Downwelling solar irradiance, upwelling solar radiance, sky leaving radiance, and cloud cover observed during ARCHEMHAB study (on Maria S. Merian Leg MSM21/3) from 2012-07-26 to 2012-08-10

The need to obtain ocean color essential climate variables (OC-ECVs) using hyperspectral technology has gained increased interest in recent years. Assessing ocean color on a large scale in high latitude environments using satellite remote sensing is constrained by polar environmental conditions. Nevertheless, on a small scale we can assess ocean color using above-water and in-water remote sensing. Unfortunately, above-water remote sensing can only determine apparent optical properties leaving the sea surface and is susceptible to near surface environmental conditions for example sky and sunglint. Consequently, we have to rely on accurate in-water remote sensing as it can provide both synoptic inherent and apparent optical properties of seawater. We use normalized water leaving radiance LWN or the equivalent remote sensing reflectance RRS from 27 stations to compare the differences in above-water and in-water OC-ECVs. Analysis of above-water and in-water RRS spectra provided very good match-ups (R2 > 0.97, MSE<1.8*10**-7) for all stations. The unbiased percent differences (UPD) between above-water and in-water approaches were determined at common OC-ECVs spectral bands (410, 440, 490, 510 and 555) nm and the classic band ratio (490/555) nm. The spectral average UPD ranged (5 - 110) % and band ratio UPD ranged (0 - 12) %, the latter showing that the 5% uncertainty threshold for ocean color radiometric products is attainable. UPD analysis of these stations West of Greenland, Labrador Sea, Denmark Strait and West of Iceland also suggests that the differences observed are likely a result of environmental and instrumental perturbations.

210Pb and AMS radiocarbon dates of sediment cores JM99-1197 and JM02-59 obtained in Malangen

A high-resolution sedimentary record from the subarctic Malangen fjord in northern Norway, northeastern North Atlantic has been investigated in order to reconstruct variations in influx of Atlantic Water for the last 2000 years. The fjord provides a regional oceanographic climatic signal reflecting changes in the North Atlantic heat flux at this latitude because of its deep sill and the relatively narrow adjoining continental shelf. The reconstructions are based on oxygen and carbon isotopic studies of benthic foraminifera from a high accumulation basin in the Malangen fjord, providing subdecadal time resolution. A comparison between instrumental measurements of bottom water temperatures at the core location and the reconstructed temperatures from benthic foraminiferal d18O for the same time period demonstrates that the stable isotope values reflect the bottom water temperatures very well. The reconstructed temperature record shows an overall decline in temperature of c. 1°C from c. 40 BC to ad 1350. This cooling trend is assumed to be driven by an orbital forced reduction in insolation. Superimposed on the general cooling trend are several periods of warmer or colder temperatures. The long-term fluctuations in the Malangen fjord are concurrent with fluctuations of Atlantic Water in the northern North Atlantic. Although they are not directly comparable, comparisons of atmospheric temperatures and marine records, indicate a close coupling between the climate systems. After ad l800 the record shows an unprecedented warming within the last 2000 years.

Compressional and shear wave velocities and elastic constants at DSDP Leg 59 Holes

Prior to the Deep Sea Drilling Project the composition of the oceanic crust could only be inferred from seismic-refraction and gravity data and the recovery of a wide variety of dredged rocks. Through the success of the Deep Sea Drilling Project, it is now clear that the top of oceanic Layer 2 usually consists of basalt. Several laboratory studies (e.g., Fox et al., 1972; Christensen and Shaw, 1970; Hyndman and Drury, 1976) have demonstrated that the seismic velocities of oceanic basalt are similar to velocities reported from refraction studies of Layer 2 and that the variability in Layer 2 velocities has many causes, the most important being fracturing and sea-floor alteration produced by the interaction of basalt and sea water (Christensen and Salisbury, 1973). To date, most reported measurements of velocities in oceanic basalts are from samples obtained from the main ocean basins. With the exception of an earlier study of velocities and related elastic properties of a suite of rocks from DSDP Sites 292, 293, 294, and 296 located in the Philippine Sea (Christensen et al., 1975; Fountain et al., 1975), elastic properties have not been determined for oceanic rocks from marginal basins. In this chapter compressional- and shear-wave velocities and elastic constants are reported at elevated confining pressures for basalt and volcanic breccias from Holes 447A, 448, and 448A.

Mineralogical composition, copper and d18O at DSDP Site 59-448

Alteration in a submarine remnant volcanic arc should leave an important record of (1) the mineralogy of sea water-volcanic arc rock interaction; (2) the chemistry of solid reaction products; (3) the isotopic characteristics of such reactions (Muehlenbachs and Clayton, 1972; Spooner, Beckinsale, et al , 1977; Spooner, Chapman, et al., 1977); (4) the metallogenesis within such a sequence (Mitchell and Bell, 1973); and (5) the geothermal gradient during the alteration. The volcaniclastic breccias, tuffs, and igneous units of Sites 448 (993 m) and 451 (930.5 m) on the Palau-Kyushu and West Mariana ridges, respectively, are particularly suited for such studies because the thick sequences have remained submarine throughout their history, seemingly unaffected by magmatic or hydrothermal events after cessation of volcanic activity. Also, shipboard observations indicated a change in alteration products with depth. At both sites the igneous units and volcaniclastic rocks were altered to brownish clays and zeolites near the top of the volcanic sequence; to bright blue green clays and zeolites at moderate depths; and to very dark, nearly opaque, forest green clays and zeolites at still greater depths. Native copper occurs both as disseminated pockets in the volcaniclastic breccias and vesicular basalts and as veins in the breccias; native copper is restricted to stratigraphic levels characterized by the absence of sulfides or oxides of copper and iron. Although some native copper is found in vesicles of basalts and may be orthomagmatic, most of it is clearly secondary. Near dikes and sills, higher sulfur fugacity conditions caused the precipitation of iron and copper sulfides with an absence of native copper (Garrels and Christ, 1965). The occurrence of native copper may be an initial stage of Cu metallogenesis that forms porphyry coppers in island arcs (Mitchell and Bell, 1973). This study will address primarily the possibility that hydrothermal sea water interaction with volcanic arc rocks has created the mineralogical and isotopic zonation in Leg 59 cores. Hydrothermal activity can be expected in a rapidly growing island arc and is probably the result of a high geothermal gradient prevalent during arc magmatic activity. The chemical character of the alteration is further discussed by Hajash (1981).