A two-phase composite in simple shear: Effective mechanical anisotropy development and localization potential

We present a combined shape and mechanical anisotropy evolution model for a two-phase inclusion-bearing rock subject to large deformation. A single elliptical inclusion embedded in a homogeneous but anisotropic matrix is used to represent a simplified shape evolution enforced on all inclusions. The mechanical anisotropy develops due to the alignment of elongated inclusions. The effective anisotropy is quantified using the differential effective medium (DEM) approach. The model can be run for any deformation path and an arbitrary viscosity ratio between the inclusion and host phase. We focus on the case of simple shear and weak inclusions. The shape evolution of the representative inclusion is largely insensitive to the anisotropy development and to parameter variations in the studied range. An initial hardening stage is observed up to a shear strain of gamma = 1 irrespective of the inclusion fraction. The hardening is followed by a softening stage related to the developing anisotropy and its progressive rotation toward the shear direction. The traction needed to maintain a constant shear rate exhibits a fivefold drop at gamma = 5 in the limiting case of an inviscid inclusion. Numerical simulations show that our analytical model provides a good approximation to the actual evolution of a two-phase inclusion-host composite. However, the inclusions develop complex sigmoidal shapes resulting in the formation of an S-C fabric. We attribute the observed drop in the effective normal viscosity to this structural development. We study the localization potential in a rock column bearing varying fraction of inclusions. In the inviscid inclusion case, a strain jump from gamma = 3 to gamma = 100 is observed for a change of the inclusion fraction from 20% to 33%.

Effect of boric acid treatment on mechanical properties of laminated beech veneer lumber

Abstract

Mechanical damage in cotton buds caused by the boll weevil

The boll weevil (Anthonomus grandis Boheman) causes high levels of bud abscission in cotton plants due to feeding or oviposition punctures. It has been reported that abscission is mainly due to enzymes present in the insect's saliva, but mechanical damage could also contribute to square abscission. The objective of this paper was to undertake an analysis of the morphological damages caused by the insect in cotton squares using microscopy. Anthers and ovules are the main target of boll weevil feeding. The process initiates by perforation of young sepal and petal tissues and proceeds with subsequent alimentation on stamen and ovary leading to abscission of floral structures.

Avaluació de l'aptitud de bioestabilitzats com a esmena orgànica per a la rehabilitació de sòls

L’objectiu d’aquest estudi ha estat avaluar l’efecte que té sobre algunes propietats fisicoquímiques del sòl i el creixement de plantes, l’adició del producte compostat obtingut a partir de la fracció orgànica dels residus sòlids urbans de recollida no selectiva, material anomenat bioestabilitzat. S’ha dut a terme un bioassaig amb blat (Triticum aestivum), utilitzant bioestabilitzat procedent de dues plantes de tractament mecànic i biològic, Vacarisses i Mataró, que s’ha aplicat a diferents dosis en un sòl de baixa qualitat. S’ha observat una relació positiva entre el creixement del blat i la dosis de bioestabilitzat aplicada. Pel que fa a la germinació, ha estat lleugerament estimulada per les dosis intermèdies de bioestabilitzat assajades. En quant a les propietats fisicoquímiques del sòl, s’ha observat un increment de la salinitat en funció de la dosis de bioestabilitzat aplicada, que en les més elevades podria ser problemàtica. També, el contingut de matèria orgànica ha augmentat de manera proporcional a la dosis, cosa que ha millorat les propietats físiques del sòl. Per altra banda, s’han trobat continguts d’impropis (vidre, plàstic ...) i concentracions d’alguns metalls pesants bastant elevades, així com una considerable variabilitat entre les partides de bioestabilitzat. Finalment, es conclou que abans de permetre l’aplicació de bioestabilitzat per a la rehabilitació de sòls degradats, cal aprofundir més en l’estudi d’aquest material.

Búsqueda de plantas con propiedades insecticidas para el control de Sitophilus zeamais en maíz almacenado

Se evaluaron, bajo condiciones de laboratorio, 23 plantas en polvo para el control de Sitophilus zeamais Mots. en maíz almacenado. En una primera etapa se evaluaron todos los polvos a una concentración del 1,0% (p/p). Posteriormente aquellos polvos con mejores resultados fueron probados en concentraciones del 0,1, 0,5, 1,0 y 2,0% en granos de maíz infestados con los insectos a las 24 horas, 30, 60 y 90 días. Se evaluaron 63 tratamientos distribuidos en un diseño experimental completamente al azar y el ensayo se repitió tres veces. En la primera etapa, la mayor mortalidad de insectos se obtuvo con Chenopodium ambrosioides L. y Peumus boldus Mol. con 65,8% y 99,3%, respectivamente. Estos tratamientos también propiciaron la menor emergencia de adultos, mientras que la pérdida de peso de los granos no superó el 13,0%. En las evaluaciones a diferentes concentraciones mostraron una mayor mortalidad y menor emergencia a concentraciones del 1,0% y 2,0% (p/p), obteniéndose para C. ambrosioides una mortalidad del 90,3% y 90,1% y para P. boldus 97,1% y 98,8%, respectivamente. La residualidad se mantuvo sólo en el tratamiento de 24 horas.

Measurement of the mechanical power of walking by satellite positioning system (GPS).

PURPOSE: This descriptive article illustrates the application of Global Positioning System (GPS) professional receivers in the field of locomotion studies. The technological challenge was to assess the external mechanical work in outdoor walking. METHODS: Five subjects walked five times during 5 min on an athletic track at different imposed stride frequency (from 70-130 steps x min(-1)). A differential GPS system (carrier phase analysis) measured the variation of the position of the trunk at 5 Hz. A portable indirect calorimeter recorded breath-by-breath energy expenditure. RESULTS: For a walking speed of 1.05 +/- 0.11 m x s(-1), the vertical lift of the trunk (43 +/- 14 mm) induced a power of 46.0 +/- 20.4 W. The average speed variation per step (0.15 +/- 0.03 m x s(-1)) produced a kinetic power of 16.9 +/- 7.2 W. As compared with commonly admitted values, the energy exchange (recovery) between the two energy components was low (39.1 +/- 10.0%), which induced an overestimated mechanical power (38.9 +/- 18.3 W or 0.60 W x kg(-1) body mass) and a high net mechanical efficiency (26.9 +/- 5.8%). CONCLUSION: We assumed that the cause of the overestimation was an unwanted oscillation of the GPS antenna. It is concluded that GPS (in phase mode) is now able to record small body movements during human locomotion, and constitutes a promising tool for gait analysis of outdoor unrestrained walking. However, the design of the receiver and the antenna must be adapted to human experiments and a thorough validation study remains to be conducted.

Rufinamide Attenuates Mechanical Allodynia in a Model of Neuropathic Pain in the Mouse and Stabilizes Voltage-gated Sodium Channel Inactivated State.

BACKGROUND:: Voltage-gated sodium channels dysregulation is important for hyperexcitability leading to pain persistence. Sodium channel blockers currently used to treat neuropathic pain are poorly tolerated. Getting new molecules to clinical use is laborious. We here propose a drug already marketed as anticonvulsant, rufinamide. METHODS:: We compared the behavioral effect of rufinamide to amitriptyline using the Spared Nerve Injury neuropathic pain model in mice. We compared the effect of rufinamide on sodium currents using in vitro patch clamp in cells expressing the voltage-gated sodium channel Nav1.7 isoform and on dissociated dorsal root ganglion neurons to amitriptyline and mexiletine. RESULTS:: In naive mice, amitriptyline (20 mg/kg) increased withdrawal threshold to mechanical stimulation from 1.3 (0.6-1.9) (median [95% CI]) to 2.3 g (2.2-2.5) and latency of withdrawal to heat stimulation from 13.1 (10.4-15.5) to 30.0 s (21.8-31.9), whereas rufinamide had no effect. Rufinamide and amitriptyline alleviated injury-induced mechanical allodynia for 4 h (maximal effect: 0.10 ± 0.03 g (mean ± SD) to 1.99 ± 0.26 g for rufinamide and 0.25 ± 0.22 g to 1.92 ± 0.85 g for amitriptyline). All drugs reduced peak current and stabilized the inactivated state of voltage-gated sodium channel Nav1.7, with similar effects in dorsal root ganglion neurons. CONCLUSIONS:: At doses alleviating neuropathic pain, amitriptyline showed alteration of behavioral response possibly related to either alteration of basal pain sensitivity or sedative effect or both. Side-effects and drug tolerance/compliance are major problems with drugs such as amitriptyline. Rufinamide seems to have a better tolerability profile and could be a new alternative to explore for the treatment of neuropathic pain.

Evaluation of peanut genotypes for resistance to Tomato spotted wilt virus by mechanical and thrips inoculation

The objective of this work was to evaluate the reactions of three peanut breeding lines (IC-10, IC-34, and ICGV 86388) to Tomato spotted wilt virus (TSWV) by mechanical and thrips inoculation, under greenhouse conditions, and compare them to the reactions of cultivars SunOleic, Georgia Green, and the breeding line C11-2-39. TSWV infection by mechanical inoculation was visually assessed using an index ranging from 0 (no symptoms) to 4 (apical death). Enzyme-linked immunosorbent assay was used to confirm TSWV infection from both mechanical and thrips inoculations. IC-10, IC-34, ICGV 86388, and C11-2-39 were more resistant than the cultivars SunOleic and Georgia Green based on mechanical inoculation. Upon thrips inoculation only IC-34 and ICGV-86388 were infected by TSWV, as demonstrated by reverse transcription polymerase chain reaction (RT-PCR), although no symptoms of infection were observed. The peanut breeding lines IC-10, IC-34, and ICGV 86388 show higher level of resistance to TSWV than cultivar Georgia Green considered a standard for TSWV resistance.

Evaluation of Gap-Graded Asphalt Concrete Mixtures, Vol. 1. Physical Properties (Part I: Mechanical Properties), HR-157, Volume 1, 1972 (1973)

This report presents the results of a comparative laboratory study between well- and gap-graded aggregates used in asphalt concrete paving mixtures. A total of 424 batches of asphalt concrete mixtures and 3,960 Marshall and Hveem specimens were examined. There is strong evidence from this investigation that, with proper-combinations of aggregates and asphalts, both continuous- and gap-graded aggregates can produce mixtures of high density and of qualities meeting current design criteria. There is also reason to believe that the unqualified acceptance of some supposedly desirable, constant, mathematical relationship between adjacent particle sizes of the form such as Fuller's curve p = 100(d/D)^n is not justified. It is recommended that the aggregate grading limits be relaxed or eliminated and that the acceptance or rejection of an aggregate for use in asphalt pavement be based on individual mixture evaluation. Furthermore, because of the potential attractiveness of gap-graded asphalt concrete in cost, quality, and skid and wear resistance, selected gap-graded mixtures are recommended for further tests both in the laboratory and in the field, especially in regard to ease of compaction and skid and wear resistance.

Variación anual de las propiedades insecticidas de Peumus boldus sobre Sitophilus zeamais

El objetivo del presente trabajo fue determinar la variación anual en las propiedades insecticidas de Peumus boldus Molina, en el control de Sitophilus zeamais Motschulsky, bajo condiciones de laboratorio. El polvo de hojas de P. boldus se evaluó durante 12 meses, en concentraciones de 0,5, 1 y 2% (p/p). Se evaluaron 36 tratamientos con tres repeticiones, en un diseño experimental completamente al azar, con un arreglo factorial. Se determinó el porcentaje de mortalidad y emergencia de insectos adultos e inmaduros y pérdida de peso y germinación del grano. La mayor mortalidad se obtuvo en los meses de agosto y septiembre de 2003, para las tres concentraciones con un 100%, mientras que la menor fue en mayo de 2003, cuando solo la concentración de 2% fue próxima a 100% de mortalidad. La menor emergencia de insectos adultos y pérdida de peso se obtuvieron en los mismos tratamientos. El efecto sobre estados inmaduros fue menor que contra adultos, y la germinación de los granos de maíz fue afectada por los polvos de P. boldus. Las propiedades insecticidas del polvo de hojas de P. boldus no son estables durante el año, Mayo es el mes con la menor eficacia insecticida, y la germinación de las semillas se ve afectada por el polvo.