964 resultados para CONSUMER PRODUCTS
Resumo:
Isothermal calorimetry has been used to examine the effect of thermodynamic non-ideality on the kinetics of catalysis by rabbit muscle pyruvate kinase as the result of molecular crowding by inert cosolutes. The investigation, designed to detect substrate-mediated isomerization of pyruvate kinase, has revealed a 15% enhancement of maximal velocity by supplementation of reaction mixtures with 0.1 M proline, glycine or sorbitol. This effect of thermodynamic non-ideality implicates the existence of a substrate-induced conformational change that is governed by a minor volume decrease and a very small isomerization constant; and hence, substantiates earlier inferences that the rate-determining step in pyruvate kinase kinetics is isomerization of the ternary enzyme product complex rather than the release of products. (C) 2003 Elsevier Science B.V. All rights reserved.
Resumo:
This article is concerned primarily with an examination and comparison of select aspects of the model international consumer protection laws proposed by the United Nations (UN), the European Union (EU), and the Organisation for Economic Co-operation and Development (OECD), using the Trade Practices Act 1974 (Australia) as a basis for examination and comparison. As a secondary consideration, it also broadly examines the content of, and differences between, the model laws. The motive for this article is that any future enforceable international consumer protection regime (possibly in the form of an international treaty or convention) would need to take into account the UN, EU and OECD guidelines. A cross-comparison of those model laws, and a comparison of them with the consumer protection provisions of a well established national consumer protection law, should provide a useful starting point for the development of such a regime. The 'select aspects' of the model laws in question are the various provisions of those laws which could relate to situations involving the wrong delivery or non-delivery of goods.
Resumo:
Conventional kinesin is a microtubule-based molecular motor involved in the transport of membranous and non-membranous cargoes. The kinesin holoenzyme exists as a heterotetramer, consisting of two heavy chain and two light chain subunits. It is thought that one function of the light chains is to interact with the cargo. Alternative splicing of kinesin light chain pre-mRNA has been observed in lower organisms, although evidence for alternative splicing of the human gene has not been reported. We have identified 19 variants of the human KNS2 gene (KLC1) that are generated by alternative splicing of downstream exons, but calculate that KNS2 has the potential to produce 285919 spliceforms. Corresponding spliceforms of the mouse KLC1 gene were also identified. The alternative exons are all located 3' of exon 12 and the novel spliceforms produce both alternative carboxy termini and alternative 3' untranslated regions. The observation of multiple light chain isoforms is consistent with their proposed role in specific cargo attachment.
Resumo:
This paper explains how, in the aftermath of World War II, a type of techno-nationalism emerged that linked being Japanese to science and technology and the increased consumption of electrical appliances. By closely examining official exhibitions, we can see how the state and private sector strongly encouraged this techno-scientific dreaming. Dazzling displays highlighted how the peaceful atom would help lead the nation to achieve high economic growth. At the same time, through the judicious purchase of labor saving appliances, consumers could reconcile the need to spend with the need to save.
Resumo:
A polymer based on a blend of starch and Bionolle(TM) has been prepared and tested for biodegradation in compost. The polymer was completely mineralised to carbon dioxide in 45 days. The potential toxicity of the polymer was tested against the earthworm Eisenia fetida using a modification of the American Standard for Testing Materials E1976-97. The earthworms were exposed to 30 g of the polymer for 28 days and changes in weight recorded. In addition, the polymer was firstly degraded by the compost and the worms exposed to the breakdown products for 28 days. Differences in weight were also recorded. In each case the production of juveniles was noted and all earthworms were examined for pathology. The results obtained were processed statistically using a t-test. The number of juveniles, produced from the breakdown products, was highly significant (P < 0.001) when compared to the earthworms added to the intact polymer. There was a definitely significant difference (P < 0.01, t = 3.25) in change in weight between the earthworms that were exposed to the polymer directly and those that were exposed to the breakdown products. There was no indication of any pathology of any earthworms. The polymer is considered safe for this species. (C) 2002 Elsevier Science Ltd. All rights reserved.
Resumo:
As perdas pós-colheita de frutas promovem a elevação do custo dos produtos e diminuem a oferta ao consumidor. Suas principais causas estão na colheita, transporte e armazenamento inadequados. A aplicação de revestimentos comestíveis juntamente com a redução da temperatura de armazenamento constitui um dos métodos empregados para a conservação pós-colheita de produtos com vida útil curta, como frutas e hortaliças. O morango é um fruto consumido preferencialmente in natura. Desta forma, torna-se promissora a utilização de revestimento comestível para aumentar seu período de armazenamento e comercialização, sem alteração do sabor, da cor e do aroma dos frutos. A produção orgânica frente a convencional de frutos podem apresentar diferenças, sendo interessante o estudo envolvendo as formas de cultivo. Este estudo teve como objetivo avaliar a conservação pós-colheita de morangos cv. Camarosa, oriundos de cultivo orgânico e convencional revestidos com coberturas comestíveis. Os morangos foram revestidos com fécula de mandioca, gelatina e cera de carnaúba, armazenados durante 10 dias a 10 ºC. A cada 2 dias de armazenamento foram determinados perda de massa, sólidos solúveis, pH, acidez titulável, firmeza, antocianinas totais e podridão fúngica. Análise sensorial foi realizada para verificar a aceitação dos morangos e para avaliar a influência da informação nesta aceitação. A perda de massa foi maior no cultivo orgânico a partir do 8º dia de armazenamento, chegando a 11,47% contra 8,88% do cultivo convencional no final do 10º dia de armazenamento. O revestimento que possibilitou menor perda de massa foi o de cera de carnaúba em relação ao controle. A contaminação fúngica iniciou-se no 4º dia de armazenamento em ambos os tipos de cultivo. No 8º dia de armazenamento observou-se diferenças na podridão entre os tipos de cultivo, sendo o orgânico visualmente mais contaminado. O revestimento de cera de carnaúba apresentou menor podridão fúngica em relação aos outros revestimentos, porém não diferiu da amostra controle. Das variáveis físico-químicas avaliadas, apenas o teor de sólidos solúveis apresentou diferenças entre os tipos de cultivo, sendo o morango convencional o que obteve maiores valores. O teor de antocianinas dos morangos revestidos com fécula de mandioca diferiu do controle, porém o revestimento com fécula não diferiu dos revestidos com gelatina e cera de carnaúba. Foram verificadas diferenças na firmeza dos frutos em relação aos revestimentos. Ao longo do tempo foi observado diferenças no pH, teor de antocianinas e firmeza. O revestimento com cera de carnaúba se mostrou mais adequado em relação aos demais revestimentos, porém sua aparência mostrou-se com pouco brilho e esbranquiçado. Os frutos avaliados apresentaram vida útil pós-colheita de aproximadamente 6 dias. Os morangos, do ponto de vista microbiológico, se mostraram aptos para consumo. A aceitação dos morangos foi boa, não tendo ix diferenças significativas entre morango orgânico e convencional. O fornecimento da informação de “morango orgânico” e a apresentação de um texto adicional informativo não influenciaram na aceitação dos morangos. Entre os revestimentos testados o de cera de carnaúba se mostrou mais aplicável, os demais nas condições testadas não mostraram bons resultados.
Resumo:
Improvement of the environmental performance of processes and products is a common objective in industry, and has been receiving increased attention in recent years. The main objective of this work is to evaluate the potential environmental impact of two bedding products, a polyurethane foam mattress (PFM) and a pocket spring mattress (PSM). These two types are the most common mattresses used in Europe. A Life Cycle Assessment (LCA) shows that the PFM has a higher environmental impact than the PSM. For both products the main cause of environmental impact is the manufacturing process, respectively the polyurethane foam block moulding process for the PFM, and the pocket spring nucleus process for the PSM. A scenario analysis shows the possibility of reducing the environmental impact of the products’ life cycle using an alternative End-of-Life scenario, resorting to incineration rather than landfill. Two strategies were also studied in order to reduce the environmental impact of the PFM: (1) reutilization of foam that was sent to the waste system management, and (2) a 20% weight reduction of the polyurethane foam. The second strategy has proven to be the most effective.
Resumo:
Developed societies are currently facing severe demographic changes: the world is getting older at an unprecedented rate. In 2000, about 420 million people, or approximately 7 percent of the world population, were aged 65 or older. By 2050, that number will be nearly 1.5 billion people, about 16 percent of the world population. This demographic trend will be also followed by an increase of people with physical limitations. New challenges will be raised to the traditional health care systems, not only in Portugal, but also in all other European states. There is an urgent need to find solutions that allow extending the time people can live in their preferred environment by increasing their autonomy, self-confidence and mobility. AAL4ALL presents an idea for an answer through the development of an ecosystem of products and services for Ambient Assisted Living (AAL) associated to a business model and validated through large scale trial. This paper presents the results of the first survey developed within the AAL4ALL project: the users’ survey targeted at the Portuguese seniors and pre-seniors. This paper is, thus, about the lives of the Portuguese population aged 50 and over.
Resumo:
Tourism is a phenomenon that moves millions of people around the world, taking as a major driver of the global economy. Such relevance is reflected in the proliferation of studies in the overall area known as tourism, under various perspectives and backgrounds. In the light of such multitude of insights our study aims at gaining a deeper understanding of customer profiling and behavior in cross-border tourism destinations. Previous studies conducted in such contexts suggest that cross-border regions (CBRs) are an attractive and desirable idea, yet requiring further theoretical and empirical research. The new configuration of many CBRs calls for a debate on issues concerning its development, raising up important dimensions, such as, organization and planning of common tourism destinations. There is still a gap in the understanding of destination management in CBRs and the customer profile and motivations. Overall this research aims at attaining a deeper understanding of the profile and behavior of consumers in tourism settings, addressing the predisposition for the destination. The study addresses the following research question: “What factors influence customer behavior and attitudes in a CBRs tourism destination?” To address our question we will take an interdisciplinary perspective bringing together inputs from marketing, tourism and local economics. When addressing consumer behavior in tourism previous studies considered the following constructs: involvement, place attachment, satisfaction and destination loyalty. In order to establish the causal relationships in our theoretical model, we intend to develop a predominant quantitative design, yet we plan to conduct exploratory interviews. In the analysis and discussion of results, we intend to use Structural Equation Modeling. It will further allow understanding how the constructs in the research model relate to each other in the specified context. Results are also expected to have managerial implications. Consequently our results may assist decision makers in developing their local policies.
Resumo:
Tourism is a phenomenon that moves millions of people around the world, taking as a major driver of the global economy. Such relevance is reflected in the proliferation of studies in the overall area known as tourism, under various perspectives and backgrounds. In the light of such multitude of insights our study aims at gaining a deeper understanding of customer profiling and behavior in cross-border tourism destinations. Previous studies conducted in such contexts suggest that cross-border regions (CBRs) are an attractive and desirable idea, yet requiring further theoretical and empirical research. The new configuration of many CBRs calls for a debate on issues concerning its development, raising up important dimensions, such as, organization and planning of common tourism destinations. There is still a gap in the understanding of destination management in CBRs and the customer profile and motivations. Overall this research aims at attaining a deeper understanding of the profile and behavior of consumers in tourism settings, addressing the predisposition for the destination. The study addresses the following research question: “What factors influence customer behavior and attitudes in a CBRs tourism destination?” To address our question we will take an interdisciplinary perspective bringing together inputs from marketing, tourism and local economics. When addressing consumer behavior in tourism previous studies considered the following constructs: involvement, place attachment, satisfaction and destination loyalty. In order to establish the causal relationships in our theoretical model, we intend to develop a predominant quantitative design, yet we plan to conduct exploratory interviews. In the analysis and discussion of results, we intend to use Structural Equation Modeling. It will further allow understanding how the constructs in the research model relate to each other in the specified context. Results are also expected to have managerial implications. Consequently our results may assist decision makers in developing their local policies.
Resumo:
A década de 1980 trouxe uma visão alternativa à corrente positivista predominante no campo de pesquisa do consumidor: a Consumer Culture Theory (CCT), que assume uma orientação epistemológica baseada no interpretativismo e na pesquisa qualitativa. Diante do destaque alcançado pela CCT, levantou-se a seguinte questão: a CCT já pode ser considerada uma escola de pensamento em marketing autônoma? Pautados em três critérios fundamentais para a qualificação de uma escola de pensamento (reconhecimento acadêmico, corpo de conhecimento e contribuições), foi realizada uma desk research, baseada em periódicos e artigos da área e na construção de um corpus de pesquisa construído com base nas referências contidas no texto seminal Consumer Culture Theory (CCT): twenty years of research. A conclusão é de que a CCT atende aos critérios adotados na presente pesquisa, podendo ser considerada uma escola de pensamento a utônoma dentro do campo de pesquisa do consumo.
Resumo:
The theoretical framework that underpins this research study is based on the Prospect Theory formulated by Kahneman and Tversky, and Thaler's Mental Accounting Theory. The research aims to evaluate the consumers' behavior when different patterns of discount are offered (in percentage and absolute value and for larger and smaller discounts). Two experiments were conducted to explore these patterns of behavior and the results that were obtained supported the view that the framing effect was a common occurrence. The patterns of choice of individuals in a sample were found to be different due to changes in the ways discounts were offered. This can be explained by the various ways of presenting discount rates that had an impact on the influence of purchase intentions, recommendations and quality perception.
Resumo:
This paper discusses the results of a large survey conducted in 2006 on the perception Portuguese movies’ audiences have of their own locally produced films. Audience’s reception of locally produced films is marked by the rejection of the consumption of these objects as a result of a bias against locally produced cultural artefacts. The prejudice shaping this relationship, not only demands for new cultural and social politics, but also raises a number of questions on local and European media industry’s ability to cope with its own audiences’ expectations. Finally, broader considerations are made on the different ways contemporary audiences are shaping media technologies, and their respective cultural artefacts, through their own use and reception of those technologies and artefacts.