Efeitos da idade dos frutos, método e condição de secagem sobre a qualidade de sementes de quiabeiro. II. Cultivar Amarelinho

Fruits of okra (Abelmoschus esculentus (L.) Moench.) cv. Amarelinho were harvested at three times: 35, 45 and 55 days after anthesis. Half part of the fruits of each harvest time was shelled and the seeds were dried in natural environment of laboratory or in dry chamber. The other half was dried unshelled in the same two conditions. Water contents of seeds were evaluated at harvest time and before the germination test, that was carried out when the seeds were in hygroscopic equilibrium with the two environments. The physiological quality of seeds was affected by the interaction effects of fruit age, drying method and drying condition. The highest values for percentage of germination were obtained from seeds taken from fruits 55 days old (up to 92%) and the hard seeds percentage was not affected by drying method and drying condition. The seeds from fruits of 35 and 45 days old had the germination percentage increased when dried inside the fruit in natural environment.

Variação da massa específica da madeira de Eucalyptus grandis aos 8 anos de idade em função de diferentes níveis de produtividade

It were analyzed Eucalyptus grandis trees of 8 years old in the forest group of Duraflora S/A, with different annual increments based on volume, to the related studies of specific gravity values based on productivity indexes. The methodology used in analysis of specific gravity was the gamma-ray attenuation technique of Americium-241. The Eucalyptus grandis showed a specific gravity decreasing with the increasing of parcel productivity. For a gain of 3,5 m3 in productivity there was a decreasing of 1% in specific gravity. Nevertheless, it was not observed correlation between specific gravity and basal area in a same parcel. The present work stands out too, some of the difficulties found with relation to wood specific gravity determinations and emphasize the importance of take samples in the form of full rounded plates in three or four relative positions in the tree.

Influência de cinco temperaturas de secagem no rendimento e composição do óleo essencial de citronela (Cymbopogon winterianus Jowitt)

The Influence of Drying Temperatures on the Yield Composition of Citronella (Cymbopogon winterianus Jowitt) essential oil. The studies were carried out to establish more precise parameters for citronella (C. winterianus Jowitt) post-harvest, and to optimize drying time and essential oil quantitative/qualitative yield. Five treatments were designed (30°C, 40°C, 50°C, 60°C and 70°C), with 14 repetitions of the drying process and 12 of the essential oil extraction. Drying at 60°C gave the best results for drying time (48 hours until weight stabilization), and also for extracted oil quantity (1.228 ± 0.127% over dry weight). Essential oil content showed high quantitative variations. The main compound found was neral, except in the 50°C treatment, where citronelal was the main compound.

Caracterização textural e estrutural de V 2O 5/TiO 2 obtidos via sol-gel: Comparação entre secagem convencional e supercrítica

This work describes a modified sol-gel method for the preparation of V 2O 5/TiO 2 catalysts. The samples have been characterized by N 2 adsorption at 77K, x-ray diffractometry (XRD) and Fourier Transform Infrared (FT-IR). The surface area increases with the vanadia loading from 24 m 2 g -1, for pure TiO 2, to 87 m 2 g -1 for 9wt.% of V 2O 5. The rutile form is predominant for pure TiO 2 but became enriched with anatase phase when vanadia loading is increased. No crystalline V 2O 5 phase was observed in the catalysts diffractograms. Two species of surface vanadium observed by FT-IR spectroscopy a monomeric vanadyl and polymeric vanadates, the vanadyl/vanadate ratio remains practically constant.

Geogenic factors affecting the selenium(IV) distribution in sediments from Madeira River Basin, Brazil

This investigation was carried out at the Madeira River basin, located in the state of Rondônia, Brazilian Amazon. Sediments from Madeira River between Teotônio and Santo Antônio waterfalls along 25 km upstream from Porto Velho, the capital of Rondônia state, and from nine lakes located around Porto Velho municipality were chemically analyzed for Se (IV) in order to evaluate the main factors affecting the Se(IV) distribution in the environment, Selenite ion was chosen to investigate the selenium behavior in the area, because acid conditions are dominant there. The importance of clays, iron oxides, organic matter and minor refractory minerals was considered in order to explain most of the obtained data.

Propriedades de contração na madeira juvenil e adulta de Pinus taeda L.

This paper had the objective of studying variability of radial, tangential, longitudinal and volumetric shrinkage between the juvenile and mature wood, from a 35 year-old Pinus taeda L., from Horto Florestal of Manduri at São Paulo State, Brazil. First of all the experimental program determinations were related to the juvenile wood, region of the transition and region of the mature wood, using anatomical analysis (length of the axial tracheids), according to ABNT and IAWA codes. Results had shown that the area of juvenile wood of this species occurs approximately until the 20th growth ring, being more representative until the 12th ring. The transition area of this wood occurs between the 12th and 20th growth ring. In the second part of the work the shrinkage of the juvenile and mature wood were evaluated. Values of the radial, tangential and volumetric shrinkage were smaller and more variable on the juvenile wood. The longitudinal shrinkage did not present significant differences between the two wood types; medium values were slightly inferior and very variable on juvenile wood related to mature wood.

Retratibilidade da madeira de Pinus caribæa var. hondurensis e de Eucalyptus grandis e suas relações com a umidade e densidade

It had been studied the dimensional variations Pinus caribæa var. hondurensis and Eucalyptus grandiswood, emphasizing the axial, radial, tangential and volumetric shrinkage. The results had shown that the volumetric shrinkage of Pinus and Eucalyptus varied according to an exponential curve, R V=R Vmaxe -ku. The total or maximum volumetric shrinkage showed a linear behavior with the specific gravity on basis of ovendry mass and volume and the same behavior as respect of the specific gravity, where the adjusted equations were, respectively: R vmax = 3,01 + 19,15,oo e R vmax = 1,96 + 24,28,ob. It was also verified that the tangential shrinkage was 1,3 times greater than the radial one and 9,0 times greater than the axial one.

Parâmetros genéticos para caracteres de crescimento, de produção e tecnológicos da madeira em clones de Eucalyptus spp

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Mensuração do comprimento das fibras para a determinação da madeira juvenil em Eucalyptus citriodora

The juvenile wood has peculiar characteristics from the anatomical structure and physical-mechanical properties, considering these aspects the knowledge of the wood is essential for wood adequate utilization. The aim of this work was to determinate the zone of juvenile wood of pith-bark direction in Eucalyptus citriodora. The juvenile and mature wood zones were determined across fiber length measurement in various height in the tree stem. Results showed that juvenile wood zone occurs approximately up to the 45 at 55 mm from the pith.

Influência da posição diametral das tábuas e da vaporização nos defeitos de secagem de Eucalyptus grandis

This study evaluated the Eucalyptus grandis drying defects acting on boards diametrical position and on log steaming. Half of the logs, with diameter from 20 to <25, 25 to <30 and 30 to <35cm, were steamed during 20 hours at 90°C of temperature. Subsequently, the logs (control and steamed) were sawn. The boards were dried in the dry-kiln pilot and the resulting defects from the drying process were measured. The results indicate that: (1) the boards coming from control logs presented different magnitude defects in function of the diametrical position. The split and spring to increase in direction to pith, the bow to increase in direction to bark and cupping were bigger in intermediary boards; (2) the boards coming from steamed logs presented a reduction from drying defects in function of logs diameter and its more homogeneous index in the pith-bark direction.

Otimização da distância de extração de madeira com forwarder

The activities and management operations of wood harvesting do not have good computational tools available to help the forest technicians with the task of cost reduction. In many cases, machines of high investment are used in wood harvesting without adequate operation planning; consequently, the cost per hour of these machines, which is high, could be reduced. Using technological resources such as the Geographic Information Systems (GIS) integrated with the Global Positioning System (GPS), which are the basis of precision harvesting. In this research, a technological tool capable of calculating and optimizing the average skidding distance of the forwarder was developed. It was used in stands of different sizes and formats through mathematical techniques and available functionalities in the Geographic Information System GRASS. The developed tool, called optimized model, divides the stand in small parts in relation to shorter skidding distances. The main variable considered was the alignment of plantation. The model was tested in eucalypt stands located in the State of São Paulo. Sixteen stands were randomly selected: eight with a rectangular polygon form, and eight with irregular polygon form. The main variables were collected in these stands. Results showed that the optimized model developed, is efficient and flexible. It was possible to divide the stands in small parts resulting in smaller skidding medium distances. The stands with irregular form had shorter skidding medium distances than the rectangular stands.

Energia de briquetes produzidos com rejeitos de resíduos sólidos urbanos e madeira de Eucalyptus grandis

The incentive for consumption and production in large quantity in modern society generates enormous amounts of urban solid residues in the form of municipal solid waste (MSW). With the intention of reducing these residues of the municipal waste tips and to generate energy, briquettes with mixtures of MSW and residues of Eucalyptus grandis were produced. The briquettes were manufactured with 0, 5, 10, 15, 20 and 25% of MSW in the mixture with wood waste and 12% of moisture content. The analyzed parameters used to choose the best treatments were combustion analysis versus ash content, mechanical strength and energy content. The briquettes up to 10% of MSW showed low resistance, and above 15% showed large increase in ash content. Therefore, the treatment that fulfilled the requirements for combustion versus ash content and mechanical resistance was of at least 15% of MSW, since the source of the ash is unidentified. Considering the net energy content, the best treatment was 25% of MSW, with 17,175 kJ kg-1. Nevertheless, it is strongly advised that further studies related to gas emissions are necessary.

Variação genética para caracteres anatômicos e retração volumétrica e sua correlação com a densidade básica da madeira em uma população base de Eucalyptus camaldulensis Dehn

Eucalyptus camaldulensis has great importance in Brazil because of their phenotypic plasticity for different environmental conditions, as soils, altitudes and rainfall. This study is an investigation of a base population of E. camaldulensis from Australia through a progeny test implanted in Selvíria, MS. The trial was established in a randomized block design, with 25 families and 60 replications of single tree plots. Genetic parameters for anatomic traits and volume shrinkage were estimated, as well as their correlations with wood basic density. No significant differences among progenies were observed for the traits studied. The additive genetic variation coefficient at individual and among progeny levels ranged from low (0.26%) to high (16.98%). The narrow sense heritability at individual and family means levels also ranged from low (0.01) to high (0.87). This indicates that some traits are under strong genetic control and can be improved by selection. In the present situation, in order to attain the highest genetic gains, the sequential selection among and within progeny would be recommended.

Variação genética para caracteres silviculturais e anatômicos da madeira em progênies de Myracrodruon urundeuva (Engler) Fr. Allem

The aims of this study were to evaluate the variation and to estimate genetic parameters for silvicultural anatomic wood traits for genetic breeding of a Myracrodruon urundeuva (Engler) Fr. Allem, population from Selvíria-MS. For this, from samples of a progeny test established in the Fazenda de Ensino, Pesquisa e Extensão da Faculdade de Engenharia de Ilha Solteira/UNESP, macroscopic anatomic wood traits of M. urundeuva (tangential diameter and vases frequency per mm2) and growth traits were measured (height, DBH and stem form). Genetic parameters were estimated in 28 open-pollinated progenies, in three replications and 10 plants per plot, using a REML/BLUP approach. Between the analysed traits, the DBH is the most indicated for selection for timber production, because it presented the highest values of coefficient of genetic variation, heritabilities and selective accuracy. Between the anatomic traits, the vessels frequency in the pith showed the highest values for genetic parameters. For pulp yield, based on the multi-effect index, the strategy of selecting the best trees for vessels frequency in the pith, independent of the progeny, permitted to obtain substantial gains by mass selection, without progeny test.

Influência do cancro basal em Eucalyptus grandis nas propriedades da madeira e polpação kraft

The objective of this research is to assess the influences of basal canker on wood properties for the kraft pulp production. The material consisted of seeded E. grandis trees classified into 4 levels of basal canker severity (0, 1, 2 and 3) and installed in three soil types classified by texture (AQ1 and AQ2 - 10 to 15% clay, and LEm2 - 26 to 35 clay). The sampling consisted of randomly selecting five trees for each for each canker severity level and soil type, totaling 60 trees (4 canker levels x 3 soil types x 5 trees). These trees were fallen and cut into sections at 0, 25, 50, 75 and 100% of the commercial height for the collection of disk and logs of wood. The results showed that the soil texture influences in the Eucalyptus canker severity and this fact should be considered when assessing the wood properties and their final destination. The texture of the soil and the severe levels of basal canker influence the wood properties, and therefore the kraft pulping.