The molecular structure and one-pot synthesis of [Li(thf)3·Sn(SiMe3)3]

The molecular structure of [Li(thf)3 · Sn(SiMe3)3], prepared by a new, one-pot synthesis in 44% yield, has been determined by a single crystal X-ray diffraction study using synchrotron radiation and a CCD detector. The +Li(thf)3 and −Sn(SiMe3)3 moieties are joined by a Li–Sn bond, 2.865(5) Å in length. [Li(thf)3 · Sn(SiMe3)3] is isomorphous with its germanium analogue.

Dopant-vacancy binding effects in Li-doped magnesium hydride

We use a combination of ab initio calculations and statistical mechanics to investigate the substitution of Li+ for Mg2+ in magnesium hydride (MgH2) accompanied by the formation of hydrogen vacancies with positive charge (with respect to the original ion at the site). We show that the binding energy between dopants and vacancy defects leads to a significant fraction of trapped vacancies and therefore a dramatic reduction in the number of free vacancies available for diffusion. The concentration of free vacancies initially increases with dopant concentration but reaches a maximum at around 1 mol % Li doping and slowly decreases with further doping. At the optimal level of doping, the corresponding concentration of free vacancies is much higher than the equilibrium concentrations of charged and neutral vacancies in pure MgH2 at typical hydrogen storage conditions. We also show that Li-doped MgH2 is thermodynamically metastable with respect to phase separation into pure magnesium and lithium hydrides at any significant Li concentration, even after considering the stabilization provided by dopant-vacancy interactions and configurational entropic effects. Our results suggest that lithium doping may enhance hydrogen diffusion hydride but only to a limited extent determined by an optimal dopant concentration and conditioned to the stability of the doped phase.

Quantitative ventilation assessments of idealized urban canopy layers with various urban layouts and the same building packing density

This paper investigates urban canopy layers (UCL) ventilation under neutral atmospheric condition with the same building area density (λp=0.25) and frontal area density (λf=0.25) but various urban sizes, building height variations, overall urban forms and wind directions. Turbulent airflows are first predicted by CFD simulations with standard k-ε model evaluated by wind tunnel data. Then air change rates per hour (ACH) and canopy purging flow rate (PFR) are numerically analyzed to quantify the rate of air exchange and the net ventilation capacity induced by mean flows and turbulence. With a parallel approaching wind (θ=0o), the velocity ratio first decreases in the adjustment region, followed by the fully-developed region where the flow reaches a balance. Although the flow quantities macroscopically keep constant, however ACH decreases and overall UCL ventilation becomes worse if urban size rises from 390m to 5km. Theoretically if urban size is infinite, ACH may reach a minimum value depending on local roof ventilation, and it rises from 1.7 to 7.5 if the standard deviation of building height variations increases (0% to 83.3%). Overall UCL ventilation capacity (PFR) with a square overall urban form (Lx=Ly=390m) is better as θ=0o than oblique winds (θ=15o, 30o, 45o), and it exceeds that of a staggered urban form under all wind directions (θ=0o to 45o), but is less than that of a rectangular urban form (Lx=570m, Ly=270m) under most wind directions (θ=30o to 90o). Further investigations are still required to quantify the net ventilation efficiency induced by mean flows and turbulence.

RESONANCES EXCITED BY THE (9)Be((6)Li,d) (13)C REACTION

Alpha resonant states in (13)C tu to 15MeV were excited by the (9)Be ((6)Li,d) (13)C reaction, The data were taken at a bombarding energy of 25.5 MeV employing the sao Paulo-Pelletron-Enge Split Pole facility and the nuclear emulsion technique. The resolution of 50 keV allowed for the separation of the resonant contributions to the known 7/2(-) and (5/2(-)) states near the (9)Be + alpha threshold both associated with an L = 4 transfer. Several narrow alpha resonant states not previously measured were detected, in particular the one at the 3 alpha + n threshold populated by an L = 2 transfer, revealing a (9)Be + alpha component for the 1/2(-) cluster state candidate at this threshold.

Probing the (6,7)Li nucleon densities through a new break-up process approach

In this work we present a double folding optical model analysis of new near-barrier quasi-elastic experimental data for the (6,7)Li + (120)Sn systems. From the analysis, it was possible to confirm the ground-state nucleon densities assumed for the weakly bound (6,7)Li isotopes. The apparent discrepancies between the experimental densities and those based on Dirac-Hartree-Fock Bogoliubov (DHB) calculations were removed. A new approach that simulates the projectile break-up and a positive polarization from couplings of (6,7)Li bound states with the continuum was considered in the reaction mechanism. (C) 2010 Elsevier B.V. All rights reserved.

Projectile breakup dynamics for (6)Li+(59)Co: Kinematical analysis of alpha-d coincidences

A study of the kinematics of the alpha-d coincidences in the (6)Li + (59)Co system at a bombarding energy of E(lab) = 29.6MeV is presented. With exclusive measurements performed over different angular intervals it is possible to identify the respective contributions of the sequential and direct projectile breakup components. The angular distributions of both breakup components are fairly well described by the Continuum-Discretized Coupled-Channels framework (CDCC). Furthermore, a careful analysis of these processes using a semiclassical approach provides information on both their lifetime and their distance of occurrence with respect to the target. Breakup to the low-lying (near-threshold) continuum is delayed, and happens at large internuclear distances. This suggests that the influence of the projectile breakup on the complete fusion process can be related essentially to the direct breakup to the (6)Li high-lying continuum spectrum.

(6)Li direct breakup lifetimes

alpha-d coincidence data are studied for the (6)Li + (59)Co reaction at E(lab) = 29.6 MeV. A kinematic analysis is used to identify which process, leading to the same final state, has the major contribution for selected angular regions. The contributions of the (6)Li sequential and direct breakup to the incomplete fusion/transfer process is discussed by considering the corresponding lifetimes obtained by using a semiclassical approach.

Reaction mechanisms in the (6)Li+(59)Co system

The reactions induced by the weakly bound (6)Li projectile interacting with the intermediate mass target (59)Co were investigated. Light charged particles singles and alpha-d coincidence measurements were performed at the near barrier energies E(lab) = 17.4, 21.5, 25.5 and 29.6 MeV. The main contributions of the different competing mechanisms are discussed. A statistical model analysis. Continuum-Discretized Coupled-Channels (CDCC) calculations and two-body kinematics were used as tools to provide information to disentangle the main components of these mechanisms. A significant contribution of the direct breakup was observed through the difference between the experimental sequential breakup cross section and the CDCC prediction for the non-capture breakup cross section. (C) 2009 Elsevier B.V. All rights reserved.

Thermoluminescence, structural and magnetic properties of a Li(2)O-B(2)O(3)-Al(2)O(3) glass system doped with LiF and TiO(2)

A Li(2)O-B(2)O(3)-Al(2)O(3) glass system, un-doped and doped with LiF, and/or TiO(2) was synthesized by the fusion method and its physical properties were investigated by thermoluminescence (TL), X-ray diffraction (XRD), electron paramagnetic resonance (EPR), atomic force microscopy (AFM) and differential thermal analysis (DTA). The samples were subjected to gamma-rays from a colbalt-60 ((60)Co) source. These techniques provided evidence of LiF and LiF doped with Ti crystal formation in the glass system. A TL glow peak at about 433 K was sensitive to (60)Co gamma-rays and showed good linearity with doses and consequently could be used to quantify radiation doses. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.

Extração de metais (K, Mg, Ba, Ca, Cr, Mn, Li, Fe) de água produzida utilizando sistema microemulsionado

The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation

Já li muita coisa, então, eu posso inventar mais! A leitura literária e o desenvolvimento do pensamento criativo na infância

This study investigates the contributions of reading literature for the development of creative thinking in childhood. Its relevance consists in exploring practices that contemplate the creative thinking development in apprentices at school space and understanding the literature like a significant way to promote the creative thinking. The study is connected to the qualitaty strand. The exploratory observation and the intervention were adopted as research techniques. The field diary and the audio and video recording of the reading sections were adopted as methodological instruments. The research was conducted in the application s college from the Federal University of Rio Grande do Norte, in a 1th grade class, with 18 students between 6 and 7 years old. During the intervention, 8 readind class happened, with varied strategies and literary genres. The reading sessions were conducted through the principles of scaffolding, defended by Graves and Graves (1995). The corpus is made of speaks episodes, whose encoding semantics allowed the grouping into two central categories: divergent thinking and coauthoring of literary reader. It was taken as a theoretical framework the studies of Amarilha (2011; 2006; 2001; 1991; 1993; 1994), Alencar (2001), Coelho (2000; 1997), Culler (1999), De Masi (2005), Gallo (2000), Guilford (1977), Iser (1996), Jouve (2002), Kneller (1978), Martínez (1997), Smith (2003), Stierle (1979), Vigotski (2009; 1998), Wechsler; Nakano (2003; 2002). The analysis points to the formation of creative individuals in the classroom, through the reading of literature. Reposition the literary education front of the new social demands. Resizes the function of school in children s development, considering the children s skill in exploring, testing hypotheses and making use of their creative thinking, in climate of freedom mental. It signals, in this way, the teacher like a mediator, promoting a favorable to the development of creative thinking environment, a stimulating atmosphere, which enhances the expression of creative thinking in community

Prediction of a weakly bound excited state in the He-4(2)-Li-7 molecule

A scale-independent approach, valid for weakly bound three-body systems, is used to analyze the existence of excited Thomas-Efimov states in molecular systems with three atoms: a helium dimer together with isotopes of lithium (Li-6 and Li-7) and sodium (Na-23). With the present study and the available data, we can clearly predict that the He-4(2)-Li-7 system supports an excited state with binding energy close to 2.31 mK. (C) 2000 American Institute of Physics. [S0021-9606(00)30442-1].

Structural effects of Li and K additives on the columbite precursor and 0.9PMN-0.1PT powders

Single-phase perovskite 0.9Pb(Mg1/3Nb2/3)O-3-0.1PbTiO(3) (PMN-PT) powders were prepared by using a Ti-modified columbite precursor (MNT) obtained by the polymeric precursor method. The innovation consists in the preparation of Ti-modified columbite in order to react directly with a stoichiometric amount of PbO to obtain pyrochlore-free PMN-PT powders. It has been shown that titanium oxide forms a solid solution with columbite (MN) and does not affect the obtaining of a single-phase columbite precursor. Thus, a high amount of perovskite phase can be obtained by reaction with PbO at 800 degreesC for 2 h. Effects of K and Li additives on the structure of MNT and PMN-PT were studied. X-ray diffraction studies were carried out to verify the phase formation at each processing step and these data were used for structural refinement by the Rietveld method. Both K and Li additives increase the crystallinity of MNT powders, being this effect more intense for the Li-doped samples. For PMN-PT samples the additives cause an insignificant decrease in the amount of perovskite phase. The morphology of the PMN-PT powder depends on the type of the additive. (C) 2003 Elsevier B.V All rights reserved.

THE EFFECT OF POSITRONIUM FORMATION IN E(+)-LI AND E(+)-NA SCATTERING

We studied e+-Li and e+-Na scattering using the close-coupling approximation in the static and coupled static expansion schemes. The effect of the positronium formation on the elastic channel is found to be strong in both cases. In the case of the lithium atom the effect is dramatic; the inclusion of the positronium formation channel transforms the purely repulsive effective e+-Li S wave (static) potential to a predominantly attractive (coupled static) potential. In this case, in the static model delta(0)-delta(infinity) = 0, whereas in the coupled static model delta(0)-delta(infinity)=pi. According to Levinson's theorem this suggests the presence of a S wave bound or continuum bound state in the e+-Li system.