Concrete Pavement Mixture Design and Analysis (MDA): Evaluation of Foam Drainage Test to Measure Air Void Stability in Concrete

The stability of air bubbles in fresh concrete can have a profound influence of the potential durability of the system, because excessive losses during placement and consolidation can compromise the ability of the mixture to resist freezing and thawing. The stability of air void systems developed by some air entraining admixtures (AEAs) could be affected by the presence of some polycarboxylate-based water reducing admixtures (WRAs). The foam drainage test provides a means of measuring the potential stability of air bubbles in a paste. A barrier to acceptance of the test was that there was little investigation of the correlation with field performance. The work reported here was a limited exercise seeking to observe the stability of a range of currently available AEA/WRA combinations in the foam drainage test; then, to take the best and the worst and observe their stabilities on concrete mixtures in the lab. Based on the data collected, the foam drainage test appears to identify stable combinations of AEA and WRA.

Pattern-based sensing of nucleotides in aqueous solution with a multicomponent indicator displacement assay

A multicomponent indicator displacement assay ( MIDA) based on an organometallic receptor and three dyes can be used for the identification and quantification of nucleotides in aqueous solution at neutral pH.

The release of antidiuretic hormone is appropriate in response to hypovolemia and/or sodium administration in children with severe head injury: a trial of lactated Ringer's solution versus hypertonic saline.

We conducted an open, randomized, and prospective study to determine the effect of hypertonic saline on the secretion of antidiuretic hormone (ADH) and aldosterone in children with severe head injury (Glasgow coma scale <8). Thirty-one consecutive patients at a level III pediatric intensive care unit at a children's hospital received either lactated Ringer's solution (Ringer's group, n = 16) or hypertonic saline (Hypertonic Saline group, n = 15) over a 3-day period. Serum ADH levels were significantly larger in the Hypertonic Saline group as compared with the Ringer's group (P = 0.001; analysis of variance) and were correlated to sodium intake (Ringer's group: r = 0.39, R(2) = 0.15, P = 0.02; Hypertonic Saline group: r = 0.42, R(2) = 0.18, P = 0.02) and volume of fluids given IV (Ringer's group: r = 0.38, R(2) = 0.15, P = 0.02; Hypertonic Saline group: r = 0.32, R(2) = 0.1, P = not significant). Correlation of ADH to plasma osmolality was significant if plasma osmolality was >280 mOsm/kg (r = 0.5, R(2) = 0.25, P = 0.06), indicating an osmotic threshold for ADH release. Serum aldosterone levels were larger on the first day than during Days 2 and 3 in both groups and inversely correlated to serum sodium levels only in the Ringer's group (r = -0.55, R(2) = 0.3, P < 0.001). This group received a significantly larger fluid volume on Day 1 (P = 0.05, Mann-Whitney U-test) than did patients in the Hypertonic Saline group, indicating hypovolemia during the first day. Head-injured children have appropriate levels of ADH. They may be hypovolemic during the first day of treatment, especially if they receive lactated Ringer's solution. IMPLICATIONS: In head-injured patients, we recommend fluid restriction to avoid inappropriate secretion of antidiuretic hormone. In a prospective, randomized, and controlled study in 31 children, we were able to show that the antidiuretic hormone levels are appropriate in response to hypovolemia, sodium load, or both.

Exotic terrains in the Alps - A solution for a single Jurassic ocean

The Brianconnais area is explained as a large scale exotic terrain separating from Europe during the opening of the Valais ocean. It's displacement history during the Alpine evolution allows to replace older concepts of multiple oceans separating narrow strips of continental crust.

Laboratory Performance Evaluation of CIR-Emulsion and its Comparison Against CIR-Foam Test Results from Phase 2, TR-474, 2009

Currently, no standard mix design procedure is available for CIR-emulsion in Iowa. The CIR-foam mix design process developed during the previous phase is applied for CIR-emulsion mixtures with varying emulsified asphalt contents. Dynamic modulus test, dynamic creep test, static creep test and raveling test were conducted to evaluate the short- and long-term performance of CIR-emulsion mixtures at various testing temperatures and loading conditions. A potential benefit of this research is a better understanding of CIR-emulsion material properties in comparison with those of CIR-foam material that would allow for the selection of the most appropriate CIR technology and the type and amount of the optimum stabilization material. Dynamic modulus, flow number and flow time of CIR-emulsion mixtures using CSS- 1h were generally higher than those of HFMS-2p. Flow number and flow time of CIR-emulsion using RAP materials from Story County was higher than those from Clayton County. Flow number and flow time of CIR-emulsion with 0.5% emulsified asphalt was higher than CIR-emulsion with 1.0% or 1.5%. Raveling loss of CIR-emulsion with 1.5% emulsified was significantly less than those with 0.5% and 1.0%. Test results in terms of dynamic modulus, flow number, flow time and raveling loss of CIR-foam mixtures are generally better than those of CIR-emulsion mixtures. Given the limited RAP sources used for this study, it is recommended that the CIR-emulsion mix design procedure should be validated against several RAP sources and emulsion types.

Manual of Laboratory Mix Design Procedure for Cold In-Place Recycling using Foamed Asphalt (CIR-foam), TR-474, 2007

The objective is to determine the optimum percentage of water needed to produce the best foam properties for a given asphalt binder. The optimum water content is determined by achieving the maximum expansion ratio and half-life of the foamed asphalt. Expansion ratio is defined as the maximum volume over its original volume and half-life is defined as the time in seconds for foam to become a half of its maximum volume.

Cadmium-free quantum dots in aqueous solution: potential for fingermark detection, synthesis and an application to the detection of fingermarks in blood on non-porous surfaces

The use of quantum dots (QDs) in the area of fingermark detection is currently receiving a lot of attention in the forensic literature. Most of the research efforts have been devoted to cadmium telluride (CdTe) quantum dots often applied as powders to the surfaces of interests. Both the use of cadmium and the nano size of these particles raise important issues in terms of health and safety. This paper proposes to replace CdTe QDs by zinc sulphide QDs doped with copper (ZnS:Cu) to address these issues. Zinc sulphide-copper doped QDs were successfully synthesized, characterized in terms of size and optical properties and optimized to be applied for the detection of impressions left in blood, where CdTe QDs proved to be efficient. Effectiveness of detection was assessed in comparison with CdTe QDs and Acid Yellow 7 (AY7, an effective blood reagent), using two series of depletive blood fingermarks from four donors prepared on four non-porous substrates, i.e. glass, transparent polypropylene, black polyethylene and aluminium foil. The marks were cut in half and processed separately with both reagents, leading to two comparison series (ZnS:Cu vs. CdTe, and ZnS:Cu vs. AY7). ZnS:Cu proved to be better than AY7 and at least as efficient as CdTe on most substrates. Consequently, copper-doped ZnS QDs constitute a valid substitute for cadmium-based QDs to detect blood marks on non-porous substrates and offer a safer alternative for routine use.

Spatial visualization of DNA in solution.

An image analysis method is presented which allows for the reconstruction of the three-dimensional path of filamentous objects from two of their projections. Starting with stereo pairs, this method is used to trace the trajectory of DNA molecules embedded in vitreous ice and leads to a faithful representation of their three-dimensional shape in solution. This computer-aided reconstruction is superior to the subjective three-dimensional impression generated by observation of stereo pairs of micrographs because it enables one to look at the reconstructed molecules from any chosen direction and distance and allows quantitative analysis such as determination of distances, curvature, persistence length, and writhe of DNA molecules in solution.

Développement d'une solution orale pédiatrique de captopril

Introduction: Le captopril, inhibiteur de l'enzyme de conversion de l'angiotensine, est largement utilisé dans le traitement de l'hypertension artérielle et de l'insuffisance cardiaque chez l'adulte et l'enfant . De par son instabilité en milieu aqueux (oxydation en captopril disulfure), il n'est actuellement commercialisé que sous forme de comprimés. La prescription fréquente de doses faibles et variables en pédiatrie justifiait le développement d'une forme orale liquide, tant sur le plan pratique et économique, que sur celui de la sécurité d'administration. Cependant toutes les formulations orales liquides publiées présentent une stabilité courte, ne dépassant guère 1 mois. Objectif: Développer une forme orale liquide de captopril d'une stabilité d'au moins 6 mois. Méthode: Sur la base des données de la littérature, élaboration de 8 formulations liquides différentes de captopril 1 mg/ml (concentration permettant le prélèvement d'un volume adéquat pour une administration en pédiatrie). Mise au point d'une « stability indicating method » par HPLC par des tests de dégradation accélérée à la chaleur (100°C), en milieu acide, basique, en présence d'un agent oxydant et de la lumière. Sélection de la formulation la plus stable durant le premier mois. Etude de stabilité sur 2 ans de 3 lots (3 échantillons/lot) dans leur conditionnement final à température ambiante (TA), au frigo et à 40° ± 2°C. Contrôle microbiologique au début et à la fin de l'étude selon la méthode de la Ph. Eur. (Ed. 3). Résultats: La formule retenue est une solution aqueuse de captopril 1 mg/ml additionnée d'EDTA 1 mg/ml comme stabilisateur et conditionnée dans des flacons VERAL en verre brun de 60 ml. Après dégradation dans les conditions définies ci-dessus, le pic du captopril est nettement séparé sur les chromatogrammes de ceux des produits de dégradation. Après 2 ans, la concentration mesurée est de 104.6% (±0.32%) au frigo, 103.6% (±0.86%) à TA et 96.5 % (±0.02%) à 40°C. Aucune croissance n'a été observée sur la durée de l'étude. Discussion et conclusion: La solution de captopril 1 mg/ml mise au point est simple à préparer. En partant du principe actif pur et en présence d'EDTA comme complexant, les traces de métaux éventuellement présents n'induisent pas l'oxydation du captopril et par conséquent le recours à d'autres stabilisateurs n'est pas nécessaire. La méthode HPLC développée est une « stability indicating method ». Les résultats de l'étude ont montré que cette solution a une durée de validité de 2 ans au frigo et à TA. Compte tenu du fait que la préparation ne contient pas d'agent antimicrobien, une conservation au frigo (2 - 8°C) est toutefois recommandée. La formule proposée présente un réel avantage en pédiatrie tant sur le plan de la sécurité d'administration que sur celui de l'économie.

A Widely Used Machine Translation Service and its Migration to a Free/Open-Source Solution : the Case of Softcatalà

Softcatalà is a non-profit associationcreated more than 10 years ago to fightthe marginalisation of the Catalan languagein information and communicationtechnologies. It has led the localisationof many applications and thecreation of a website which allows itsusers to translate texts between Spanishand Catalan using an external closed-sourcetranslation engine. Recently,the closed-source translation back-endhas been replaced by a free/open-sourcesolution completely managed by Softcatalà: the Apertium machine translationplatform and the ScaleMT web serviceframework. Thanks to the opennessof the new solution, it is possibleto take advantage of the huge amount ofusers of the Softcatalà translation serviceto improve it, using a series ofmethods presented in this paper. In addition,a study of the translations requestedby the users has been carriedout, and it shows that the translationback-end change has not affected theusage patterns.