The post-Lisbon role of the European Parliament in the EU's Common Commercial Policy: Implications for bilateral trade negotiations. EU Diplomacy Paper 05/2012, July 2012

This paper sets out to conduct an empirical analysis of the post-Lisbon role of the European Parliament (EP) in the EU’s Common Commercial Policy through an examination of the ‘deep and comprehensive’ bilateral Free Trade Agreements (FTAs) currently negotiated as part of the EU’s Global Europe strategy. The EU-Korea and EU-India FTAs are used as case studies in order to determine the implications of the EP’s enhanced trade powers on the processes, actors and outcomes of EU bilateral trade policy. The EP is now endowed with the ‘hard power’ of consent in the ratification phase of FTAs, acting as a threat to strengthen its ‘soft power’ to influence negotiations. The EP is developing strategies to influence the mandate and now plays an important role in the implementation of FTAs. The entry of this new player on the Brussels trade policy field has brought about a shift in the institutional balance of power and opened up the EP as a new point of access for trade policy lobbyists. Finally, increased EP involvement in EU trade policy has brought about a politicisation of EU trade policy and greater normative outcomes of FTAs.

Off-road sampling reveals a different grassland bird community than roadside sampling: implications for survey design and estimates to guide conservation

Grassland bird species continue to decline steeply across North America. Road-based surveys such as the North American Breeding Bird Survey (BBS) are often used to estimate trends and population sizes and to build species distribution models for grassland birds, although roadside survey counts may introduce bias in estimates because of differences in habitats along roadsides and in off-road surveys. We tested for differences in land cover composition and in the avian community on 21 roadside-based survey routes and in an equal number of adjacent off-road walking routes in the grasslands of southern Alberta, Canada. Off-road routes (n = 225 point counts) had more native grassland and short shrubs and less fallow land and road area than the roadside routes (n = 225 point counts). Consequently, 17 of the 39 bird species differed between the two route types in frequency of occurrence and relative abundance, measured using an indicator species analysis. Six species, including five obligate grassland species, were more prevalent at off-road sites; they included four species listed under the Canadian federal Species At Risk Act or listed by the Committee on the Status of Endangered Wildlife in Canada: Sprague’s Pipit (Anthus spragueii), Baird’s Sparrow (Ammodramus bairdii), the Chestnut-collared Longspur (Calcarius ornatus), and McCown’s Longspur (Rhynchophanes mccownii). The six species were as much as four times more abundant on off-road sites. Species more prevalent along roadside routes included common species and those typical of farmland and other human-modified habitats, e.g., the European Starling (Sturnus vulgaris), the Black-billed Magpie (Pica hudsonia), and the House Sparrow (Passer domesticus). Differences in avian community composition between roadside and off-road surveys suggest that the use of BBS data when generating population estimates or distribution models may overestimate certain common species and underestimate others of conservation concern. Our results highlight the need to develop appropriate corrections for bias in estimates derived from roadside sampling, and the need to design surveys that sample bird communities across a more representative cross-section of the landscape, both near and far from roads. 

Effect of human disturbance on long-term habitat use and breeding success of the European Nightjar, Caprimulgus europaeus

Land managers often respond to declining numbers of target species by creating additional areas of habitat. If these habitats are also subject to human disturbance, then their efforts may be wasted. The European Nightjar (Caprimulgus europaeus) is a ground-nesting bird that is listed as a species of European Conservation Concern. It appears to be susceptible to human disturbance during the breeding season. We examined habitat use and reproductive success over 10 years in a breeding population on 1335 ha of managed land in Nottinghamshire, England. The study site was divided into a heavily disturbed section and a less disturbed section of equal habitat availability, forming a natural long-term experiment. The site is open to the public, and visitor numbers approximately doubled during the study. We found that overall Nightjar density was significantly lower and there were significantly fewer breeding pairs in the heavily disturbed habitat compared with the less disturbed habitat. However, average breeding success per pair, in terms of eggs and fledglings produced, was not significantly different between the two sections across years. Our findings suggest that human recreational disturbance may drastically alter settlement patterns and nest site selection of arriving females in some migratory ground-nesting species and may reduce the utility of apparently suitable patches of remnant and created habitat. Land managers should bear this in mind when creating new areas of habitat that will also be accessible to the public. Our study also highlights the value of long-term population monitoring, which can detect trends that short-term studies may miss.

Predicting origins of passerines migrating through Canadian migration monitoring stations using stable-hydrogen isotope analyses of feathers: a new tool for bird conservation

The Canadian Migration Monitoring Network (CMMN) consists of standardized observation and migration count stations located largely along Canada’s southern border. A major purpose of CMMN is to detect population trends of migratory passerines that breed primarily in the boreal forest and are otherwise poorly monitored by the North American Breeding Bird Survey (BBS). A primary limitation of this approach to monitoring is that it is currently not clear which geographic regions of the boreal forest are represented by the trends generated for each bird species at each station or group of stations. Such information on “catchment areas” for CMMN will greatly enhance their value in contributing to understanding causes of population trends, as well as facilitating joint trend analysis for stations with similar catchments. It is now well established that naturally occurring concentrations of deuterium in feathers grown in North America can provide information on their approximate geographic origins, especially latitude. We used stable hydrogen isotope analyses of feathers (δ²Hf) from 15 species intercepted at 22 CMMN stations to assign approximate origins to populations moving through stations or groups of stations. We further constrained the potential catchment areas using prior information on potential longitudinal origins based upon bird migration trajectories predicted from band recovery data and known breeding distributions. We detected several cases of differences in catchment area of species passing through sites, and between seasons within species. We discuss the importance of our findings, and future directions for using this approach to assist conservation of migratory birds at continental scales.

Measuring bee diversity in different European habitats and biogeographical regions

Bee pollinators are currently recorded with many different sampling methods. However, the relative performances of these methods have not been systematically evaluated and compared. In response to the strong need to record ongoing shifts in pollinator diversity and abundance, global and regional pollinator initiatives must adopt standardized sampling protocols when developing large-scale and long-term monitoring schemes. We systematically evaluated the performance of six sampling methods (observation plots, pan traps, standardized and variable transect walks, trap nests with reed internodes or paper tubes) that are commonly used across a wide range of geographical regions in Europe and in two habitat types (agricultural and seminatural). We focused on bees since they represent the most important pollinator group worldwide. Several characteristics of the methods were considered in order to evaluate their performance in assessing bee diversity: sample coverage, observed species richness, species richness estimators, collector biases (identified by subunit-based rarefaction curves), species composition of the samples, and the indication of overall bee species richness (estimated from combined total samples). The most efficient method in all geographical regions, in both the agricultural and seminatural habitats, was the pan trap method. It had the highest sample coverage, collected the highest number of species, showed negligible collector bias, detected similar species as the transect methods, and was the best indicator of overall bee species richness. The transect methods were also relatively efficient, but they had a significant collector bias. The observation plots showed poor performance. As trap nests are restricted to cavity-nesting bee species, they had a naturally low sample coverage. However, both trap nest types detected additional species that were not recorded by any of the other methods. For large-scale and long-term monitoring schemes with surveyors with different experience levels, we recommend pan traps as the most efficient, unbiased, and cost-effective method for sampling bee diversity. Trap nests with reed internodes could be used as a complementary sampling method to maximize the numbers of collected species. Transect walks are the principal method for detailed studies focusing on plant-pollinator associations. Moreover, they can be used in monitoring schemes after training the surveyors to standardize their collection skills.

Environmental evaluation of agri-environment schemes using participatory approaches: experiences of testing the Agri-Environmental Footprint Index

The Agri-Environment Footprint Index (AFI) has been developed as a generic methodology to assess changes in the overall environmental impacts from agriculture at the farm level and to assist in the evaluation of European agri-environmental schemes (AES). The methodology is based on multicriteria analysis (MCA) and involves stakeholder participation to provide a locally customised evaluation based on weighted environmental indicators. The methodology was subjected to a feasibility assessment in a series of case studies across the EU. The AFI approach was able to measure significant differences in environmental status between farms that participated in an AES and nonparticipants. Wider environmental concerns, beyond the scheme objectives, were also considered in some case studies and the benefits for identification of unintentional (and often beneficial) impacts of AESs are presented. The participatory approach to AES valuation proved efficient in different environments and administrative contexts. The approach proved to be appropriate for environmental evaluation of complex agri-environment systems and can complement any evaluation conducted under the Common Monitoring and Evaluation Framework. The applicability of the AFI in routine monitoring of AES impacts and in providing feedback to improve policy design is discussed.

The monitoring of ecological quality and the classification of standing waters in temperate regions: a review and proposal based on a worked scheme for British waters

This paper reviews the ways that quality can be assessed in standing waters, a subject that has hitherto attracted little attention but which is now a legal requirement in Europe. It describes a scheme for the assessment and monitoring of water and ecological quality in standing waters greater than about I ha in area in England & Wales although it is generally relevant to North-west Europe. Thirteen hydrological, chemical and biological variables are used to characterise the standing water body in any current sampling. These are lake volume, maximum depth, onductivity, Secchi disc transparency, pH, total alkalinity, calcium ion concentration, total N concentration,winter total oxidised inorganic nitrogen (effectively nitrate) concentration, total P concentration, potential maximum chlorophyll a concentration, a score based on the nature of the submerged and emergent plant community, and the presence or absence of a fish community. Inter alia these variables are key indicators of the state of eutrophication, acidification, salinisation and infilling of a water body.

August Thienemann and Loch Lomond - an approach to the design of a system for monitoring the state of north-temperate standing waters

Limnologists had an early preoccupation with lake classification. It gave a necessary structure to the many chemical and biological observations that were beginning to form the basis of one of the earliest truly environmental sciences. August Thienemann was the doyen of such classifiers and his concept with Einar Naumann of oligotrophic and eutrophic lakes remains central to the world-view that limnologists still have. Classification fell into disrepute, however, as it became clear that there would always be lakes that deviated from the prescriptions that the classifiers made for them. Continua became the de rigeur concept and lakes were seen as varying along many chemical, biological and geographic axes. Modern limnologists are comfortable with this concept. That all lakes are different guarantees an indefinite future for limnological research. For those who manage lakes and the landscapes in which they are set, however, it is not very useful. There may be as many as 300000 standing water bodies in England and Wales alone and maybe as many again in Scotland. More than 80 000 are sizable (> 1 ha). Some classification scheme to cope with these numbers is needed and, as human impacts on them increase, a system of assessing and monitoring change must be built into such a scheme. Although ways of classifying and monitoring running waters are well developed in the UK, the same is not true of standing waters. Sufficient understanding of what determines the nature and functioning of lakes exists to create a system which has intellectual credibility as well as practical usefulness. This paper outlines the thinking behind a system which will be workable on a north European basis and presents some early results.

Obstacle avoidance routing scheme through optimal sink movement for home monitoring and mobile robotic consumer devices

In recent years, ZigBee has been proven to be an excellent solution to create scalable and flexible home automation networks. In a home automation network, consumer devices typically collect data from a home monitoring environment and then transmit the data to an end user through multi-hop communication without the need for any human intervention. However, due to the presence of typical obstacles in a home environment, error-free reception may not be possible, particularly for power constrained devices. A mobile sink based data transmission scheme can be one solution but obstacles create significant complexities for the sink movement path determination process. Therefore, an obstacle avoidance data routing scheme is of vital importance to the design of an efficient home automation system. This paper presents a mobile sink based obstacle avoidance routing scheme for a home monitoring system. The mobile sink collects data by traversing through the obstacle avoidance path. Through ZigBee based hardware implementation and verification, the proposed scheme successfully transmits data through the obstacle avoidance path to improve network performance in terms of life span, energy consumption and reliability. The application of this work can be applied to a wide range of intelligent pervasive consumer products and services including robotic vacuum cleaners and personal security robots1.