Thumb metastasis from small cell lung cancer treated with radiation

A rare case of thumb metastasis from small cell lung cancer is presented. The patient underwent local radiotherapy with complete palliation of symptoms. She died 4 months later with disseminated disease. Considerations about incidence, treatment, and physiopathology of this kind of dissemination are made. Conservative treatment of finger metastasis with radiation may be considered due to the poor outcome of these patients.

Concomitant involvement of the small intestine and the distal esophagus in an infant with massive necrotizing enterocolitis

Necrotizing enterocolitis is a disease of the newborn that may involve the small intestine and/or the colon, and the stomach. To our knowledge, massive necrosis of the small intestine with concomitant involvement of the esophagus has never been reported. A case of a 6-month-old boy with necrotizing enterocolitis and pan-necrosis of the small intestine, cecum, and the lower third of the esophagus is presented. After 70 days of treatment, intestinal transit was established by an anastomosis between the first centimeter of jejunum and the ascending colon. Finally, esophageal transit was established by a total gastric transposition with cervical esophagogastric anastomosis. The patient was maintained under total parenteral nutrition, and after 19 months he developed fulminant hepatic failure due to parenteral nutrition; he then underwent combined liver and small bowel transplantation. After 2 months, the patient died due to undefined neurologic complications, probably related to infection or immunosuppressive therapy.

Small mammal abundances in isolated and non-isolated primary forest reserves near Manaus, Brazil

Abundances of msmall terrestrial mammals were estimated in 10 and 100-ha, isolated and non-isolated primary forest reserves near, Manaus, Brazil between October 1983 and March 1984. The smalt mammal abundance pattern In a 10 ha reserve isolated fan appoximately three years differed significantly from that in othen reserves, primarily due to higher capture rates of Marmosa cinerea, Rhipidomys mastacalis, and Onyzomys paricola in the isolated reserve. Viet type and re-invasion potential may be important factors the small mammal communities in forest patches. Variation the small mammal community among othen reserves was pnimanlty due to variatton In the abundances of Proechimys and 0. capito. At least pant of this vantation was attributable to temporal efects, but variation due to reserve effects also was suggested. Small mammals were much more abundant in the reserves during the present study than in 1982.

The persistence of ant-following birds in small amazonian forest fragments

SUMMARYMist-net captures of army ant-following bird were monitored during the isolation of central Amazonian forest fragments of 1 ha (n = 5), 10 ha (n = 4) and 100 ha (n = 1). Post-isolation captures of the three obligate ant-following birds Dendrocinela merula, Pithys albifrons, and Gymnopithys rufigula decreased significantly in all fragments. post-isolation captures of four facultative ant-following species were not significantly different in forest fragments of 1 ha and 10 ha, although two species decreased significantly in the 100 ha fragment. Experimental introductions of obligate species into small forest fragments in the absence and presence of introduced Eciton burchelli army ant colonies resulted in significantly greater recaptures of introduced birds when active army ant colonies were present. Of the 105 birds introduced, 58 ' 55%) crossed 100-320 m od dedorested area an were recaptured in continuous forest.

A minimal version of a Protein Tyrosine Phosphatase

Phosphatase and tensin homologue (PTEN) protein belongs to the family of protein tyrosine phos-phatase. Mutations on the phosphatase and tensin homologue (PTEN) protein are highly observed in diverse types of human tumors, being mostly identified on the phosphatase domain of the protein. Although PTEN is a modular protein composed by a phosphatase domain and a C2 domain for mem-brane anchoring, this work aimed at developing a minimal version of PTEN´s phosphatase domain. The minimal version (Small Domain) comprises a 28 residue peptide, with the PTEN 8-mer catalytic peptide accommodated between a α-helix and β-turn as observed in PTEN native structure. Firstly, a de novo prediction of the Small Domain´s secondary structure was carried out by molecular modeling tools. The stability of the predicted structures were then evaluated by Molecular Dynamics. Automated molecular docking of PTEN natural substrate PIP3, its analogue (Inositol) and a PTEN inhibitor (L-tar-tare) were performed with the modeled structure, and PTEN used as a positive control. The gene en-coding for Small Domain was designed and cloned into an expression vector at N-terminal of Green Fluorescence Protein (GFP) encoding gene. The fusion protein was then expressed in Escherichia coli cells. Different expression conditions have been explored for the production of the fusion protein to minimize the formation of inclusion bodies.

How small accounting firms can compete in an environment in which the big four are getting bigger

This paper sets out to determine how small accounting firms can compete in the United States in the early 21st century. The first chapter identifies the central goal of the paper: namely, to use existing literature and market data to define a business strategy for Ross & Moncure, Inc., a small accounting firm in the metropolitan Washington area. The second chapter is a literature review, and in it the author finds that large accounting firms are advantaged in terms of reputation, ability to diversify, and ability to retain employees, but are disadvantaged in their ability to form longstanding successful relationships with clients. In the third chapter, the author explores the relationship between the Big Four firms and their employees. The goal of this chapter is to determine how small accounting firms can compete for top talent in the HR market, and the author finds that this can be done by offering faster career progression and more client interaction. The fourth chapter looks at the market for accounting services in the United States, exploring the different options that consumers have to meet their accounting needs. It is found in this chapter that big and small accounting firms tend to compete for clients of different profiles. In the fifth chapter, the author uses proprietary company data to explore the composition, existing strategy and culture of Ross & Moncure. In the sixth chapter, all of the previous chapters come together to formulate a strategy and plan for action for Ross & Moncure: specifically, that the firm should further cultivate networks and relationships, and should create a fulfilling professional environment by increasing client-employee interaction, encouraging external education, and allowing employees to take on many different projects

Affordable prefabricated modular houses using cement and polymer based materials and advanced design tools

By taking advantage of the appropriate use of cement and polymer based materials and advanced computational tools, a pre-fabricated affordable house was built in a modular system. Modular system refers to the complete structure that is built-up by assembling pre-fabricated sandwich panels composed of steel fibre reinforced self-compacting concrete (SFRSCC) outer layers that are connected by innovative glass fibre reinforced polymer (GFRP) connectors, resulting in a panel with adequate structural, acoustic, and thermal insulation properties. The modular house was prepared for a typical family of six members, but its living area can be easily increased by assembling other pre-fabricated elements. The speed of construction and the cost of the constructive elements make these houses competitive when compared to traditional solutions. In this paper the relevant research subjacent to this project (LEGOUSE) is briefly described, as well as the construction process of the built real scale prototype.

Strategies of the small-scale fisheries on the Central Amazon floodplain

A multivariate approach was applied to data of small-scale fisheries developed in Central Amazon, using information about catch composition, environment, fishing gear and season of the hydrological cycle. The correspondence analysis demonstrated to be a good tool for the analysis related multispecies fisheries. The analysis identified patterns of use of fisheries resources by the riverine communities, showing the correlation between the environmental factors and the fishing strategy for the capture of target fish species, indicating the high level of empiric knowledge about the environment and fisheries.

Dispersion and re-agglomeration of graphite nanoplates in polypropylene melts under controlled flow conditions

The kinetics of GnP dispersion in polypropylene melt was studied using a prototype small scale modular extensional mixer. Its modular nature enabled the sequential application of a mixing step, melt relaxation, and a second mixing step. The latter could reproduce the flow conditions on the first mixing step, or generate milder flow conditions. The effect of these sequences of flow constraints upon GnP dispersion along the mixer length was studied for composites with 2 and 10 wt.% GnP. The samples collected along the first mixing zone showed a gradual decrease of number and size of GnP agglomerates, at a rate that was independent of the flow conditions imposed to the melt, but dependent on composition. The relaxation zone induced GnP re-agglomeration, and the application of a second mixing step caused variable dispersion results that were largely dependent on the hydrodynamic stresses generated.

Environment, health and safety policy in small construction sites: an analysis of the situation in Brazil

This paper analyzes the safety, environmental and occupational health of workers in the small construction industry in Brazil. In this sector there are still many unsafe practices, which are very common in small work sites. We used a qualitative approach to understand these problems by long interviews with people who work directly in small construction sites, including occupational physicians, civil engineers, safety engineers, safety technicians, general foremen, construction workers, labor unionists and auditors. This paper aims to demonstrate that the "invisibility" of the small sites workers makes them less safe and therefore more prone to accidents, also weakening their health. The results show that small constructions workers are less visible to society and supervision because of their short periods of work. Therefore, they are also uncovered to the rigorous applicability of principles of safety and accident prevention. Thus, it has been seen in this field of work a precarious application of NR - 18, which was specifically made for the construction sites and it needs simplification to meet normative characteristics of small construction sites. In the State of Rio de Janeiro, some laws on small sites were recently created and implemented. This study concludes that the rules to work are not being taken as seriously as the legislation determinates, remaining practically unknown by many professionals, from the plot command, supervisors, engineers, architects and technicians who work on construction sites. This ignorance creates space for the lack of safety and consequently to accidents, leading to by weakness in the workers health. Therefore, the work process needs to be modified, the safety regulation must be disseminated through safer practices, promoting employee health and ensure that the work of small sites can be visible, especially ensuring the construction workers health and safety.

Evidence for inter- and intra-species biofilm formation variability among a small group of coagulase-negative staphylococci

Coagulase-negative staphylococci (CoNS) are common bacterial colonisers of the human skin. They are often involved in nosocomial infections due to biofilm formation in indwelling medical devices. While biofilm formation has been extensively studied in Staphylococcus epidermidis, little is known regarding other CoNS species. Here, biofilms from six different CoNS species were characterised in terms of biofilm composition and architecture. Interestingly, the ability to form a thick biofilm was not associated with any particular species, and high variability on biofilm accumulation was found within the same species. Cell viability assays also revealed different proportions of live and dead cells within biofilms formed by different species, although this parameter was particularly similar at the intra-species level. On the other hand, biofilm disruption assays demonstrated important inter- and intra-species differences regarding extracellular matrix composition. Lastly, confocal laser scanning microscopy (CLSM) experiments confirmed this variability, highlighting important differences and common features of CoNS biofilms. We hypothesised that the biofilm formation heterogeneity observed was rather associated with biofilm matrix composition than with cells themselves. Additionally, our results indicate that polysaccharides, DNA and proteins are fundamental pieces in the process of CoNS biofilm formation.

Engineering modular viral scaffolds for targeted bacterial population editing

Bacteria are central to human health and disease, but existing tools to edit microbial consortia are limited. For example, broad-spectrum antibiotics are unable to precisely manipulate bacterial communities. Bacteriophages can provide highly specific targeting of bacteria, but assembling well-defined phage cocktails solely with natural phages can be a time-, labor- and cost-intensive process. Here, we present a synthetic biology strategy to modulate phage host ranges by engineering phage genomes in Saccharomyces cerevisiae. We used this technology to redirect Escherichia coli phage scaffolds to target pathogenic Yersinia and Klebsiella bacteria, and conversely, Klebsiella phage scaffolds to target E. coli by modular swapping of phage tail components. The synthetic phages achieved efficient killing of their new target bacteria and were used to selectively remove bacteria from multi-species bacterial communities with cocktails based on common viral scaffolds. We envision this approach accelerating phage biology studies and enabling new technologies for bacterial population editing.

Different module placements in a modular façade system for natural ventilation

Nowadays natural ventilation has gained prominence because its correct use can reduce energy consumption for cooling systems and improve thermal comfort among users. In this paper, we report on the modelling initiative, based on the wind tunnel tests that were carried out for the determination of the influence of natural ventilation in buildings. Indeed, the renewal of air in a closed environment without using an air conditioning system with mechanical elements can lead to energy savings and, in addition, provide air quality.The wind tunnel tests were carried out by varying the positioning of six ventilation modules in the façade system configuration. The modules were positioned below the window-sill (ventilated window-sill) as well as separately above and below the façade. The wind speed measurements were taken inside and outside the model for the different façades configurations to evaluate the best performance in relation to natural ventilation. The results supported the positioning of the six ventilation modules below the window-sill, forming a â ventilated window-sillâ as the most effective natural ventilation solution.

Study of natural ventilation for a modular façade system in wind tunnel tests

Wind tunnel tests are a reliable tool to determine the effect of natural ventilation on buildings. This paper presents results of wind tunnel tests conducted to evaluate the influence of ventilation modules positioning on a façade system. Modules positioning was modified, resulting in different façade configurations. The tests were carried out with the use of a model, varying the position of the ventilation modules in the façade configuration. The cases tested were six ventilation modules positioned below the window-sill (ventilated window-sill), and three ventilation modules positioned above and below the façade. The façade system proposed was movable and interchangeable so that the same basic model could be used to test the possibilities for ventilation. Wind speed measurements were taken inside and outside the model for the different façades configurations to evaluate the best performance in relation to natural ventilation. Singleâ sided and Cross ventilation were considered for wind speed measurements. Results show the use of six ventilation modules positioned below the window-sill, forming "a ventilated window-sill" is the best solution in terms of natural ventilation.

Design modular: Solução sustentável aplicada aos resíduos limpos na indústria do couro

ISSN 19820941