Avaliação da porosidade de microcápsulas contendo proteína bioativa por porosimetria de mercúrio e adsorção de nitrogênio

Microcapsules containing lactoferrin were produced by spray drying using dextrin:octenylsuccinate starch, as wall materials. Porosity characteristics of spray-dried microcapsules were investigated by mercury intrusion porosimetry and nitrogen adsorption. The outer and inner structures of microcapsules were studied by Scanning Electron Microscopy and sizes were determined by Laser Diffraction. Results indicate that all microcapsules presents adsorption isotherm of type II and that micropores on the microcapsules surface will be very few or none. Our results show that microstructure, surface area and size of microcapsules are affected by dextrin: octenylsuccinate starch proportion. Pore characteristics for various microcapsules are found to be different.

Ce - promoted catalyst from hydrotalcites for CO2 reforming of methane: calcination temperature effect

Ce-promoted Ni-catalysts from hydrotalcites were obtained. The effect of calcination temperature on the chemical and physical properties of the catalysts was studied. Several techniques were used to determine the chemical and physical characteristics of oxides. The apparent activation energies of reduction were determined. Catalytic experiments at 48 L g-1h-1 without pre-reduction in CO2 reforming of methane were performed. The spinel-like phase in these oxides was only formed at 1000 ºC. The reduction of Ni2+ in the oxides was clearly affected by the calcination temperature which was correlated with catalytic performance. The catalyst calcined at 700 ºC showed the greatest activity.

Determinação dos parâmetros cinéticos e termodinâmicos da adsorção de L-cisteína em ouro por meio da técnica de microbalança a cristal de quartzo

This article discusses the adsorption kinetics of a L-cysteine monolayer onto a gold surface by means of information obtained through the QCM technique. The results indicate that the adsorption process is rapid and follows the Langmuir isotherm, in which adsorption and desorption are considered. From these measurements the following parameter values were obtained: k d = (4.2 ± 0.4) x 10-3 s-1, k a = 75 ± 6 M-1 s-1, Keq=(1.8 ± 0.3) x 10(4) M-1 and ΔGads = - (5.8 ± 0.2) kcal mol-1.

Aproveitamento da glicerina proveniente da produção de biodiesel na obtenção de híbrido de caulinita para adsorção de Cr3+

The aim of this work was to contribute to the creation of new ways of treating wastewater contaminated with Cr3+, based on solid-liquid adsorption. An adsorbent material was prepared by functionalization of kaolinite with glycerin biodiesel by-product. This material was tested for adsorption performed using a batch method, and results showed that inclusion of glycerin in the structure of kaolinite led to a significant increase in the capacity of Cr3+ adsorption. This contributes to the allocation of by-product of biodiesel and to the treatment of effluents from tanneries.

Uso de materiais recicláveis na determinação gravimétrica de CO2 no ar ambiente e tratamento dos resíduos de laboratório gerados

An alternative system was tested for the determination of CO2 in air using recyclable materials. The results indicate that the proposed system allows for reliable, accurate, robust and efficient collection, comparable to the standard gravimetric method. Laboratory wastes are easily treated using a filtrate that can be discharged into the sewer and solids that can be reused. The proposed system is a simple and low-cost tool that encompasses important aspects of environmental education, which should be part of the education in chemistry of undergraduate students and technicians.

Adsorção do corante Reativo Azul 19 em solução aquosa por lama vermelha tratada quimicamente com peróxido de hidrogênio

Adsorption of Reactive Blue 19 dye onto activated red mud was investigated. Red mud was treated with hydrogen peroxide (LVQ) and heated at both 400 ºC (LVQ400) and 500 ºC (LVQ500). These samples were characterized by pH, specific surface area, point of zero charge and mineralogical composition. Adsorption was found to be significantly dependent on solution pH, with acidic conditions proving to be the most favorable. The adsorption followed pseudo-second-order kinetics. The Langmuir isotherm was the most appropriate to describe the phenomenon of dye removal using LVQ, LVQ400 and LVQ500, with maximum adsorption capacity of 384.62, 357.14 and 454.54 mg g-1, respectively.

Potencial uso de serpentinito no armazenamento mineral do CO2

Rising anthropogenic CO2 emissions are considered a major contributor to the greenhouse effect. There are several options for reducing atmospheric CO2 levels, and among these alternatives, Carbon Capture and Storage (CCS) has been identified as an effective and promising approach. This work investigated the feasibility of using serpentinite as a vehicle for carbon storage presenting a source-sink match. The main results of the work confirmed that serpentinite is appropriate for the carbonation process due to the high concentration of Mg in its composition.

Intraspecific variability of Holostylis reniformis: concentration of lignans, as determined by maceration and supercritical fluid extraction (SFE-CO2), as a function of plant provenance and plant parts

Maceration and supercritical fluid extraction were used to prepare extracts from parts of plants (Holostylis reniformis) collected in two different regions of Brazil. ¹H NMR, HPLC-DAD-ESI/MS, HPLC-DAD, GC-MS, and chemometric techniques were used to analyse lignans in the extracts and showed that yields of SFE-CO2 were less than or equal to those of hexane maceration extracts. These analyses, in conjunction with the concentrations of aliphatic hydrocarbons, fatty acids and their methyl and ethyl derivatives in the extracts, also allowed the chemical composition of parts and provenance of the plant to be differentiated.

Adsorção de alfa-lactalbumina do soro de leite em hidroxiapatita: efeito do pH e da temperatura e análise termodinâmica

The nutritional and functional benefits offered by whey protein α-lactalbumin justify the great interest in its manufacture in large quantities at a high purity level. Hydroxyapatite is a calcium phosphate material able to adsorb proteins and can be synthesized at low production cost. Therefore, this work evaluated the adsorption of α-lactalbumin on hydroxyapatite using solid-liquid phase equilibrium data reported as adsorption isotherms. Van't Hoff's thermodynamics analysis showed that the adsorption process is entropically driven.

SYNGAS PRODUCTION FROM CO2-REFORMING OF CH4 OVER SOL-GEL SYNTHESIZED Ni-Co/Al2O3-MgO-ZrO2 NANOCATALYST: EFFECT OF ZrO2 PRECURSOR ON CATALYST PROPERTIES AND PERFORMANCE

Ni-Co/Al2O3-MgO-ZrO2 nanocatalyst with utilization of two different zirconia precursors, namely, zirconyl nitrate hydrate (ZNH) and zirconyl nitrate solution (ZNS), was synthesized via the sol-gel method. The physiochemical properties of nanocatalysts were characterized by XRD, FESEM, EDX, BET and FTIR analyses and employed for syngas production from CO2-reforming of CH4. XRD patterns, exhibiting proper crystalline structure and homogeneous dispersion of active phase for the nanocatalyst ZNS precursor employed (NCAMZ-ZNS). FESEM and BET results of NCAMZ-ZNS presented more uniform morphology and smaller particle size and consequently higher surface areas. In addition, average particle size of NCAMZ-ZNS was 15.7 nm, which is close to the critical size for Ni-Co catalysts to avoid carbon formation. Moreover, FESEM analysis indicated both prepared samples were nanoscale. EDX analysis confirmed the existence of various elements used and also supported the statements made in the XRD and FESEM analyses regarding dispersion. Based on the excellent physiochemical properties, NCAMZ-ZNS exhibited the best reactant conversion across all of the evaluated temperatures, e.g. CH4 and CO2 conversions were 97.2 and 99% at 850 ºC, respectively. Furthermore, NCAMZ-ZNS demonstrated a stable yield with H2/CO close to unit value during the 1440 min stability test.

TRATAMENTO DA VINHAÇA POR ADSORÇÃO EM CARVÃO DE BAGAÇO DE CANA-DE-AÇÚCAR

The aim of this study was to develop an effective and economically viable technology for the treatment of vinasse, prior to its disposal in the soil for fertirrigation, aiming this way at reducing the environmental impacts generated by inadequately discarding this effluent. The primary treatment of vinasse by adsorption was evaluated. Adsorbents were prepared from sugar cane bagasse and their efficiency evaluated in relation to the treatment of vinasse. The process of preparation of activated carbon consisted of carbonizing bagasse at different temperatures followed by chemical activation with NaOH. The carbon samples obtained by solely carbonizing sugar cane bagasse were more efficient for removing turbidity of vinasse than samples activated with NaOH. The sample carbonized at 800 °C was the most efficient for removing turbidity of wastewater (83%). During a process of adsorption of vinasse in two stages, it was possible to obtain color removal, turbidity and COD of approximately 76, 85 and 69%, respectively. After the adsorption step of vinasse, the solid waste generated in the second stage of adsorption can be burned in the boilers of the power plant itself, affording an energy of 4606 cal g-1.

Thermal behaviour studies of solid state compounds of cinnamylidenepyruvate with trivalent lanthanides and yttrium (III) in an atmosphere of CO2

Solid state cinnamylidenepyruvate of trivalent lanthanides (except for promethium) and yttrium, were prepared. Thermogravimetry, derivative thermogravimetry (TG, DTG), differential scanning calorimetry (DSC), X-ray diffraction powder patterns and complexometry were used to characterize and to study the thermal behavior of these compounds in a dynamic CO2 atmosphere. The results obtained showed significative differences on the thermal stability and thermal decomposition of these compounds, with regard to the thermal behavior study in a dynamic air atmosphere.

Hidrogeneoftalato de potássio como molécula modelo para estudos de adsorção sobre TiO2

Este trabalho teve por objetivo utilizar o hidrogenoftalato de potássio como molécula modelo para estudos de adsorção em TiO2. Os resultados de adsorção do hidrogeneoftalato sobre TiO2 se ajustaram aos modelos de adsorção propostos por Langmuir e Freundlich, sendo que o modelo de Freundlich descreveu melhor o fenômeno. A adsorção foi função da temperatura e a capacidade de adsorção aumentou de 2,4 para 4,5 mg.g-1 quando se elevou a temperatura de 20 para 30ºC.

Estudo da adsorção/dessorção de 2,4-D em solos usando técnica cromatográfica

Este trabalho estudou a adsorção e a desorção do herbicida ácido 2,4-Diclorofenoxiacético (2,4-D) em solo da região de Urbano Santos - MA. A região possui campos de cultivo de eucaliptos para obtenção de celulose. Para a limpeza dos campos, antes da plantação e nos primeiros 12 meses de plantio, são aplicados herbicidas, dentre os quais destacamos o 2,4-D. A isoterma de Freundlich foi utilizado como modelo para este estudo e a concentração de 2,4-D foi determinada por cromatografia líquida de alta eficiência (CLAE), acompanhada de ensaios de recuperação para garantir a confiabilidade dos dados obtidos na investigação de adsorção/dessorção. Os resultados indicaram que o 2,4-D apresenta maior adsorção à matéria orgânica do solo estudado, quando comparado a outros tipos de solo, o que pode resultar em pequena diminuição em sua tendência de lixiviação e de degradação microbiológica. Entretanto, este herbicida apresenta elevado potencial de lixiviação quando comparado a outros pesticidas.

Remoção de compostos tóxicos de solução aquosa por adsorção com zeólita sintetizada a partir de cinzas de carvão

A capacidade das zeólitas sintetizadas a partir da cinza de carvão brasileiro na remoção dos íons de Cd, Zn e do azul de metileno de soluções aquosas foi investigada. O material zeolítico preparado com a cinza de carvão do filtro manga apresentou a eficiência de remoção mais alta para os poluentes. A seletividade aos íons metálicos deste produto foi determinada como: Cd2+ > Zn2+. As capacidades máximas de adsorção encontradas foram 36,1 mg g-1 para o Zn2+, 76,3 mg g-1 para o Cd2+e 3,93 mg g-1 para o corante.