In situ characterization of stickiness of sugar-rich foods using a linear actuator driven stickiness testing device

A stickiness testing device based on the probe tack test has been designed and tested. It was used to perform in situ characterization of drying hemispherical drops with an initial radius 3.5 mm. Tests were carried out in two drying temperatures, 63 and 95 degreesC. Moisture and temperature histories of the drying drops of fructose, honey, sucrose, maltodextrin and sucrose-maltodextrin mixtures were determined. The rates of moisture evaporation of the fructose solution was the fastest while those of the maltodextrin solution was the lowest. A profile reversal was observed when the temperature profiles of these materials were compared. Different modes of failure were observed during the stickiness tests. Pure fructose and honey solutions remained completely sticky and failed cohesively until the end of drying. Pure sucrose solution remained sticky and failed cohesively until complete crystallization occurred. The surface of the maltodextrin drops formed a skin shortly after the start of drying. It exhibited adhesive failure and reached a state of non-adhesion. Addition of maltodextrin significantly altered the stickiness of sucrose solution. (C) 2002 Elsevier Science Ltd. All rights reserved.

A class B switch-mode assisted linear amplifier

A switch-mode assisted linear amplifier (SMALA) combining a linear (Class B) and a switch-mode (Class D) amplifier is presented. The usual single hysteretic controlled half-bridge current dumping stage is replaced by two parallel buck converter stages, in a parallel voltage controlled topology. These operate independently: one buck converter sources current to assist the upper Class B output device, and a complementary converter sinks current to assist the lower device. This topology lends itself to a novel control approach of a dead-band at low power levels where neither class D amplifier assists, allowing the class B amplifier to supply the load without interference, ensuring high fidelity. A 20 W implementation demonstrates 85% efficiency, with distortion below 0.08% measured across the full audio bandwidth at 15 W. The class D amplifier begins assisting at 2 W, and below this value, the distortion was below 0.03%. Complete circuitry is given, showing the simplicity of the additional class D amplifier and its corresponding control circuitry.

Pseudo-randomness of round-off errors in discretized linear maps on the plane

We analyze the sequences of round-off errors of the orbits of a discretized planar rotation, from a probabilistic angle. It was shown [Bosio & Vivaldi, 2000] that for a dense set of parameters, the discretized map can be embedded into an expanding p-adic dynamical system, which serves as a source of deterministic randomness. For each parameter value, these systems can generate infinitely many distinct pseudo-random sequences over a finite alphabet, whose average period is conjectured to grow exponentially with the bit-length of the initial condition (the seed). We study some properties of these symbolic sequences, deriving a central limit theorem for the deviations between round-off and exact orbits, and obtain bounds concerning repetitions of words. We also explore some asymptotic problems computationally, verifying, among other things, that the occurrence of words of a given length is consistent with that of an abstract Bernoulli sequence.

Remuneração executiva e desempenho: evidências empíricas no mercado de capitais brasileiro

O objetivo desta dissertação é analisar a relação existente entre remuneração executiva e desempenho em companhias brasileiras de capital aberto listadas na BM&FBOVESPA. A linha teórica parte do pressuposto que o contrato de incentivos corrobora com o alinhamento de interesses entre acionistas e executivos e atua como um mecanismo de governança corporativa a fim de direcionar os esforços dos executivos para maximização de valor da companhia. A amostra foi composta pelas 100 companhias mais líquidas listadas em quantidade de negociações de ações na BM&FBOVESPA durante o período 2010-2012, totalizando 296 observações. Os dados foram extraídos dos Formulários de Referência disponibilizados pela CVM e a partir dos softwares Economática® e Thomson Reuters ®. Foram estabelecidas oito hipóteses de pesquisa e estimados modelos de regressão linear múltipla com a técnica de dados em painel desbalanceado, empregando como variável dependente a remuneração total e a remuneração média individual e como regressores variáveis concernentes ao desempenho operacional, valor de mercado, tamanho, estrutura de propriedade, governança corporativa, além de variáveis de controle. Para verificar os fatores que explicam a utilização de stock options, programa de bônus e maior percentual de remuneração variável foram estimados modelos de regressão logit. Os resultados demonstram que, na amostra selecionada, existe relação positiva entre remuneração executiva e valor de mercado. Verificou-se também que os setores de mineração, química, petróleo e gás exercem influência positiva na remuneração executiva. Não obstante, exerce relação inversa com a remuneração total à concentração acionária, o controle acionário público e o fato da companhia pertencer ao nível 2 ou novo mercado conforme classificação da BMF&BOVESPA. O maior valor de mercado influencia na utilização de stock options, assim como no emprego de bônus, sendo que este também é impactado pelo maior desempenho contábil. Foram empregados também testes de robustez com estimações por efeitos aleatórios, regressões com erros-padrão robustos clusterizados, modelos dinâmicos e os resultados foram similares. Conclui-se que a remuneração executiva está relacionada com o valor corporativo gerando riqueza aos acionistas, mas que a ausência de relação com o desempenho operacional sugere falhas no sistema remuneratório que ainda depende de maior transparência e outros mecanismos de governança para alinhar os interesses entre executivos e acionistas.

Testes para verificar a igualdade de parâmetros e a identidade de modelos de regressão não-linear em dados de experimento com delineamento em blocos casualizados

Considerou-se o ajustamento de equações de regressão não-linear e o teste da razão de verossimilhança, com aproximações pelas estatísticas qui-quadrado e F, para testar as hipóteses de igualdade de qualquer subconjunto de parâmetros e de identidade dos modelos para dados com repetições provenientes de experimento com delineamento em blocos completos casualizados. Concluiu-se que as duas aproximações podem ser utilizadas, mas a aproximação pela estatística F deve ser preferida, principalmente para pequenas amostras.

Bone mineral density of rat femurs after hindlimb unloading and different physical rehabilitation programs

Bone weakening can occur due to the absence of load on the skeleton or even short periods of decreased physical activity. Therefore, musculoskeletal diseases that involve temporary immobilization by casts, inactivity or tension increases the risk of fractures. Physical activity is the most studied procedure both to prevent damage and to restore bone structure. The present study aimed at evaluating, by bone densitometry on rat femurs, the influence of hindlimb unloading and later running activity on treadmill or free movement. Sixty-four Wistar rats were used, aged 65 days with a mean corporal mass of 316.11g, randomly divided into eight experimental groups: group 1, the suspended control with seven animals under hindlimb unloading regimen for 28 days, then euthanized; groups 2 and 3, the trained suspended comprising of 7 and five animals, respectively, subjected to hindlimb unloading for 28 days, followed by treadmill exercise for 28 days (group 2) or 56 days (group 3), then euthanized; groups 4 and 5, designated free suspended, comprised of 7 animals each under hindlimb unloading regimen for 28 days followed by free activity in cages for 28 days (group 4) or 56 days (group 5), then euthanized; groups 6, 7 and 8, negative controls, each with 8 animals allowed to free activity in cages and euthanized at the ages of 93, 121 and 149 days, respectively. Bone mineral density (BMD) of the left femur was analyzed by bone densitometry. Unloading by tail-suspension decreased BMD while treadmill training and free activity in cages promoted its recovery in a similar way and over time.

Atributos físicos de um Latossolo Vermelho correlacionados linear e espacialmente com a consorciação de guandu com milheto

O sistema cultivo mínimo, por possibilitar pouca movimentação de solo, menor número de operações agrícolas sem incorporação dos resíduos vegetais, apresenta vantagens em razão do menor custo de preparo e da redução das perdas de solo e água. No ano agrícola de 2006/2007, na Fazenda de Ensino e Pesquisa da Faculdade de Engenharia de Ilha Solteira, SP, Brasil - FEIS/UNESP, situada nas condições do Cerrado Brasileiro, objetivou-se analisar a produtividade de massa de matéria seca da consorciação de forragem (guandu+milheto) (MSF), em função de atributos físicos do solo, tais como resistência à penetração (RP), umidade gravimétrica (UG), umidade volumétrica (UV) e densidade do solo (DS) nas profundidades de 0,0-0,10 m; 0,10-0,20 m e 0,20-0,30 m. Para tanto, foi instalado um ensaio, contendo 117 pontos amostrais, em um Latossolo Vermelho distroférrico, sob pivô central, numa área experimental de 1600 m² sob cultivo mínimo. A análise estatística constou de análise descritiva inicial dos atributos e análise das correlações lineares simples entre eles, e, finalmente, de análise geoestatística. Do ponto de vista da correlação espacial, o atributo que mais bem explica a produtividade de massa de matéria seca da consorciação é a densidade do solo na camada de 0,20-0,30 m, com uma correlação inversa, indicando que as espécies se desenvolvem bem em solos adensados.

Identifying clones in functional programs for refactoring

Clone detection is well established for imperative programs. It works mostly on the statement level and therefore is ill-suited for func- tional programs, whose main constituents are expressions and types. In this paper we introduce clone detection for functional programs using a new intermediate program representation, dubbed Functional Control Tree. We extend clone detection to the identi cation of non-trivial func- tional program clones based on the recursion patterns from the so-called Bird-Meertens formalism

Criminal Liability of Organizations, Corporations, Legal Persons, and Similar Entities on Law of Portuguese Cybercrime: A Brief Discussion on the Issue of Crimes of “False Information,” the “Damage on Other Programs or Computer Data,” the “Computer-Software Sabotage,” the “Illegitimate Access,” the “Unlawful Interception,” and “Illegitimate Reproduction of the Protected Program”

Abstract: in Portugal, and in much of the legal systems of Europe, «legal persons» are likely to be criminally responsibilities also for cybercrimes. Like for example the following crimes: «false information»; «damage on other programs or computer data»; «computer-software sabotage»; «illegitimate access»; «unlawful interception» and «illegitimate reproduction of protected program». However, in Portugal, have many exceptions. Exceptions to the «question of criminal liability» of «legal persons». Some «legal persons» can not be blamed for cybercrime. The legislature did not leave! These «legal persons» are v.g. the following («public entities»): legal persons under public law, which include the public business entities; entities utilities, regardless of ownership; or other legal persons exercising public powers. In other words, and again as an example, a Portuguese public university or a private concessionaire of a public service in Portugal, can not commit (in Portugal) any one of cybercrime pointed. Fair? Unfair. All laws should provide that all legal persons can commit cybercrimes. PS: resumo do artigo em inglês.

Slicing functional programs by calculation

Program slicing is a well known family of techniques used to identify code fragments which depend on or are depended upon specific program entities. They are particularly useful in the areas of reverse engineering, program understanding, testing and software maintenance. Most slicing methods, usually targeting either the imperative or the object oriented paradigms, are based on some sort of graph structure representing program dependencies. Slicing techniques amount, therefore, to (sophisticated) graph transversal algorithms. This paper proposes a completely different approach to the slicing problem for functional programs. Instead of extracting program information to build an underlying dependencies’ structure, we resort to standard program calculation strategies, based on the so-called Bird- Meertens formalism. The slicing criterion is specified either as a projection or a hiding function which, once composed with the original program, leads to the identification of the intended slice. Going through a number of examples, the paper suggests this approach may be an interesting, even if not completely general alternative to slicing functional programs

Designing competitive international compensation programs

Over the past 25 years, expatriate managers have voiced increased disenchantment with their compensation packages whíle abroad. This paper takes a prescriptive approach, outlíning severa I elements of a successful human resources strategy and stressing key ingredients of effective international compensation programs. Particular ettention is given to the adherence of cultural values and distrlbutive justice when working across nations and cultures.

The undergraduate level (1st study cycle) as a fundamental platform/standard for the development of Urban and Regional Planning in higher education programs

LUDA is a research project of Key Action 4 "City of Tomorrow & Cultural Heritage" of the programme "Energy, Environment and Sustainable Development" within the Fifth Framework Programme of the European Commission