Oxygen and carbon isotope data from late calcite and zeolite pore-fill cements at DSDP Site 445

Oxygen isotopic composition of zeolite pore-fill cements in andesitic volcaniclastic sandstones recovered from DSDP Site 445 ranges from +30.1 to +17.8? (SMOW) downhole. This change is controlled by large heat flow from the basement which caused early diagenetic emplacement of zeolites during early basin rifting. d18O-values of late calcite cements range from +25.1 to +27.4? (SMOW); their petrographic relation and inferred temperature of formation suggest that calcite cements were formed during late stages of diagenesis. Isotopic composition in these sandstones is in agreement with mineral paragenesis determined microscopically.

Petrology and isotope characteristics of basalts from ODP Hole 111-504B

Petrography and isotope geochemical characteristics of H, O, S, Sr, and Nd have been described for basalts recovered from Hole 504B during Leg 111 of the Ocean Drilling Program. The petrographic and chemical features of the recovered basalts are similar to those obtained previously (DSDP Legs 69, 70, and 83); they can be divided into phyric (plagioclase-rich) and aphyric (Plagioclase- and clinopyroxene-rich) basalts and show low abundances of TiO2, Na2O, K2O, and Sr. This indicates that the basalts belong to Group D, comprising the majority of the upper section of the Hole 504B. The diopside-rich nature of the clinopyroxene phenocrysts and Ca-rich nature of the Plagioclase phenocrysts are also consistent with the preceding statement. The Sr and Nd isotope systematics (average 87Sr/86Sr = 0.70267 ± 0.00007 and average 143Nd/144Nd = 0.513157 ± 0.000041) indicate that the magma sources are isotopically heterogeneous, although the analyzed samples represent only the lowermost 200-m section of Hole 504B. The rocks were subjected to moderate hydrothermal alteration throughout the section recovered during Leg 111. Alteration is limited to interstices, microfractures, and grain boundaries of the primary minerals, forming chlorite, actinolite, talc, smectite, quartz, sphene, and pyrite. In harmony with the moderate alteration, the following alteration-sensitive parameters show rather limited ranges of variation: H2O = 1.1 ±0.2 wt%, dD = - 38 per mil ± 4 per mil, d180 = 5.4 per mil ± 0.3 per mil, total S = 562 ± 181 ppm, and d34S = 0.8 per mil ± 0.3 per mil. Based on these data, it was estimated that the hydrothermal fluids had dD and d180 values only slightly higher than those of seawater, the water/rock ratios were as low as 0.02-0.2, and the temperature of alteration was 300°-400°C. Sulfur exists predominantly as pyrite and in minor quantities as chalcopyrite. No primary monosulfide was detected. This and the d34S values of pyrite (d34S = 0.8 per mil) suggest that primary pyrrhotite was almost completely oxidized to pyrite by reaction with hydrothermal fluids containing very little sulfate.

Composition of fossil manganese nodules from Costa Rica

Horizons of several types of Upper Jurassic to Lower Cretaceous manganese nodules occur locally in sequences of radiolarian cherts within the Nicoya Ophiolite Complex (NW Costa Rica). Field studies, X-ray diffraction analysis, petrographic, chemical and experimental studies give evidence of a sedimentary, early diagenetic origin of the nodules, in contrast to earlier suggestions. Smooth, discoidal, compact and very dense nodules with diameters of some mm to 9 cm dominate. They are characterized by braunite, hollandite, pyrolusite and quartz as well as 39-61% Mn, 0.9-1.6% Fe, 5-26% SiO2, 1.3-1.9% Al2O3, 1.5-3.0% Ba, 460-5400 ppm Cu, 85-340 ppm Ni and 40-130 ppm Co, among others. It is suggested that the original mineralogy (todorokite?) was altered during thermometamorphic (braunite) and hydrothermal (hollandite. pyrolusite) events. Petrographic similarities between the fossil nodules and modern deep-sea nodules are striking. Using standard hydrothermal techniques in an experimental study it is shown that under special conditions, braunite can be produced from modern nodule material.

Isotope ratios of smectites, calcites and whole rocks from DSDP Legs 51 and 52, Atlantic Ocean

Delta180 and 87Sr/86Sr isotopic data from smectites, calcites, and whole rocks, together with published isotopic age determinations, alkali element concentration data and petrographic observations suggest a sequential model of ocean floor alteration. The early stage lasts about 3 m.y. and is characterized by palagonite and smectite formation, and solutions with a large basaltic component, increasing with temperature which varies from 15° to 80° C at DSDP site 418A. Most carbonates are deposited after this stage from solutions with a negligible basaltic Sr component and temperatures of 15° to 40° C. Water of seawater Sr and O isotopic composition is shown to percolate to at least 500 m into the basaltic basement. No evidence was found for continuing exchange of strontium or oxygen after 3 m.y.

Heavy and light minerals at DSDP Leg 67 Holes

Heavy and light minerals were examined in 29 samples from Sites 494, 498, 499, 500, and 495 on the Deep Sea Drilling Project Leg 67 Middle America Trench transect; these sites represent lower slope, trench, and oceanic crust environments off Guatemala. All samples are Quaternary except those from Hole 494A (Pliocene) and Hole 498A (Miocene). Heavy-mineral assemblages of the Quaternary sediments are characterized by an immature pyroxene-amphibole suite with small quantities of olivine and epidote. The Miocene sediments yielded an assemblage dominated by epidote and pyroxene but lacking olivine; the absence of olivine is attributed to selective removal of the most unstable components by intrastratal solution. Light-mineral assemblages of all samples are predominantly characterized by volcanic glass and plagioclase feldspar. The feldspar compositions are compatible with andesitic source rocks and frequently exhibit oscillatory zoning. The heavy- and light-mineral associations of these sediments suggest a proximal volcanic source, most probably the Neogene highland volcanic province of Guatemala. Sand-sized components from Site 495 are mainly biogenic skeletons and volcanic glass and, in one instance (Section 495-5-3), euhedral crystals of gypsum.