917 resultados para Pesticide Residues
Resumo:
The electrochemical behaviour of the herbicide Asulam was studied by cyclic and square wave voltammetry. Asulam may be irreversibly oxidised at a glassy carbon electrode. Maximum currents were obtained at pH=1.9 in aqueous electrolyte solution. Based on the electrochemical behaviour of Asulam, two analytical methodologies were developed for its determination in water samples, using square wave voltammetry (SWV) and flow injection analysis (FIA) coupled with an amperometric detector. Limits of detection of 7.1x10-6 mol L-1 and 1.2x10-8 mol L-1 for SWV and FIA respectively, were achieved. Repeatability was calculated by assessing the relative standard deviation (%) for 10 consecutive determinations of one sample. The found values were 2.1% for SWV and 5.0% for FIA. Validation of the results provided by SWV and FIA methodologies was performed by comparison with results from an HPLC-DAD technique. Good relative deviations were found (<5%). Recovery trials were performed to assess the accuracy of the results and the obtained values were between 84% and 107% for both methods.
Resumo:
A detailed study of voltammetric behavior of ethiofencarb (ETF) is reported using glassy carbon electrode (GCE) and hanging mercury drop electrode (HMDE). With GCE, it is possible to verify that the oxidative mechanism is irreversible, independent of pH, and the maximum intensity current was observed at +1.20 V vs. AgCl/Ag at pH 1.9. A linear calibration line was obtained from 1.0x10-4 to 8.0x10-4 mol L-1 with SWV method. To complete the electrochemical knowledge of ETF pesticide, the reduction was also explored with HMDE. A well-defined peak was observed at –1.00V vs. AgCl/Ag in a large range of pH with higher signal at pH 7.0. Linearity was obtained in 4.2x10-6 and 9.4x10-6 mol L-1 ETF concentration range. An immediate alkaline hydrolysis of ETF was executed, producing a phenolic compound (2-ethylthiomethylphenol) (EMP), and the electrochemical activity of the product was examined. It was deduced that it is oxidized on GCE at +0.75V vs. AgCl/Ag with a maximum peak intensity current at pH 3.2, but the compound had no reduction activity on HMDE. Using the decrease of potential peak, a flow injection analysis (FIA) system was developed connected to an amperometric detector, enabling the determination of EMP over concentration range of 1.0x10-7 and 1.0x10-5 mol L-1 at a sampling rate of 60 h-1. The results provided by FIA methodology were performed by comparison with results from high-performance liquid chromatography (HPLC) technique and demonstrated good agreement with relative deviations lower than 4%. Recovery trials were performed and the obtained values were between 98 and 104%.
Resumo:
This study focused on the development of a sensitive enzymatic biosensor for the determination of pirimicarb pesticide based on the immobilization of laccase on composite carbon paste electrodes. Multi- walled carbon nanotubes(MWCNTs)paste electrode modified by dispersion of laccase(3%,w/w) within the optimum composite matrix(60:40%,w/w,MWCNTs and paraffin binder)showed the best performance, with excellent electron transfer kinetic and catalytic effects related to the redox process of the substrate4- aminophenol. No metal or anti-interference membrane was added. Based on the inhibition of laccase activity, pirimicarb can be determined in the range 9.90 ×10- 7 to 1.15 ×10- 5 molL 1 using 4- aminophenol as substrate at the optimum pH of 5.0, with acceptable repeatability and reproducibility (relative standard deviations lower than 5%).The limit of detection obtained was 1.8 × 10-7 molL 1 (0.04 mgkg 1 on a fresh weight vegetable basis).The high activity and catalytic properties of the laccase- based biosensor are retained during ca. one month. The optimized electroanalytical protocol coupled to the QuEChERS methodology were applied to tomato and lettuce samples spiked at three levels; recoveries ranging from 91.0±0.1% to 101.0 ± 0.3% were attained. No significant effects in the pirimicarb electro- analysis were observed by the presence of pro-vitamin A, vitamins B1 and C,and glucose in the vegetable extracts. The proposed biosensor- based pesticide residue methodology fulfills all requisites to be used in implementation of food safety programs.
Resumo:
The indiscriminate use of antibiotics in food-producing animals has received increasing attention as a contributory factor in the international emergence of antibiotic-resistant bacteria (Woodward in Pesticide, veterinary and other residues in food, CRC Press, Boca Raton, 2004). Numerous analytical methods for quantifying antibacterial residues in edible animal products have been developed over years (Woodward in Pesticide, veterinary and other residues in food, CRC Press, Boca Raton, 2004; Botsoglou and Fletouris in Handbook of food analysis, residues and other food component analysis, Marcel Dekker, Ghent, 2004). Being Amoxicillin (AMOX) one of those critical veterinary drugs, efforts have been made to develop simple and expeditious methods for its control in food samples. In literature, only one AMOX-selective electrode has been reported so far. In that work, phosphotungstate:amoxycillinium ion exchanger was used as electroactive material (Shoukry et al. in Electroanalysis 6:914–917, 1994). Designing new materials based on molecularly imprinted polymers (MIPs) which are complementary to the size and charge of AMOX could lead to very selective interactions, thus enhancing the selectivity of the sensing unit. AMOX-selective electrodes used imprinted polymers as electroactive materials having AMOX as target molecule to design a biomimetic imprinted cavity. Poly(vinyl chloride), sensors of methacrylic acid displayed Nernstian slopes (60.7 mV/decade) and low detection limits (2.9 × 10−5 mol/L). The potentiometric responses were not affected by pH within 4–5 and showed good selectivity. The electrodes were applied successfully to the analysis of real samples.
Resumo:
Carbamate compounds are an important group of cholinesterase inhibitors. There is a need for creating awareness regarding the risks of the inadequate carbamate use in the residential areas due to potential adverse human effects. Carbaryl is a commonly used pesticide worldwide. A simple, fast, and high throughput method was developed employing liquid chromatography with fluorescence detector to determine carbaryl residues in rat feces. The extraction was performed by using a rapid, easy, cheap, effective, reliable, and safe (QuEChERS) method, using acetonitrile as the extracting solvent. The parameters for the performance of the extraction method were optimized, such as ratio of mass of sample per volume of extraction solvent, QuEChERS content, and cleanup columns. Linear response was obtained for all calibration curves (solven and matrix-matched) over the established concentration range (5 500 mg/L) with a correlation coefficients higher than 0.999. The achieved recovery was 97.9% with relative standard deviation values of 1.1% (n D 4) at 167 mg/kg fortified concentration level and the limits of detection and quantification were 27.7 and 92.3 mg/kg respectively.
Resumo:
Dissertação para obtenção do Grau de Mestre em Biotecnologia
Resumo:
Dissertação para obtenção do Grau de Mestre em Engenharia do Ambiente Perfil de Engenharia de Sistemas Ambientais
Resumo:
In forensic investigation of firearm-related cases, determination of the residual amount of volatile compounds remaining inside a cartridge could be useful in estimating the time since its discharge. Published approaches are based on following the decrease of selected target compounds as a function of time by using solid phase micro-extraction (SPME). Naphthalene, as well as an unidentified decomposition product of nitrocellulose (referred to as "TEA2"), are usually employed for this purpose. However, reliability can be brought into question given their high volatility and the low reproducibility of their extracted quantities. In order to identify alternatives and therefore develop improved dating methods, an extensive study on the composition and variability of volatile residues in nine different types of cartridges was carried out. Analysis was performed using headspace sorptive extraction (HSSE), which is a more exhaustive technique compared to SPME. 166 compounds were identified (several of which for the first time), and it was observed that the final compositional characteristics of each residue were strongly dependent on its source. Variability of single identified compounds within and between different types of cartridge, as well as their evolution over time, was also studied. Many explosion products containing up to 4 aromatic rings were found to be globally present in high proportions amongst residues. 27 of them (excluding naphthalene) also presented detectable decreases during the first 24 h. Therefore, they could be used as complementary target analytes in future dating methods.
Resumo:
The carbamate pesticide, carbaryl, was quantitatively studied using fast atom bombardment mass spectrometry (FAB-MS). Mass spectra were obtained in the positive ion-mode using both 2-nitrophenyloctyl ether (NPOE) and 3-nitrobenzyl alcohol (NBA) as matrix liquids. The sample was applied by three different techniques; simple mixing, solvent mixing and surface precipitation. Smaller volumes of matrix liquid were found to produce more favourable ion currents. Detection limits were largely independent of the matrix or application technique used. The relationship between ion current and the mass of analyte was found to be intricately related to the choice of matrix liquid.
Resumo:
Combined gas chromatography and mass spectrometry has been used to identify unknown residues in soils (especially pesticides). The effect of U.V. light on DDT and linuron and quantitative estimation of elemental sulfur in different soils has also been carried out.
Resumo:
En 1940, Paul Erdős énonça une conjecture sur la distribution des classes inversibles modulo un entier. La présente thèse étudie la distribution des k-uplets de classes inversibles propose une preuve de la conjecture d'Erdős étendue au cas des k-uplets.
Resumo:
Le parasite Varroa destructor provoque depuis plus de 30 ans la perte de nombreuses colonies à travers le monde. L’utilisation d’acaricides de synthèse s’est avérée inefficace au Canada et ailleurs dans le monde à la suite de la sélection de varroas résistants. Dans ce contexte, il est devenu impératif de trouver de nouveaux moyens pour contrôler cette peste apicole. Ce travail original de recherche a pour but de déterminer les paramètres fondamentaux d’une lutte intégrée contre la varroase fondée sur l’utilisation périodique de différents pesticides organiques (l’acide oxalique, l’acide formique et le thymol) associée à des seuils d’interventions. Les seuils d’intervention ont été déterminés à l’aide de régressions linéaires entre les taux de parasitisme par V. destructor et la formance zootechnique des colonies d’abeilles mellifères (production de miel et force des colonies). Un total de 154 colonies d’abeilles du Centre de recherche en sciences animales de Deschambault (CRSAD) ont été suivies de septembre 2005 à septembre 2006. Les seuils calculés et proposés à la suite de cette recherche sont de 2 varroas par jour (chute naturelle) au début mai, 10 varroas par jour à la fin juillet et de 9 varroas par jour au début septembre. L’efficacité des traitements organiques avec l’acide oxalique (AO), l’acide formique (AF) et le thymol a été vérifiée en mai (avant la première miellée) en juillet (entre deux miellées), en septembre (après la miellée et pendant le nourrissage des colonies) et en novembre (avant l’hivernage). L’acide oxalique a été appliqué en utilisant la méthode d’égouttement (4% d’AO p/v dans un sirop de sucrose 1 :1 p/v). L’acide formique a été appliquée sous forme de MiteAwayII™ (tampon commercial imbibé d’AF 65% v/v placé sur le dessus des cadres à couvain), Mitewipe (tampons Dri-Loc™ 10/15cm imbibés de 35 mL d’AF 65% v/v placés sur le dessus des cadres à couvain) ou Flash (AF 65% coulé directement sur le plateau inférieur d’une colonie, 2 mL par cadre avec abeilles). Le thymol a été appliqué sous forme d’Apiguard™ (gélose contenant 25% de thymol p/v placée sur le dessus des cadres à couvain). Les essais d’efficacité ont été réalisés de 2006 à 2008 sur un total de 170 colonies (98 appartenant au CRSAD et 72 appartenant au privé). Les résultats montrent que les traitements de printemps testés ont une faible efficacité pour le contrôle des varroas qui sont en pleine croissance durant cette période. Un traitement avec l’AF à la mi-été permet de réduire les taux de parasites sous le seuil en septembre mais il y a risque de contaminer la récolte de miel avec des résidus d’AF. Les traitements en septembre avec le MiteAwayII™ suivis par un traitement à l’acide oxalique en novembre (5 mL par égouttement entre chaque cadre avec abeilles, 4% d’AO p/v dans un sirop de sucrose 1 :1 p/v) sont les plus efficaces : ils réduisent les niveaux de varroase sous le seuil de 2 varroas par jour au printemps. Nos résultats montrent également que les traitements réalisés tôt en septembre sont plus efficaces et produisent des colonies plus fortes au printemps comparativement à un traitement réalisé un mois plus tard en octobre. En conclusion, ce travail de recherche démontre qu’il est possible de contenir le développement de la varroase dans les ruchers au Québec en utilisant une méthode de lutte intégrée basée sur une combinaison d’applications d’acaricides organiques associée à des seuils d’intervention.