Amplitude ratios and the approach to bulk criticality in parallel plate geometries

We present analytical and numerical results for the specific heat and susceptibility amplitude ratios in parallel plate geometries. The results are derived using field-theoretic techniques suitable to describe the system in the bulk limit, i.e., (L/ξ±)≫ 1, where L is the distance between the plates and ξ± is the correlation length above (+) and below (-) the bulk critical temperature. Advantages and drawbacks of our method are discussed in the light of other approaches previously reported in the literature.

Pion-distribution amplitude within the instanton model

The leading-twist pion-distribution amplitude is obtained at a low normalization scale of order ρc (inverse average size of an instanton). Pion dynamics, consistent with gauge invariance and low-energy theorems, is considered within the instanton vacuum model. The results are QCD-evolved to higher momentum-transfer values and are in agreement with recent data from CLEO on the pion transition form factor. It is also shown that some previous calculations violate the axial Ward-Takahashi identity. © 2001 MAIK Nauka/Interperiodica.

A simple constant-current neural stimulator with accurate pulse-amplitude control

A simple constant-current electrocutaneous stimulator for high-impedance loads using low-cost, standard high-voltage components is presented. A voltage-regulator powers an oscillator built across the primary of a transformer whose secondary delivers, after rectification, the high-voltage supply to switched current-mirrors in the driving stage. Since the compliance high-voltage is proportional to the stimulation current, overall power consumption is minimized. By adjusting the regulated voltage, control of the pulsed-current amplitude is achieved. A prototype with readily available components features stimulation currents of amplitude and pulsewidth in the range 0≤Iskin≤20mA and 50μs ≤Tpulse≤1ms, respectively. Pulse-repetition spans from 1 Hz to 10Hz. Worst-case ripple is 3.7% @Iskin=1mA. Measured pulse fall-time is shorter than 32μs. Overall consumption is 4.4W @Iskin=20mA. Subject isolation from line is 4KV.

Análise térmica do processo de incineração de resíduos aquosos com chamas enriquecidas

The use of oxygen to enrich the combustion air can be an attractive technique to increase capacity of an incinerator originally designed to operate with air. If incinerator parameters such as operation temperature, turbulence level and residence time are fixed for a certain fuel supply rate, it is possible to increase the residue consumption rate using enriched air. This paper presents the thermal analysis for operation with enriched air of an aqueous residue experimental incinerator. The auxiliary fuel was diesel oil. The theoretical results showed that there is a considerable increase in the incineration ratio up to approximately 50 % of O 2 in the oxidiser. The tendency was confirmed experimentally. Thermal analysis was demonstrated to be an important tool to predict possible incinerator capacity increase.

Análise térmica de esparfloxacino

Sparfloxacin, a third-generation fluoroquinolone, is a potent antibacterial agent against a wide range of Gram-positive and Gram-negative organisms, for example Streptococcus pneumonias, Staphylococcus aureus (including methicillin-resistant strains), Legionella spp., Mycoplasma spp., Chlamydia spp. and Mycobacterium spp. This compound has been submitted to thermal analysis and the results are presented here. The DSC curve of sparfloxacin has an endothermic peak that indicates a melting point at 276.5 °C. The DTA curve of the sample in synthetic air shows two exothermic peaks, at 341.6 and 579.2 °C, attributed to compound decomposition. In the TG curve, the loss of mass can be seen to occur in two steps between 285.5 and 645.3 °C. The DTA curve obtained in a nitrogen atmosphere shows an exothermic peak, with decomposition of sparfloxacin at 340.0 °C; from the corresponding TG plot, the loss of mass starts at 254.4 °C.

Four-point one-loop amplitude computation in the pure spinor formalism

The massless 4-point one-loop amplitude computation in the pure spinor formalism is shown to agree with the computation in the RNS formalism. © SISSA 2006.

Valores da Amplitude de Distribuição do Tamanho dos Eritrócitos (RDW) em eqüinos Puro Sangue Inglês (PSI) submetidos a exercícios de diferentes intensidades

In order to evaluate the influence of exercise of different intensities on Red Blood Cell Distribution width (RDW) and Packed Cell Volume (VG) in Thoroughbred horses, blood was collected from 60 animals, 30 males and 30 females, subdivided in groups of horses with 24 to 36 months of age and not in training, and after 12 months of training, and horses with 36 to 48 months of age in training. Blood samples where collected before and after trot and gallop. Samples where analyzed with a automatic cell counter (Cell-Dyn 3500R, Abbott Diagnostic). Red Blood Cell Distribution width (RDW) values increased significantly after trot and gallop demonstrating a variation in the size of red blood cells, while Packed Medium Cell Volume (VGM) values did not show variations before or after exercise.

Estimativa do padrão de preferência térmica de matrizes pesadas (frango de corte)

Female broiler breeder productivity is based on the principles of thermal comfort that are directly related with the microclimate inside the housing. This research had the objective of monitoring the behavior of female broiler breeders, using the technology of radio-frequency, injectable transponders and readers in different existing microclimates inside a small scale distorted housing model. Eight birds with electronic identification were used. Three readers were used, in three different points inside the model: on the floor of the nest, in the passage besides the lateral wall and below the water facility. Dry bulb (DBT), wet bulb (WBT) and black globe (BGT) temperature were measured continuously. The results point out a distinct behavioral pattern of the birds regarding the environment exposition during the experiment. Three probabilistic models of behavior were developed from the recorded data: probabilistic model for the passage use: FP = 1.10 - 0.244 ln(DBT), probabilistic model for the water facility use: FB = 0.398 + 0.00866(DBT), and probabilistic model for the nest use: FN = 2.22 - 0.272 DBT + 0,011 DBT 2 - 0.000144 DBT 3.

Analysis of the kinetics of phase and amplitude gratings recorded in azopolymer films

In this work we use a stabilized holographic technique to study both refractive index and absorption gratings recorded in thin films made of Disperse Red 1 (DR1) embedded in an organic polymer matrix (PMMA) deposited on glass substrate. Gratings are recorded by linearly polarized illumination with the interference pattern of two crossing beams. One of the beams is phase modulated and the interference signals between the transmitted and diffracted waves are detected by a tuned lock-in amplifier. The technique allows measuring separately changes of the refractive index and the absorption coefficient during the course of the photoreaction process. The time evolution of the diffraction efficiencies during recording has shown bi-exponential kinetics for both gratings. © 2008 American Institute of Physics.

First study of the radiation-amplitude zero in W gamma production and limits on anomalous WW gamma couplings at root s=1.96 TeV

We present results from a study of pp̄→Wγ+X events utilizing data corresponding to 0.7fb-1 of integrated luminosity at s=1.96TeV collected by the D0 detector at the Fermilab Tevatron Collider. We set limits on anomalous WWγ couplings at the 95% C.L. The one-dimensional 95% C.L. limits are 0.49<κγ<1.51 and -0.12<λγ<0.13. We make the first study of the charge-signed rapidity difference between the lepton and the photon and find it to be indicative of the standard model radiation-amplitude zero in the Wγ system. © 2008 The American Physical Society.

Estrutura térmica identificada por transectos móveis e canal termal do Landsat 7 em cidade tropical

This study aims to examine the thermal structure of the urban climate based on the interpretation of the satellite Landsat 7 (thermal channel) and measures for the area. It identifies how the production of urban climate develops based on an analysis of the structure of space forms and characteristics of land use and constructive materials in the generation of heat islands and their implications in environmental comfort in a tropical climate medium size city at Brazil. To check intra-urban air temperature, measures were carried out in mobile transects in the North-South and East-West routes. Thermal Channel data of Landsat-7, were converted to surface values. The results showed that the pattern of urbanization and characteristics of land use are responsible for the distribution of temperature generating heat islands in downtown and popular densely built neighborhoods. In those cases the highest indexes of social segregation added to higher temperature also provokes elevation in the number of illnesses and morbidity cases, mostly of respiratory diseases.

Measurement of phase and amplitude modulations in Sb-Based Films

In this work we studied the changes of the optical constants of films in the binary system Sb2O3-Sb2S3 induced by light in the VIS-UV. The measurements were performed before and after homogeneous irradiation of the films to a Hg lamp and in real time during the holographic exposure of the samples (at 458nm). Changes of the absorption coefficient (amplitude grating) and refractive index (phase grating) were measured simultaneously using the self-diffraction using the holographic setup. Besides the films presented a strong photodarkening effect under homogeneous irradiation, the samples holographically exposed presented only refractive index modulations. None amplitude modulation was measured in real time for spatial frequencies of about 1000 l/mm. © 2009 SPIE.

The overall coefficient of the two-loop superstring amplitude using pure spinors

Using the results recently obtained for computing integrals over (non-minimal) pure spinor superspace, we compute the coefficient of the massless two-loop four-point amplitude from first principles. Contrasting with the mathematical difficulties in the RNS formalism where unknown normalizations of chiral determinant formulæ force the two-loop coefficient to be determined only indirectly through factorization, the computation in the pure spinor formalism can be smoothly carried out. © SISSA 2010.

Metodologia para análise da dependência térmica da germinação pelo modelo de grausdia

The effects of temperature on the rate of biological processes such as the germination are reported in several papers. The analysis of the thermal effect can be performed either from numerical indices or germination curves, which is usually presented as the accumulated percentage of germination versus time. Such curves can be fitted by empirical models and generally they offer a better description of the time-course of germination than single-value indices. On the other hand, in analyzing the germination curves, a question arises whether the model parameters have biological meaning. Thus, it is desirable that the model parameters both describe properly the germination curve and have biological meaning, which often does not occur. Considering the involvement of populations and percentages in germination assays, an analytical model has been widely used in the last two decades which is based on the concept of thermal time. This article discusses the conceptual basis and provides procedures for applying the thermal-time model in germination studies by using the probit regression method, both at infra and supra-optimal temperatures.

Aspectos taxonômicos e amplitude ecológica de Schizomeris leibleinii (Chaetophorales, chlorophyta)

Pós-graduação em Ciências Biológicas (Biologia Vegetal) - IBRC