978 resultados para 13077-065
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Dados de crescimento e reprodução de 573 vacas da raça Guzerá, nascidas entre 1961 e 1985, na Fazenda Canoas, em Curvelo, MG, foram analisados com o objetivo de estabelecer um padrão médio de crescimento, mediante o uso de um modelo matemático que se ajuste adequadamente aos dados. Os modelos Brody, Bertalanffy, Logístico, Gompertz e Richards foram ajustados aos dados de peso/idade, coletados até 1992, e comparados quanto à qualidade de ajustamento. Os pesos assintóticos e as taxas de maturidade estimadas foram, respectivamente: para o modelo Brody, 464,49 e 0,046; para o Bertalanffy, 453,18 e 0,065; para o Logístico, 447,05 e 0,085; para o Gompertz, 449,89 e 0,075, e para o Richards, 458,26 e 0,055. O modelo Richards apresentou dificuldades computacionais para ajustamento aos dados. Os outros modelos se revelaram adequados para descrever o crescimento nesses animais, apresentando pequenas variações na qualidade de ajustamento, de acordo com os critérios utilizados. O modelo Bertalanffy foi escolhido para representar a curva média de crescimento dos animais, por apresentar um ajustamento superior no conjunto dos critérios.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
The objective of this research was to measure the activity of e-desaturase enzyme in lactating buffaloes. Data from forty lactating Murrah-crossbred buffaloes were collected on five commercial farms located at Sarapui and Pilar do Sul, São Paulo-Brazil. A field survey was done from April to November 2002. In four farms, buffaloes were fed with wet brewers grains (primary concentrate). Only one farm (Farm 4) offered pasture and corn silage. Monthly milk samples were collected and stored at -20 degrees C until analyzed for fatty acid composition. The Delta(9)-desaturase activity was measured using an indirect method (myristoleic and myristic acids ration - C(14:1c9)/C(14:0)). The higher C(14:1c9)/C(14:0) rate was verified on Farm 4 (0.092). The C(14:1c9)/C(14:0) ratio were 0.064 to Farm 1; 0.065 to Farm 2; 0.062 to Farm 3 and 0.065 to Farm 5. The C(17:1)/C(17:0), C(18:1c9)/C(18:0) and C(18:2c9t11)/C(18:1t11) ratios were also affected. The Farm 4 showed higher value for all ratios. Therefore, in lactating buffaloes grazing pasture the Delta(9)-desaturase activity could be enhanced.
Crystal structure of bis(benzyltriethylammonium) hexachlorotellurate(IV), [C7H7(C2H5)(3)N](2)(TeCI6)
Resumo:
C26H44Cl6N2Te, monoclinic, P12(1)/n1 (no. 14), a = 9.3981(5) Angstrom, b = 14.606(1) Angstrom, c = 12.4524(7) Angstrom, beta = 108.335(5)degrees, V = 1622.6 Angstrom(3), Z = 2, R-gt(F) = 0.024, wR(ref)(F-2) = 0.065, T = 293 K.
Resumo:
The preparation of crack-free SnO2 supported membranes requires the development of new strategies of synthesis capable to allow controlled changes of surface chemistry and to improve the processability of supported layers. In this way, the controlled modification of the SnO2 nanoparticle surface by adding capping molecules like Tiron(R) ((OH)(2)C6H2(SO3Na)(2)) during the sol-gel process was studied, aiming to obtain high performance membranes. Colloidal suspensions were prepared by hydrolyzing SnCl4.5H(2)O aqueous solution with NH4OH in presence of Tiron(R). The effect of the amount of Tiro(R) (from I to 20 wt.%) on the structural features of nanoparticles, powder redispersability and particle-solution interface properties was investigated by X-ray powder diffraction (XRPD), extended X-ray absorption fine structure (EXAFS), quasi-elastic light scattering and electrophoretic mobility measurements. XRPD and EXAFS results showed that the addition of Tiron(R) up to 20 wt.% to colloidal suspensions does not affect the crystallite size of SnO2 primary particles, determined around 2-3 nm. This value is comparable to the hydrodynamic size measured after redispersion of powder prepared with amount of Tiro(R) higher than 7.5 wt.%, indicating the absence of condensation reactions between primary particles after the initial precipitation step. As a consequence the powder with amount of Tiron(R) > 7.5 wt.%, can be fully redispersed in aqueous solution at pH greater than or equal to I I until a nanoparticle concentration of 6 vol.%. The electrophoresis measurements showed a decrease of the isoelectric point by increasing the amount of grafted Tiron(R) at the SnO2 nanoparticle surface, resulting in negatively charged particle-solution interface in all the studied pH range (2-11). These features govern the gelation process favoring the preparation of crack-free SnO2 supported membranes. The control exercised by Tiron(R) modifying agent in the aggregation process allows the fine-tuning of the porosity, from 0.124 to 0.065 cm(3) g(-1), and mean pore size, from 6.4 to 1.9 nm, as the amount of grafted molecules increases from 0 to 10 wt.%. In consequence, the membrane cut-off determined by filtration of polyethylene glycol standard solutions can be screened from 1500 to 3500 g mol(-1). (C) 2002 Elsevier B.V. B.V. All rights reserved.
Resumo:
A capillary zone electrophoresis method using indirect UV detection for the analysis of chloride and sulfate in alcohol fuel samples was developed. The anions were analyzed in less than 3 min using an electrolyte containing 10 mmol 1(-1) chromate and 0.75 mmol 1(-1) hexamethonium bromide (HMB) as electroosmotic flow modifier. Coefficients of variation were better than 0.6% for migration time (n = 10) and between 2.05 and 2.82% for peak area repeatabilities. Analytical curves of peak area versus concentration in the range of 0.065-0.65 mg kg(-1) for chloride and 0.25-4.0 mg kg(-1) for sulfate were linear with coefficients of correlation higher than 0.9996. The limits of detection for sulfate and chloride were 0.033 and 0.041 mg kg(-1), respectively. Recovery values ranged from 85 to 103%. The method was successfully applied for the quantification of sulfate and chloride in five alcohol fuel samples. The concentration of sulfate varied from 0.45 to 3.12 mg kg(-1). Chloride concentrations were below the method's LOD.
Resumo:
The object of this work was to study the conditions of embryo development and egg production in Portunus spinimanus Latreille, 1819 at Ubatuba region of Brazil. The number of eggs laid by 21 females in a range of size was determined. Eggs at 3 differ ent stages of embryonic development were measured P. spinimanus fecundity varied between 188,065 and 682,992, with an average of 429,676 +/- 157,203, for animals with a carapace width ranging from 56.2 to 86.6 mm. Between the initial and final stages of development there was an increase of 55.1% in egg diameter. The relatively high fecundity of P. spinimanus may be a strategy of the species faced with a high mortality rate in the larval phase; however this hypothesis should be tested.
Resumo:
Calcium modified lead titanate sol was synthesized using a soft solution processing, the so-called polymeric precursor method. In soft chemistry method, soluble precursors such as lead acetate trihydrate, calcium carbonate and titanium isopropoxide, as starting materials, were mixed in aqueous solution. Pb0.7Ca0.3TiO3 thin films were deposited on platinum-coated silicon and quartz substrates by means of the spinning technique. The surface morphology and crystal structure, dielectric and optical properties of the thin films were investigated. The electrical measurements were conducted on metal-ferroelectric-metal (MFM) capacitors. The typical measured small signal dielectric constant and dissipation factor at a frequency of 100 kHz were 299 and 0.065, respectively, for a thin film with 230 nm thickness annealed at 600degreesC for 2 h. The remanent polarization (2P(r)) and coercive field (E-c) were 32 muC/cm(2) and 100 kV/cm, respectively. Transmission spectra were recorded and from them, refractive index, extinction coefficient, and band gap energy were calculated. Thin films exhibited good optical transmissivity, and had optical direct transitions. The present study confirms the validity of the DiDomenico model for the interband transition, with a single electronic oscillator at 6.858 eV. The optical dispersion behavior of PCT thin film was found to fit well the Sellmeir dispersion equation. The band gap energy of the thin film, annealed at 600degreesC, was 3.56 eV. The results confirmed that soft solution processing provides an inexpensive and environmentally friendly route for the preparation of PCT thin films.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
The objective of this experiment was to determine the protein requirements for hen pullets from 1 to 18 weeks of age, by factorial method, using the nitrogen balance and the comparative slaughtering techniques. Protein requirements for maintenance, was obtained by the nitrogen balance technique using four diets with different protein levels (18,9, 4 and 2% of CP) aiming to obtain positive balance, next to zero and negative nitrogen balance. The endogenous nitrogen losses (0.2575 g of N/kg·75/day) was obtained by regression of nitrogen balance (NB) on ingestion nitrogen (IN). The requirements of nitrogen for maintenance was estimated by the intercept of axis X (0.3831 g of N/kg·75/day). The slope of the straight line still supplied the efficiency of N of the diet (67.21%). The regression coefficients of the equation represented the requirements of net nitrogen for weight gain. Considering the conversion efficiencies of nitrogen of the diet into nitrogen for weight gain, the requirements of nitrogen were determined for weight gain of .065, .087g and .090 g of N per gram of weight gain, for the phases 1 to 6, 7 to 12, and 13 to 18 weeks of age, respectively. Based on the results, three equations of prediction of the daily nitrogen requirements were fitted in function of live weight (LW in kg) and daily weight gain (G in g): 1 to 6 weeks N=.3831 x BW·75 + G .065, 7 to 12 weeks N=.3831 × BW·75 + G .087, and 13 to 18 weeks N=.3831 × BW·75 + G .090.