V2O5/TiO2 catalyst xerogels: Method of preparation and characterization

This work describes a modified sol-gel method for the preparation of V2O5/TiO2 catalysts. The samples have been characterized by N-2 adsorption at 77 K, X-ray Diffractometry (XRD), Scanning Electronic Microscopy (SEM/EDX) and Fourier Transform Infrared Spectroscopy (FT-IR). The surface area increases with the vanadia loading from 24 m(2) g(-1) for pure TiO2 to 87 m(2) g(-1) for 9 wt% of V2O5. The rutile form is predominant for pure TiO2 but becomes enriched with anatase phase when vanadia loading is increased. No crystalline V2O5 phase was observed in the diffractograms of the catalysts. Analysis by SEM showed heterogeneous granulation of particles with high vanadium dispersion. Two species of surface vanadium were observed by FT-IR spectroscopy: a monomeric vanadyl and polymeric vanadates. The vanadyl/vanadate ratio remains practically constant. Ethanol oxidation was used as a catalytic test in a temperature range from 350 to 560 K. The catalytic activity starts around 380 K. For the sample with 9 wt% of vanadia, the conversion of ethanol into acetaldehyde as the main product was approximately 90% at 473 K.

V(2)O(5)/TiO(2) catalytic xerogels raman and EPR studies

Raman spectroscopy and Electron Paramagnetic Resonance (EPR) studies were performed on a series of V(2)O(5)/TiO(2) catalysts prepared by a modified sol-gel method in order to identify the vanadium species. Two species of surface vanadium were identified by Raman measurements, monomeric vanadyls and polymeric vanadates. Monomeric vanadyls are characterized by a narrow Raman band at 1030 cm(-1) and polymeric vanadates by two broad bands in the region from 900 to 960 cm(-1) and 770 to 850 cm(-1). The Raman spectra do not exhibit characteristic peaks of crystalline V(2)O(5). These results are in agreement with those of X-ray Diffractometry (XRD) and Fourier Transform Infrared (FT-IR) previously reported (C.B. Rodella et al., J. Sol-Gel Sci. Techn., submitted). At least three families of V(4+) ions were identified by EPR investigations. The analysis of the EPR spectra suggests that isolated V(4+) ions are located in sites with octahedral symmetry substituting for Ti(4+) ions in the rutile structure. Magnetically interacting V(4+) ions are also present as pairs or clusters giving rise to a broad and structureless EPR line. At higher concentration of V(2)O(5), a partial oxidation of V(4+) to V(5+) is apparent from the EPR results.

Patulin biodegradation using Pichia ohmeri and Saccharomyces cerevisiae

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Reaction pathway to the synthesis of anatase via the chemical modification of titanium isopropoxide with acetic acid

Anatase nanoparticles were obtained through a modified sol-gel route from titanium isopropoxide modified with acetic acid in order to control hydrolysis and condensation reactions. The modification of Ti(O(i)Pr)(4) with acetic acid reduces the availability of groups that hydrolyze and condense easily through the formation of a stable complex whose structure was determined to be Ti(OCOCH(3))(O(i)Pr)(2) by means of FTIR and (13)C NMR. The presence of this complex was confirmed with FTIR in the early stages of the process. A doublet in 1542 and 1440 cm(-1) stands for the asymmetric and symmetric stretching vibrations of the carboxylic group coordinated to Ti as a bidentate ligand. The gap of 102 cm(-1) between these signals suggests that acetate acts preferentially as a bidentate rather than as a bridging ligand between two titanium atoms. The use of acetic acid as modifier allows the control of both the degree of condensation and oligomerization of the precursor and leads to the preferential crystallization of TiO(2) in the anatase phase. A possible reaction pathway toward the formation of anatase is proposed on the basis of the intermediate species present in a 1:1 Ti(O(i)Pr)(4):CH(3)COOH molar system in which esterification reactions that introduce H(2)O into the reaction mixture were seen to be negligible. The Rietveld refinement and TEM analysis revealed that the powder is composed of isotropic anatase nanocrystallites.

Potencialidades analíticas do dietilditiofosfato de amônio em espectrometria de massas com plasma indutivamente acoplado empregando extração em fase sólida e sistemas de injeção em fluxo

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Validated HPLC method for the standardization of Phyllanthus niruri (herb and commercial extracts) using corilagin as a phytochemical marker

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Phenolic Derivatives from Fruits of Dipteryx lacunifera DUCKE and Evaluation of Their Antiradical Activities

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Cardiac glycosides isolated from the Indian-snuff, Maquira sclerophylla Ducke

The hydroalcoholic extract of the powdered bark of the Indian-snuff Maquira sclerophylla Ducke was purified by column chromatography in silica-gel and the major cardenolide isolated from preparative TLC was identified by 1H-NMR, 1 2 C-NMR and IR analyses. The spectra showed that the active substance has strophanthidin as aglicone.

Tolerância à dessecação de sementes de palmito-vermelho (Euterpe espiritosantensis Fernandes)

Com o objetivo de identificar a tolerância à dessecação de sementes de Euterpe espiritosantensis, dois lotes de frutos foram colhidos na coleção de palmeiras do Instituto Agronômico de Campinas, no município de Ubatuba, estado de São Paulo e transportados em embalagem impermeável até a Faculdade de Ciências Agronômicas/UNESP, município de Botucatu, estado de São Paulo, onde foram despolpados. As sementes foram submetidas à secagem em sílica gel a partir das testemunhas não desidratadas (51,4% e 46,6% de teor de água), retirando-se amostras a cada 12 ou 24 horas. O efeito da desidratação foi avaliado através da porcentagem de germinação, e da velocidade de protrusão de embrião, do botão germinativo, da plúmula, e do comprimento das plântulas. Avaliaram-se ainda a matéria seca e o teor de água das sementes. Concluiu-se que as sementes de E. espiritosantensis são recalcitrantes, apresentando porcentagem alta de germinação (90,0% a 87,5%) quando não desidratadas (teor inicial de água de 51,4% a 46,6%). Abaixo de uma faixa de teor de água situada entre 40,7% e 51,4 % os valores de germinação e vigor foram significativamente reduzidos. A mortalidade total das sementes foi observada, com a redução do teor de água das sementes a uma faixa situada entre 13,4% e 15,8%.

Avaliação da perda da tolerância à dessecação e da quantidade de dna nuclear em sementes de Peltophorum dubium (spreng.) taubert durante e após a germinação

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Desiccation tolerance of Tapirira obtusa seeds collected from different environments

O objetivo deste trabalho foi avaliar a sensibilidade à dessecação de sementes de Tapirira obtusa (Benth.) J. D. Mitchell provenientes de três ambientes e submetidas a duas velocidades de secagem. As sementes foram coletadas em área de campo rupestre, Cerrado e em mata ciliar, da região de Lavras, MG. As sementes foram submetidas à secagem com cloreto de magnésio (secagem lenta) ou sílica gel (secagem rápida), em ambiente fechado, até os graus de umidade de 40%, 30%, 20% e 10%, considerando como controle o percentual de germinação na umidade inicial em cada ambiente, a qual variou de 47% a 50%. Foram avaliados os percentuais de germinação e de plântulas normais e também o índice de velocidade de germinação. Nos três ambientes analisados, não houve efeito da secagem lenta sobre a germinação das sementes. Sementes oriundas do Cerrado apresentaram pequena redução da germinação, quando submetidas à secagem rápida. Sementes oriundas de áreas rupestres apresentaram aumento na germinação quando submetidas à secagem rápida. Sementes oriundas de mata ciliar não apresentaram redução na germinação, independente da velocidade de secagem. Os resultados sugerem que sementes de T. obtusa não apresentam sensibilidade à dessecação.

Extraction and clean-up procedure for analysis of organochlorine pesticide residues in ethoxylated lanolin

In the present study an evaluation was made of a method for the determination of organochlorine pesticide residues in ethoxylated lanolin. Samples were homogenized with Celite, transferred to chromatographic columns, prepacked with silica gel deactivated to 10%. The pesticide elution was processed with n-hexane-dichloromethane and the concentrated eluate was analyzed using gas-liquid chromatography (GC) with electron capture detection (ECD). The composition of the elution solvent was a significant factor for the recovery of the pesticides. Mean recoveries obtained for fortified samples ranged from 87 to 94% for p,p'-DDE, dieldrin, endrin, p,p'-DDD and p,p'-DDT. Optimization of the experimental conditions resulted in a small-scale method that combines extraction and cleanup in a single step. (C) 2000 Elsevier B.V. S.A. All rights reserved.

Alkene epoxidation with iodosylbenzene catalysed by polyionic manganese porphyrins electrostatically bound to counter-charged supports

Manganese(III) complexes of tetra-anionic and tetra-cationic porphyrins have been immobilised on counter-charged, surface-modified silica supports and on organic ion-exchange resins. The reactions of these supported manganese(III) porphyrin systems and analogous uncharged homogeneous systems have been examined using cyclooctene and (E)- and (Z)-4- methylpent-2-ene epoxidations, with iodosylbenzene (PhIO) as the oxygen donor.Comparisons using the manganese porphyrin systems as catalysts for the epoxidation of cyclooctene in acetonitrile reveal that, in low turnover reactions (maximum 136 turnovers), they all give an essentially quantitative yield of epoxide although the heterogeneous reactions are significantly slower than the homogeneous analogues. In large scale repeat-use experiments, however, the supported catalysts are clearly superior, giving markedly better yields.The epoxidations of (E)- and (Z)-4- methylpent-2-ene with all the catalysts show a very high stereoretention, with the (Z)-alkene reacting faster than the (E)-isomer. The sterically hindered manganese(III) 5,10,15,20-tetrakis(2,6-dichloro-3-sulfonatophenyl)porphyrin (MnTDCSPP) shows the highest selectivity for the (Z)-isomer; by contrast the supported manganese(III) 5,10,15,20-tetrakis[2,3,5,6-tetrafluoro-4-(trimethylammonio)phenyl]porphyrin on Dowex (MnTF(4)TMAPP-Dowex) reacts with the two alkenes at effectively the same rate.The mechanism of the epoxidations and the influence of the porphyrin ligand and support on the substrate selectivity are discussed.

On-line extraction and determination of carbofuran in raw milk by direct HPLC injection on an ISRP column

A method has been developed for extraction and determination of carbofuran in milk. The method involved direct injection of raw milk on to a human serum albumin dimethyloctyl-silica gel (HSA-Cs) column and the use of 80:20 (v/v) 0.01 M phosphate buffer pH 5.5 - acetonitrile as mobile phase. UV spectrophotometric detection was performed at 220 nm. Identification was based on retention time. Quantification was performed by automatic peak-area determination and was calibrated by use of an external standard.

Screening and confirmation of PAHs in vegetable oil samples by use of supercritical fluid extraction in conjunction with liquid chromatography and fluorimetric detection

A fast, simple, non-destructive method for the direct screening of polycyclic aromatic hydrocarbons (PAHs) in vegetable oil samples is proposed. The method uses a supercritical fluid extraction (SFE) system coupled on-line with a fluorimetric detector to determine PAHs. This special assembly avoids the main problems encountered in the determination of PAHs in complex matrices such as vegetable oils. PAHs are selectively extracted by using silica gel in the thimble and cleaned up by passage through a C18 column. Interferences are preferentially retained by the silica gel during the SFE process while PAHs are adsorbed in the C18 column and the remainder of the matrix is sent to waste. Finally, the C18 column is purged to remove residual CO2 gas and adsorbed PAHs are recovered by desorption with a solvent. The extracts from positive samples are subsequently analyzed by liquid chromatography (LC) with fluorescence detection. The proposed method allows the confirmation of vegetable oil safety and hence provides a new tool for consumer protection. (C) 2004 Elsevier B.V. All rights reserved.