The use of flow control devices to improve the flow pattern and throughput of sieve trays

Compared to packings trays are more cost effective column internals because they create a large interfacial area for mass transfer by the interaction of the vapour on the liquid. The tray supports a mass of froth or spray which on most trays (including the most widely used sieve trays) is not in any way controlled. The two important results of the gas/liquid interaction are the tray efficiency and the tray throughput or capacity. After many years of practical experience, both may be predicted by empirical correlations, despite the lack of understanding. It is known that the tray efficiency is in part determined by the liquid flow pattern and the throughput by the liquid froth height which in turn depends on the liquid hold-up and vapour velocity. This thesis describes experimental work on sieve trays in an air-water simulator, 2.44 m in diameter. The liquid flow pattern, for flow rates similar to those used in commercial scale distillation, was observed experimentally by direct observation; by water-cooling, to simulate mass transfer; use of potassium permanganate dye to observe areas of longer residence time; and by height of clear liquid measurements across the tray and in the downcomer using manometers. This work presents experiments designed to evaluate flow control devices proposed to improve the gas liquid interaction and hence improve the tray efficiency and throughput. These are (a) the use of intermediate weirs to redirect liquid to the sides of the tray so as to remove slow moving/stagnant liquid and (b) the use of vapour-directing slots designed to use the vapour to cause liquid to be directed towards the outlet weir thus reducing the liquid hold-up at a given rate i.e. increased throughput. This method also has the advantage of removing slow moving/stagnant liquid. In the experiments using intermediate weirs, which were placed in the centre of the tray. it was found that in general the effect of an intermediate weir depends on the depth of liquid downstream of the weir. If the weir is deeper than the downstream depth it will cause the upstream liquid to be deeper than the downstream liquid. If the weir is not as deep as deep as the downstream depth it may have little or no effect on the upstream depth. An intermediate weir placed at an angle to the direction of flow of liquid increases the liquid towards the sides of the tray without causing an increase in liquid hold-up/ froth height. The maximum proportion of liquid caused to flow sideways by the weir is between 5% and 10%. Experimental work using vapour-directing slots on a rectangular sieve tray has shown that the horizontal momentum that is imparted to the liquid is dependent upon the size of the slot. If too much momentum is transferred to the liquid it causes hydraulic jumps to occur at the mouth of the slot coupled with liquid being entrained, The use of slots also helps to eliminate the hydraulic gradient across sieve trays and provides a more uniform froth height on the tray. By comparing the results obtained of the tray and point efficiencies, it is shown that a slotted tray reduces both values by approximately 10%. This reduction is due to the fact that with a slotted tray the liquid has a reduced residence time Ion the tray coupled also with the fact that large size bubbles are passing through the slots. The effectiveness of using vapour-directing slots on a full circular tray was investigated by using dye to completely colour the biphase. The removal of the dye by clear liquid entering the tray was monitored using an overhead camera. Results obtained show that the slots are successful in their aim of reducing slow moving liquid from the sides of the tray, The net effect of this is an increase in tray efficiency. Measurements of slot vapour-velocity found it to be approximately equal to the hole velocity.

TRial of an Educational intervention on patients' knowledge of Atrial fibrillation and anticoagulant therapy, INR control, and outcome of Treatment with warfarin (TREAT)

Background Atrial fibrillation (AF) patients with a high risk of stroke are recommended anticoagulation with warfarin. However, the benefit of warfarin is dependent upon time spent within the target therapeutic range (TTR) of their international normalised ratio (INR) (2.0 to 3.0). AF patients possess limited knowledge of their disease and warfarin treatment and this can impact on INR control. Education can improve patients' understanding of warfarin therapy and factors which affect INR control. Methods/Design Randomised controlled trial of an intensive educational intervention will consist of group sessions (between 2-8 patients) containing standardised information about the risks and benefits associated with OAC therapy, lifestyle interactions and the importance of monitoring and control of their International Normalised Ratio (INR). Information will be presented within an 'expert-patient' focussed DVD, revised educational booklet and patient worksheets. 200 warfarin-naïve patients who are eligible for warfarin will be randomised to either the intervention or usual care groups. All patients must have ECG-documented AF and be eligible for warfarin (according to the NICE AF guidelines). Exclusion criteria include: aged < 18 years old, contraindication(s) to warfarin, history of warfarin USE, valvular heart disease, cognitive impairment, are unable to speak/read English and disease likely to cause death within 12 months. Primary endpoint is time spent in TTR. Secondary endpoints include measures of quality of life (AF-QoL-18), anxiety and depression (HADS), knowledge of AF and anticoagulation, beliefs about medication (BMQ) and illness representations (IPQ-R). Clinical outcomes, including bleeding, stroke and interruption to anticoagulation will be recorded. All outcome measures will be assessed at baseline and 1, 2, 6 and 12 months post-intervention. Discussion More data is needed on the clinical benefit of educational intervention with AF patients receiving warfarin. Trial registration ISRCTN93952605

Design of a stock control methodology for use within an oil blending company

The thesis deals with the background, development and description of a mathematical stock control methodology for use within an oil and chemical blending company, where demand and replenishment lead-times are generally non-stationary. The stock control model proper relies on, as input, adaptive forecasts of demand determined for an economical forecast/replenishment period precalculated on an individual stock-item basis. The control procedure is principally that of the continuous review, reorder level type, where the reorder level and reorder quantity 'float', that is, each changes in accordance with changes in demand. Two versions of the Methodology are presented; a cost minimisation version and a service level version. Realising the importance of demand forecasts, four recognised variations of the Trigg and Leach adaptive forecasting routine are examined. A fifth variation, developed, is proposed as part of the stock control methodology. The results of testing the cost minimisation version of the Methodology with historical data, by means of a computerised simulation, are presented together with a description of the simulation used. The performance of the Methodology is in addition compared favourably to a rule-of-thumb approach considered by the Company as an interim solution for reducing stack levels. The contribution of the work to the field of scientific stock control is felt to be significant for the following reasons:- (I) The Methodology is designed specifically for use with non-stationary demand and for this reason alone appears to be unique. (2) The Methodology is unique in its approach and the cost-minimisation version is shown to work successfully with the demand data presented. (3) The Methodology and the thesis as a whole fill an important gap between complex mathematical stock control theory and practical application. A brief description of a computerised order processing/stock monitoring system, designed and implemented as a pre-requisite for the Methodology's practical operation, is presented as an appendix.

The development of a computer simulation model of the interaction between the supply and usage of major components in car assembly you use in stock control

DUE TO COPYRIGHT RESTRICTIONS ONLY AVAILABLE FOR CONSULTATION AT ASTON UNIVERSITY LIBRARY AND INFORMATION SERVICES WITH PRIOR ARRANGEMENT

Neural Control of Chaos and Aplications

Signal processing is an important topic in technological research today. In the areas of nonlinear dynamics search, the endeavor to control or order chaos is an issue that has received increasing attention over the last few years. Increasing interest in neural networks composed of simple processing elements (neurons) has led to widespread use of such networks to control dynamic systems learning. This paper presents backpropagation-based neural network architecture that can be used as a controller to stabilize unsteady periodic orbits. It also presents a neural network-based method for transferring the dynamics among attractors, leading to more efficient system control. The procedure can be applied to every point of the basin, no matter how far away from the attractor they are. Finally, this paper shows how two mixed chaotic signals can be controlled using a backpropagation neural network as a filter to separate and control both signals at the same time. The neural network provides more effective control, overcoming the problems that arise with control feedback methods. Control is more effective because it can be applied to the system at any point, even if it is moving away from the target state, which prevents waiting times. Also control can be applied even if there is little information about the system and remains stable longer even in the presence of random dynamic noise.

The use of presidential executive orders to control the management and administration of the federal government

As long as governmental institutions have existed, efforts have been undertaken to reform them. This research examines a particular strategy, coercive controls, exercised through a particular instrument, executive orders, by a singular reformer, the president of the United States. The presidents studied-- Johnson, Nixon, Ford, Carter, Reagan, Bush, and Clinton--are those whose campaigns for office were characterized to varying degrees as against Washington bureaucracy and for executive reform. Executive order issuance is assessed through an examination of key factors for each president including political party affiliation, levels of political capital, and legislative experience. A classification typology is used to identify the topical dimensions and levels of coerciveness. The portrayal of the federal government is analyzed through examination of public, media, and presidential attention. The results show that executive orders are significant management tools for the president. Executive orders also represent an important component of the transition plans for incoming administrations. The findings indicate that overall, while executive orders have not increased in the aggregate, they are more intrusive and significant. When the factors of political party affiliation, political capital, and legislative experience are examined, it reveals a strong relationship between executive orders and previous executive experience, specifically presidents who served as a state governor prior to winning national election as president. Presidents Carter, Reagan, and Clinton (all former governors) have the highest percent of executive orders focusing on the federal bureaucracy. Additionally, the highest percent of forceful orders were issued by former governors (41.0%) as compared to their presidential counterparts who have not served as governors (19.9%). Secondly, political party affiliation is an important, but not significant, predictor for the use of executive orders. Thirdly, management strategies that provide the president with the greatest level of autonomy--executive orders--redefine the concept of presidential power and autonomous action. Interviews of elite government officials and political observers support the idea that executive orders can provide the president with a successful management strategy, requiring less expenditure of political resources, less risk to political capital, and a way of achieving objectives without depending on an unresponsive Congress. ^

The use of treatment theories and procedures for postural control in adult with hemiplegia: A national survey

This study investigated the use of treatment theories and procedures for postural control training used by Occupational Therapists (OTs) when working with hemiplegic adults who have had cerebrovascular accident (CVA) or traumatic brain injury (TBI). The method of data collection was a national survey of 400 randomly selected physical disability OTs with 127 usable surveys returned. Results showed that the most common used treatment theory was neurodevelopmental treatment (NDT), followed by motor relearning program (MRP), proprioceptive neuromuscular facilitation (PNF), Brunnstrom's approach, and the approach of Rood. The most common treatment posture used was sitting, followed by standing, mat activity, equilibrium reaction training, and walking. The factors affecting the use of various treatment theories procedures were years certified, years of clinical experience, work situation and work status. Pearson correlation coefficient analyses found significant positive relationships between treatment theories and postures. There were significant high correlations between usage of all pairs of treatment procedures. ^

Signal processing and information fusing algorithms for the synthesis of an alternative electromyogram/eye gaze tracking computer cursor control system

This research pursued the conceptualization and real-time verification of a system that allows a computer user to control the cursor of a computer interface without using his/her hands. The target user groups for this system are individuals who are unable to use their hands due to spinal dysfunction or other afflictions, and individuals who must use their hands for higher priority tasks while still requiring interaction with a computer. ^ The system receives two forms of input from the user: Electromyogram (EMG) signals from muscles in the face and point-of-gaze coordinates produced by an Eye Gaze Tracking (EGT) system. In order to produce reliable cursor control from the two forms of user input, the development of this EMG/EGT system addressed three key requirements: an algorithm was created to accurately translate EMG signals due to facial movements into cursor actions, a separate algorithm was created that recognized an eye gaze fixation and provided an estimate of the associated eye gaze position, and an information fusion protocol was devised to efficiently integrate the outputs of these algorithms. ^ Experiments were conducted to compare the performance of EMG/EGT cursor control to EGT-only control and mouse control. These experiments took the form of two different types of point-and-click trials. The data produced by these experiments were evaluated using statistical analysis, Fitts' Law analysis and target re-entry (TRE) analysis. ^ The experimental results revealed that though EMG/EGT control was slower than EGT-only and mouse control, it provided effective hands-free control of the cursor without a spatial accuracy limitation, and it also facilitated a reliable click operation. This combination of qualities is not possessed by either EGT-only or mouse control, making EMG/EGT cursor control a unique and practical alternative for a user's cursor control needs. ^

The use of presidential executive orders to control the management and administration of the federal government

As long as governmental institutions have existed, efforts have been undertaken to reform them. This research examines a particular strategy, coercive controls, exercised through a particular instrument, executive orders, by a singular reformer, the president of the United States. The presidents studied- Johnson, Nixon, Ford, Carter, Reagan, Bush, and Clinton-are those whose campaigns for office were characterized to varying degrees as against Washington bureaucracy and for executive reform. Executive order issuance is assessed through an examination of key factors for each president including political party affiliation, levels of political capital, and legislative experience. A classification typology is used to identify the topical dimensions and levels of coerciveness. The portrayal of the federal government is analyzed through examination of public, media, and presidential attention. The results show that executive orders are significant management tools for the president. Executive orders also represent an important component of the transition plans for incoming administrations. The findings indicate that overall, while executive orders have not increased in the aggregate, they are more intrusive and significant. When the factors of political party affiliation, political capital, and legislative experience are examined, it reveals a strong relationship between executive orders and previous executive experience, specifically presidents who served as a state governor prior to winning national election as president. Presidents Carter, Reagan, and Clinton (all former governors) have the highest percent of executive orders focusing on the federal bureaucracy. Additionally, the highest percent of forceful orders were issued by former governors (41.0%) as compared to their presidential counterparts who have not served as governors (19.9%). Secondly, political party affiliation is an important, but not significant, predictor for the use of executive orders. Thirdly, management strategies that provide the president with the greatest level of autonomy-executive orders redefine the concept of presidential power and autonomous action. Interviews of elite government officials and political observers support the idea that executive orders can provide the president with a successful management strategy, requiring less expenditure of political resources, less risk to political capital, and a way of achieving objectives without depending on an unresponsive Congress.

Asthma in Asia : Physician perspectives on control, inhaler use and patient communications

Peer reviewed

Determinants of bed net use in The Gambia: implications for malaria control

Malaria is still one of the biggest health threats in the developing world, with an estimated 300 million episodes per year and one million deaths, most of which are in sub-Saharan Africa. Although the efficacy and cost-effectiveness of treated bed nets has been widely reported, little is known about the range, strength, or interaction between different factors that influence their demand at the household level. This study modeled the determinants of bed net ownership as well as the factors that influence the number of bed nets purchased. Data was collected from 1,700 randomly selected households in the Farafenni region of The Gambia. Interviews were also held with 129 community spokespersons to explore the extent to which community level factors such as the quality of roads and access to market centers also influence demand for bed nets. The results of each model of demand and their policy implications are discussed.