The influence of crystallization route on the SrBi2Nb2O9 thin films

Polycrystalline SrBi2Nb2O9-layered ferroelectric thin films were synthesized on Pt/Ti/SiO2/Si substrate using the polymeric precursors solution. The dip-coated films were specular and crack-free and crystallized during firing at 700 °C. Single-, double-, and triple-layered films were obtained by several dips in the deposition solution, and the influence of crystallization between each dip was studied. Microstructure and morphological evaluation were followed by grazing incident x-ray diffraction (GIXRD), scanning electron microscopy (SEM), and atomic force microscopy (AFM). Multilayered films obtained using the intermediate-crystallized layer route present a dense microstructure with spherical grains, with a preferential orientation in the 〈215〉 direction; films obtained using the intermediate-amorphous layer route are polycrystalline and present elongated grains around 250 nm in size.

Effect of in concentration in the starting solution on the structural and electrical properties of ZnO films prepared by the pyrosol process at 450°C

Undoped and indium-doped Zinc oxide (ZnO) solid films were deposited by the pyrosol process at 450°C on glass substrates from solutions where In/Zn ratio was 2, 5, and 10 at.%. Electrical measurements performed at room temperature show that the addition of indium changes the resistance of the films. The resistivities of doped films are less than non-doped ZnO films by one to two orders of magnitude depending on the dopant concentration in the solution. Preferential orientation of the films with the c-axis perpendicular to the substrate was detected by X-ray diffraction and polarized extended X-ray absorption fine structures measurements at the Zn K edge. This orientation depends on the indium concentration in the starting solution. The most textured films were obtained for solutions where In/Zn ratio was 2 and 5 at.%. When In/Zn = 10 at.%, the films had a nearly random orientation of crystallites. Evidence of the incorporation of indium in the ZnO lattice was obtained from extended X-ray absorption fine structures at the In and Zn K edges. The structural analysis of the least resistive film (Zn/In = 5 at.%) shows that In substitutes Zn in the wurtzite structure. © 2000 Elsevier Science B.V. All rights reserved.

Behavior of Atta sexdens rubropilosa (Hymenoptera: Formicidae) workers during the preparation of the leaf substrate for symbiont fungus culture

The behavioral repertory of Atta sexdens rubropilosa Forel (Hymenoptera: Formicidae) workers marked by size category was studied during the preparation of the leaf substrate in the laboratory. The workers were marked according to three physical castes, i.e., minima, generalist and forager. Seven types of behavioral acts were recorded for each caste, with the following frequencies: licking leaf fragments (64.6%), holding fragments on the surface of the fungus garden (16.4%), shredding the fragments (6.0%), chewing and crimping the edges of the fragments (9.0%), incorporating the fragments (2.7%), touching the surface of the fungus with their mandibles and other mouthparts after incorporation (0.3%), and depositing fecal fluid (0.1%). The minima workers were found to be more specialized in the activities related to the preparation of the leaf substrate, which represented 52% of the total number of tasks performed. The generalists performed 40.3% of these tasks, and the foragers 7.9%. Licking the substrate was the behavior most frequently recorded and performed for a longer period of time. In this way, the workers may feed and at the same time eliminate microorganisms that are harmful to the symbiont fungus. The smaller castes, minima and generalists, are those most responsible for the preparation of the leaf substrate and predominate within a colony. From a practical viewpoint, with the introduction of toxic bait containing insecticides, for example, these size categories will be those most intensely intoxicated, especially through the behavior of licking bait pellets. On the basis of the data obtained about these behaviors, we may raise the hypothesis that trophallaxis in not the major factor triggering contamination with an insecticide among the workers of a colony.

Uso de biossólido como substrate para produção de mudas de eucalipto

The objective of this study was to evaluate the feasibility of the biosolids used as substrate component for seedlings production of Eucalyptus. This way, different proportions of biosolid/carbonized rice (80/20, 70/30, 60/40, 50/05 and 40/60) were tested as substrates in mixture, which were compared to the common substrate used by forest nursery (Multiplant®), as control. The experiment was established with Eucalyptus grandis where growth seedlings-related parameters were assessed: shoot height, collar diameter, accumulation of dry matter on the shoot and root, chemical analysis of the vegetal tissue of aerial part and root, foliar area and chlorophyll content. The results revealed that Eucalypts seedlings developed in substrate with 50% biosolid were similar to the control in relation to the evaluated parameters, concluding that the use of biosolids for seedlings production is quite promising.

Interference of epicuticular wax from leaves of grasses in selection and preparation of substrate for cultivation of symbiont fungus by Atta capiguara (Hym. Formicidae)

The selection of plants is one of the stages of foraging behavior, executed by leaf-cutting ants for the cultivation of symbiont fungus. Anatomical, biochemical and physiological characteristics of vegetal species are some of the factors that influence selection of substrate; however, most studies described in the literature refer to leaf-cutting ants. Due to the scarcity of studies on the role of epicuticular waxes of grasses in relation to foraging behavior of monocotyledonous leaf-cutters, we completed three experiments with the ant species Atta capiguara in which we analyzed: the attractiveness or selectivity of leaves of Saccharum officinarum (sugarcane) and/or Hypharrenia rufa (capim jaraguá), with and without epicuticular wax in relation to the worker of this ant species, their processing and elimination in the form of pellets of epicuticular wax from the referred fragments removed by the workers for cultivation of symbiont fungus. We observed that vegetal fragments without wax were those most transported by workers to the inside of the nests; that they processed the fragments equally with as much as without wax, and eliminated, in the form of pellets, wax removed from the same into garbage chambers of the colonies, leading us to conclude that for monocotyledonous leaf-cutters, epicuticular wax from vegetal leaves has great importance in vegetal integrity by being used as substrate, representing a physical barrier to the growth of symbiont fungus.

Tensile bond strength of self-etching versus total-etching adhesive systems under different dentinal substrate conditions

The use of acid etchants to produce surface demineralization and collagen network exposure, allowing adhesive monomers interdiffusion and consequently the formation of a hybrid layer, has been considered the most efficient mechanism of dentin bonding. The aim of this study was to compare the tensile bond strength to dentin of three adhesive systems, two self-etching ones (Clearfil SE Bond - CSEB and One Up Bond F - OUBF) and one total-etching one (Single Bond - SB), under three dentinal substrate conditions (wet, dry and re-wet). Ninety human, freshly extracted third molars were sectioned at the occlusal surface to remove enamel and to form a flat dentin wall. The specimens were restored with composite resin (Filtek Z250) and submitted to tensile bond strength testing (TBS) in an MTS 810. The data were submitted to two-way ANOVA and Tukey's test (p = 0.05). Wet dentin presented the highest TBS values for SB and CSEB. Dry dentin and re-wet produced significantly lower TBS values when using SB. OUBF was not affected by the different conditions of the dentin substrate, producing similar TBS values regardless of the surface pretreatments.

Influence of cerium (IV) ions on the inorganic and organic phase for preparation of a siloxane-PMMA based film on tin plate substrate

Tinplate is one of the most widely used food canning materials, however, there are significant problems related to the use of tinplate cans, such as alterations in sensory features affecting food quality and corrosion phenomena of the canning material. To avoid corrosion problems different methods have been used for the passivation of tinplate such protective lacquers or different kinds of corrosion inhibitors (chromate and dichromate). However, chromates and dichromates are extremely harmful to the environment and can cause carcinogenic tumors to humans. An option, protective coatings obtained by the sol-gel process, act as a physical barrier, which isolates the surface of metal protecting from the corrosive agents. The aim of this work is to study the influence of addition of cerium (IV) ions in the inorganic and organic part of sol-gel processing in the formation of hybrid coatings based on siloxane-PMMA on tin plate. The coatings were obtained by dip-coating technique and evaluated by open circuit and impedance measurements, linear polarization and polarization curves obtained in 3.5% NaCl solution. The results have clearly shown the improvement on the protective properties of the Ce 4+ modified film when added into the organic phase, which can be due to the formation of a more uniform and densely reticulated siloxane-PMMA film. © 2009 by NACE International.

Preferential trade agreements in the Caribbean: issues and approaches

Includes bibliography

Rules of origin and trade facilitation in preferential trade agreements in Latin America

Includes bibliography

Ex-post evaluation of the employment effects of a preferential trade agreement: methodological issues, illustrated with a reference to Chile

Includes bibliography

Agaricus blazei as a Substrate for the Production of β-1,3-Glucanase by Trichoderma harzianum Rifai

Extracellular β-1,3-glucanase was produced by Trichoderma harzianum Rifai cultivated in the Agaricus blazei (Agaricus brasiliensis) extract as a substrate in submerged fermentation. A 22-central composite factorial design was developed using the time of culture (x1/day) and Agaricus blazei extract concentration (x2/(g/L)) as variables, and the results were analyzed using response surface methodology (RSM). The results showed that the Agaricus blazei extract concentration was the most important variable in the production of β-1,3-glucanase, and the maximum β-1,3-glucanase activity (0.77 U/mL) was obtained in one day of cultivation. The β-glucan present in the cell wall of Agaricus blazei mushroom proved to be a good substrate for inducing the production of specific β-1,3-glucanase by Trichoderma harzianum Rifai.

Alterations in levels of NPK, electrical conductivity and pH of substrate, in cultivation of peppers

The objective of this work was to evaluate the chemical alterations of the substrate in the cultivation of pepper in coconut husk fiber, in a protected environment. Initially, 160 pepper plants ('Eppo') were divided into four blocks, where two pots per block were analyzed every 21 days after transplanting. The cultivation of pepper was carried out in plastic pots of 13 L, containing coconut husk fiber, and placed in double rows with a spacing of 0.5×0.8 m between single rows and 1.10 m between double rows. After removal of the plants from the pots, individual samples of substrate (approximately 1 L) were collected from each pot and dried at ambient temperature. Electrical conductivity (EC), pH, and levels of NH4 +-N, NO3 -, P and K were determined for all periods of the cultivation. These analyses were performed using the method of extraction 1:1.5 v/v. For the conditions which the experiment was conducted, there was an increase in substrate EC, as well as in the levels of nitrogen, phosphorus and potassium.

Chemical alterations of substrate in the cultivation of peppers

The objective of this study was to evaluate the chemical alterations of the substrate in the cultivation of peppers grown in coconut husk fiber, in a protected environment. Initially, 160 pepper plants ('Eppo') were divided into four blocks, where two pots per block were analyzed every 21 days after transplanting. The cultivation of pepper was carried out in plastic pots of 13 L, containing coconut husk fiber, and placed in double rows with a spacing of 0.5×0.8 m between single rows and 1.10 m between double rows. After removal of the plants from the pots, individual samples of substrate (approximately 1 L) were collected from each pot and dried at ambient temperature. The levels of Ca, Mg, S, Cl, Na, B, Fe, Mn, Cu and Zn were determined for all periods of the cultivation. These analyses were performed using the method of extraction 1:1.5 v/v. There was an increase in the levels of all the nutrients evaluated. Further studies should be conducted to develop a better nutrient solution.

Cultivation of Pleurotus ostreatus using supplemented spent oyster Mushroom substrate

Spent Agaricus and Pleurotus substrates are mainly used as components of amendments and growing substrates, but not in sufficient quantities to solve the problem of their accumulation in mushroom producing areas, where they represent a potential pollution risk. The mushroom growing sector in Spain generates about 5105 t of spent compost, while the EU, as a whole, produces more than 3.5106 t. Among alternative management applications, it is possible to reuse these wastes in the cultivation of mushrooms, as a casing material for growing Agaricus spp. and as substrate for growing other species. In this work, the application of commercial nutritional supplements (Calprozime, Champfood and Promycel), widely used in Agaricus cultivation, is evaluated for its possible use as additive to substrates, based on spent oyster mushroom substrate (SMS), for the cultivation of Pleurotus ostreatus. Using a mixture of straw and SMS (1:1, w/w) as base material, the addition of CaSO4 (50 g kg-1) and CaCO3 (10 g kg-1) and the above supplements at 20 g kg-1 brought about a remarkable increase in production compared with the substrate without any supplement. The biological efficiencies did not differ significantly from that obtained when a commercial substrate was used as control, reaching values of 48.9 kg/100 kg substrate (dry matter) when Calprozime was used as supplement. Sporophores harvested from the supplemented substrates presented a higher dry matter content than those obtained from both commercial and non-supplemented substrates. SMS is cheap and easily available; it can be integrated into new formulations with the added advantages of lowering production costs, limiting growers' dependence on straw, and decreasing the environmental impact of its ever-growing accumulation.

Alterations in the fat body cells of rhinocricus padbergi (Diplopoda) resulting from exposure to substrate containing sewage sludge

Abstract The final disposal of residues generated at sewage treatment plants (STPs) has become a major problem for cities, due to the increase in the amount of treated sewage. One of the alternatives for the residue, labeled sewage sludge, is its reuse in agriculture and in degraded soil. However, not all pathogens and metals present in it are eliminated during treatment. Diplopods have been used as bioindicators in ecotoxicological tests as they are constantly in close contact with the soil. Owing to this fact, the purpose of this study was to expose specimens of the diplopod Rhinocricus padbergi to substrate containing sewage sludge collected at STPs to analyze morphological alterations in their parietal and perivisceral fat body, where substances are stored. The exposures were held for 7, 15, or 90 days at different concentrations of sewage sludge (control, 1%, 10%, and 50%). The parietal fat body showed no alterations in any of the three exposure periods or concentrations. Alterations in the perivisceral fat body were observed for all exposure periods. According to the results, we suggest that the sludge used has toxic agents responsible for changing the animal's perivisceral fat body. © 2012 Microscopy Society of America.