974 resultados para Metals in sediments
Resumo:
Eight different sites from 2300 to 4420 m water depth in the Arabian Sea were sampled for a biochemical quantification of phospholipid concentrations in the sediments. This method serves as a measure of microbial biomass in marine sediments comprising all small-sized organisms, including bacteria, fungi, protozoa and metazoa. Phospholipid concentrations can be converted to carbon units as an estimate of total microbial biomass in the sediments. The average phospholipid concentrations in the surface sediments (0-1 cm) of the 4 abyssal sites ranged from 7 nmol cm?3 at the southern site (SAST, 10°N 65°E, 4425 m) to 29 nmol/cm**3 at the western site (WAST, 16°N 60°E, 4045 m). The high values detected at the abyssal station WAST exceeded those in the literature for other abyssal sites and were comparable to values from the upper continental slope of the NE-Atlantic and the Arctic. At the four continental slope sites in the Arabian Sea, average phospholipid concentrations ranged from 9 to 53 nmol/cm**3 with the maximum values at stations A (2314 m) and D (3142 m) close to the Omani coast. Records of particulate organic carbon flux to the deep sea are available for four of the investigated locations, allowing a test of the hypothesis that the standing stock of benthic microorganisms in the deep sea is controlled by substrate availability, i.e. particle sedimentation. Total microbial biomass in the surface sediments of the Arabian Sea was positively correlated with sedimentation rates, consistent with previous studies of other oceans. The use of the measurement of phospholipid concentrations as a proxy for input of particulate organic matter is discussed.
Resumo:
Originally, we had planned to piston core at Site 595 in order to meet the sedimentologic and biostratigraphic objectives outlined in the introductory chapter. However, consultation with our colleagues, Thomas Jordan and John Orcutt on board Melville, indicated that coring near the ocean bottom seismometer (OBS) array around Hole 595B could alter the programmed signal to noise ratio above which teleseisms trigger recording in the OBSs. They requested that we core no closer than about 8 km from three OBSs nearest Hole 595B, and selected a target for us about that distance to the west. Since a new beacon was required at this distance, a new site number, 596, was designated. Briefly, we planned to obtain oriented hydraulic piston cores to the top of the cherts, then core through the cherts using the extended core barrel (XCB) to basement. With improved recovery, we hoped to reach the sediment/basalt contact, and thus obtain a reliable biostratigraphic determination of the basement age. We planned to obtain at least one core in basement, perhaps more, with time permitting. We planned no geophysical program for the hole.
Resumo:
Interstitial water samples from Leg 129, Sites 800, 801, and 802 in the Pigafetta and Mariana basins (central western Pacific), have been analyzed for major elements, B, Li, Mn, Sr, and 87Sr/86Sr. At all sites waters show enrichment in Ca and Sr and are depleted in Mg, K, Na, SO4, B, alkalinity, and 87Sr compared to seawater. These changes are related to alteration of basaltic material into secondary smectite and zeolite and recrystallization of biogenic carbonate. Water concentration depth profiles are characterized by breaks due to the presence of barriers to diffusion such as chert layers at Sites 800 and 801 and highly cemented volcanic ash at Site 802. In Site 800, below a chert layer, concentration depth profiles are vertical and reflect slight alteration of volcanic matter, either in situ or in the upper basaltic crust. Release of interlayer water from clay minerals is likely to induce observed Cl depletions. At Site 801, two units act as diffusion barrier and isolate the volcaniclastic sediments from ocean and basement. Diagenetic alteration of volcanic matter generates a chemical signature similar to that at Site 800. Just above the basaltic crust, interstitial waters are less evolved and reflect low alteration of the crust, probably because of the presence in the sediments of layers with low diffusivities. At Site 802, in Miocene tuffs, the chemical evolution generated by diagenetic alteration is extreme (Ca = 130 mmol, 87Sr/86Sr = 0.7042 at 83 meters below seafloor) and is accompanied by an increase of the Cl content (630 mmol) due to water uptake in secondary hydrous phases. Factors that enhance this evolution are a high sediment accumulation rate, high cementation preventing diffusive exchange and the reactive composition of the sediment (basaltic glass). The chemical variation is estimated to result in the alteration of more than 20% of the volcanic matter in a nearly closed system.
Resumo:
Volatile C1-C7 components in sediments were examined for Japan Trench DSDP Sites 438, 439, 435, 440, 434 and 436, proceeding from west to east. Levels of all components are lowest in the highly fractured sediments of Sites 440 and 434. A number of alkenes, furans, and sulfur compounds were detected in concentrations higher than noted in any other DSDP sediments examined to date. The types, amounts, and specificity of occurrence are similar to those for 1-meter gravity cores we have examined which bear a significant biological imprint. Site 436 shows high levels of saturated and aromatic hydrocarbons, as well as olefins, including traces of dimethycyclopentanes and the highest level of cyclohexene detected in any DSDP sediment we have examined to date. The results from Site 436 were unexpected, considering the low organic-carbon content, absence of biogenic methane, and evidence of an aerobic depositional environment at this site.
Resumo:
Carbon isotopic data of interstitial dissolved CO2 (CO2), CO2 gas, and methane show that a variety of microbial diagenetic processes produce the observed isotopic trends. Anaerobic methane oxidation (AMO) is an important process near the sulfate-methane interface (SMI) that strongly influences the isotopic composition of CO2 in the sulfate reduction and upper methanogenic zones, which in turn impacts methane isotopic composition. Dissolved CO2 and methane are maximally depleted in 13C near the SMI, where 13C values are as light as -31.8 and -101 PDB for CO2 and methane, respectively. CO2 reduction links the CO2 and methane pools in the methanogenic zone so that the carbon isotopic composition of both pools evolves in concert, generally showing increasing enrichments of 13C with increasing depth. These isotopic trends mirror those within other methane-rich continental rise sediments worldwide.