Effect of handpiece tip design on the cutting efficiency of an air abrasion system

Purpose : the aim of this study was to evaluate the effect of nozzle angle and tip diameter on the cutting efficiency of an air abrasion system. Materials and Methods: Thirty-six extracted human third molars were air-abraded with the PrepStar microabrasion machine using a handpiece with either 80degrees or 45degrees nozzle angles with 0.38 or 0.48 nun tip orifice diameters. The following parameters were held constant: abrasive particle size (27 mum), air pressure (80 psi), distance (2 mm.) and duration (15 seconds). The cutting efficiency was compared using enamel, dentin and cementum substrates. Width and depth of the cutting patterns were analyzed and measured using scanning electron micrographs. Results: Statistical analysis using three-way ANOVA and Duncan's Multiple Range test revealed that the width of the cuts was significantly greater when the cavities were prepared using the 45degrees nozzle angle. Significantly deeper cavities were produced with the 80degrees nozzle angle. The tip orifice of the nozzle influenced the cutting efficiency in softer substrates, dentin and cementum. Precise removal of hard tissue is best accomplished using the 80degrees angle nozzle tips for all types of tooth surfaces, enamel, dentin and cementum.

Longer wavelengths of light improve the growth, intake and feed efficiency of individually reared juvenile pikeperch Sander lucioperca (L.)

We tested the effects of monochromatic light on the specific growth rate (SGR), feed intake and feed efficiency (FE) of juvenile pikeperch, Sander lucioperca (L.). Pikeperch were reared individually for 42 days in aquaria covered with blue, green, yellow or red gelatin filters or white paper (control; n=5). Linear regression analysis indicated a significant positive effect of longer wavelengths of light on the condition factor (CF), FE and SGR. The final weight, SGR and CF were significantly higher in fish reared under red than under white light, and FE was better under green, yellow and red light than under white light (Dunnett's post hoc test, P < 0.05) while blue was comparable to white light in terms of the measured parameters. After the growth trial, the spectral sensitivity of photoreceptor cells in the retina was tested using microspectrophotometry, which revealed the presence of rods with lambda(max) at ca. 530 nm and two cone classes, absorbing maximally at ca. 535 and 603 nm, all containing a porphyropsin-based pigment. These results suggest that the presence of mid and long wavelength-sensitive cones enhances visual sensitivity under mid-wavelength and long-wavelength environments, and thus supports the finding that longer wavelengths of incoming light can improve FE and SGR of the cultivated pikeperch.

A comparative study of the efficiency of a pro-biotic and the anti-K99 and anti-A14 vaccines in the control of diarrhea in calves in Brazil.

A total of 99 pregnant cows were divided into eight groups submitted to the following treatments: group I (n = 29) consisted of unvaccinated cows whose calves did not receive a probiotic and was used as control. Group II (n = 10) consisted of vaccinated cows whose calves did not receive a probiotic. Groups III, IV and V (n = 10 neach) consisted of vaccinated cows whose calves received a probiotic for 5, 15 and 30 days, respectively. Groups VI, VII and VIII (n = 10 each) consisted of unvaccinated cows whose calves received a probiotic for 5, 15 and 30 days, respectively. Each animal in the vaccinated groups received two 5.0 ml vaccine doses containing pili K99 and A14 of Escherichia coli by the subcutaneous route. The probiotic containing Lactobacillus acidophilus at the dose of 2.0 x 10(8) live cells in 250 ml milk, was administered orally. All animals were observed clinically and bacteriologically and anti-K99 and anti-A14 antibody titers were determined in serum and colostrum. Mean calf weight was measured at birth and at 30 days of age. The results showed that a combination of the vaccine with the probiotic administered for 15 and 30 days was the most efficient treatment for the control of diarrhea.

Efficiency of safety measures applied to a manual knapsack sprayer for paraquat application to Maize (Zea mays L.)

The objectives of the present study were to evaluate the safety of mixer/loaders and applicators of paraquat to maize crop by knapsack sprayers and to determine the efficacy of safety measures applied to the sprayers. Potential dermal exposure (PDE) was evaluated in 22 worker body parts. The Cu2+ cation of a copper-based fungicide was used as tracer in the spray solution. Sanitary pads and cotton gloves were used to collect the pesticide solution on the sampled body parts. It was observed that paraquat application in front of the applicator's body (0.5 and 1.0 m lance) is unsafe because PDE was 1,979.8 ml/day (for 0.5 m lance) and 1,290.4 ml/day (for 1.0 m lance) and needs 50-80% and 37-69% control of PDE respectively. Control can be achieved by the use of protective garment on the legs and feet only, which received 92-93% of the PDE. Switching the spray nozzle to the back of the operator reduced the PDE by 98% and was sufficient to make working conditions safe, while maintaining the efficiency of application and making the work lighter and more comfortable. Mixer/loaders received 86% of the PDE to the hands and the work condition was safe (MOS > 1), however impermeable gloves could be used as a further safety measure.

Measuring the efficiency of outsourcing: An illustrative case study from the aerospace industry

Outsourcing is related to the action which an organization deals with its suppliers through a kind of business contract where a specific activity or service has been hired to be made. The outsourcing of some activities has become a common practice in the industry, nowadays. It reduces costs, significantly, in the production process and, at the same time, adds some values to the business organization. However it is necessary to measure the performance of these activities. Data Envelopment Analysis (DEA) is a non-parametric method useful to measure comparative performance. It has a wide range of applications measuring comparative efficiency. The Analytic Hierarchy Process (AHP) is a multiple criteria decision-making method that uses hierarchic structures to represent a decision problem and then develops priorities for the alternatives based on the decision-maker's judgments. This paper presents an integrated application based on DEA and AHP to evaluate the efficiency of subcontracted companies in a Brazilian aerospace factory. © 2007 Springer-Verlag London Limited.

In vitro antimicrobial efficiency of a mouthwash containing triclosan/gantrez and sodium bicarbonate

Several antiseptic substances have been used as adjuncts to routine mechanical procedures of oral hygiene, based on their antimicrobial effects. The objective of this study was to assess in vitro the antimicrobial efficiency of 2 mouthwash containing Triclosan/Gantrez and sodium bicarbonate in comparison to both positive and negative controls. Standard strain samples of Escherichia coli, Pseudomonas aeruginosa, Actinomyces viscosus and Bacillus subtilis were used. Samples of Streptococcus mutans and Gram-negative bacilli were collected from 20 volunteers (10 with a clinically healthy periodontium and 10 presenting biofilm-associated gingivitis). Evaluation of the antimicrobial activity was performed by determining the minimal inhibitory concentration (MIC). The results indicated that the test solution inhibited the growth of both Gram-negative and Gram-positive microorganisms from the volunteers' saliva as well as that of the standard strains at the MIC dilution of 1:20, whereas the MIC dilution of 0.12% chlorhexidine against the same bacteria was 1:80. Thus, even though the tested mouthrinse solution presented an in-vitro antimicrobial activity superior to that of a placebo, it was inferior to that of chlorhexidine.

Development of a model to measure the efficiency of outsourced companies in the process of aircraft spare parts technical publications

This paper presents a proposal of a model to measure the efficiency of outsourced companies in the aeronautical industry applying the methods DEA and AHP. It also proposes an evaluation in the relation between the variables of the process and the value obtained for the effiiency. The criteria of Quality, Time and Cost were considered the outputs of the process, and those criteria were quantified by AHP for DEA matrix.The number of technical documents received by those outsorced companies were considered the input of the process. The other purpose is to separate the companies in groups considered able to receive an investment to improve their process. Copyright © 2008 SAE International.

On the efficiency of an alternative codification for multiobjective service restoration in electric distribution networks

This paper proposes an alternative codification to solve the service restoration in electric power distribution networks using a SPEA2 multiobjective evolutionary algorithm, assuming the minimization of both the load not supplied and the number of switching operations involved in the restoration plan. Constrains as the line, power source and voltage drop limits in order to avoid the activation of protective devices are all included in the proposed algorithm. Experimental results have shown the convenience on considering these new representations in the sense of feasibility maintenance and also in the sense of better approximation to the Pareto set. ©2009 IEEE.

Economic efficiency of free and open source software in the public sector: the example of Chile

Includes bibliography

How FTAI and FTET impact reproductive efficiency of Brazilian dairy herds

Background: Throughout dairy cows evolution, milk production was always the key point to select the superior animal. Currently, several evidences has shown that high milk production have intensively contributed to the decline of dairy cattle fertility. Beyond milk production, dairy cows have their reproductive performance impaired by another factors, heat stress and repeat-breeding. Methods like fixed time artificial insemination and embryo transfer were developed to minimize the effects of these factors, and improve dairy herds profitability. This review aims to show some key-point experiments conducted to improve the efficiency of the self-appointed protocols for artificial insemination and embryo transfer in Brazil, overcoming several reproductive problems. Our goal is to develop cheap and easy self-appointed programs that facilitate animal handling and maximize their reproductive outcomes all over the year. Review: Failure in estrus detection is the mainly limiting factor for the use of artificial insemination in high-production dairy herd. An excellent alternative to overcome the need of estrus detection is fixed time artificial insemination. Many protocols with and without the use of estradiol have been developed to that end. Among the protocols for fixed time artificial insemination without estradiol, DoubleOvsynch has been extensively used recently in American dairy herds. In Brazil, similar pregnancy rate was obtained compared to progesterone-estradiol based protocols for fixed time artificial insemination. Particularities of progesterone-estradiol based protocols as (1) new progesterone device or devices previously used for eight days; (2) different doses of eCG; and (3) the use of estradiol cypionate for fixed time artificial insemination have been studied in Brazil. The use of self-appointed artificial insemination also enabled the reduction of the interval calving-conception compared to cows inseminated following the standing estrus. Regarding the low fertility of repeat breeders and the effect of heat stress at early pregnancy, other methods like embryo transfer became important tools to enhance reproductive efficiency of Brazilian dairy herds. Protocols were also developed to allow fixed time embryo transfer, eliminating the need of estrus detection and improving the reproductive efficiency of lactating recipients. As well as described for fixed time artificial insemination treatments, there is a large variety of hormone combination for fixed time embryo transfer (with and without estradiol). An experiment conducted in Brazil demonstrated that protocols for fixed time embryo transfer without estradiol can be as good as with estradiol to synchronize high-producing Holstein recipients, essentially during summer. Particularities related to embryos cryopreservation, synchronization of the estrus cycle of donors and recipients and the site of embryo release into the uterine horn were also investigated. Greater conception rates were achieved when fresh embryos were transferred compared to frozen-thawed ones. Also, the tight synchronization between donor and recipient (same day of estrus) resulted more pregnancies than when recipients were one day later or in advantage in relation to donors. Moreover, the site of embryo release into the uterine horn (ipsilateral to the corpus luteum) had no effect on pregnancy rates after in vivo produced embryo transfer. Conclusion: Both fixed time artificial insemination and fixed time embryo transfer are important tools to improve reproductive efficiency of high-producing dairy cows. These biotechnologies help bypassing some of the greatest challenges of dairy cattle reproduction: the difficulties of estrus detection, and the low fertility associated to heat stress and repeat breeding.