992 resultados para 12930-075


Relevância:

10.00% 10.00%

Publicador:

Resumo:

The effects of breed and of recombinant bovine somatotropin (rbST) treatment on growth hormone gene expression were studied in young bulls. The experiment was completely randomized in a [2 × 2]-factorial arrangement, using two levels of rbst (0 or 250 mg/animal/14 days), and two breed groups (Nelore and Simmental x Nelore crossbred). A CDNA encoding Bos indicus growth hormone was cloned and sequenced for use as a probe in Northern and dot blot analyses. Compared to the Bos taurus structural gene, the Bos indicus CDNA was found to begin 21 bases downstream from the transcription initiation site and had only two discrepancies (C to T at position 144-His and T to C at position 354-Phe), without changes in the polypeptide sequence. However, two amino acid substitutions were found for Bubalus spp., which belong to the same tribe. The rbst treatment did not change any of the characteristics evaluated (body and pituitary gland weights, growth hormone MRNA expression level). Crossbred animals had significantly higher body weight and heavier pituitaries than Nelore cattle. Pituitary weight was proportional to body weight in both breed groups. Growth hormone MRNA expression in the pituitary was similar (P>0.075) for both breed and hormonal treatment groups, but was 31.9% higher in the pure Nelore group, suggesting that growth hormone gene transcription regulation differs among these breeds.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

In this work we introduce a mapping between the so-called deformed hyperbolic potentials, which are presenting a continuous interest in the last few years, and the corresponding nondeformed ones. As a consequence, we conclude that these deformed potentials do not pertain to a new class of exactly solvable potentials, but to the same one of the corresponding nondeformed ones. Notwithstanding, we can reinterpret this type of deformation as a kind of symmetry of the nondeformed potentials. © 2005 Elsevier B.V. All rights reserved.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

We construct an infinite number of exact time dependent soliton solutions, carrying non-trivial Hopf topological charges, in a 3+1 dimensional Lorentz invariant theory with target space S2. The construction is based on an ansatz which explores the invariance of the model under the conformal group SO(4,2) and the infinite dimensional group of area preserving diffeomorphisms of S2. The model is a rare example of an integrable theory in four dimensions, and the solitons may play a role in the low energy limit of gauge theories. © SISSA 2006.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The massless 4-point one-loop amplitude computation in the pure spinor formalism is shown to agree with the computation in the RNS formalism. © SISSA 2006.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Piptadenia moniliformis Benth. is a tree species which is important for beekeeping, as well as being recommended for soil restoration, reforestation, wood production for small civil construction projects, and cattle and sheep forage. Information on how to evaluate seed physiological quality is still scarce and in this was the study aimed to adapt the procedures of the tetrazolium test to assess the viability of P. moniliformis seeds. Four seed lots were scarified in sulphuric acid for 30 min, and soaked between paper towels at 25 °C for 24 hours. The seed coat was then removed and the naked seeds immersed in tetrazolium solutions with concentrations of 0.05, 0.075 and 0.1% for 2, 3, and 4 hours at 35 oC in the dark. Each treatment consisted of four replications of 25 seeds. The embryos were classified according to viability based on the staining patterns. The previous soaking of the seeds for 24 hours at 25 oC between paper towels, followed by the removal of the seed coat and staining of the naked seeds for 4 hours in a 0.075% tetrazolium solution at 35 oC was the most efficient method for evaluating the viability of P. moniliformis Benth seeds.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

We developed and optimized a simple, efficient and inexpensive method for in vitro culture of peripheral blood lymphocytes from the Brazilian tortoise Chelonoidis carbonaria (Testudinidae), testing various parameters, including culture medium, mitogen concentration, mitotic index, culture volume, incubation time, and mitotic arrest. Peripheral blood samples were obtained from the costal vein of four couples. The conditions that gave a good mitotic index were lymphocytes cultured at 37°C in minimum essential medium (7.5 mL), with phytohemagglutinin as a mitogen (0.375 mL), plus streptomycin/penicillin (0.1 mL), and an incubation period of 72 h. Mitotic arrest was induced by 2-h exposure to colchicine (0.1 mL), 70 h after establishing the culture. After mitotic arrest, the cells were hypotonized with 0.075 M KCl for 2 h and fixed with methanol/acetic acid (3:1). The non-banded mitotic chromosomes were visualized by Giemsa staining. The diploid chromosome number of C. carbonaria was found to be 52 in females and males, and sex chromosomes were not observed. We were able to culture peripheral blood lymphocytes of a Brazilian tortoise in vitro, for the preparation of mitotic chromosomes.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

This research aimed to standardize the tetrazolium test for evaluation of viability of Copaifera langsdorffii Desf. and Schizolobium parahyba Vell. Blake seeds. It evaluated the following methodologies: seeds scarificated mechanically and soaked up by 24 and 48 hours, with posterior seed coat removal and immersed in tetrazolium solution at 0.075; 0.10 and 0.20% for 2, 3 and 4 hours, 35 °C, the dark one. The evaluated methodologies that had been efficient in the attainment of satisfactory coloration, allowing the differentiation of tissues, and in the evaluation of the physiological quality of the seeds when compared with the germination test, had been: for the species Copaifera langsdorffii, seeds scarificated and soaked up by 24 hours, 35 °C, with posterior seed coat removal, submitted to the tetrazolium solution 0.20% for 4 hours, 35 °C, in the dark one, and for the species guapuruvu, seeds scarificated and soaked up by 48 hours, 35 °C, with posterior seed coat removal, submitted to the tetrazolium solution 0.10% for 4 hours, 35 °C, in the dark one.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

We measure the Λb0 lifetime in the fully reconstructed decay Λb0→J/ψΛ0 using 10.4fb -1 of pp̄ collisions collected with the D0 detector at √s=1.96TeV. The lifetime of the topologically similar decay channel B0→J/ψKS0 is also measured. We obtain τ(Λb0)=1.303±0.075(stat)±0.035(syst)ps and τ(B0)=1.508±0.025(stat)±0.043(syst)ps. Using these measurements, we determine the lifetime ratio of τ(Λb0)/τ(B0)=0. 864±0.052(stat)±0.033(syst). © 2012 American Physical Society.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

A new palladium chelate compound is described for the determination of sulfide in aqueous samples. The reagent, bis(2-aminobenzoate)palladium(II) (PdA 2), was prepared by reaction of tetrachloropalladate (PdCl 4 -) with 2-aminobenzoic acid. The compound was characterized by infrared spectroscopy and CHN elemental analysis. The measurement was based on the selective reaction of PdA 2 with sulfide in an aqueous medium, which quantitatively produced fluorescent 2-aminobenzoate (λ ex=245nm, λ em=410nm). The analytical response was linear in the range 0.10-20.0μmol (S 2-) L -1 (r>0.99), with a limit of detection of 0.075μmolL -1 and repeatability (RSD) of 3.4%. There was no interference from CO 3 2-, NO 3 -, Cl -, SO 4 2-, Br -, NO 2 -, K +, NH 4 +, Na +, citrate or S 2O 8 2-. The fluorescence intensity decreased in the presence of H 3CCOO -, PO 4 3- and SCN -, while OH - caused a positive interference. The new fluorescent compound was successfully applied for the determination of sulfide in synthetic wastewater and natural water sample. The advantages of the proposed palladium chelate are absence of toxic by-products, simple synthesis procedure of reagent and yield reaction of about 85%, easy handling and fast acquirement of analytical signal. © 2012 Elsevier B.V.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Purpose: The purpose of this research was to analyze and measure, under optical microscopy, the hybrid layer thickness and resin tags length, as well as the microtensile bond strength of two conventional adhesive systems when applied to dry and moist dentinal substrate. Methods: Thirty-two extracted human molars were randomly distributed into four groups according to the adhesive systems (XP Bond and Prime&Bond 2.1) and moisture condition (dry and moist). In Groups I and II, XP adhesive system was applied on dry and moist dentin, respectively; while Groups III and IV received PB adhesive system, in the same way as was done in Groups I and II, respectively. After adhesive and restorative procedures, all specimens were sectioned along their long axes; one hemi-tooth sample was subjected to the microtensile bond strength test while the other was decalcified and serially sectioned into six micron thick slices and sequentially mounted on glass slides. These sections were stained by the Brown and Brenn method for posterior analysis and measurement of the hybrid layer and resin tags under a light microscope with a micrometric ocular 40/075. Results: Data were analyzed using two-way ANOVA and Tukey's test (α=0.05). For the variable hybrid layer thickness, XP showed no significant differences between dry and moist dentin (5.2 μm and 5.5 μm, respectively), but for PB, hybrid layer was significantly thicker for moist (4.0 μm) than for dry dentin (3.0 μm). For the variable resin tags length XP showed 17.9 μm length for dry dentin and 20.8 μm for moist dentin; PB 11.7 μm for dry and 12.69 μm for moist dentin;there was no significant differences between them, independent of the moisture condition. For the variable microtensile bond strength, XP showed 38.0 MPa for dry dentin and 44.5 MPa for moist dentin; and PB showed 22.7 MPa for dry dentin and 20.8 MPa for dry dentin no significant difference was observed between moist and dry dentin for XP (p=0.2) and PB (p=0.7), but XP was presented significantly higher bond strength values than PB in both moisture conditions (p=0.003 for dry and p=0.002 for moist). Conclusion: The two-step butanol-based etch-and-rinse adhesive XP Bond presented a superior behavior with regard to the hybrid layer thickness, length of resin tags and bond strength to dry and moist dentin substrates when compared with two-step acetone-based adhesive system Prime&Bond2.1. © 2013 Elsevier Ltd.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Synovial fluid (SF) is capable of reflecting infectious, immunological, or inflammatory joint conditions in horses by altering its composition and appearance. Although plasma and SF compositions are quantitatively different, this latter compartment reflects changes in plasma macromolecules. Therefore, changes in serum immunoglobulin protein concentrations tend also to alter intracapsular levels. Therefore, it is necessary to know the physiological concentrations of proteins present in SF. The aim of this study was to determine the levels of total protein, albumin, transferrin, haptoglobin, α1-acid glycoprotein, ceruloplasmin, and immunoglobulins A and G in SF of six healthy horses. The synovial proteinogram was obtained by sodium dodecyl sulfate polyacrylamide gel electrophoresis. The SF proteins reached a maximum of 25% of serum concentrations, varying inversely with molecular weight of the protein, except for the ceruloplasmin. © 2013 Elsevier Inc.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Incluye Bibliografía

Relevância:

10.00% 10.00%

Publicador:

Resumo:

A water-soluble polysaccharide was extracted with alkali from the cell wall of Verticillium lecanii (also called Lecanicillium lecanii). After freezing and thawing, the water-soluble fraction was purified by gel filtration chromatography on Sepharose CL-6B and eluted as one peak by HPSEC/RID. Monosaccharide analysis showed galactose and glucose (1.1:1), with traces of mannose (<1%). The structural characteristics were determined by spectroscopic analysis, FT-IR and 1D and 2D 1H and 13C NMR, and methylation results. On the basis of the data obtained, the following structure of the polysaccharide (E3SIV fraction) was established: where n ≈ 22 and m ≈ 22. © 2013 Elsevier Ltd. All rights reserved.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)