Mineralogy and diagenesis: Their effect on acoustic and electrical properties of pelagic clays at DSDP Leg 86 Holes

Analysis of pelagic clay samples from Sites 576, 578, and 581 shows that physical, acoustic, and electrical trends with increasing burial depth are related to mineralogical and diagenetic changes. The properties of interest are bulk density (roo), porosity (phi), compressional-wave velocity (Vp) and velocity anisotropy (Ap), and electrical resistivity (Ro) and resistivity anisotropy (Ar). In general, as demonstrated in particular for the brown pelagic clay, the increase in roo, Vp, Ro, and to a lesser extent Ap and Ar with increasing depth is primarily caused by decreasing phi (and water content) as a result of compaction. The mineralogy and chemistry of the pelagic clays vary as a function of burial depth at all three sites. These variations are interpreted to reflect changes in the relative importance of detrital and diagenetic components. Mineralogical and chemical variations, however, play minor roles in determining variations in acoustic and electrical properties of the clays with increasing burial depth.

Chemistry of zeolithe and clays from Central Kerguelen Plateau basalts

Ocean Drilling Program Leg 120 recovered basement samples that consisted of zeolite-facies metabasalts at Sites 747, 749, and 750 on the Kerguelen Plateau. These basalts were metamorphosed in the low to intermediate zones of the zeolite facies, as indicated by the presence of diagnostic zeolites and the absence of chlorite, epidote, prehnite, pumpellyite, and wairakite. Chabazite, natrolite, thompsonite, mesolite, stilbite, huelandite, and smectites occur as amygduloidal fillings in basalts from Holes 747C and 750B, whereas only stilbite, laumontite, and pure and mixed-layered smectites were identified in amygduloidal basalts from Hole 749C. In the lower sections of Hole 749C, only laumontite and mixed-layered smectites coexist. Based on calculations with published experimental phase equilibria, the absence of wairakite in basalts from Hole 749C and of laumontite in basalts from Holes 747C and 750B suggests that metamorphic temperatures did not exceed approximately 225° and 120°C, respectively. The presence of well-developed zeolite mineral assemblages and the absence of carbonate and clay mineral assemblages restricts XCO2 in the fluid to approximately <=0.0075. Low- to intermediate-zone zeolite-facies mineral assemblages in basalts from the Kerguelen Plateau can be accounted for by metamorphism in an active geothermal area such as present-day Iceland.

Mineral XRD peak areas and ratios of ODP Site 184-1146 clays, South China Sea

Site 1146 (19°27.40'N, 116°16.37'E) was drilled in ~2092 m water depth in a rift basin on the continental slope of the South China Sea. A total of 607 m of sediment was cored in Hole 1146A, and a composite section from three holes extends down to 640 meters composite depth (mcd). Three stratigraphic sedimentary units were recognized at this site: late Pliocene to Pleistocene nannofossil clay (Unit I), middle Miocene to late Pliocene foraminifer and nannofossil clay mixed sediment (Unit II), and early to middle Miocene nannofossil clay (Unit III). This study reports the mineralogy from the late Miocene through early Pleistocene, 150-440 mcd.