1000 resultados para quirera de arroz
Resumo:
Currently, the accumulation of rice husk is a serious environmental problem. The burning of rice husk generates a considerable volume of ash, that falls to the ground and gets into the air and the rivers, causing a disequilibrium in the ecosystem. This motived research into solutions that aim to exploit the husks for energy generation and the ashes for developing diverse technological products. This work presents the possibilities of using rice husks and their ashes after burning.
Resumo:
A comparison between silica by acid leaching of rice husk (RH) and silica obtained from thermal treatment of rice husk ash (RHA) is presented. The best leaching results were obtained using 10% hydrochloric acid followed by washing with water. The alternative method, calcination of RHA at 700 ºC for 6 h followed by grinding for 80 min, was more effective. Silica obtained from RH was about 97% amorphous, had a 17.37 µm mean particle size, and a specific surface area of 296 m²/g. On the other hand, for silica obtained from RHA the values were about 95% amorphous material 0.68 µm, and 81 m²/g.
Resumo:
This work consists in a study about the chemical activation of charred rice hulls using NaOH as the activation agent. The influence of the naturally-occurring silica was particularly evidenced. X-ray diffraction patterns showed the formation of sodium carbonate and silicates in the activated samples, whereas thermogravimetric curves revealed a strong reduction in the ash content of these samples after washing with water. Nitrogen adsorption data indicated a microporosity development only in the washed samples, with BET surface area values of 450 and 1380 m²/g achieved for the samples activated at 800 °C starting from the precursor with or without silica, respectively.
Resumo:
Evaluation of the pollution by the herbicides alachlor, propanil and atrazine in water samples from four rivers in the cities of Turvo and Meleiro, south of Santa Catarina State, was made using the SPME-GC-ECD method. The proposed method was optimized and validated. The correlation coefficients were higher than 0.997 and linear ranges of the analytical curves were 0.1-4; 0.1-2.5 and 0.1-5 µg L-1 for atrazine, alachlor and propanil, respectively. The herbicides were quantified by GC-ECD and identified by GC-MS. Both of the selected rivers presented contamination by at least one of the studied herbicides.
Resumo:
The objective of the present work was to evaluate the distribution of Cd, Cu, Mn, Pb and Zn among the different fractions of contaminated soil, before and after rice cultivation. Seven soil samples with different degrees of contamination were studied using a randomized experimental design, with four replicates. Using an ICP-OES we analyzed the contents of heavy metals in fractions of soil, the organic matter therein, the oxides and the residual content before and after rice cultivation. The largest concentrations of Cd, Cu, Mn and Zn in the soil are found in the fractions with stable chemical bonds.
Resumo:
The rice husk combustion in a bubbling and atmospheric fluidized bed reactor was investigated. This paper presents the rice husk ash characterization employing the techniques of X-ray diffraction (XRD), X-ray fluorescence (XRF), and scanning electron microscopy (SEM) among others. After combustion, a rice husk ash containing 93% amorphous silica and <3% unburned char was produced. Methods usually applied to fixed bed considering external sources of energy and high reaction times were employed. Thus, the potential of this type of reactors with respect to speed, continuity and self-sufficiency energy of the process was shown.
Resumo:
The removal study was conducted using 1.00 g of the rice husk ash (RHA) and 20.0 mL solution with concentrations in the range of 10-1000 mg/L of Zn(II). The influence of contact time, initial metal concentration, agitation and pH of the removal process was investigated. Superior removals to 95% were obtained at the end of 24 h of contact. The agitation increased in 20% the removal of Zn(II), being needed only 5 min to reach the equilibrium. The adsorption process was studied by the models of isotherms of Langmuir, Freundlich and BET, obtaining results of R L and 1/n for a process favorable of adsorption. BET isotherm best represents the equilibrium adsorption. The results showed that the RHA has the largest capacity and affinity for the removal of Zn(II).
Resumo:
The aim of this work was to study the enzymatic modification on rice flour using lipase pancreatic and amyloglucosidase to obtain resistant starch. For this, Response Surface Methodology (RSM) was used to determine the best operating conditions for each enzyme. For lypase pancreatic, the highest value for resistant starch (45%) was achieved within 2 h reaction at pH 7 using an enzyme/substrate ratio of 4% (w/w) and Dp= 100/200 tyler. For amyloglucosidase, optima conditions corresponded to an enzyme/substrate ratio of 0,006 mL/g and Dp= 100/200 tyler at 45 ºC, yielding 57% of resistant starch in 2 h reaction. These results show the potential of using both enzymes to modified rice flour, increasing the resistant starch in about 5.7 folds in relation to the flour without treatment (resistant starch=10.6%).
Resumo:
Poly (3-hydroxybutyrate) (P(3HB)) is a biopolymer, completely biodegradable, which has similar properties to fuel-based polymers. However to make it economically competitive it is necessary the study of cheap sources of substrate. The influence of hydrolyzed rice starch supplemented with soybean oil at different temperatures (30, 35 and 40 °C) was studied in the production of P(3HB) by C. necator. The percentage of P(3HB) produced in the cultures at 30, 35 °C was 30, 39% and 35, 43% without and with supplementation of oil, respectively. The culture at 40 °C showed no production phase due to a possible oxygen limitation. These results demonstrate that hydrolyzed rice starch supplemented with soybean oil increases the yield of P(3HB) and temperature of 35 ºC is the most favorable for biopolymer production.
Resumo:
The potential use of rice husk as biosorbent to remove Cu2+, Al3+, Ni2+ and Zn2+ ions from aqueous solutions was investigated under both noncompetitive and competitive conditions. The biosorbent was used in the form of particles with size smaller than 0.5 μm and in the concentration of 500 mg L-1 (dry weight). The experiments were performed using batch adsorption technique for concentrations of 10, 30 and 70 mg L-1 of metal ions at pH 4.0 and 5.0. The chemical speciation of metals in the experimental conditions used in this work was predicted by the software Visual MINTEQ 2.6.
Resumo:
The objective this study was to monitor pesticide residues in groundwater at three different times and in seven regions producing rice in southern Brazil, in the 2007/08 season. Imazethapyr and fipronil were found in all regions studied. All groundwater samples from the Planície Costeira Interna to Lagoa dos Patos and Santa Catarina contained at least one pesticide. The lowest number of contaminated samples were detected in the Southern region. The highest frequency of contaminated samples was found after drainage of the rice fields. Only fipronil exceeded limits of potability, in 27% of samples, according European Community criteria.
Resumo:
Silica obtained from rice husk after acid leaching and calcination was compared to commercial silica as a catalyst support. CaO and SnO2 catalysts were prepared by impregnation and tested in the transesterification of soybean oil and the esterification of oleic acid. CaO catalysts showed basic character and were the most active for transesterification, whereas SnO2 catalysts were acid and the most effective for esterification. In both cases the performances of the catalysts prepared with rice husk ash and commercial silica were similar. These results demonstrate that rice husk is a cost-effective and environmentally-friendly source of silica that can be used as a catalyst support.
Resumo:
This article describes an experiment that involves the extraction and separation of the pigments of spinach extract by column chromatography using the silica obtained from rice husk ash as a stationary phase. The experimental procedure is very simple to apply in the chemistry laboratory, and allowed to illustrate some concepts of organic chemistry: structure of organic molecules, solubility, polarity, extraction, partition coefficient, adsorption and retention factor (Rf), as well as objectives and fundamentals of chromatographic methods. The experiment can be carried out in a 4 h period.
Resumo:
A simple, fast and inexpensive method was developed to determine essential elements in pellets of rice samples using energy dispersive X-ray fluorescence spectrometry (EDXRF). The accuracy and precision were evaluated using Standard Reference Material (rice flour NIST 1568a), and yielding relative standard deviation below 5%. The paired t-test showed good agreement within 95% confidence values. The detection limits (3σ) of Mn and Zn were 5.1 and 2.2 mg kg-1, respectively. The proposed method proved to be effective when used to determine Mn and Zn in commercial samples of rice without go by stage of decomposition.
Resumo:
The QuEChERS extraction method followed by quantification using HPLC/UV-FL was evaluated for deoxynivalenol (DON) and zearalenone (ZEA) determination in natural and parboiled rice and their fractions (bran and husk). The comparison between QuEChERS and partition with acetonitrile extraction showed that the first one was better. It presented higher recovery (91% for DON, 105% for ZEA) wih precision ranging from 1.5 to 18.6%. The limits of quantification were 22.2 µg kg-1 for DON and 4.3 µg kg-1 for ZEA. DON and ZEA showed higher levels in endosperm of parboiled rice (8 e 111.7 µg kg-1, respectively) when compared to natural rice.