Digestibility of feeds containing sorghum, with and without tannin, for broiler chickens submitted to three room temperatures

The traditional method of total excreta collection was applied, using 30 to 40 day old male Ross 308 broiler chickens. One hundred and eight broiler chickens were used, randomly assigned to a 3x3 factorial experimental design. The room temperatures were 14 C (cold), 25 °C (thermoneutral) and 32 °C (hot) and the three diets were 100% maize, 100% sorghum with tannin and 100% sorghum without tannin, with four replicates of each. The digestibility coefficients for the dry matter, crude protein, crude fibre, neutral detergent fibre, acid detergent fibre, ether extract, mineral matter and nitrogen-free extract were determined. It was observed that all the digestibility coefficients were higher in the hot chamber and lower in the cold chamber, and that these values tended to be higher for maize.

Lipid Peroxidation Is Associated with the Severity of Periodontal Disease and Local Inflammatory Markers in Patients with Type 2 Diabetes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Customized fiber glass posts. Fatigue and fracture resistance

Purpose: To evaluate the root fracture strength of human single-rooted premolars restored with customized fiberglass post-core systems after fatigue simulation. Methods: 40 human premolars had their crowns cut and the root length was standardized to 13 mm. The teeth were endodontically treated and embedded in acrylic resin. The specimens were distributed into four groups (n=10) according to the restorative material used: prefabricated fiber post (PFP), PFP+accessory fiber posts (PFPa), PFP+unidirectional fiberglass (PFPf), and unidirectional fiberglass customized post (CP). All posts were luted using resin cement and the cores were built up with a resin composite. The samples were stored for 24 hours at 37 degrees C and 100% relative humidity and then submitted to mechanical cycling. The specimens were then compressive-loaded in a universal testing machine at a crosshead speed of 0.5 mm/minute until fracture. The failure patterns were analyzed and classified. Data was submitted to one-way ANOVA and Tukey's test (alpha= 0.05). Results: The mean values of maximum load (N) were: PFP - 811.4 +/- 124.3; PFPa - 729.2 +/- 157.2; PFPf - 747.5 +/- 204.7; CP - 762.4 +/- 110. Statistical differences were not observed among the groups. All groups showed favorable restorable failures. Fiberglass customized post did not show improved fracture resistance or differences in failure patterns when compared to prefabricated glass fiber posts. (Am J Dent 2012;25:35-38).

Ecological modeling and pest population management: a possible and necessary connection in a changing world

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mucosa-associated but not luminal Escherichia coli is augmented in Crohn's disease and ulcerative colitis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Psychopathological features in patients with Parkinson's disease and related caregivers' burden

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Esterase enzymes involved in pyrethroid and organophosphate resistance in a Brazilian population of Riphicephallus (Boophilus) microplus (Acari, Ixodidae)

Esterases are a group of enzymes that are reportedly associated with acaricide resistance in Riphicephallus (Boophilus) microplus. A comparative analysis was made of the esterase patterns in malathion and deltamethrin-sensitive, tolerant and resistant tick groups, using non-denaturing polyacrylamide gel electrophoresis. Electrophoretical profiles revealed four bands of esterase activity against alpha-naphthyl acetate; which were dubbed EST-1 to EST-4. The EST-3 and EST-4 were detected in all strains and were classified as carboxylesterases (CaEs). The EST-2, classified as an acetylcholinesterase (AChE), was detected in all groups, but its staining intensity increased from susceptible to resistant groups, indicating an altered production according to the degree of resistance. EST-1, which was also classified as an AChE, was detected exclusively in tolerant and resistant groups to both acaricides, but displayed greater activity in the malathion-resistant group. These data suggest that these AChEs may represent an important detoxification strategy developed to overcome the effects of acaricides. (C) 2008 Elsevier B.V. All rights reserved.

Prevalence and antifungal resistance profile of Candida spp. oral isolates from patients with type 1 and 2 diabetes mellitus

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Finite element analysis and fracture resistance testing of a new intraradicular post

Objectives: The objective of the present study was to evaluate a prefabricated intraradicular threaded pure titanium post, designed and developed at the Sao Jose dos Campos School of Dentistry - UNESP, Brazil. This new post was designed to minimize stresses observed with prefabricated post systems and to improve cost-benefits. Materials and and methods: Fracture resistance testing of the post/core/root complex, fracture analysis by microscopy and stress analysis by the finite element method were used for post evaluation. The following four prefabricated metal post systems were analyzed: group 1, experimental post; group 2, modification of the experimental post; group 3, Flexi Post, and group 4, Para Post. For the analysis of fracture resistance, 40 bovine teeth were randomly assigned to the four groups (n=10) and used for the fabrication of test specimens simulating the situation in the mouth. The test specimens were subjected to compressive strength testing until fracture in an EMIC universal testing machine. After fracture of the test specimens, their roots were sectioned and analyzed by microscopy. For the finite element method, specimens of the fracture resistance test were simulated by computer modeling to determine the stress distribution pattern in the post systems studied. Results: The fracture test presented the following averages and standard deviation: G1 (45.63 +/- 8.77), G2 (49.98 +/- 7.08), G3 (43.84 +/- 5.52), G4 (47.61 +/- 7.23). Stress was homogenously distributed along the body of the intraradicular post in group 1, whereas high stress concentrations in certain regions were observed in the other groups. These stress concentrations in the body of the post induced the same stress concentration in root dentin. Conclusions: The experimental post (original and modified versions) presented similar fracture resistance and better results in the stress analysis when compared with the commercial post systems tested (08/2008PA/CEP).

Electrochemical stability and corrosion resistance of Ti-Mo alloys for biomedical applications

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of HVOF parameters on the corrosion and wear resistance of WC-Co coatings sprayed on AA7050 T7

Thermal spray WC-based coatings are widely used in the aircraft industry mainly for their resistance to wear, reworking and rebuilding operations and repair of worn components on landing gear, hydraulic cylinders, actuators, propeller hub assemblies, gas turbine engines, and so on. The aircraft industry is also trying to use thermal spray technology to replace electroplating coatings such as hard chromium. In the present work, WC-Co coatings were built up on an AA 7050 aluminum alloy using high velocity oxygen fuel (HVOF) technology and a liquid nitrogen cooling prototype system. The influence of the spray parameters (standard conditions, W19S, increasing the oxygen flux, W19H, and also increasing the carrier gas flux, W19F) on corrosion, friction, and abrasive wear resistance were also studied. The coatings were characterized using optical (OM) and scanning electron (SEM) microscopy, and X-ray diffraction (XRD). The friction and abrasive wear resistance of the coatings were studied using Rubber Wheel and Ball on Disk tests. The electrochemical studies were conducted using open-circuit potential (E(oc)) measurements and electrochemical impedance spectroscopy (EIS). Differences among coated samples were mainly related to the variation of the thermal spray parameters used during the spray process. No significant differences were observed in the wear resistance for the coatings studied, and all of them showed a wear rate around 10 times lower than that of the aluminum alloy. The results of mass loss and wear rate were interpreted considering different mechanisms. Comparing the different spray parameters, the oxygen flux (higher flame temperature) produced the sample which showed the highest corrosion resistance in aerated and unstirred 3.5% NaCl solution. Aluminum ions were detected on the surface almost immediately after the immersion of samples W19S and W19F in chloride solution, showing that the electrolyte reached the substrate and galvanic corrosion probably occurred. For sample W19H, aluminum ions were not detected even after 120 min of immersion in NaCl solution. (C) 2008 Elsevier B.V. All rights reserved.

Fluoride uptake and acid resistance of enamel irradiated with Er : YAG laser

This study evaluated the resistance to demineralization and fluoride incorporation of enamel irradiated with Er:YAG. A total of 110 bovine teeth were selected and divided into eight groups: unlased, 37% phosphoric acid, and samples irradiated with the Er:YAG laser at several fluences (31.84 J/cm(2), 25.47 J/cm(2), 19.10 J/cm(2), 2.08 J/cm(2), 1.8 J/cm(2), and 0.9 J/cm(2)). The application of acidulated phosphate fluoride was performed after treatments. All samples were immersed in 2 ml of 2.0 M acetic-acetate acid solution at pH 4.5 for 8 h, and fluoride, calcium, and phosphorus ions dissolved were analyzed by atomic absorption spectrometry and spectrophotometry. The phosphoric acid and 31.84 J/cm(2) groups presented the lowest dissolution of calcium and phosphorus ions. Higher fluoride incorporation was observed on 1.8 J/cm(2) and 0.9 J/cm(2) groups. Based on these results, Er:YAG laser was able to decrease acid dissolution and increase fluoride uptake and can be a promissory alternative for preventive dentistry.

Transpiration and stomatal resistance variations of perennial tropical crops under soil water availability conditions and water deficit

O experimento foi realizado no Departamento de Produção Vegetal da Escola Superior de Agricultura Luiz de Queiroz, ESALQ/USP, Piracicaba, São Paulo, Brasil, utilizando-se as culturas de guaranazeiro (Paullinia cupana Kunth), cafeeiro (Coffea arabica L.), cajueiro (Anacardium occidentale L.), goiabeira (Psidium guajava L.) e seringueira (Hevea brasiliensis Muell. - Arg.). No período de seca (setembro/94) e de chuvas (novembro/94), realizaram-se determinações de resistência estomática (RE) (s cm-1) e transpiração (T) (µg cm-1 s-1) nas diferentes espécies. O delineamento experimental foi em blocos casualizados com cinco repetições. A partir das análises dos dados pode-se concluir: 1. diferenças significativas entre espécies, em termos das variáveis avaliadas no período de deficiência hídrica, com valores decrescentes de resistência estomática e crescente de transpiração na seguinte ordem: guaranazeiro > cafeeiro > cajueiro > goiabeira > seringueira; 2. Nas águas as diferenças entre espécies, para ambas as variáveis, foram menos evidentes, continuando a cultura da seringueira a apresentar menor resistência estomática e maior transpiração dentre as espécies; 3. As culturas de guaraná e café apresentaram maior resistência à perda de água, em relação às demais culturas.

Gastroesophageal reflux disease and vocal disturbances

CONTEXTO: A doença do refluxo gastroesofágico (DRGE) é uma doença crônica na qual o conteúdo gastroduodenal reflui para o esôfago. O quadro clínico da DRGE é usualmente referido como pirose e regurgitação (manifestações típicas). Manifestações atípicas (distúrbios da voz e asma) podem também ser referidas. OBJETIVO: Analisar os aspectos clínicos, endoscópicos, manométricos e pHmétricos de pacientes portadores da DRGE com distúrbios da voz. MÉTODO: Foram estudados 50 pacientes com a DRGE, sendo 25 com distúrbios da voz (grupo 1 - G1) e 25 sem estes sintomas (controles, grupo 2 - G2). Todos os pacientes foram submetidos a endoscopia, manometria e pHmetria esofágica (dois sensores). Os pacientes do G1 foram submetidos a videolaringoscopia. RESULTADOS: Achados endoscópicos: DRGE não-erosiva foi observada em 95% dos pacientes de G1 e em 88% de G2. Videolaringoscopia: congestão das pregas vocais, assimetria, nódulos e pólipos foram diagnosticados nos pacientes do G1. Manometria esofágica: pressão no esfíncter inferior do esôfago (mm Hg): 11,6 ± 5,2 em G1 e 14,0 ± 6,2 em G2 (P = 0,14); pressão no esfíncter superior do esôfago (mm Hg): 58,4 ± 15,9 em G1 e 69,5 ± 30,7 nos controles. Achados pHmétricos: índice de DeMeester: 34,0 ± 20,9 em G1 e 15,4 ± 9,4 em G2 (P<0,001); número de episódios de refluxo no sensor distal: 43,0 ± 20,4 em G1 e 26, 4 ± 17,2 em G2 (P<0,003); percentagem do tempo com pH esofágico menor que 4 unidades (sensor distal): 9,0% ± 6,4% em G1 e 3,4% ± 2,1% em G2 (P<0,001); número de episódios de refluxo no sensor proximal: 7,5 ± 10,9 em G1 e 5,3 ± 5,7 em G2 (P = 0,38); percentagem de tempo com pH esofágico menor que quatro unidades (sensor proximal): 1,2% ± 2,7% em G1 e 0,5% ± 0,7% em G2 (P = 0,210). CONCLUSÕES: Os aspectos clínicos, endoscópicos e manométricos em pacientes com a DRGE e distúrbios da voz não diferem dos pacientes sem estes sintomas. A intensidade do refluxo gastroesofágico é maior nos pacientes com distúrbios da voz. Os pacientes sem distúrbios da voz podem também apresentar episódios de refluxo gastroesofágico no sensor proximal.