Planning a Medical School to Serve an Educationally and Medically Underserved Area: Florida International University in Miami, FL

This paper provides the historic background of the Florida International University College of Medicine planning process.

Effects of shading on calcareous benthic periphyton in a short-hydroperiod oligotrophic wetland (Everglades, FL, USA)

The effects of shade on benthic calcareous periphyton were tested in a short-hydroperiod oligotrophic subtropical wetland (freshwater Everglades). The experiment was a split-plot design set in three sites with similar environmental characteristics. At each site, eight randomly selected 1-m2 areas were isolated individually in a shade house, which did not spectrally change the incident irradiance but reduced it quantitatively by 0, 30, 50, 60, 70, 80, 90 and 98%. Periphyton mat was sampled monthly under each shade house for a 5 month period while the wetland was flooded. Periphyton was analyzed for thickness, DW, AFDW, chlorophyll a (chl a) and incubated in light and dark BOD bottles at five different irradiances to assess its photosynthesis–irradiance (PI) curve and respiration. The PI curves parameters P max, I k and eventually the photoinhibition slope (β) were determined following non-linear regression analyses. Taxonomic composition and total algal biovolume were determined at the end of the experiment. The periphyton composition did not change with shade but the PI curves were significantly affected by it. I k increased linearly with increasing percent irradiance transmittance (%IT = 1−%shade). P max could be fitted with a PI curve equation as it increased with %IT and leveled off after 10%IT. For each shade level, the PI curve was used to integrate daily photosynthesis for a day of average irradiance. The daily photosynthesis followed a PI curve equation with the same characteristics as P max vs. %IT. Thus, periphyton exhibited a high irradiance plasticity under 0–80% shade but could not keep up the same photosynthetic level at higher shade, causing a decrease in daily GPP at 98% shade levels. The plasticity was linked to an increase in the chl a content per cell in the 60–80% shade, while this increase was not observed at lower shade likely because it was too demanding energetically. Thus, chl a is not a good metric for periphyton biomass assessment across variously shaded habitats. It is also hypothesized that irradiance plasticity is linked to photosynthetic coupling between differently comprised algal layers arranged vertically within periphyton mats that have different PI curves.

The Influence of Hydrologic Restoration on Groundwater-Surface Water Interactions in a Karst Wetland, the Everglades (FL, USA)

Efforts to rehydrate and restore surface water flow in karst wetlands can have unintended consequences, as these highly conductive and heterogeneous aquifers create a close connection between groundwater and surface water. Recently, hydrologic restoration efforts in the karstic Taylor Slough portion of the Everglades has changed from point source delivery of canal water (direct restoration), to the use of a series of surface water recharge retention basins (diffuse restoration). To determine the influence of restoration on groundwater-surface water interactions in the Taylor Slough headwaters, a water budget was constructed for 1997–2011 using 70 hydro-meteorological stations. With diffuse restoration, groundwater seepage from the Everglades toward the urban boundary increased, while the downstream delivery of surface water to the main portion of the slough declined. The combined influence of diffuse restoration and climate led to increased intra-annual variability in the volume of groundwater and surface water in storage but supported a more seasonally hydrated wetland compared to the earlier direct tactics. The data further indicated that hydrologic engineering in karst wetland landscapes enhances groundwater-surface water interactions, even those designed for restoration purposes.

Maps of Sea Level Rise - Nautilus Island, Miami Beach, FL

A series of 7 maps illustrating the impact of sea level rise on Nautilus Island in Miami Beach.

The 2008 Terrestrial Vegetation of Biscayne National Parko FL, USA Derived From Aerial Photography, NDVI, and LiDAR

Established as a National Park in 1980, Biscayne National Park (BISC) comprises an area of nearly 700 km2 , of which most is under water. The terrestrial portions of BISC include a coastal strip on the south Florida mainland and a set of Key Largo limestone barrier islands which parallel the mainland several kilometers offshore and define the eastern rim of Biscayne Bay. The upland vegetation component of BISC is embedded within an extensive coastal wetland network, including an archipelago of 42 mangrove-dominated islands with extensive areas of tropical hardwood forests or hammocks. Several databases and vegetation maps describe these terrestrial communities. However, these sources are, for the most part, outdated, incomplete, incompatible, or/and inaccurate. For example, the current, Welch et al. (1999), vegetation map of BISC is nearly 10 years old and represents the conditions of Biscayne National Park shortly after Hurricane Andrew (August 24, 1992). As a result, a new terrestrial vegetation map was commissioned by The National Park Service Inventory and Monitoring Program South Florida / Caribbean Network.

Seawater carbonate chemistry and processes during experiments with Emiliania huxleyi (2005 Bergen) and Coccolithus braarudii (RCC 1200), 2010

The physiological performance of two coccolithophore species,Emiliania huxleyi and Coccolithus braarudii, was investigated during long-term exposure to elevated pCO2 levels. Mono-specific cultures were grown over 152 (E. huxleyi) and 65 (C. braarudii) generations while pCO2 was gradually increased to maximum levels of 1150 ?atm (E. huxleyi) and 930 ?atm (C. braarudii) and kept constant thereafter. Rates of cell growth and cell quotas of particulate organic carbon (POC), particulate inorganic carbon (PIC) and total particulate nitrogen (TPN) were determined repeatedly throughout the incubation period. Increasing pCO2 caused a decrease in cell growth rate of 9% and 29% in E. huxleyi and C. braarudii, respectively. In both species cellular PIC:TPN and PIC:POC ratios decreased in response to rising pCO2, whereas no change was observed in the POC:TPN ratios of E. huxleyi and C. braarudii. These results are consistent with those obtained in shorter-term high CO2exposure experiments following abrupt pertubations of the seawater carbonate system and indicate that for the strains tested here a gradual CO2 increase does not alleviate CO2/pH sensitivity.

Uso da cinza do bagaço da cana-de-açúcar como matéria-prima na substituição dos fundentes para aplicações em porcelanato

The present study aims to evaluate the potential use of bagasse ash from sugar cane (CBC) as a flux, replacing phyllite and/or feldspar in standard industrial mass production of enameled porcelain, verifying the possibility of the CBC contribute to the overall reduction of the coefficient of thermal expansion of the ceramic mass. To this end, as a result of the research, we characterized the raw material components of the standard mass (clay, phyllite, kaolin, feldspar, quartz and talc) and the residue of BCC, by testing by XRF, XRD, AG, DTA and ATG. Specimens (CDP) were manufactured in the dimensions of 100 mm x 50 mm x 8 mm in uniaxial matrix under compaction pressure of 33 MPa, assembled in batches of 3 units subsequently sintered at temperatures of 1150°C to 1210°C by varying the Rating Scale at 10°C, heating and cooling ramp of 50°C/min and 25°C/min, with levels of 1 min, 3 min, 5 min, 8 min, 10 min, 15 min, 30 min and 60 min. analyzing the results of the physical properties of water absorption (WA), linear firing shrinkage (LFS), dilatometric analysis (DTA), flexural strain (SFT) and SEM of the sintered bodies in order to verify the adequacy of CDP to ISO 13006, ISO 10545, NBR 13816 standards; NBR 13817 and NBR 13818. The study showed that the formulations that best suit the requirements of the standards are:. G4 - which was applied in 10% of replacing the CBC phyllite, sintering temperature 1210 ° C for 10 min and porch, and F3 - with application of 7.5% of CBC to replace the feldspar in the sintering temperatures of 1190°C, 1200°C and 1210°C for 10 min and porch. These formulations showed better performance regarding the formation of primary and secondary mullite, with considerable reduction of cracks and pores, meeting the prerequisites of standards for glazed porcelain. The results shows that the use of the CBC as a flux in the preparation of porcelain mass meets standard parameters for the manufacture of the product, and thereby can reduce environmental impact and the cost of production. Therefore, it is recommended to use this residue in the ceramics industry, due to its industrial, commercial and collaborative viability for sustainability.

NY NOW President Diane Welsh speaks out at protest against murder of abortion doctor John Britton of Pensacola, FL

General note: Title and date provided by Bettye Lane.

¿Fue la crisis política del Occidente musulmán del siglo XIII debida a un cambio climático? Una aproximación histórica al fin del Periodo Cálido Medieval

Durante el siglo XIII se produjo una sucesión de revueltas que supuso la desaparición del Imperio almohade y su sustitución por poderes regionales en al-Andalus, el Magreb y el Magreb al-Aqsà. La historiografía ha presentado el surgimiento y pugna entre estos poderes como un fenómeno social, político e, incluso, cultural y religioso, con el que se ha podido explicar su aniquilación o marginalización. Este trabajo pretende contextualizar los hechos desde una perspectiva medioambiental, de forma que la desintegración del califato almohade, el surgimiento de aquellos poderes y la progresión de los reinos cristianos en la península ibérica puedan entenderse desde una visión global de cambio climático y una posible crisis agrícola.

El derecho público en Iberoamérica. Libro homenaje al profesor Jaime Vidal Perdomo. Tomos I y II

La obra que se entrega hoy es un gran ejemplo de la riqueza académica con la que todos cuentan en Iberoamérica, motor de una nueva integración, que mueve y motiva por encima de intereses políticos y partidarios. Para una mejor lectura de las evoluciones y las expectativas en derecho público en Iberoamérica, así como del balance del derecho administrativo colombiano, en sus primeros cien años de justicia contencioso-administrativa, en este orden de ideas se ha dividido la publicación en dos tomos. El primero de ellos se divide en tres partes: derecho constitucional, teoría general del derecho administrativo, y acto y procedimiento administrativo. El segundo tomo viene distribuido en cinco partes: la primera parte se ha denominado contratos administrativos, la segunda parte régimen local, la tercera parte, denominada bienes del Estado, la cuarta parte, contencioso-administrativo y la última parte, se ha descrito como temas varios. En ella se encuentran reflexiones sobre la evolución de la teoría del daño especial en Colombia. Con lo anterior, se espera haber cumplido con un buen balance bicentenario del derecho público en Iberoamérica y del derecho administrativo colombiano en estos cien primeros años de justicia contencioso-administrativa, en homenaje al maestro Jaime Vidal Perdomo, eximio jurista colombiano consagrado al estudio y análisis del derecho público y exponente calificado y reconocido de la academia en Colombia y en los países iberoamericanos.

Adição de subprodutos da cinza da casca de café (coffea canephora) em massa cerâmica para porcelanato

To produce porcelain tiles fluxing agents are used in order to obtain a liquid phase during firing. This liquid phase fills the pores decreasing porosity, water absorption and contributes to material densification. In the porcelain tiles industry, feldspar is the main flux material used, with quantities ranging between 35 and 50%. Studies focus on the discovery of materials with flux characteristics that can reduce the consumption of feldspar by porcelain tiles industry. In this context, the coffee husk ashes, a residue obtained when coffee husks are burned to produce heat for the dryers during the processing of the green fruit, have as main chemical constituents potassium, calcium and magnesium, giving them characteristics of fluxing material. Brazil is the largest coffee producer in the world and is responsible for over 30% of the world s production. In this work a physical treatment of coffee husk ash was carried out in order to eliminate the organic matter and, after this, two by-products were obtained: residual wastes R1 and R2. Both residues were added separately as single fluxes and also in association with feldspar in mixtures with raw materials collected in a porcelain industry located in Dias d Ávila-Ba. The addition of these residues aimed to contribute to the reduction of the consumption of feldspar in the production of porcelain tiles. Specimens were produced with dimensions of 60 mm x 20 mm x 6 mm in an uniaxial die with compacting pressure of 45 MPa. The samples were heated to a temperature of 1200 °C, for 8 minutes. Tests were performed to characterize the raw materials by XRF, XRD, particle size analysis, DTA and TGA and, additionally, the results of the physical properties of water absorption, apparent porosity, linear shrinkage, density, dilatometry, flexural strength and SEM of sintered body were analyzed. Additions of less than 8% of the residue R1 contributed to the decrease of porosity, but the mechanical strength of the samples was not satisfactory. Additions of 5% the R2 residue contributed significantly to decrease the water absorption and apparent porosity, and also to increase the mechanical strength. Samples with addition of feldspar associated with the R2 residue, in proportions of 6.7% of R2 and 6.7% of feldspar, led to results of water absorption of 0.12% and mechanical strength of 46 MPa, having parameters normalized to the manufacture of porcelain stoneware tiles