On the relative utility of different methods to increase the vertical height in an otter trawl

Comparative fishing experiments to study the relative utility of different methods for increased vertical spread of bottom trawl and the availability of off bottom fishes in the region were made using gussets, kite, separate float line and side panels on a two seam net. The catch rates as well as composition of fish were studied. The opening of the trawl mouth, both horizontally and vertically, under different operating gears and towing tension on warps were measured and estimated for comparison purposes. Better catch rate with good quality fishes was obtained with the gear operated with separate float line. With kite, the vertical spread was increased with less catch indicating poor concentration of off bottom fishes.

Vertical distribution of molluscs in the intertidal area in and around Mumbai, India

Vertical distribution of intertidal molluscs in and around Mumbai had been studied. Each species has an upper and lower limit of distribution along the vertical intertidal gradient and are concentrated at particular levels or zones where they find optimum living conditions. Zonation of the intertidal area with reference to molluscs at rocky shores of TIFR, Bandstand and NCPA has similarities. However, there is no similarity in zonation among rocky, sandy and muddy shores. Rocky intertidal zones are more diverse and dense in terms of molluscs. The mid and lower littoral zones have rich diversity. The upper littoral zone at some sites, especially Girgaon chowpatty is totally devoid of molluscs due to anthropogenic activities. Gafrarium divaricatum, Nerita oryzarum, N. polita and Neritina crepidularia have established themselves in all three marked zones, indicating their power to adjust with the wide fluctuations in surrounding environmental conditions.

Post-processing of vertical-cavity surface-emitting lasers for transverse mode and polarization control

The operation on how high quality single-mode operation can be readily attained on etching circles in multimode devices is discussed. Arrays of such spots can also be envisaged. Control of the polarization state is also achieved by use of deep line etches. The output filaments and beam shapes of the conventional multimode vertical cavity surface emitting lasers (VCSEL) is shown to be engineered in terms of their positions, widths, and polarizations by use of focused ion beam etching (FIBE). Several GaAs quantum well top-emitting devices with cavity diameters of 10 μm and 18 μm were investigated.

Mode control in vertical-cavity surface-emitting lasers by post-processing using focused ion-beaih etching

Single-mode emission is achieved in previously multimode gain-guided vertical-cavity surface-emitting lasers (VCSEL's) by localized modification of the mirror reflectivity using focused ion-beam etching. Reflectivity engineering is also demonstrated to suppress transverse mode emission in an oxide-confined device, reducing the spectral width from 1.2 nm to less than 0.5 nm.

Mode-controlled vertical cavity surface emitting lasers for bandwidth enhancement of multimode fibre links

A GaAs Vertical Cavity Surface Emitting Laser (VCSEL) that generates controlled modes offset from the center is described. The device is modulated with a 27-1 pseudo-random bit sequence and its output is transmitted along a 1 km length of multimode fiber (MMF). Open eyes are obtained for data rates as high as 1.4Gb/s. The transmission bandwidth increases by a factor of 4 over over-filled launch (OFL). This enhancement is stable against environment influences on the fiber.