Iron in the Sargasso Sea

We report iron measurements for water column and aerosol samples collected in the Sargasso Sea during July-August 2003 (summer 2003) and April-May 2004 (spring 2004). Our data reveal a large seasonal change in the dissolved iron (dFe) concentration of surface waters in the Bermuda Atlantic Time-series Study region, from ~1-2 nM in summer 2003, when aerosol iron concentrations were high (mean 10 nmol/m**3), to ~0.1-0.2 nM in spring 2004, when aerosol iron concentrations were low (mean 0.64 nmol/m**3). During summer 2003, we observed an increase of ~0.6 nM in surface water dFe concentrations over 13 days, presumably due to eolian iron input; an estimate of total iron deposition over this same period suggests an effective solubility of 3-30% for aerosol iron. Our summer 2003 water column profiles show potentially growth-limiting dFe concentrations (0.02-0.19 nM) coinciding with a deep chlorophyll maximum at 100-150 m depth, where phytoplankton biomass is typically dominated by Prochlorococcus during late summer.

Dissolved iron measurements from 32 stations in the Central Arctic Ocean and Arctic Shelf Sea during POLARSTERN expedition ARK-XXII/2

Concentrations of dissolved (<0.2 µm) Fe (DFe) in the Arctic shelf seas and in the surface waters of the central Arctic Ocean are presented. In the Barents and Kara seas, near-surface DFe minima indicate depletion of DFe by phytoplankton growth. Below the surface, lower DFe concentrations in the Kara Sea (~0.4-0.6 nM) than in the Barents Sea (~0.6-0.8 nM) likely reflect scavenging removal or biological depletion of DFe. Very high DFe concentrations (>10 nM) in the bottom waters of the Laptev Sea shelf may be attributed to either sediment resuspension, sinking of brine or regeneration of DFe in the lower layers. A significant correlation (R2 = 0.60) between salinity and DFe is observed. Using d18O, salinity, nutrients and total alkalinity data, the main source for the high (>2 nM) DFe concentrations in the Amundsen and Makarov Basins is identified as (Eurasian) river water, transported with the Transpolar Drift (TPD). On the North American side of the TPD, the DFe concentrations are low (<0.8 nM) and variations are determined by the effects of sea-ice meltwater, biological depletion and remineralization and scavenging in halocline waters from the shelf. This distribution pattern of DFe is also supported by the ratio between unfiltered and dissolved Fe (high (>4) above the shelf and low (<4) off the shelf).

(Table 1) Composition of manganese-iron accumulates in the Kiel Bay, western Baltic Sea

Manganese-iron accumulates in the Kiel Bay were investigated with regard to their occurence, chemical composition and formation. Three morphologically different types were identified: a) growth on mussels, b) spherical nodules (ca. 1-3 cm) and c) disshaped symetrical and asymetrical nodules (up to 10 cm). Average values from 110 accumulates representing the three types were: Mn 29.3%, Fe 10.0%, Co 77 ppm, Ni 97 ppm, Cu 21 ppm and Zn 340 ppm. Accumulates on mussels showed the highest trace metal concentrations. A growth rate of ca. 0.6 mm/yr for type (a) was estimated. Heavy metal concentrations were determined in ca. 60 sediment and 30 pore water samples, and in 110 Baltic sea water samples. During certain periods, large increases in Mn values (up to 400 (µg/l) were found in the deeper waters. These concentrations develop during periods of strong stagnant conditions in the sediments where dissolution of Mn oxides, and diffusion mobilizes the Mn into the overlying waters. The manganese is then reprecipitated close to the boundary of the O2-enriched surface waters. This critical O2-concentration was found to be 40% saturation. In the Kiel Bay, Mn-Fe-accumulates are found in a zone which marks the upper limit sometimes reached by the deep waters of lower O2-concentration. Additionally, the availability of larger particles (especially stones or mussels) on the sediment surface is necessary. These conditions are met in the Kiel Bay in a water depth of 20-28 m at several places.

Pore water and solid phase sulfur, carbon and iron data from samples collected in the Argentine Basin during expedition M78

Sulfur phases in the Argentine Basin.