Resina de Protium heptaphyllum: isolamento, caracterização estrutural e avaliação das propriedades térmicas

Three mixtures of triterpenes (maniladiol and breine; alpha and beta-amyrin; lupenone, alpha and beta-amyrinone) were isolated from Protium heptaphyllum March resin. The structural identification was based on NMR and mass spectrometry data. Lupenone, and alpha and beta-amyrinone were not reported before as constituents of this resin. The resin was submitted to methylation and acetylation reactions. The pure and derivatized resins and the mixtures (maniladiol and breine; alpha and beta-amyrin) were analyzed by TG and DSC. The TG curves revealed that the derivatization decreases the thermal stability of the resin. The DSC curves showed peaks that can be assigned to evaporation and phase transitions processes.

Estimation of Water Circulation in a Mediterranean Salt Marsh and its Relationship with Flooding Causes

Variations in water volume in small depressions in Mediterranean salt marshes in Girona (Spain) are described and the potential causes for these variations analysed. Although the basins appear to be endorrheic, groundwater circulation is intense, as estimated from the difference between water volume observed and that expected from the balance precipitation / evaporation. The rate of variation in volume (VR = AV / VAt) may be used to estimate groundwater supply ('circulation'), since direct measurements of this parameter are impossible. Volume.conductivity figures can also be used to estimate the quantity of circulation, and to investigate the origin of water supplied to the system. The relationships between variations in the volume of water in the basins and the main causes of flooding are also analysed. Sea storms, rainfall levels and strong, dry northerly winds are suggested as the main causes of the variations in the volumes of basins. The relative importance assigned to these factors has changed, following the recent regulation of freshwater flows entering the system

Cálculo de evaporadores de múltiple efecto en paralelo. Parte I: Modelo matemático y análisis del mismo

En el presente artículo se desarrolla el modelo matemático de un sistema de evaporadores de múltiple efecto operando en paralelo. Se analiza asimismo el modelo matemático para hallar el número de grados de libertad del sistema y la forma de consumir esos grados de libertad.

Cálculo de evaporadores de múltiple efecto en paralelo: Parte II. Resolución del modelo matemático y un ejemplo numérico

En el presente artículo se expone la resolución mediante calculador digital, del modelo matemático de evaporadores de múltiple efecto que fue publicado en Química e Industria, en el número del pasado mes de febrero.

A simple and rapid method for urinary acetone analysis by headspace/gas chromatography

Urinalysis of acetone is important to monitor workers occupationally exposed to acetone and/or isopropanol, as well as in diagnosis of some diseases related to lipid metabolism impairment. This work shows a sensitive, simple and rapid static headspace-gas chromatographic procedure for quantitative determination of acetone in urine. The method was applied to measure acetone in 207 samples from general population volunteers, resulting in a mean level of 1.12 mg/L (± 0.47) and a range of 0.20 - 1.95 mg/L. The method is reproducible and reliable, making it suitable for routine analysis of acetone in urine.

Estudo das propriedades e biodegradabilidade de blendas de poliéster/amido submetidas ao ataque microbiano

This work deals with the biodegradation of blends of poly(beta-hydroxybutyrate)/starch and poly(beta-hydroxybutyrate-co-hydroxyvalerate)/starch. The blends were obtained by evaporation of the solvent in the mixture of the polymers in chloroform. Tests were carried out in presence of micro-organisms which acted as biodegradation agents. The blends were consumed as carbon substrate and the production of CO2 was evaluated in the process. In addition, the polyesters' mechanical properties were reduced by the incorporation of starch in its structure. (¹H) NMR and infrared spectroscopy detected some characteristic polyester degradation groups in the polyesters' chemical structure, thus confirming the alteration suffered by it.

A low-cost ultrasonic spray dryer to produce spherical microparticles from polymeric matrices

The spray-drying technique has been widely used for drying heat-sensitive foods, pharmaceuticals, and other substances, because it leads to rapid solvent evaporation from droplets. This method involves the transformation of a feed from a fluid state into a dried particulate, by spraying the feed into a hot medium. Despite being most often considered a dehydration process, spray drying can also be used as an encapsulation method. Therefore, this work proposes the use of a simple and low-cost ultrasonic spray dryer system to produce spherical microparticles. This equipment was successfully applied to the preparation of dextrin microspheres on a laboratory scale and for academic purposes.

Processamento de pilhas do tipo botão

This work presents hydrometallurgical routes for recovering valuable elements from spent button cells, based on leaching of internal components with sulfuric acid (Li/MnO2 and Zn-air) or nitric acid (Ag-Zn), at 90 ºC for 2h. Slow evaporation of the leachate crystallized MnSO4.H2O, whereas lithium was partially recovered as LiF. Mercury present in Zn-air and Ag-Zn samples was precipitated as HgS. Silver was recovered as AgCl before mercury precipitation. Zinc and iron were precipitated as hydroxides. The amount of iron varied according to the intensity of the corrosion of the external cell case. Final wastes are neutral and colorless sodium sulfate/nitrate solutions.

Analytical procedures for determining Pb and Sr isotopic compositions in water samples by ID-TIMS

Few articles deal with lead and strontium isotopic analysis of water samples. The aim of this study was to define the chemical procedures for Pb and Sr isotopic analyses of groundwater samples from an urban sedimentary aquifer. Thirty lead and fourteen strontium isotopic analyses were performed to test different analytical procedures. Pb and Sr isotopic ratios as well as Sr concentration did not vary using different chemical procedures. However, the Pb concentrations were very dependent on the different procedures. Therefore, the choice of the best analytical procedure was based on the Pb results, which indicated a higher reproducibility from samples that had been filtered and acidified before the evaporation, had their residues totally dissolved, and were purified by ion chromatography using the Biorad® column. Our results showed no changes in Pb ratios with the storage time.

Biodegradação de tolueno e óleo de pescado em solos impactados utilizando surfactantes químico e biológico

The process of biodegradation of soils contaminated by animal (raw fish oil) and mineral (toluene) origin compounds was studied, verifying the influence of adding biosurfactants and chemical surfactants and nutrients in the media. The highest removal rate of fish oil was 59.47% obtained in the experiments containing biosurfactant and biostimulate in 90 days process. The highest removal rate of toluene was achieved in 14 days for experiments containing biosurfactant, chemical spreading and biosurfactant with biostimulation, showing great influence of evaporation on the process. The use of surfactants has shown to increase the contaminant bioavailability due to its higher degradation rate.

Variações de curto prazo nas emissões de CO2 do solo em diferentes sistemas de manejo do cafeeiro

Soil CO2 emissions represent an important component of carbon global cycle. However, information about short-term alterations of CO2 fluxes in soils of tropical regions are scarce. So, the objective of this study was to evaluate such variations in coffee plantations in Latosol (Oxisol). The CO2 emissions were not affected by environmental abiotic factors, such as temperature and soil water evaporation, but they were significantly correlated with the carbon content of microbial biomass (R=0.90, P<0.05). It happens a close relationship between root activity and soil CO2 emission in coffee plantations.

Determinação de etanol e voláteis relacionados em sangue e fluido oral por microextração em fase sólida em headspace associada à cromatografia gasosa com detector de ionização em chama

The aim of this study was to validate a method for the determination of acethaldehyde, methanol, ethanol, acetone and isopropanol employing solid-phase microextraction associated to gas chromatography with flame ionization detection. The operational conditions of SPME were optimized by response surface analysis. The calibration curves for all compounds were linear with r² > 0.9973. Accuracy (89.1-109.0%), intra-assay precision (1.8-8.5%) and inter-assay precision (2.2-8.2%) were acceptable. The quantification limit was 50 µg/mL. The method was applied to the meaurement of ethanol in blood and oral fluid of a group of volunteers. Oral fluid ethanol concentrations were not directly correlated with blood concentrations.

Determinação de olanzapina em formulações farmacêuticas por espectrofotometria: desenvolvimento e validação

Spectrophotometric methods of zero order, first and second derived order had been developed for olanzapine determination in tablets using ethanol and isopropanol as solvent. The two solvents revealed to be adequate. For the three methods the calibration curve coefficient of correlation had been greater than 0.9998 with limit of detection varying from 0.068 to 0.190 mg L-1, in ethanol, and 0.026 to 0.205 mg L-1, in isopropanol. The inter-day precision was inferior to 1.1 and 1.9 mg L-1 for ethanol and isopropanol, respectively. The average recoveries varied from 98 to 101%, in ethanol and 99 to 103% in isopropanol.

Aplicação do modelo Tucker-3 para a análise da biodegradação de diesel

Tucker-3 model offers several advantages for analysis of environmental data but its interpretation is still challenging. A Tucker-3 model was applied to a biodegradation experiment involving a large number of overlapped chromatographic peaks and a temporal variation. The Tucker-3 model allowed the data to be decomposed in two processes: evaporation and biodegradation. The results suggest that linear hydrocarbons were those biodegraded first and demonstrate that the data analysis can be simplified by interpreting the elements of the core array. The approach discussed in this work can be applied in similar problems involving multi-way data in other areas of chemistry.

Encapsulation of naproxen in nanostructured system: structural characterization and in vitro release studies

Nanoparticles were produced by solvent emulsification evaporation method with the following characteristics: nanometric size (238 ± 3 nm), narrow polydispersity index (0.11), negative zeta potential (-15.1 mV), good yield of the process (73 ± 1.5%), excellent encapsulation efficiency (81.3 ± 4.2%) and spherical shape. X-rays diffraction demonstrated the loss of drug crystallinity after encapsulation; however, the profile of the diffractograms of the poly-ε-caprolactone (PCL) nanoparticles was kept. Differential scanning calorimetry thermograms, correspondingly, exhibited the loss of drug melting peak and the increasing of the melting point of the PCL nanoparticles, evidencing an interaction drug-polymer. Naproxen release was low and sustained obeying the Higuchi´s kinetic. The results show that nanoparticles are promising sustained release system to the naproxen.