Characterization of a multiresonance ring resonator-based optical device

We describe the linear and nonlinear transfer characteristics of a multi-resonance optical device consisting of two ring resonators coupled one to another and to a waveguide. The propagation effects displayed by the device are compared with those of a sequence of a waveguide-coupled fundamental ring resonators.

Transfer characteristics and propagation effects of a multi-resonance ring resonator-based optical device

We describe the linear and nonlinear optical transfer characteristics of a multi-resonance device consisting of two optical ring resonators coupled one to the other and to an optical waveguide. The propagation effects displayed by the device are compared with those of a sequence of fundamental ring resonators coupled to a waveguide.

Generation of harmonic oscillations in ring resonator with high Q-factor

We report on generation of harmonic oscillations with frequencies of hundreds of MHz and radio-frequency linewidth of 13 Hz in unidirectional ring laser oscillator. This high stability makes these oscillators a suitable substitute for existing quartz resonators used in high frequency optoelectronics applications.

环形非稳腔倒向波抑制镜抑制效果的数值模拟

对环形非稳腔激光器做数值计算模拟，给带有倒向波抑制(RWS)镜的环形非稳腔激光器的设计提供了数值参考。通过自洽方程，用Matlab计算带有倒向波抑制镜的环形非稳腔正、倒向波的稳定过程。改变腔长、放大率等参数来计算，发现使用倒向波抑制镜能明显提高正向波的输出，并能抑制倒向波。气体分子的多普勒频移导致正、倒向波的频率变化。频率分开的越小，竞争越大，抑制效果越好，正向波输出功率则有所下降。对于特定的结构，存在最佳的放大率，使正向波的输出最大。计算结果表明，倒向波抑制镜的引入能增大环形非稳腔输出功率。计算结果对实

Monolithic surface acoustic wave resonator oscillator

A monolithic surface acoustic wave (SAW) resonator operating at 156 MHz, in which the frequency controlling element is a Fabry–Perot type of SAW resonator and the gain element is a monolithic SAW amplifier (SiOx/InSb/SiOx structure located inside the SAW resonator cavity) is described and experimental details presented. Based on the existing experimental data, an uhf monolithic ring resonator oscillator is proposed. Journal of Applied Physics is copyrighted by The American Institute of Physics.

Monolithic surface acoustic wave resonator oscillator

A monolithic surface acoustic wave (SAW) resonator operating at 156 MHz, in which the frequency controlling element is a Fabry–Perot type of SAW resonator and the gain element is a monolithic SAW amplifier (SiOx/InSb/SiOx structure located inside the SAW resonator cavity) is described and experimental details presented. Based on the existing experimental data, an uhf monolithic ring resonator oscillator is proposed. Journal of Applied Physics is copyrighted by The American Institute of Physics.

Characteristics of an add-drop filter composed of a Mach-Zehnder interferometer and double ring resonators

A planar lightwave circuit (PLC) add-drop filter is proposed and analyzed, which consists of a symmetric Mach-Zehnder interferometer (MZI) combined with double microring resonators. A critical coupling condition is derived for a better box-like drop spectrum. Comparisons of its characteristics with other schemes, such as a MZI with a single ring resonator, arepresented, and some of the issues about device design and fabrication are also discussed.

A Unique Filter-Preserver Device for Digital Photonic Circuits

We discuss micro ring resonator based optical logic gates using Kerr-type nonlinearity. Resonant wavelength selectivity is one key factor in achieving the desired gate. Based on basic gates like AND gate, OR gate etc. We proceed to propose a 3-bit binary adder circuit.Due to the presence of more than a single wavelength, the system gets complicated as we increase the number of components in the circuit. Hence it has been observed that for efficient designing and functioning of digital circuits in optical domain, we need a device which can give single wavelength output, filtering out all other wavelengths and at the same time preserve the digital characteristics of the output. We propose such filter-preserver device based on micro ring resonator.

溶胶-凝胶光波导环形谐振腔的挥发性有机化合物传感特性

采用溶胶-凝胶法制作波导环形谐振腔, 讨论了环形谐振腔器件的传输特性。测量了在不同物质、不同体积分数的挥发性有机化合物(VOC)蒸气气氛下器件的传输光谱的敏感性。结果表明, 谐振波长随甲醇、乙醇、丙醇等醇类化合物, 以及丙酮、甲醛等蒸气体积分数的上升而向长波方向移动, 具有高的灵敏度, 且两者基本呈线性关系。其中, 对丙醇最敏感, 灵敏度达到1.403 pm/10-6。对甲烷和二甲苯也有微弱反应, 但是其灵敏度很低。也测量了水蒸气对传输谱特性的影响。观察到传输谱衬比度对不同挥发性有机化合物物质蒸气的不同敏

一种新型结构的单纵模光纤激光器

单纵模掺铒光纤激光器在光通信和光传感等方面有着广泛的应用前景。设计了一种新型的光纤激光器，在光纤环形镜中嵌入未抽运的掺铒光纤作为可饱和吸收体以抑制多纵模，用光纤环谐振腔作为滤波器抑制拍频噪声，用光纤光栅作为波长选择器件，最终得到了单纵模输出并消除了拍频噪声。使用零拍法测量其线宽小于频谱仪的低频极限5kHz。实验结果证明了可饱和吸收体和光纤环的功能。

有源波导环形谐振腔滤波特性分析

将掺铒有源波导材料引入环形谐振腔结构，从理论上分析了有源波导环形谐振腔的滤波特性。结果表明由于抽运光提供的增益补偿了腔内损耗，使得环形谐振腔满足临界耦合条件，实现对信号光的最佳陷波，同时发现通过改变抽运光功率，可以对精细度和带宽进行动态调谐。分析了铒离子掺杂浓度、信号光功率以及抽运光耦合系数对最佳陷波抽运功率的影响，为有源波导器件设计制作提供了理论依据。

利用有机-无机溶胶-凝胶方法制备平面波导环形谐振腔

采用简单的有机一无机混合的溶胶一凝胶方法制备了折射率在一定范围内可调的波导材料，并利用其制备了平面波导环形谐振腔器件。波导结构呈现倒脊形，其制备工艺首先是利用感应耦合等离子体刻蚀技术（ICP）在二氧化硅衬底上刻蚀波导结构的凹槽，然后再沉积波导薄膜。利用光谱仪对器件的传输特性进行了测量，观测到具有10dB对比度，自由光谱范围0．182nm周期性谐振现象，结合环形谐振腔的传输特性，得到环形腔具有较低的传输损耗1．7dB／cm。同时对环形谐振腔的温度特性进行了测量，得出波导材料的热光系数为-1．54×10^-4

一种离子交换制备的玻璃光波导谐振腔滤波器

采用AgNO3、KNO3混和熔盐作为离子交换源，在K9玻璃上制备了跑道形谐振腔滤波器。测试得到该滤波器的自由光谱范围为0．178nm，两个输出端口的衬比度分别为1．47dB和6．5dB，分析得到耦合器的分束比和谐振腔的传输损耗分别为κ=0．16和α=8．1dB／cm。利用热光效应在16℃的温度变化范围内，滤波器实现了2π的相位调制，同时分析得到波导材料的热光系数约为1．28×10^-5／℃。

High resolution direct measurement of temperature distribution in silicon nanophotonics devices.

Following the miniaturization of photonic devices and the increase in data rates, the issues of self heating and heat removal in active nanophotonic devices should be considered and studied in more details. In this paper we use the approach of Scanning Thermal Microscopy (SThM) to obtain an image of the temperature field of a silicon micro ring resonator with sub-micron spatial resolution. The temperature rise in the device is a result of self heating which is caused by free carrier absorption in the doped silicon. The temperature is measured locally and directly using a temperature sensitive AFM probe. We show that this local temperature measurement is feasible in the photonic device despite the perturbation that is introduced by the probe. Using the above method we observed a significant self heating of about 10 degrees within the device.

Compact four-channel reconfigurable optical add-drop multiplexer using silicon photonic wire

We designed and fabricated a four-channel reconfigurable optical add-drop multiplexer based on silicon photonic wire waveguide, which is controlled through the thermo-optic effect. The effective footprint of the device is about 1000 x 500 mu m(2). The minimum insertion loss including the transmission loss and coupling loss is about 10.7 dB. The tuning bandwidth is about 17 nm, the average tuning efficiency about 6.11 mW/nm and the tuning speed about 24.5 kHz. (c) 2009 Elsevier B.V. All rights reserved.