Gases e ruídos em edificações para suínos: aplicação das normas NR-15, CIGR e ACGIH

Swine production represents an important segment of Brazilian economy, and the possibility of increasing production is eminent mainly if considered the low pork consumption when compared to other meat and the consumption of other countries. The increasing need in the international market demands show that in a near future the commercial barriers will be based on welfare, in the protection of the environment as well as in the worker's legislation. Little knowledge is available in the subject of worker's standards in the environmental agents in rural activities as well as the air quality under Brazilian conditions. The objectives of this research were to apply the main used standards related to noise and gases and to estimate occupational risk using measurements of noise level, hydrogen sulfide, methane and oxygen in swine housing, in piglet's nursery and finishing. The results showed that the continuous noise level were below the one found in the standards, however there were observed differences (P < 0.05) in relation to the noise level measured in piglet's nursing cages and in semi-slatted floor. The respective concentrations of hydrogen sulfide and methane were less than 1 ppm and less than 0,1% by volume, which was lower than the recommended limits in NR-15, CIGR and ACGIH. The oxygen level was 21% in average.

Avaliação térmica de placas de argamassa de cimento e casca de arroz aquecidas por resistência elétrica

An alternative proposal for floor heating system by means of electric resistance for both chick and piggy installation is presented in this work. Several formulations of rice husk and cement mortar boards were used. An electronic device controlled all board temperature. This system presented a good efficiency design. The conventional cement mortar mixed with rice husk showed a better performance.

Indicadores de bem-estar baseados em reações comportamentais de matrizes pesadas

Knowing the importance that the poultry industry represents for the Brazilian economy, this work, searched to understand and to identify new welfare pointers inherent to the animal that contributed for the increase of the productive effectiveness, studying different behavior reactions in broiler breeders, in climatic chamber. The experiment was delineated as a Latin Square 3x3x3, where the variable: temperature of air, birds ration and birds age had been controlled. The birds of different ages had been lodged in distinct boxes. Observations of the behavior of the birds in two schedules of the day had been made, being one in the morning and the other one in the afternoon, during a period of 15 minutes each through video cameras, installed in the ceiling of the climatic chamber, having no interference of human being in the register of the data. It was verified the influence of the controlled variables in diverse observed behaviors where it was concluded that the presence of food resulted in bigger occurrences of aggressiveness reactions.

Identificação eletrônica para avaliação do comportamento dos suínos na fase de gestação

The efficiency of swine production performance depends on the herd administration, such as good nutrition, sanitary control, facilities and appropriate environmental conditions. The concept of this production model is directly related with the reduction of selective losses and the process control. Each production segment is controlled to reach the optimization in the system totality, it is necessary to apply animals handling concepts, environmental control implementation, diseases control, nutrition control, information concerning in guaranteeing the animal welfare and individual identification. The present work presents as objective the development of the mathematical model to evaluate interactions among the internal atmosphere of the installation and the thermal animals preference, in the expectation of detecting a relationship among the frequency access to the drinking fountain and the atmosphere conditions - temperature, black globe temperature and relative humidity, using as tool the electronic identification. The results obtained by the mathematical model, allowed to conclude accurately the evaluation of the swine thermal preference correlating with the climatic variables in the pregnancy stage.

Simulação da varredura da superfície por um cortador de base segmentado

Base cutting and feeding into harvesters of plants lying close to the ground surface require an efficient sweeping action of the cutting mechanism. It is not the case of conventional sugarcane harvesters which have rigid blades mounted on discs capable to contaminate the cane with dirt as well as damage the ratoons. The objective of this work was to simulate the sweeping performance of a segmented base cutter. The model was developed using the laws of dynamic. Simulation included two rotational speeds (400 and 600 rpm), two cutting heights (0.12 and 0.13 m) and two disk tilting angles (-10º and -12º). The simulated sweeping angle varied between 56º and 193º, which are very promising as a mean to cutting and feeding cane sticks lying on the ground. Cutting height was the variable that affected sweeping action the most. This behavior indicates the need to have an automatic control of the cutting disk height in order to keep good sweeping performance as the harvester moves forward.

Determinação da difusividade efetiva de raiz de chicória

Inulin is a fructooligosacharide found in diverse agricultural products, amongst them garlic, banana, Jerusalem artichoke and chicory root. Inulin generally is used in developed countries, as a substitute of sugar and/or fat due to its characteristics of fitting as functional and dietary food. Chicory root is usually used as source and raw material for commercial extration of inulin. The experiments consisted on drying sliced chicory roots based on a factorial experimental design in a convective dryer whose alows the air to pass perpendicularly through the tray. Effective diffusivity (dependent variable) has been determined for each experimental combination of independent variables (air temperature and velocity). The data curves have been fitted by the solution of the second Fick law and Page's model. Effective difusivity varied from 3.51 x 10-10 m² s-1 to 1.036 x 10-10 m² s-1. It is concluded that, for the range of studied values, air temperature is the only statistically significant variable. So, a first order mathematical model was obtained, representing effective diffusivity behavior as function of air temperature. The best drying condition was correspondent to the trial using the highest drying air temperature.

Calibração da Reflectometria no Domínio do Tempo (TDR) para a estimativa da concentração da solução no solo

Time Domain Reflectometry (TDR) is a reliable method for in-situ measurements of the humidity and the solution concentration at the same soil volume. Accurate interpretation of electrical conductivity (and soil humidity) measurements may require a specific calibration curve. The primary goal of this work was to establish a calibration procedure for using TDR to estimate potassium nitrate concentrations (KNO3) in soil solution. An equation relating the electrical conductivity measured by TDR and KNO3 concentration was established enabling the use of TDR technique to estimate soil water content and nitrate concentration for efficient fertigation management.

Colheita de cana-de-açúcar com auxílio mecânico

Civil society and sugarcane farmer demands indicate that harvesting technology has enough limitations to jeopardize production in large sugar cane producing areas. This work analyses the current mechanical harvesting compared to a semi-mechanical harvesting proposal, on the bases of eleven characteristics considered determinant for a quick spreading of green cane harvesting on hilly areas, with lower impact on agricultural labor and farmers investment capacity.

Avaliação física do tomate de mesa 'Romana' durante manuseio na pós-colheita

Tomato postharvest losses are very high in Brazil and the goal of this research was to evaluate the effect of handling and the transport of tomato fruits, cultivar Romana on the steps of harvesting, weight and transportation to the packinghouse, pointing some critical points. Tomatoes were harvested at plastic boxes, weighted and shipped to a packinghouse. Fruits taken directly from the plant were determined as reference. The parameters evaluated were weight loss and mechanical injury and tomato physical quality after storage during 21 days. It was observed an increasing on the weight loss, external damage, and postharvest losses, after storage. Handling and transportation were the cause of an increase in 6.6% in external damage and 1.93% of weight loss after storage, when comparing harvested fruits and fruits evaluated on the packing-house. The main reason for postharvest losses was due to mechanical injury caused during transportation mainly due to the compressure force among fruits and against the plastic boxes.

Equipamento microprocessado para geração de sinal de correção diferencial, em tempo real, para GPS

This work presents the development of low cost microprocessor-based equipment for generation of differential GPS correction signal, in real time, and configuration and supervision of the GPS base. The developed equipment contains a dedicated microcontroller connected to the GPS receiver, alphanumeric display and multifunction keyboard for configuration and operation of the system and communication interfaces. The electronic circuit has the function of receiving the information from GPS base; interpret them, converting the sentence in the RTCM SC-104 protocol. The microcontroller software makes the conversion of the signal received by the GPS base from the specific format to RTCM SC-104 protocol. The processing main board has two serials RS-232C standard interfaces. One of them is used for configuration and receiving the information generated by the GPS base. The other operates as output, sending the differential correction signal for the transmission system. The development of microprocessor-based equipment showed that it is possible the construction of a low cost private station for real time generation of differential GPS correction signal.

Análise de aspectos socioeconômicos e tecnológicos da agropecuária na Bacia Hidrográfica do Rio Mogi Guaçu

Currently, owing to the occurrence of environmental problems, along with the need of environmental preservation, both the territory management of Hydrographic Basin and the conservation of natural resources have proven to have remarkable importance. Thus, the mean goal of the research is to raise and scrutinize social-economic and technologic data from the Mogi Guaçu River Hydrographic Basin (São Paulo, Brazil). The aim is to group municipalities with similar characteristics regarding the collected data, which may direct joint actions in the Hydrographic Basin Management. There were used both the methods of factorial analysis and automatic hierarchical classifications. Additionally, there is going to be applied a Geographical Information System to represent the outcomes of the methods aforementioned, through the evolvement of a geo-referenced database, which will allow the obtainment of information categorically distributed including theme maps of interest. The main characteristics adopted to group the municipalities were: agricultural area, sugar cane production, small farms, animal production, number of agriculture machinery and equipments and agricultural income. The methodology adopted in the Mogi Guaçu River Hydrographic Basin will be analyzed vis-à-vis its appropriateness on basin management, as well as the possibility of assisting the studies on behalf of the São Paulo Hydrographic Basin groups, to regional development.

Influência do auxílio mecânico na colheita de tomates

Fresh tomato harvest is traditionally made without harvesting aids. The main goal of this research was to evaluate performance parameters of fresh tomato harvesting aid equipment and compare it to traditional harvest, in the state of São Paulo. Therefore, an equipment was developed and the harvest process was evaluated in four different ways: traditional system (harvest system used in Santa Luzia farm, Brotas, SP, Brazil), picker walking with a harvesting aid equipment, picker seated in a harvesting aid equipment and a composition of both systems: two pickers seated and one picker walking in two different velocities ranges. The different systems using harvesting aid showed an average yield by picker more efficient than reference. Harvest system using three pickers showed an increase of 290% on yield average by picker, on the range of 0.5-1.0 fruit per plant, followed by the systems with a walking picker, that increased productivity in 41%, and picker seated harvester, that showed an increase of 35%. These results demonstrate the importance of using a harvesting aid equipment.

Avaliação de perdas invisíveis na colheita mecanizada em dois fluxos de massa de cana-de-açúcar

In this work the performance of a sugar cane chopped harvester was analysed when fed with two sugar cane mass flows, measuring the invisible losses, which are impossible to measure in the field, harvester sugar cane cleaning efficiency and air velocity on extractors exit. The trial was done under controlled conditions at Copersucar Technology Center in January 2000. The results showed that the flow of sugar cane through the harvester doesn't influence the magnitudes of total invisible losses and raw material cleaning efficiency. The mean air velocity on the primary extractors exit was 12.0 m s-1, and 9.2 m s-1 on the secondary extractor, with a coefficient of variation of 21%, indicating that the poor cleaning performance of the harvester could be related to air velocity difference inside the extractor. Analyzing the data collected in the trials, it was possible to conclude that invisible losses in sugar cane harvester were 10% and the cleaning efficiency was 87%.

Transferência de massa e secagem em leitos vibrofluidizados: uma revisão

Development of processing technology and equipments requires new methods and better quality of the processed product. In the continuous drying process, utilization of equipments that promotes an increment in the transfer coefficients becomes of the major interest. The use of vibrational energy has been recommended to the dispersed materials. Such method is based on the use of vibrational energy applied to disperse media. Thus, a literature review on the mass transfer and drying in vibro-fluidized beds was carried out, showing experimental results and mathematical modeling.

Aerodinâmica de leitos vibrofluidizados: uma revisão

Application of mechanical vibration to aid fluidization and to improve heat, mass and momentum transfer are usual processes in agricultural industry and it has found nowadays extensive applications in particle processing of materials difficult-to-fluidized. Equations and experimental data found in literature for the aerodynamics characteristics of vibro-fluidized beds are presented and discussed, emphasizing the vibration effect in the bed.