A HPF AC-AC converter for Permanent Magnet Generator applications

This paper describes the design and development of a high input power-factor (HPF) AC to AC converter for naval applications using Permanent Magnet Generator (PMG). The proposed converter comprises an isolated three-phase uncontrolled multipulse rectification stage directly connected to a single-phase inverter stage, without the use of DC to DC intermediary stage, resulting in more simplicity for the overall circuitry, assuring robustness, reliability and reduced costs. Furthermore, the multipulse rectifier stage is capable to provide high power factor and input currents with low total harmonic distortion (THD). The output voltage of the PMG varies from 260V rms (220 Hz) to 380V rms (360 Hz), depending on load conditions. The output single-phase inverter stage was designed to operate with wide range of DC bus voltage, maintaining 120V rms, 60 Hz output. Measured total harmonic distortion for the AC output voltage represents less than 2%, at 3.6kW nominal linear load. © 2010 IEEE.

Conversor CA-CA de elevado fator de potência para aplicações com geradores de Ímã permanente

This paper proposes and describes a high power factor AC-AC converter for naval applications using Permanent Magnet Generator (PMG). The three-phase output voltages of the PMG vary from 260 Vrms (220 Hz) to 380 Vrms (360 Hz), depending on load conditions. The proposed converter consists of a Y-/ΔY power transformer, which provides electrical isolation between the PMG and remaining stages, and a twelve-pulse uncontrolled rectifier stage directly connected to a single-phase inverter stage, without the use of an intermediary DC-DC topology. This proposal results in more simplicity for the overall circuitry, assuring robustness, reliability and reduced costs. Furthermore, the multipulse rectifier stage is capable to provide high power factor and low total harmonic distortion for the input currents of the converter. The single-phase inverter stage was designed to operate with wide range of DC bus voltage, maintaining 120 Vrms, 60 Hz output. The control philosophy, implemented in a digital signal processor (DSP) which also contains protection routines, alows series connections between two identical converters, achieving 240 Vrms, 60 Hz total output voltage. Measured total harmonic distortion for the AC output voltage is lower than 2% and the input power factor is 0.93 at 3.6kW nominal load. © 2010 IEEE.

Anisotropy in the transport properties of type II superconducting films with periodic pinning

Using numerical simulations, we analyze the anisotropy effects in the critical currents and dynamical properties of vortices in a thin superconducting film submitted to hexagonal and Kagomé periodical pinning arrays. The calculations are performed at zero temperature, for transport currents parallel and perpendicular to the main axis of the lattice, and parallel to the diagonal axis of the rhombic unit cell. We show that the critical currents and dynamic properties are anisotropic for both pinning arrays and all directions of the transport current. The anisotropic effects are more significant just above the critical current and disappear with higher values of current and both pinning arrays. The dynamical phases for each case and a wide range of transport forces are analyzed. © 2012 Springer Science+Business Media, LLC.

Efficacy of mouth rinses and toothpaste on tooth whitening.

People increasingly desire tooth whitening. Considering the wide range of whitening products on the market, this study evaluated the efficacy of whitening toothpastes and mouth rinses compared with the 10% carbamide peroxide (CP) whitening gel. We obtained 120 cylindrical specimens from bovine teeth, which were darkened for 24 hours in a coffee solution. The color measurement was performed by a spectrophotometer using the CIE L*a*b* system, and specimens were divided into six groups according to the use of the following agents: group 1, conventional fluoridated toothpaste; group 2, Close Up White Now; group 3, Listerine Whitening; group 4, Colgate Plax Whitening; group 5, experimental mouth rinse with Plasdone; and group 6, 10% CP Whiteness Perfect. After the simulation of 12 weeks of treatment for groups 1 to 5 and 14 days of treatment for group 6, the specimens were subjected to a new color reading. Data were subjected to one-way analysis of variance (α=0.05), which showed significant differences among groups after 12 weeks for ΔE (p=0.001). Results of the Tukey test revealed that groups 3, 4, and 6 presented significantly higher color alteration than groups 1, 2, and 5. The whitening toothpaste Close Up White Now and the experimental mouth rinse with Plasdone showed similar color alteration as conventional toothpaste after a 12-week treatment simulation. These groups presented significantly lower color alteration compared with whitening mouth rinses Listerine and Colgate Plax Whitening, which showed similar results to those observed after 14 days of bleaching with 10% CP treatment.

Phylogenetic and structural studies of a novel equine papillomavirus identified from aural plaques

Papillomaviruses (PVs) infect a wide range of animal species and show great genetic diversity. To date, excluding equine sarcoids, only three species of PVs were identified associated with lesions in horses: Equus caballus papillomavirus 1 (EcPV1-cutaneous), EcPV2 (genital) and EcPV3 (aural plaques). In this study, we identified a novel equine PV from aural plaques, which we designated EcPV4. Cutaneous samples from horses with lesions that were microscopically diagnosed as aural plaques were subjected to DNA extraction, amplification and sequencing. Rolling circle amplification and inverse PCR with specific primers confirmed the presence of an approximately 8. kb circular genome. The full-length EcPV4 L1 major capsid protein sequence has 1488 nucleotides (495 amino acids). EcPV4 had a sequence identity of only 53.3%, 60.2% and 51.7% when compared with the published sequences for EcPV1, EcPV2 and EcPV3, respectively. A Bayesian phylogenetic analysis indicated that EcPV4 clusters with EcPV2, but not with EcPV1 and EcPV3. Using the current PV classification system that is based on the nucleotide sequence of L1, we could not define the genus of the newly identified virus. Therefore, a structural analysis of the L1 protein was carried out to aid in this classification because EcPV4 cause lesion similar to the lesion caused by EcPV3. A comparison of the superficial loops demonstrated a distinct amino acid conservation pattern between EcPV4/EcPV2 and EcPV4/EcPV3. These results demonstrate the presence of a new equine PV species and that structural studies could be useful in the classification of PVs. © 2012 Elsevier B.V.

Structural and dielectric properties of polyvinyl alcohol/barium zirconium titanate polymer-ceramic composite

The polyvinyl alcohol (PVA)/barium zirconium titanate Ba[Zr0.1Ti0.9]O3 (BZT) polymer-ceramic composites with different volume percentage are obtained from solution mixing and hot-pressing method. Their structural and electrical properties are characterized by X-ray diffraction (XRD), Rietveld refinement, cluster modeling, scanning electron microscope and dielectric study. XRD patterns of PVA/BZT polymer-ceramics composite (with 50% volume fractions) indicate no obvious differences than the XRD patterns of pure BZT which shows that the crystal structure is still stable in the composite. The scanning electron micrograph indicates that the BZT ceramic is dispersed homogeneously in the polymer matrix without agglomeration. The dielectric permittivity (ε r) and the dielectric loss (tan δ) of the composites increase with the increase of the volume fraction of BZT ceramic. Theoretical models are employed to rationalize the dielectric behavior of the polymer composites. The dielectric properties of the composites display good stability within a wide range of temperature and frequency. The excellent dielectric properties of these polymer-ceramic composites indicate that the BZT/PVA composites can be a candidate for embedded capacitors. © 2013 Elsevier B.V.

Interferometria óptica aplicada à medição de amplitudes de vibração nanométricas em piezoatuadores flextensionais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise filogenética de linhagens de Xylella fastidiosa de diferentes hospedeiros baseada na sequencia da região intergênica 16S-23S rDNA

Pós-graduação em Ciências Biológicas (Biologia Celular e Molecular) - IBRC

Avaliação da resistência ao desgaste abrasivo de revestimentos soldados do tipo Fe-C-Cr utilizados na indústria sucroalcooleira

Pós-graduação em Engenharia Mecânica - FEIS

Preparo, caracterização e aplicação do compósito PTCa (Titanato de chumbo modificado com cálcio)/PEEK (Poliéter éter cetona) como sensor de radiação

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Taxonomia, distribuição ambiental e considerações biogeográficas de algas verdes macroscópicas em ambientes lóticos de unidades de conservação do sul do Brasil

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Caracterização clínica da cardiomiopatia hipertrófica hipertensiva em cães com doença renal crônica (DRC)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Dinâmica Geográfica do Trabalho no Século XXI: (Limites Explicativos, Autocrítica e Desafios Teóricos)

A trajetória que percorremos após o Doutorado, ou seus principais aspectos, encontra-se nos quatro volumes deste trabalho de Livre Docência. Nossa opção pela discussão crítica da obra nos estimulou a oferecer parte da nossa produção individual e em coautoria – ou coletiva –, mas que rigorosamente representasse nosso esforço de reflexão sobre a temática do trabalho na Geografia. Mais que isso, apresentamos o que vimos demarcando, nos últimos anos, ou as dificuldades de entendimento da rica trama de relações que atinge o trabalho, produto das redefinições estruturais por que passa o modo de produção capitalista em escala planetária, e os desdobramentos (re)estruturantes em marcha. É desse processo que se fazem presentes as novas identidades do trabalho, territorialmente expressas na plasticidade que se refaz continuamente e que extrapola os limites do rural e do urbano, da cidade e do campo. Por sua vez, ele redefine constantemente as profissões, habilitações, especializações, deslocamentos, migrações, o espaço de relações e a demarcação das territorialidades da luta de classes, sem contar o quadro mais perverso da reestruturação produtiva do capital, no século XXI, ou seja, o desemprego estrutural...

A tool for controlling accelerometers. Secondary calibration data

Vibration monitoring requires acceleration transducers capable of providing data with high precision. Accelerometers are the most frequently used vibration transducers. Their calibration plays an important role in measuring vibrations and is a key component in ensuring the integrity of the vibration measurement. For managing secondary calibration data of accelerometers, a database computer system was implemented. The implementation of this software has been an important step forward in providing a wide range of analysis and display tools. This paper reviews the main concepts involving accelerometer secondary calibration and describes the tool developed and the methods used in its development. (C) 2013 Academie des sciences. Published by Elsevier Masson SAS. All rights reserved.

Pressure distribution on the frontal disk for turbulent flows in a radial diffuser

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)