Methanol and ethanol analysis in marine sediment pore water

Low-molecular-weight (LMW) alcohols are produced during the microbial degradation of organic matter from precursors such as lignin, pectin, and carbohydrates. The biogeochemical behavior of these alcohols in marine sediment is poorly constrained but potentially central to carbon cycling. Little is known about LMW alcohols in sediment pore waters because of their low concentrations and high water miscibility, both of which pose substantial analytical challenges. In this study, three alternative methods were adapted for the analysis of trace amounts of methanol and ethanol in small volumes of saline pore waters: direct aqueous injection (DAI), solid-phase microextraction (SPME), and purge and trap (P&T) in combination with gas chromatography (GC) coupled to either a flame ionization detector (FID) or a mass spectrometer (MS). Key modifications included the desalination of samples prior to DAI, the use of a threaded midget bubbler to purge small-volume samples under heated conditions and the addition of salt during P&T. All three methods were validated for LMW alcohol analysis, and the lowest detection limit (60 nM and 40 nM for methanol and ethanol, respectively) was achieved with the P&T technique. With these methods, ambient concentrations of volatile alcohols were determined for the first time in marine sediment pore waters of the Black Sea and the Gulf of Mexico. A strong correlation between the two compounds was observed and tentatively interpreted as being controlled by similar sources and sinks at the examined stations.

Geochemical analysis of bulk sediment and interstitial water of sediment cores from the North-West African continental margin

Molybdenum and vanadium were analysed in 9 scediment cores recovered from the continental slope and rise off NW Africa. Additionall chemical and sedimentological parameters as well as isotope stage boundaries were available for the same core profiles from other investigations. Molybdenum, ranging between <1 and 10 ppm, occurs in two associateions, either with organic carbon and sulphides in sediments with reducing conditions or with Mn oxides in oxidized near-surface core sections. Highest values (between 4 and 10 ppm Mo) are found in sulphide-rich core sections deposited during glacial times in a core from 200 m water depth. The possibility of anoxic near-bottom water conditions prevailing at thhis site during certain glacial intervals is discussed. In oxidized near-surface core sections, the diagenetic mobility of Mo becomes evident from strong Mo enrichment together with Mn oxides (values up to 4 ppm Mo). This enrichment is probably due to coprecipitation and/or adsorption of Mo from interstitial water to the diagenetically forming Mn oxides. The close relation between Mo and Corg results in strongly covarying sedimentation rates in both components reaching up to 10 times the rates in glacial compared to interglacial core sections. Vanadium (values between 20 and 100 ppm) does not show clear relations to climate and near-bottom or sediment milieu. It occurs mainly bound to the fine grained terrigenous fraction, associated with aluminium silicates (clay minerals) and iron oxides. Additionally positive covariation of vanadium with phosphorus in most core profiles suggest that some V may be bound to phosphates.