1000 resultados para Expansão canavieira


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The expansion of psychiatric labeling does not reach only the adult population, but also the problematic related to childhood have been captured by the speeches and practices of the medical-psychiatric knowledge and turned into psychopathologies which tend to be treated with the main resource made available by psychiatrics in the present times: the psychotropic drugs. This work presents a critical thinking on the expansion of the diagnoses of “attention deficit disorder and hyperactivity” (ADHD) both in children and teenagers and on the conduction of drug therapies. It follows that the processes of childhood psycho-pathologization and the trivializing of psychotropic drug prescription are related to the overvaluation of the biological conception of psychic suffering and to the economic interests of the great pharmaceutical laboratories which by means of several strategies influence the medical practices, factors that lead to exposure of these patients to possible side effects and the risks of stigmatization that must be considered.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pós-graduação em Educação - IBRC

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Soil tillage is one of the agricultural practices that may contribute to increase the loss of carbon through emission of CO2 (FCO2). The aim of this study was to investigate the effect of three soil tillage systems on FCO2, soil temperature and soil moisture in a sugarcane area under reform. The experimental area consisted of three tillage plots: conventional tillage (CT), conventional subsoiling (CS), and localized subsoiling (LS). FCO2, soil temperature and soil moisture were measured over a period of 17 days. FCO2 showed the highest value in CT (0.75 g CO2 m(-2) h(-1)). Soil temperature presented no significant difference (p > 0.05) between LS (26.2 degrees C) and CS (25.9 degrees C). Soil moisture was higher in LS (24%), followed by CS (21.8%) and CT (18.3%). A significant correlation (r = -0.71; p < 0.05) between FCO2 and soil temperature was observed only in CT. The conventional tillage presented a total emission (2,864.3 kg CO2 ha(-1)) higher than the emissions observed in CS (1,970.9 kg CO2 ha(-1)) and LS (1,707.7 kg CO2 ha(-1)). The conversion from CT to LS decreased soil CO2 emissions, reducing the contribution of agriculture in increasing the concentration of greenhouse gases in the atmosphere.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The sugar and ethanol industry has always stood out in the Brazilian economy. Contributing to the growth and development of the economy and the country the sector has gone through several phases. This paper makes a study of the industry and exposes the work of some authors on the subject in order to demonstrate the economic and social impacts caused by the installation of a sugar cane industry in a small city and its contribution to local development. Actual results are generally encouraging and reported that the sugarcane industry contributes to the development of cities where it is installed, benefiting them

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Consider a finite body of mass m (C1) with moments of inertia A, B and C. This body orbits another one of mass much larger M (C2), which at first will be taken as a point, even if it is not completely spherical. The body C1, when orbit C2, performs a translational motion near a Keplerian. It will not be a Keplerian due to external disturbances. We will use two axes systems: fixed in the center of mass of C1 and other inertial. The C1 attitude, that is, the dynamic rotation of this body is know if we know how to situate mobile system according to inertial axes system. The strong influence exerted by C2 on C1, which is a flattened body, generates torques on C1, what affects its dynamics of rotation. We will obtain the mathematical formulation of this problem assuming C1 as a planet and C2 as the sun. Also applies to case of satellite and planet. In the case of Mercury-Sun system, the disturbing potential that governs rotation dynamics, for theoretical studies, necessarily have to be developed by powers of the eccentricity. As is known, such expansions are delicate because of the convergence issue. Thus, we intend to make a development until the third order (superior orders are not always achievable because of the volume of terms generated in cases of first-order resonances). By defining a modern set of canonical variables (Andoyer), we will assemble a disturbed Hamiltonian problem. The Andoyer's Variables allow to define averages, which enable us to discard short-term effects. Our results for the resonant angle variation of Mercury are in full agreement with those obtained by D'Hoedt & Lemaître (2004) and Rambaux & Bois (2004)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pós-graduação em História - FCLAS

Relevância:

20.00% 20.00%

Publicador:

Resumo:

To evaluate the volumetric changes due to polymerization and thermocycling on different resin-composites. Methods: Thirteen A2 Universal Dentin shade resin-composites (n = 10) from eight manufacturers were evaluated (4Seasons, Grandio, Venus, Amelogen Plus, P90, Z350, Esthet-X, Amaris, Vita-l-escence, Natural-Look, Charisma, Z250 and Opallis). The polymerization shrinkage percentage (PS) was calculated using an image measurement device (ACUVOL - Bisco Dental). Equal volumes of material, standardized by a semisphere polyurethane matrix (d = 3mm) were used and, after 5 minutes of relaxation, the baseline volume measurements were obtained with 18 J of energy dose from the LED light-curing unit. Measurements were obtained after 5 minutes and PS values calculated. Specimens were stored in a drydark environment for 24 hours and re-measured. Specimens were then thermocycled in distilled water between 5oC and 55oC for 20,000 cycles, subjected to another volume measurement at 5,000 cycle intervals. Specimens were gently dried prior to each measurement. Results: Repeated measurements were made using ANOVA (α = 0.05) showed that all resin-composite volumes were influenced by the number of cycles. Volumes at 5 minutes post-polymerization (12.47 ± 0.08) were significantly lower than those at baseline (12.80 ± 0.09). Volumes at 24 hours (12.43 ± 0.19) were insignificantly lower than those at 5 minutes postpolymerization. With regards to the impact of thermocycling, all specimens showed statistically significant increases in volume after 5,000 cycles (13.04 ± 0.22). Although statistically different from those after 5,000 cycles, there was no statistically significant difference between volumes measured at 10,000 (12.87±0.21), 15,000 (12.92±0.24), and 20,000 (12.84±0.23) cycles. Conclusion: According to the video-imaging analysis, thermocycling caused a significant expansion in resin-composites tested, the volume increase was not able to...

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Aim: the purpose of this study is to present a case of surgically assisted rapid maxillary expansion using piezosurgery and describe the benefits of using this device in this type of procedure. Case description: patient had adento-skeletal deformity Cl III with asevereatresia of jaw and underwent a rapid maxillary expansion and surgically assisted with the use of piezosurgery. Conclusion: the piezosurgerycan be used as an alternative in oral and maxillofacial surgery wich features provide greater accuracy and safety in surgery.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundamentation: The correction of maxillary transverse deficiencies involves orthodontic and surgical procedures that can be performed before or after skeletal maturity. The surgically assisted rapid maxillary expansion (SAR ME) is performed by osteotomies through the lateral walls of the maxilla, zygomatic and canines buttresses, palatal and pterygomaxillary sutures, causing the maxillary disjunction. Followed by activation of the expander to the desired over-expansion in order to correct intercuspal later. Objective: The purpose of this study was to discuss the issues involved in the diagnosis of maxillary atresia, SAR ME indications, as well as surgical technique, through a case study. Methods: The male patient, 19 years old, had severe transverse maxillary deficiency with facial pattern III , Class III , with great lip incompetence. The patient underwent general anesthesia in a hospital environment, the osteotomies was done according to the technique described by Epker and Wolford (1980). Postoperatively, the patient underwent activations daily for 15 days and after 6 months, the orthodontist installed fixed orthodontic appliance to prepare the patient to orthognathic surgery later. Conclusion: The diagnosis by clinical evaluation and models study is essential for the indication of SAR ME and this procedure provides good predictability in the correction of transverse deficiency, with minimal morbidity.