Density, d18O and accumulation rates from snow pits on the Filchner-Ronne Ice Shelf

Accumulation rates in the eastern part of Ronne Ice Shelf were determined by isotopic stratigraphy (18O). The samples were taken from snow-pits dug during the Filchner I and II operations in 1984 and 1986. In general, the accumulation rate decreases towards the south; the greatest decrease, from 21.3 to 13.3 g/cm**2/a, was observed between Filchner Station and measuring point 341, sited 270 km up-stream of the ice edge. The d18O values of the near-surface layers vary between -25 and -29 per mil. The 18O content in the more southerly part is progressively depleted in the direction of Möllereisstrom, paralleling a decrease in the accumulation rate. Near the ice edge the 18O content decreases to the west. A 100 m ice core drilled in 1984 at point 340, 22 km from the ice edge, probably goes back to A.D. 1460; it has been dated by isotopic stratigraphy. The accumulation rate up-stream of the drilling site was deduced from the sequence of annual layers, using a simple ice-flow model. The accumulation shows strong variations over the last 200 years, which may be caused in part by local variations in the accumulation on Ronne Ice shelf.

14C ages of core top samples from Ontong-Java Plateau

Radiocarbon measurements on core tops from the Ontong-Java plateau confirm a previous finding by Berger and Killingley [1982] that at any given water depth, cores taken on the equator have higher accumulation rates and younger core top ages than their off-equator counterparts. Further, these new results fortify the conclusion by Broecker et al. [1991] that the increase in core top radiocarbon age with water depth rules out homogeneous dissolution within the pore waters as the dominant mechanism. Either most of the dissolution must occur prior to burial or it must occur during the first pass through the respiration-CO2-rich upper pore waters after which the calcite grains become armored against further dissolution. A puzzling aspect of this new data set is that despite the sizable difference in accumulation rate, the extent of dissolution as measured by either the CaCO3 content or the ratio of CaCO3 in the >150-µm size fraction to that in the < 63-µm fraction is no different off than on the equator. In order to reconcile the results of this study with those obtained by Hales and Emerson [1996] using in situ electrodes, it is necessary to call upon calcite armoring.

Chemical composition and accumulation rates of chemical elements in metalliferous sediments from axial zones of the East Pacific Rise and the Mid-Atlantic Ridge

In the monograph metalliferous sediments of the East Pacific Rise near 21°S are under consideration. Distribution trends of chemical, mineral and grain size compositions of metalliferous sediments accumulated near the axis of this ultrafast spreading segment of the EPR are shown. On the basis of lithological and geochemical investigations spatial and temporal variations of hydrothermal activity are estimated. Migration rates of hydrothermal fields along the spreading axis are calculated. The model of cyclic hydrothermal process is suggested as a result of tectono-magmatic development of the spreding centre.

Grain size analyses, Ca/Ti and other selected elemental ratios from XRF core scanning of sediment cores from the Apulian Margin

An extensive, high-resolution, sedimentological-geochemical survey was done using geo-acoustics, XRF-core scans, ICP-AES, AMS 14C-dating and grain size analyses of sediments in 11 cores from the Gulf of Taranto, the southern Adriatic Sea, and the central Ionian Sea spanning the last 16 cal. ka BP. Comparable results were obtained for cores from the Gallipoli Shelf (eastern Gulf of Taranto), and the southern Adriatic Sea suggesting that the dominant provenance of Gallipoli Shelf sediments is from the western Adriatic mud belt. The 210Pb and 14C-dated high-accumulation-rate sediments permit a detailed reconstruction of climate variability over the last 16 cal. ka BP. Although, the Glacial-Interglacial transition is generally dry and stable these conditions are interrupted by two phases of increased detrital input during the Bølling-Allerød and the late Younger Dryas. The event during the Younger Dryas period is characterized by increased sediment inputs from southern Italian sources. This suggests that run-off was higher in southern- compared to northern Italy. At approximately ~ 7 cal. ka BP, increased detrital input from the Adriatic mud belt, related to sea level rise and the onset of deep water formation in the Adriatic Sea, is observed and is coincident with the end of sapropel S1 formation in the southern Adriatic Sea. During the mid-to-late Holocene we observed millennial-scale events of increased detrital input, e.g. during the Roman Humid Period, and of decreased detrital input, e.g., Medieval Warm Period. These dry/wet spells are consistent with variability in the North Atlantic Oscillation (NAO). A negative state of the NAO and thus a more advanced penetration of the westerlies into the central Mediterranean, that result in wet conditions in the research area concord with events of high detrital input e.g., during the Roman Humid Period. In contrast, a positive state of the NAO, resulting in dry conditions in the Mediterranean, dominated during events of rapid climate change such as the Medieval Warm Period and the Bronze Age.

Geochemistry, sediment components, and paleoproductivity reconstruction for the Miocene to early Pliocene sediments

We reconstruct paleoproductivity at three sites in the Atlantic Ocean (Ocean Drilling Program Sites 982, 925, and 1088) to investigate the presence and extent of the late Miocene to early Pliocene 'biogenic bloom' from 9 to 3 Ma. Our approach involves construction of multiple records including benthic foraminiferal and CaCO3 accumulation rates, Uvigerina counts, dissolution proxies, and geochemical tracers for biogenic and detrital fluxes. This time interval also contains the so-called late Miocene carbon isotope shift, a well-known decrease in benthic foraminiferal d13C values. We find that the timing of paleoproductivity maxima differs among the three sites. At Site 982 (North Atlantic), benthic foraminifera and CaCO3 accumulation were both at a maximum at ~5 Ma, with smaller peaks at ~6 Ma. The paleoproductivity maximum was centered earlier (~6.6-6.0 Ma) in the tropical Atlantic (Site 925). In the South Atlantic (Site 1088), paleoproductivity increased even earlier, between 8.2 Ma and 6.2 Ma, and remained relatively high until ~5.4 Ma. We note that there is some overlap between the interval of maximum productivity between Sites 925 and 1088, as well as the minor productivity increase at Site 982. We conclude that the paleoproductivity results support hypotheses aiming to place the biogenic bloom into a global context of enhanced productivity. In addition, we find that at all three sites the d13C shift is accompanied by carbonate dissolution. This observation is consistent with published studies that have sought a relationship between the late Miocene carbon isotope shift and carbonate preservation.