considered better methods to calculate residual strength and critical pressure of injecting water corrosion pipelines

Influence of Wind and Grain Size on Migration of Asymmetric Sand Waves

Large parts of shallow seas are covered by regular seabed patterns and sand wave is one kind of these patterns. The instability of the sedimentary structures may hazard pipelines and the foundations of offshore structures. In the last decade or so, it's a focus for engineers to investigate the movement mechanism of sand waves. Previous theoretical studies of the subject have developed a general model to predict the growth and migration of sand waves, which is based on the two-dimensional vertical shallow water equations and the bed-form deformation equations. Although the relation between wave-current flow and sand bed deformation has been established, the topographic influence has not been considered in the model. In this paper some special patterns, which are asymmetric and close to the reality, are represent as the perturbed seabed and the evolution of sand waves is calculated. The combination of a steady flow induced by wind and a sinusoidal tidal flow is considered as the basic flow. Finally the relations of some parameters (grain size, etc.) and sand waves' growth and migration are discussed, and the growth rate and migration speeds of asymmetric sand waves are carried out.

Experimental Study of Pipeline Stability on Sandy Seabed under the Influence of Ocean Currents

Ocean-current-induced pipeline stability on sandy seabed was simulated physically in a flow flume. The process of pipeline losing onbottom stability in currents was recorded and analyzed. Experimental data show that, for a pipeline directly laid on sandy seabed, there exists a linear relationship between the dimensionless submerged weight of pipeline and Froude number, in which the current-pipe-soil coupling effects are reflected. The sand-particle size effects on pipeline onbottom stability are further discussed. The new established empirical relationship may provide a guide for the engineering practice of current-induced on-bottom stability design of a submarine pipeline.