Design and implementation of a fft pruning engine for DSA-enabled cognitive radios.

This research work presents the design and implementation of a FFT pruning block, which is an extension to the FFT core for OFDM demodulation, enabling run-time 8 pruning of the FFT algorithm, without any restrictions on the distribution pattern of the active/inactive sub-carriers. The design and implementation of FFT processor core is not the part of this work. The whole design was prototyped on an ALTERA STRATIX V FPGA to evaluate the performance of the pruning engine. Synthesis and simulation results showed that the logic overhead introduced by the pruning block is limited to a 10% of the total resources utilization. Moreover, in presence of a medium-high scattering of the sub-carriers, power and energy consumption of the FFT core were reduced by a 30% factor.

Compressed sensing based cyclic feature spectrum sensing for cognitive radios

Spectrum sensing is currently one of the most challenging design problems in cognitive radio. A robust spectrum sensing technique is important in allowing implementation of a practical dynamic spectrum access in noisy and interference uncertain environments. In addition, it is desired to minimize the sensing time, while meeting the stringent cognitive radio application requirements. To cope with this challenge, cyclic spectrum sensing techniques have been proposed. However, such techniques require very high sampling rates in the wideband regime and thus are costly in hardware implementation and power consumption. In this thesis the concept of compressed sensing is applied to circumvent this problem by utilizing the sparsity of the two-dimensional cyclic spectrum. Compressive sampling is used to reduce the sampling rate and a recovery method is developed for re- constructing the sparse cyclic spectrum from the compressed samples. The reconstruction solution used, exploits the sparsity structure in the two-dimensional cyclic spectrum do-main which is different from conventional compressed sensing techniques for vector-form sparse signals. The entire wideband cyclic spectrum is reconstructed from sub-Nyquist-rate samples for simultaneous detection of multiple signal sources. After the cyclic spectrum recovery two methods are proposed to make spectral occupancy decisions from the recovered cyclic spectrum: a band-by-band multi-cycle detector which works for all modulation schemes, and a fast and simple thresholding method that works for Binary Phase Shift Keying (BPSK) signals only. In addition a method for recovering the power spectrum of stationary signals is developed as a special case. Simulation results demonstrate that the proposed spectrum sensing algorithms can significantly reduce sampling rate without sacrifcing performance. The robustness of the algorithms to the noise uncertainty of the wireless channel is also shown.

Arquitectura de Radios Wake-up para redes de sensores inalámbricas basada en FPGA

En este artículo se muestra la implementación de una Wake-up radio para nodos de redes de sensores inalámbricas basada en FPGAS de ultra bajo consumo. El objetivo principal es evaluar la utilización de dispositivos de lógica programable para realizar el procesamiento de los mensajes y explotar su velocidad de, flexibilidad y bajo consumo comparado con las implementaciones más tradicionales basadas en ASIC o microcontroladores.

TETRA mobile radios interfere with electroencephalography recording equipment

We observed an anomaly in the human electroencephalogram (EEG) associated with exposure to terrestrial trunked radio (TETRA) Radiofrequency Fields (RF). Here, we characterize the time and frequency components of the anomaly and demonstrate that it is an artefact caused by TETRA RF interfering with the EEG recording equipment and not by any direct or indirect effect on the brain.

Spectrum redistribution for cognitive radios using discriminatory spectrum double auction

With the reformation of spectrum policy and the development of cognitive radio, secondary users will be allowed to access spectrums licensed to primary users. Spectrum auctions can facilitate this secondary spectrum access in a market-driven way. To design an efficient auction framework, we first study the supply and demand pressures and the competitive equilibrium of the secondary spectrum market, considering the spectrum reusability. In well-designed auctions, competition among participants should lead to the competitive equilibrium according to the traditional economic point of view. Then, a discriminatory price spectrum double auction framework is proposed for this market. In this framework, rational participants compete with each other by using bidding prices, and their profits are guaranteed to be non-negative. A near-optimal heuristic algorithm is also proposed to solve the auction clearing problem of the proposed framework efficiently. Experimental results verify the efficiency of the proposed auction clearing algorithm and demonstrate that competition among secondary users and primary users can lead to the competitive equilibrium during auction iterations using the proposed auction framework. Copyright © 2011 John Wiley & Sons, Ltd.

Towards an Archaeology of Media Ecologies: The Case of Italian Free Radios

This article looks at the contemporary reinvention of the term Media Ecologies in the work of Matthew Fuller, arguing that its provenance is less form Postman's Media Ecology Association andmore form the work of Felix Guattari. It then presents an account of free radios in Italy and France in the 1970s and contemporary pirate radio as exemplary cases of media ecologies in Fuller's sense of the term

Power control in cognitive radios, Internet-of Things (IoT) for factories and industrial automation

Cognitive radio (CR) is fast emerging as a promising technology that can meet the machine-to machine (M2M) communication requirements for spectrum utilization and power control for large number of machines/devices expected to be connected to the Internet-of Things (IoT). Power control in CR as a secondary user can been modelled as a non-cooperative game cost function to quantify and reduce its effects of interference while occupying the same spectrum as primary user without adversely affecting the required quality of service (QoS) in the network. In this paper a power loss exponent that factors in diverse operating environments for IoT is employed in the non-cooperative game cost function to quantify the required power of transmission in the network. The approach would enable various CRs to transmit with lesser power thereby saving battery consumption or increasing the number of secondary users thereby optimizing the network resources efficiently.

Implementación de la señalización DTMF y respuesta interactiva de voz usando radios E&M

El presente trabajo tiene como finalidad el estudio de alternativas de radios que soporten tanto la señalización E&M como DTMF y a partir de ello, lograr que interactúen con servicios de respuesta interactiva de voz. Con radios VHF se puede expandir la cobertura en servicios de comunicación telefónica. Se diseñó un circuito para facilitar la integración de tarjetas E&M y el radio Motorola Pro 3100, utilizándose como un receptor para conectar llamadas de otros radios hacia una planta telefónica conectada a un Router cisco que es una CME o la planta telefónica conectada a una computadora con Elastix. Así un radio que contenga teclado DTMF, puede hacer llamadas hacia las plantas telefónicas como si se tratara de un teléfono y también un teléfono hacer llamadas a los radios, mediante una IVR hacer consultas en una base de datos

¿Hacia dónde van los radios sociales?

Hasta la aparición de Internet, la radio ha sido, y de hecho lo sigue siendo en las regiones más desfavorecidas por la brecha digital, el medio que más han utilizado los movimiento sociales. El artículo hace un breve repaso a la aparición de las radios sociales diferenciando el contexto americano del europeo ya que éstos marcaron lo que han sido las radios posteriormente. En un segundo epígrafe se profundiza en la experiencia de las radios sociales en el Estado español y su situación actual. Por último, se explicitan los cuatro retos que tienen por delante la radio social para ser incidente: la movilización, la construcción de la comunidad global, el desarrollo de la ciudadanía y la apropiación de la tecnología.

Fast mobility support in low-power wireless networks: smart-HOP over RPL/6LoWPAN

With the emergence of low-power wireless hardware new ways of communication were needed. In order to standardize the communication between these low powered devices the Internet Engineering Task Force (IETF) released the 6LoWPAN stand- ard that acts as an additional layer for making the IPv6 link layer suitable for the lower-power and lossy networks. In the same way, IPv6 Routing Protocol for Low- Power and Lossy Networks (RPL) has been proposed by the IETF Routing Over Low power and Lossy networks (ROLL) Working Group as a standard routing protocol for IPv6 routing in low-power wireless sensor networks. The research performed in this thesis uses these technologies to implement a mobility process. Mobility management is a fundamental yet challenging area in low-power wireless networks. There are applications that require mobile nodes to exchange data with a xed infrastructure with quality-of-service guarantees. A prime example of these applications is the monitoring of patients in real-time. In these scenarios, broadcast- ing data to all access points (APs) within range may not be a valid option due to the energy consumption, data storage and complexity requirements. An alternative and e cient option is to allow mobile nodes to perform hand-o s. Hand-o mechanisms have been well studied in cellular and ad-hoc networks. However, low-power wireless networks pose a new set of challenges. On one hand, simpler radios and constrained resources ask for simpler hand-o schemes. On the other hand, the shorter coverage and higher variability of low-power links require a careful tuning of the hand-o parameters. In this work, we tackle the problem of integrating smart-HOP within a standard protocol, speci cally RPL. The simulation results in Cooja indicate that the pro- posed scheme minimizes the hand-o delay and the total network overhead. The standard RPL protocol is simply unable to provide a reliable mobility support sim- ilar to other COTS technologies. Instead, they support joining and leaving of nodes, with very low responsiveness in the existence of physical mobility.