具有环氧化酶-2选择性抑制活性的多取代蒽醌的合成

1-甲基-2-甲氧羰基-3, 6, 8-三羟基-7-甲氧基蒽醌是从唐菖蒲干球茎中分离到的具有环氧化酶-2选择性抑制活性的多取代蒽醌类化合物。本文试图合成该化合物，实现了其类似物的合成，同时发现了几个未见报道的反应。 1．通过Diels-Alder 反应合成了关键中间体——3-甲基-5-羟基-1, 2, 4-苯三甲酸三甲酯，1-COOMe选择性水解产物与1, 2, 3-三甲氧基苯进行分子间Friedel-Crafts反应的产物再进行分子内Friedel-Crafts反应得到了目标产物的类似物1-甲基-2-甲氧羰基-3-羟基-6，7，8-三甲氧基蒽醌（路线1）。目标产物及其它类似物的合成正在进行中。 2．以乙酰乙酸甲酯和巴豆醛为原料，经过Michael加成、分子内的Aldol反应、芳香化、选择性甲酰化和还原反应，得到关键中间体2-甲基-3-羟甲基-6-甲氧基苯甲酸甲酯及其衍生物。通过该化合物与3，4，5-三甲氧基苯甲酸甲酯进行Friedel-Crafts烷基化反应得到了多取代的二苯基甲烷衍生物，拟进一步关环合成目标化合物（路线2）。 3．发现邻甲氧基苯甲酸甲酯中酯甲基可以被正丁基锂和仲丁基锂中烷基交换生成相应的酯，反应的机理不明确。当使用叔丁基锂时，得到的是邻甲氧基苯基叔丁酮，这个方法可以用来合成芳基叔丁酮类化合物。 4．以2-苄氧基-6-甲基苯甲酸甲酯为原料进行氯甲基化反应时，以苯和二氯乙烷作溶剂，发生了苄基的迁移和芳环的偶联，分别得到2，2'-二甲基-3，3'-二甲氧羰基-4，4'-二羟基联苯和2，2'-二甲基-3，3'-二甲氧羰基-4，4'-二羟基-5，5'-二苄基联苯。这是对称联苯合成的新方法。 5．水杨酸羟基邻对位的选择性甲酰化可以分别通过水杨酸和水杨酸甲酯用HMTA/CF3COOH来实现。 6．Lewis酸催化3，4，5-三甲氧基苄醇环化成1, 2, 3, 6, 7, 8, 11, 12, 13-nonamethoxyl-10,15-dihydro-5H-trbibenzo [a, d, g] cyclononene (NDTC)，产率(54%)高于已有方法（12%）。 Methyl 3,6,8-trihydroxy-7-methoxy-1-methylanthraquinone-2-carboxylate is a new COX-2 selective inhibitor isolated from Gladiolus gandavensis. Two strategies were investigated to synthesis this compound, in which some important reactions were discovered. 1. The key intermediate 5-hydroxy-3-methylbenzene-1,2,4-tricarboxylic acid 2,4-dimethyl ester was prepared via Diels-Alder reaction followed by selective hydrolysis of 1-COOMe. This compound was coupled with 1,2,3-trimethoxybenzene and the product undergo intramolecular Friedel-Crafts reaction to give methyl 3-hydroxy-5,6,7-trimethoxy-1-methylanthraquinone-2-carboxylate (1st route). The target compound and other analogues are being prepared with the same procedure. 2. The key intermediates methyl 3-hydroxymethyl-6-methoxy-2-methylbenzoate and its derivatives were prepared starting from crotonaldehyde and methyl acetoacetate via Michael addition, intramolecular aldol reaction, aromatization, formylation and reduction. The intermediates were coupled respectively with derivatives of gallic acid to give polysubstituted diphenylmethane. However, attempts to cyclize these compounds to the target compounds and analogues were not successful (2nd route). 3. In the process for ortho-lithiation of methyl 2-methoxybenzoate, the substrate converted respectively to n-butyl 2-methoxybenzoate and sec-butyl 2-methoxybenzoate when n-BuLi and sec-BuLi were used. However, tert-BuLi reacted with methyl 2-methoxybenzoate afford 2-methoxyphenyl tert-butyl ketone, which could be used to synthesize aryl tert-butyl ketones. 4. The transformtion of methyl 2-benzoxy-6-methylbenzoate to dimethyl 4,4'-dihydroxy-2,2'-dimethylbiphenyl-3,3'-dicarboxylate in benzene, and dimethyl 5,5'-dibenzyl-4,4'-dihydroxy-2,2'-dimethylbiphenyl-3,3'-dicarboxylate in 1,2-dichloroethane in the presence of ZnCl2 provides a new method for the synthesis of symmetric biphenyl. 5. The formylation of salicylic acid at C-5 and methyl 2-hydroxybenzoate at C-3 could be regioselectively realized by using HMTA/CF3COOH. 6. Racemic 1, 2, 3, 6, 7, 8, 11, 12, 13-nonamethoxyl-10, 15-dihydro-5H-trbibenzo [a, d, g] cyclononene was prepared via Lewis acids catalyzed trimerization of 3, 4, 5-trimethoxylbenzyl alcohol with yield (54%) higher than the reported procesure (12%).

Solvent extraction study of protactinium(V) with methyl-iso-butyl carbinol and methyl-iso-butyl ketone

In order to study the extraction pattern of protactinium in different types of extracting agents and compare the similarity of patterns of extraction with dubnium and thereby unraveling its chemistry, solvent extraction of protactinium(V) with methyl-iso-butyl carbinol (MIBC) and methyl-iso-butyl ketone (MIBK) was studied using Pa-233 as a radiotracer. The extraction efficiencies of Pa were determined as a function of shaking time, concentrations of mineral acids, and extractant concentrations using the two extractants. The results show that MIBK is more suitable for the extraction of protactinium than MIBC in benzene. Furthermore, the effect of the F anion is also discussed.

Chemisorption and reaction characteristics of methyl radicals on Cu(110)

Methyl radicals are generated by pyrolysis of azomethane, and the condition for achieving neat adsorption on Cu(110) is described for studying their chemisorption and reaction characteristics. The radical-surface system is examined by X-ray photoemission spectroscopy, ultraviolet photoemission spectroscopy, temperature-programmed desorption, low-energy electron diffraction (LEED), and high-resolution electron energy loss spectroscopy under ultrahigh vacuum conditions. It is observed that a small fraction of impinging CH3 radicals decompose into methylene possibly on surface defect sites. This type of CH2 radical has no apparent effect on CH3(ads) surface chemistry initiated by dehydrogenation to form active CH2(ads) followed by chain reactions to yield high-mass alkyl products. All thermal desorption products, such as H-2, CH4, C2H4, C2H6, and C3H6, are detected with a single desorption peak near 475 K. The product yields increase with surface coverage until saturation corresponding to 0.50 monolayer of CH3(ads). The mass distribution is, however, invariant with initial CH3(ads) coverage, and all desorbed species exhibit first-order reaction kinetics. LEED measurement reveals a c(2 x 2) adsorbate structure independent of the amount of gaseous exposure. This strongly suggests that the radicals aggregate into close-packed two-dimensional islands at any exposure. The islanding behavior can be correlated with the reaction kinetics and is deemed to be essential for the chain propagation reactions. Some relevant aspects of the CH3/Cu(111) system are also presented. The new results are compared with those of prior studies employing methyl halides as radical sources. Major differences are found in the product distribution and desorption kinetics, and these are attributed to the influence of surface halogen atoms present in those earlier investigations.

Photodissociation dynamics of the methyl radical at 212.5 nm: Effect of parent internal excitation

Photodissociation dynamics of the CH3 radical at 212.5 nm has been investigated using the H atom Rydberg tagging time-of-flight method with a pure CH3 radical source generated by the photolysis of CH3I at 266 nm. Time-of-flight spectra of the H atom products from the photolysis of both cold and hot methyl radicals have been measured at different photolysis polarizations. Experimental results indicate that the photodissociation of the methyl radical in its ground vibrational state at 212.5 nm excitation occurs on a very fast time scale in comparison with its rotational period, indicating the CH3 dissociation at 212.5 nm occurs on the excited 3s Rydberg state surface. Experimental evidence also shows that the photodissociation of the methyl radical in the nu(2)=1 state of the umbrella mode at 212.5 nm excitation is characteristically different from that in the ground vibrational state. (C) 2004 American Institute of Physics.

Analysis of specific gene by integration of isothermal amplification and electrophoresis on poly(methyl methacrylate) microchips

We have successfully achieved the integration of isothermal amplification and the subsequent analysis of specific gene fragments on poly(methyl methacrylate) microchips. In our experiments, loop-mediated isothermal amplification, which can offer higher specificity and efficiency than PCR, has been performed at a constant temperature (65 degreesC). After amplification, products could be either examined by the integrated microchip-based electrophoresis or directly observed by naked eye with SYBR Green I added into the reaction solution. By such an integrated microsystem, the amplification and the subsequent analysis of prostate-specific antigen gene with template concentration at 23 fg/muL could be finished within 15 min, which demonstrates its advantages of high specificity, good reproducibility, and fast speed in gene detection.