The Decrease in Summer Surface Water Temperature with Altitude in Swiss Alpine Lakes: A Comparison with Air Temperature Lapse Rates

Using miniature thermistors with integrated data loggers, the decrease in summer lake surface water temperature (LSWT) with increasing altitude a.s.l. was investigated in 10 Swiss Alpine lakes located between 613 m a.s.l. and 2339 m a.s.l. The LSWTs exhibit essentially the same short-term structure as regional air temperature, but are about 3 to 5°C higher than the air temperature at the altitude of the lake. LSWTs decrease approximately linearly with increasing altitude at a rate slightly greater than the surface air temperature lapse rate. Diel variations in LSWT are large, implying that single water temperature measurements are un- likely to be representative of the mean. Local factors will affect LSWT more than they affect air temperature, possibly resulting in severe distortion of the empirical relationship between the two. Several implications for paleoclimate reconstruction studies result. (1) Paleolimnologically reconstructed LSWTs are likely to be higher than the air temperatures prevailing at the altitude of the lake. (2) Lakes used for paleoclimate reconstruction should be selected to minimize local effects on LSWT. (3) The calibration of organism-specific quantitative paleotemperature inference models should not be based on single water temperature measurements. (4) Consideration should be given to calibrating such models directly against air temperature rather than water temperature. (5) The primary climate effect on the aquatic biota of high-altitude lakes may be mediated by the timing of the ice cover.

Der alpine Versuchsgarten bei der Bremerhütte (2390 m) im Gschnitztale

von E. Zederbauer

Die alpine Flora des Plose-Gebirges (2561 m) bei Brixen a. E. (Südtirol)

von Raimund von Klebelsberg

Die alpine Flora des Plose-Gebirges (2561 m) bei Brixen a. E. (Südtirol)

von Raimund v. Klebelsberg

Alpine Flora

Anonym

Adenostyles alpine - Ranunculus divaricatus - Blatt von Ranunculus aconitifolius

AR

Alpine permafrost index map

The objective of this study is the production of an Alpine Permafrost Index Map (APIM) covering the entire European Alps. A unified statistical model that is based on Alpine-wide permafrost observations is used for debris and bedrock surfaces across the entire Alps. The explanatory variables of the model are mean annual air temperatures, potential incoming solar radiation and precipitation. Offset terms were applied to make model predictions for topographic and geomorphic conditions that differ from the terrain features used for model fitting. These offsets are based on literature review and involve some degree of subjective choice during model building. The assessment of the APIM is challenging because limited independent test data are available for comparison and these observations represent point information in a spatially highly variable topography. The APIM provides an index that describes the spatial distribution of permafrost and comes together with an interpretation key that helps to assess map uncertainties and to relate map contents to their actual expression in terrain. The map can be used as a first resource to estimate permafrost conditions at any given location in the European Alps in a variety of contexts such as research and spatial planning. Results show that Switzerland likely is the country with the largest permafrost area in the Alps, followed by Italy, Austria, France and Germany. Slovenia and Liechtenstein may have marginal permafrost areas. In all countries the permafrost area is expected to be larger than the glacier-covered area.

Stable carbon and nitrogen isotopic ratios of cores from the Bering Sea

Stable carbon and nitrogen isotopic ratios (d13C and d15N) of organic matter were measured in three sediment cores from deep basins of the Bering Sea to investigate past changes in surface nutrient conditions. For surface water reconstructions, hemipelagic layers in the cores were distinguished from turbidite layers (on the basis of their sedimentary structures and 14C ages) and analyzed for isotopic studies. Although d13C profiles may have been affected by diagenesis, both d15N and d13C values showed common positive anomalies during the last deglaciation. We explain these anomalies as reflecting suppressed vertical mixing and low nutrient concentrations in surface waters caused by injection of meltwater from alpine glaciers around the Bering Sea.

Numerical modeling of marine radiocarbon reservoir ages during the last deglaciation

A critical problem in radiocarbon dating is the spatial and temporal variability of marine reservoir ages (MRAs). We assessed the MRA evolution during the last deglaciation by numerical modeling, applying a self-consistent iteration scheme in which an existing radiocarbon chronology (derived by Hughen et al., Quat. Sci. Rev., 25, pp. 3216-3227, 2006) was readjusted by transient, 3-D simulations of marine and atmospheric Delta14C. To estimate the uncertainties regarding the ocean ventilation during the last deglaciation, we considered various ocean overturning scenarios which are based on different climatic background states (PD: modern climate, GS: LGM climate conditions). Minimum and maximum MRAs are included in file 'MRAminmax_21-14kaBP.nc'. Three further files include MRAs according to equilibrium simulations of the preindustrial ocean (file 'C14age_preindustrial.nc'; this is an update of our results published in 2005) and of the glacial ocean (files 'C14age_spinupLGM_GS.nc' and 'C14age_spinupLGM_PD.nc').

Pollen record and age determination of sediment core Fersina 2

Pollen analysis of samples taken from the core of the water well Fersina 2 (Adige Valley, Prov. Trento, NE Italy) did not reveal any indication of an interglacial or Holocene age of the uppermost 190 m in the sediment sequence deposited in the over-deepened Adige River Valley. The sediment sequence dates entirely from late-glacial times. Four radiocarbon ages of pieces of wood indicate that about 165 m of the upper part of the profile are of Younger Dryas age. The lower part of the sequence dates from the Allerød or Bølling/Allerød and a preceding cold phase, probably the Oldest Dryas. Accordingly the deposition of the sequence took about 2500 or 3500 years and was completed long before the onset of the Neolithic. Our results are in excellent agreement with findings in other formerly glaciated alpine valleys (e.g. the Traun, Salzach and Enns valleys in the Northern Alps). The final depth of the Fersina 2 well is 190 m. It is very likely that the sediment sequence found below this level in the nearby 423 m deep Fersina 1 well was also deposited after the deglaciation of the Adige Valley at the end of the last glacial period.

A coupled model for carbon and radiocarbon evolution during the last deglaciation, link to model results

Changes in the ventilation of the Southern Ocean are thought to play an important role on deglacial carbon and radiocarbon evolution, but have not been tested within a coupled climate-carbon model. Here, we present such a simulation based on a simple scenario of transient deglacial sinking of brines - sea-ice salt rejections - around Antarctica, which modulates Southern Ocean ventilation. This experiment is able to reproduce deglacial atmospheric changes in carbon and radiocarbon but also ocean radiocarbon records measured in the Atlantic, Southern and Pacific Oceans. Simulated for the first time in a fully coupled climate-carbon model including radiocarbon, our modeling results suggest that the deglacial changes in atmospheric carbon dioxide and radiocarbon were achieved by means of a breakdown in the glacial brine-induced stratification of the Southern Ocean.