Challenges and opportunities in using wastewater analysis to measure drug use in a small prison facility

Introduction and Aims Wastewater analysis (WWA) is intended to be a direct and objective method of measuring substance use in large urban populations. It has also been used to measure prison substance use in two previous studies. The application of WWA in this context has raised questions as to how best it might be used to measure illicit drug use in prisons, and whether it can also be used to measure prescription misuse. We applied WWA to a small regional prison to measure the use of 12 licit and illicit substances. We attempted to measure the non-medical use of methadone and buprenorphine and to compare our findings with the results of the prison's mandatory drug testing (MDT). Design and Methods Representative daily composite samples were collected for two periods of 12 consecutive days in May to July 2013 and analysed for 18 drug metabolites. Prescription data and MDT results were obtained from the prison and compared with the substance use estimates calculated from WWA data. Results Daily use of methamphetamine, methadone, buprenorphine and codeine was detected, while sporadic detection of ketamine and methylone was also observed. Overall buprenorphine misuse appeared to be greater than methadone misuse. Discussion and Conclusions Compared with MDT, WWA provides a more comprehensive picture of prison substance use. WWA also has the potential to measure the misuse of medically prescribed substances. However, a great deal of care must be exercised in quantifying the usage of any substance in small populations, such as in prisons.

ESR measurements of the partitioning of some new spin probes in n-octanol-water

The stable free radical 1,1,3,3-tetramethylisoindolin-2-yloxyl (TMIO) has proved to be very suitable for use as a spin probe for a number of applications. Because it is soluble mainly in non-polar liquids, there is a need for new derivatives that can be used in a variety of environments. This has been done by introducing substituents in the 5-position of the aromatic ring, namely carboxyl (CTMIO), trimethylamino (TMTMIOI) and sodium sulphonate (NaTMIOS). An accurate ESR method was developed for the measurement of partition coefficients in n-octanol–water. For comparison purposes the method was also applied to some Tempo derivatives. The effect of temperature on the rotational correlation times and the nitrogen-14 hyperfine coupling constant of some of the spin probes was investigated. There is evidence for dimerization of CTMIO to form a biradical

Relationships between behavioural traits and liveweight performance of Brahman steers in a feedlot

Large variations in growth and feed conversion efficiency occur between cattle in feedlots. We aimed to test whether different behaviours of cattle may reflect some of these production differences.

Characterization of 26 new microsatellite loci in the dugong (Dugong dugon)

Twenty-six microsatellite loci have been isolated from a dugong (Dugong dugon). The average heterozygosity was 0.52 with two to 10 alleles per locus surveyed from 50 individuals. The markers are suitable for genetic mark-recapture (PID = 5 × 10-16) in dugongs and they could also be used to quantify physical tag loss, estimate relatedness, assign paternity, elucidate population structure and identify migrants.

Social Audit for raising CSR Performance of Banking Corporations in Bangladesh

Corporations' commitment to their social responsibilities has long been a global concern with reference to sustainability, transparency and fair practice, which is of great concern to stakeholders. Corporations are expected to be responsible to the society they operate within and do business in a socially responsible manner.

Atmospheric visibility and PM10 as indicators of new particle formation in an urban environment

It is well-known that new particle formation (NPF) in the atmosphere is inhibited by pre-existing particles in the air that act as condensation sinks to decrease the concentration and, thus, the supersaturation of precursor gases. In this study, we investigate the effects of two parameters - atmospheric visibility, expressed as the particle back-scatter coefficient (BSP), and PM10 particulate mass concentration, on the occurrences of NPF events in an urban environment where the majority of precursor gases originate from motor vehicle and industrial sources. This is the first attempt to derive direct relationships between each of these two parameters and the occurrence of NPF. NPF events were identified from data obtained with a neutral cluster and air ion spectrometer over 245 days within a calendar year. Bayesian logistic regression was used to determine the probability of observing NPF as functions of BSP and PM10. We show that the BSP at 08 h on a given day is a reliable indicator of an NPF event later that day. The posterior median probability of observing an NPF event was greater than 0.5 (95%) when the BSP at 08 h was less than 6.8 Mm-1.

Sustainable productivity improvements in allium and solanaceous vegetable crops in Indonesia and sub-tropical Australia

The most important vegetable crops grown in Indonesia, and particularly lowland coastal production, are the true shallot and chilli. These crops are usually grown in rotation with rice but are far more valuable crops and are increasingly in high demand. They offer an opportunity for small farmers to generate extra income, increase farm profitability and shift away from subsistence production. However, the yield and profitability of shallot and chilli production is severely limited by a range of agronomic constraints. This project aims towards raising the productivity of allium (shallot and garlic) and chilli/capsicum cropping systems. The methodology will include a benchmarking survey and review of grower practices. This will be supplemented with physical surveys of crops for disease incidence and efficiency of fertiliser use. Once surveys are completed in Indonesia and the important pathogens identified, recommendations can be made for disease management. This will include review of chemical usage in Indonesia and Australia to provide best management guidelines for the application of insecticides, fungicides and other chemicals.

Influence of cyclonic winds on the performance of hardwood plantations in tropical north Queensland.

Severe Tropical Cyclone Yasi crossed the far north Queensland coast at Mission Beach on February 3rd, 2011, shattering the regions developing hardwood plantation industry. The cyclone’s path covered the primary areas of hardwood and softwood plantations in this region, causing widespread destruction. The extent of cyclone damage, coupled with the weak international economy has resulted in a severe decline in industry confidence for the future of timber plantations in this region. This report reviews the impacts of Severe TC Yasi on the performance of key hardwood plantation species in north Queensland. It summarises the influence of species, genetics, plantation design, management and age on plantation resilience. The information will contribute to a “Best Practice Guide for Timber Plantations in Cyclonic Areas” to be produced by Timber Queensland. This will assist companies with future plantation investment decisions in the tropical cyclone zone. 2 200 trees were assessed, including 44 species at 32 localities located from Daintree to Townsville. Data are also presented for a post-cyclone assessment of 5 900 African mahogany trees on four sites in the Ingham region. A report prepared for the Timber Queensland project: Best Practice Guide for Timber Plantations in Cyclonic Areas.

Construction timbers in Queensland. Book 1 and Book 2: Properties and specifications for satisfactory performance of construction timbers in Queensland. Class 1 and Class 10 buildings (houses, carports, garages, greenhouses and sheds). 2013 edition.

This publication lists the more important wood properties of commercial timbers used for construction in Queensland. It also provides requirements and conditions of use for these timbers to provide appropriate design service life in various construction applications. The correct specification of timber considers a range of timber properties including, but not limited to, stress grade; durability class; moisture content and insect resistance. For the specification of timber sizes and spans, relevant Australian Standards and design manuals should be consulted—e.g. Australian Standard AS 1684 series Residential timber—framed construction parts 2 and 3 (Standards Australia 2006a;b.) Book 1 explains the terms used; with reference to nomenclature; origin and timber properties presented under specific column headings in the schedules (Book 2). It also explains target design life; applications and decay hazard zones; presented in the Book 2 Schedules. Book 2 consists of reference tables; presented as schedules A; B and C: • Schedule A contains commercial mixtures of unidentified timbers and of some Australian and imported softwoods. Index numbers 1–10 • Schedule B contains Australian-grown timber species; including both natural forests and plantations. Index numbers 11–493 • Schedule C contains timbers imported into Australia from overseas. Index numbers 494–606 Each schedule has two parts presenting data in tables. • Part 1: Nomenclature, origin and properties of imported timber species • Part 2: Approved uses for commercial mixtures of imported timber species The recommendations made in this publication assume that good building practice will be carried out.

2-O-methyl-1-methyl adenosine: A new modified nucleoside in ragi (eleusine coracana ) tRNA

A new modified nucleoside 2-²-O-methyl-l-methyl adenosine has been found to be present in the tRNA of (eleusine coracana ) (ragi) seedlings. The sequence of the dinucleotide of which this modified nucleoside is a part suggests its presence in phenylalanine-tRNA. The structural implications of the presence of this new modification are discussed.

Components of productivity growth in Finnish agriculture

The objective was to measure productivity growth and its components in Finnish agriculture, especially in dairy farming. The objective was also to compare different methods and models - both parametric (stochastic frontier analysis) and non-parametric (data envelopment analysis) - in estimating the components of productivity growth and the sensitivity of results with respect to different approaches. The parametric approach was also applied in the investigation of various aspects of heterogeneity. A common feature of the first three of five articles is that they concentrate empirically on technical change, technical efficiency change and the scale effect, mainly on the basis of the decompositions of Malmquist productivity index. The last two articles explore an intermediate route between the Fisher and Malmquist productivity indices and develop a detailed but meaningful decomposition for the Fisher index, including also empirical applications. Distance functions play a central role in the decomposition of Malmquist and Fisher productivity indices. Three panel data sets from 1990s have been applied in the study. The common feature of all data used is that they cover the periods before and after Finnish EU accession. Another common feature is that the analysis mainly concentrates on dairy farms or their roughage production systems. Productivity growth on Finnish dairy farms was relatively slow in the 1990s: approximately one percent per year, independent of the method used. Despite considerable annual variation, productivity growth seems to have accelerated towards the end of the period. There was a slowdown in the mid-1990s at the time of EU accession. No clear immediate effects of EU accession with respect to technical efficiency could be observed. Technical change has been the main contributor to productivity growth on dairy farms. However, average technical efficiency often showed a declining trend, meaning that the deviations from the best practice frontier are increasing over time. This suggests different paths of adjustment at the farm level. However, different methods to some extent provide different results, especially for the sub-components of productivity growth. In most analyses on dairy farms the scale effect on productivity growth was minor. A positive scale effect would be important for improving the competitiveness of Finnish agriculture through increasing farm size. This small effect may also be related to the structure of agriculture and to the allocation of investments to specific groups of farms during the research period. The result may also indicate that the utilization of scale economies faces special constraints in Finnish conditions. However, the analysis of a sample of all types of farms suggested a more considerable scale effect than the analysis on dairy farms.

Review of productivity decline in sown grass pastures

Productivity decline in sown grass pastures is widespread in northern Australia and reduces production by approximately 50%, a farm gate cost to industry of > $17B over the next 30 years. Buffel grass is the most widely established sown species (>75% of plantings) and has been estimated to be “dominant” on 5.8 M hectares and “common” on a further 25.9 M hectares of Queensland. Legumes are the most cost effective mitigation option and can reclaim 30-50% of lost production. Commercial use of legumes has achieved mixed results with notable successes but many failures. There is significant opportunity to improve commercial results from legumes using existing technologies, however there is a need for targeted research to improve the reliability of establishment and productivity of legumes. This review recommends the grazing industry invest in targeted R,D&E to assist industry in improving production and sustainability of rundown pastures.