Methane concentration profiles and isotopic composition of sediment cores from the Black Sea

We present high resolution profiles for the methane concentration and the carbon isotope composition of methane from surface sediments and from the sediment-water transition in the Black Sea. At shallow water sites methane migrates from the sediment into the water column, and the magnitude of this upward migrating flux depends on the depth of the sulfate-methane transition (SMT) in the sediment. The isotope data reveal that the sediments at shallow water sites are a source for methane depleted in 13C relative to the isotope composition of methane in the water column. At deep water sites the methane concentration first decreases with depth in the sediment to reach lowest values at the Unit I to Unit II transition. Below this transition the concentration increases again. Numerical modeling of methane concentration and isotope data shows that high methane oxidation rates occur in the surface sediment layer, indicating that the removal of methane in the surface sediments is not related to the anaerobic oxidation of methane coupled to sulfate reduction that occurs a few meters deep in the sediment, at the SMT. Instead, near-surface methane consumption in the euxinic Black Sea sediments appears to be related to lithological stratification. Furthermore, a map of the diffusive methane fluxes in the Black Sea surface sediments indicates that approximately half of the Black Sea seafloor acts as a sink for methane and thus limits the flux of methane to the atmosphere.

(Figure 2) Suspended sediment concentration profiles from samples in the outer harbor of Emden, Germany

One particularly complex phenomenon is the episodic, tidally driven variation of navigable depth level as a result of fluid mud settlement. This paper presents results from dynamic cone penetration testing with pore pressure measurement (CPTU) as a nonacoustical, direct device to support surveying and management of these areas. The new technique is modular and uses a disk configuration for fluid mud detection. Both disk resistance and pore pressure measurements accurately identify suspended matter concentrations of 90 g/L or more, and the transition from fluid mud to consolidating mud once concentrations exceed 150 g/L. Hence, the procedure attests the potential for rapid, reliable assessment of a fluid mud layer and concurrent characterization of the underlying consolidated sediment by monitoring the pore pressure and strength changes during penetration.

Release currents of IP₃ receptor channel clusters and concentration profiles

We simulate currents and concentration profiles generated by Ca2+ release from the endoplasmic reticulum (ER) to the cytosol through IP3 receptor channel clusters. Clusters are described as conducting pores in the lumenal membrane with a diameter from 6 nm to 36 nm. The endoplasmic reticulum is modeled as a disc with a radius of 1–12 mm and an inner height of 28 nm. We adapt the dependence of the currents on the trans Ca2+ concentration (intralumenal) measured in lipid bilayer experiments to the cellular geometry. Simulated currents are compared with signal mass measurements in Xenopus oocytes. We find that release currents depend linearly on the concentration of free Ca2+ in the lumen. The release current is approximately proportional to the square root of the number of open channels in a cluster. Cytosolic concentrations at the location of the cluster range from 25 μM to 170 μM. Concentration increase due to puffs in a distance of a few micrometers from the puff site is found to be in the nanomolar range. Release currents decay biexponentially with timescales of < 1 s and a few seconds. Concentration profiles decay with timescales of 0.125–0.250 s upon termination of release.