940 resultados para X-RAY STRUCTURES
Resumo:
New mono- and bis-chelated zinc(II) and cadmium(II) complexes of formula, [M(dpksbz)NCS] (dpksbz = anionic form of the di-2-pyridylketone Schiff base of S-benzyldithiocarbazate) and [M(dpksbz)(2)] (M = Zn-II, Cd-II) have been prepared and characterized. The structure of the bis-ligand complex, [Zn(dpksbZ)(2)] has been determined by X-ray diffraction. The complex has a distorted octahedral geometry in which the ligands are coordinated to the zinc(II) ion as uninegatively charged tridentate chelates via the thiolate sulfur atoms, the azomethine nitrogen atoms and the pyridine nitrogen atoms. The distortion from a regular octahedral geometry is attributed to the restricted bite angles of the Schiff base ligands. X-ray structural analysis shows that the [Cd(dpksbz)NCS](2) complex is a centrosymmetric dimer in which each of the cadmium(II) ions adopts a five-coordinate, approximately square-pyramidal configuration with the Schiff base acting as a tetradentate chelating agent coordinating a cadmium(II) ion via one of the pyridine nitrogen atoms, the azomethine nitrogen atom and the thiolate sulfur atom; the second pyridine nitrogen atom is coordinated to the other cadmium(II) ion of the dimer. The fifth coordination position around each cadmium(II) is occupied by an N-bonded thiocyanate ligand. (C) 2003 Elsevier Science Ltd. All rights reserved.
Resumo:
Conventional film based X-ray imaging systems are being replaced by their digital equivalents. Different approaches are being followed by considering direct or indirect conversion, with the later technique dominating. The typical, indirect conversion, X-ray panel detector uses a phosphor for X-ray conversion coupled to a large area array of amorphous silicon based optical sensors and a couple of switching thin film transistors (TFT). The pixel information can then be readout by switching the correspondent line and column transistors, routing the signal to an external amplifier. In this work we follow an alternative approach, where the electrical switching performed by the TFT is replaced by optical scanning using a low power laser beam and a sensing/switching PINPIN structure, thus resulting in a simpler device. The optically active device is a PINPIN array, sharing both front and back electrical contacts, deposited over a glass substrate. During X-ray exposure, each sensing side photodiode collects photons generated by the scintillator screen (560 nm), charging its internal capacitance. Subsequently a laser beam (445 nm) scans the switching diodes (back side) retrieving the stored charge in a sequential way, reconstructing the image. In this paper we present recent work on the optoelectronic characterization of the PINPIN structure to be incorporated in the X-ray image sensor. The results from the optoelectronic characterization of the device and the dependence on scanning beam parameters are presented and discussed. Preliminary results of line scans are also presented. (C) 2014 Elsevier B.V. All rights reserved.
Resumo:
Two octahedral complexes [Ni(HL1)(2)](ClO4)(2) (1) and [Ni(HL2)(2)](ClO4)(2) (2) and a square planar complex [Ni(HL3)]ClO4 (3) have been prepared, where [HL1 = 3-(2-amino-ethylimino)-butan-2-one oxime, HL2 = 3-(2-amino-propylimino)butan-2-one oxime] and H2L3 = 3-[2-(3-hydroxy-1-methyl-but-2-enylideneamino)-1-methyl-ethylimino]-buta n-2-one oxime. All the complexes have been characterized by elemental analyses, spectral studies and room temperature magnetic moment measurements. The molecular structures of all three compounds were elucidated on the basis of X-ray crystallography: complexes 1 and 2 are seen to be the met isomers. (C) 2008 Elsevier Ltd. All rights reserved.
Resumo:
The compounds chlorothiazide and hydrochlorothiazide (crystalline form II) have been studied in their fully hydrogenous forms by powder neutron diffraction on the GEM diffractometer. The results of joint Rietveld refinement of the structures against multi-bank neutron and single-bank X-ray powder data are reported and show that accurate and precise structural information can be obtained from polycrystalline molecular organic materials by this route.
Resumo:
A program is provided to determine structural parameters of atoms in or adsorbed on surfaces by refinement of atomistic models towards experimentally determined data generated by the normal incidence X-ray standing wave (NIXSW) technique. The method employs a combination of Differential Evolution Genetic Algorithms and Steepest Descent Line Minimisations to provide a fast, reliable and user friendly tool for experimentalists to interpret complex multidimensional NIXSW data sets.
Resumo:
Two new complex salts of the form (Bu4N)(2)[Ni(L)(2)] (1) and (Ph4P)(2)[Ni(L)(2)] (2) and four heteroleptic complexes cis-M(PPh3)(2)(L) [M = Ni(II) (3), Pd(II) (4), L = 4-CH3OC6H4SO2N=CS2] and cis-M(PPh3)(2)(L') [M = Pd(II) (5), Pt(II) (6), L' = C6H5SO2N=CS2] were prepared and characterized by elemental analyses, IR, H-1, C-13 and P-31 NMR and UV-Vis spectra, solution and solid phase conductivity measurements and X-ray crystallography. A minor product trans-Pd(PPh3)(2)(SH)(2), 4a was also obtained with the synthesis of 4. The NiS4 and MP2S2 core in the complex salts and heteroleptic complexes are in the distorted square-plane whereas in the trans complex, 4a the centrosymmetric PdS2P2 core is perforce square planar. X-ray crystallography revealed the proximity of the ortho phenyl proton of the PPh3 ligand to Pd(II) showing rare intramolecular C-H center dot center dot center dot Pd anagostic binding interactions in the palladium cis-5 and trans-4a complexes. The complex salts with sigma(rt) values similar to 10 (5) S cm (1) show semi-conductor behaviors. The palladium and platinum complexes show photoluminescence properties in solution at room temperature.
Resumo:
Tethered deuterated polystyrene-block-polymethyl methacrylate films have been examined by X-ray scattering both in their native state and following treatment with ruthenium tetroxide. The use of the stain, while increasing the thickness of the films, does not significantly alter the lateral structure or periodicity of the films and provides contrast between the two blocks. Both the periodicity of the films and the structure normal to the surface have been identified following staining. Experiments were also performed on films treated by a solvent exchange process, and the effects of staining on these films are discussed.
Resumo:
Reaction of with one or two equivalents of LiPPh2 afforded the new phosphanidometal(III) complexes . Reaction of 2 with LiC≡CSiMe3 led to the diamagnetic zirconium(III) alkynyl derivative [{Zr(C5H5)(μ−C≡CSiMe3)}2(μ−η5−C5H4−η5−C5H4], 7. Alkylation of 6 with LiCH2CMe2Ph gave [{Zr(η5−C5H5)(CH2CMe2Ph)2}2{μ−(η5−C5H4)}], 8. A detailed NMR study of complexes 3 and 4 allowed the observation of the spectral behaviour of the eight different fulvalene protons through their coupling to the 31P nucleus. The fluxional behaviour of complex 7 was studied by dynamic DNMR, and kinetic parameters for the σ-π-conversion of the alkynyl ligand were determined. The molecular structures of complexes 3 and 7 were determined by X-ray diffraction methods.
Resumo:
Phenylphosphinic acid (HPhPO2H) and phenylphosphonic acid (PhPO3H2) react with a methanolic solution of [Ru2(μ-O2CCH3)4(O2CCH3)2]H·0.7H2O at room temperature to give [Ru2(μ-O2CCH3)4(HPhPO2)2H (1) and [Ru2(μ-O2CCH3)4 (PhPO3H)2]H·H2O (2), respectively. The X-ray crystal structures of 1 and 2 each show the RuRu core to be ligated by four bridging bidentate acetate ligands [RuRu distances: 1 = 2.272(1) Å; 2 = 2.267(2) Å] and two axial phenylphosphinate and phenylphosphonate ligands, respectively. In each complex the individual bimetallic molecules are linked together by a hydrogen ion which bridges the oxygen atoms of neighbouring axial ligands. In 2 the water molecule is also hydrogen-bonded to one of the axial phenylphosphonate groups. Spectroscopic, magnetic and cyclic voltammetric data for the complexes are given.
Resumo:
Phenylphosphinic acid (HPhPO2H) is oxidized to phenylphosphonic acid (PhPO3H2) at room temperature using a solution of [Cu2(μ-O2CCH3)4(H2O)2] in pyridine. The phenylphosphonic acid was recovered as the monomeric copper(II) complex [Cu(PhPO3H)2(C5H5N)4]·H2O (1a), and the reaction thought to proceed via a copper(I) intermediate. Recrystallization of 1a from methanol gave [Cu(PhPO3H)2(C5H5N)4]·2CH3OH (1b). The unsolvated complex [Cu(PhPO3H)2(C5H5N)4] (1c) was prepared by refluxing polymeric [Cu(PhPO3)(H2O)] (2) in pyridine. The X-ray crystal structures of 1b and 1c show that in each of these monomeric complexes the copper(II) ion is ligated by four equatorial pyridine molecules and two axial monoanionic phenylphosphonate groups. A cyclic voltammetric study of 1a revealed a quasi-reversible Cu2+/Cu+ couple with E1/2 = +228 mV (vs Ag/AgCl).
Resumo:
1,1′-Diacetylferrocene reacts with neat hydrate over a period of 72 h at 20°C to give the dihydrazone [H2NN(Me)CC5H4FeC5H4C(Me)NNH2] (6) in almost quantitative yield. Either prolonging the reaction time or reacting 6 with fresh hydrazine causes the iron to be stripped from the metallocene and bis(hydrazine)bis(hydrazinecarboxylato-N′,O) iron(II), [Fe(N2H4)2(OOCNHNH2)2] (11), crystallizes. In the presence of Ba2+ or Mo2+ ions two molecules of complex 6 react to give the cyclic diazine [N(Me)CC5H4FeC5H4C (Me)N]2 (7) in high yield. Hydrazine is liberated in this reaction. Complexes 6 and 11 have been characterized crystallographically. The cyclic voltammograms of complexes 6 and 7 contain essentially non-reversible oxidation peaks.
Resumo:
Mild heating of the phosphidotriosmium cluster [Os3H(CO)10(µ2-PH2)](1) with [Os3(CO)12 –n(MeCN)n](n= 1 or 2) gives high yields of the (µ3-PH) bridged hexaosmium clusters (2) and (3); reactions of (2) and (3) with bases and X-ray structure analyses of (3) and of (6), which was obtained from (3) and MeO– followed by acid treatment are described.
Resumo:
Reaction of Li(CPhCMe2) with SnCl4 or CrCl3·3thf (thf = tetrahydrofuran) affords the isoleptic compounds Sn(CPhCMe2)4 or [Cr(CPhCMe2)4] respectively. The mode of formation and chemical properties are reported for the chromium species, and the structures of the new compounds, both of which have been determined by single-crystal X-ray analysis, are described.
Resumo:
Treatment of the labile cluster [Os3(CO)11(MeCN)] with PH3 affords the substituted product [Os3(CO)11(PH3)](1) in high yield. Subsequent reaction of (1) with Na2CO3 in MeOH, followed by acidification, gives the hydrido phosphido cluster [Os3(µ-H)(CO)10(µ-PH2)](2). When (2) is heated to 45–60 °C in the presence of [Os3(CO)11(MeCN)] a hexanuclear complex with the formulation [Os6(µ-H)2(CO)21(µ3-PH)](3) is obtained. If this reaction is repeated using [Os3(CO)10(MeCN)2] instead of [Os3(CO)11(MeCN)], an acetonitrile-containing product, [Os6(µ-H)2(CO)20(MeCN)(µ3-PH)](4), is obtained. An X-ray analysis of (4) shows that two Os3 triangular units are linked by a µ3-phosphinidene ligand, which symmetrically bridges an Os–Os edge of one triangle and is terminally co-ordinated to one Os atom of the second triangle. When (3) is treated with a weak base, such as [N(PPh3)2]Cl or [PPh3Me] Br, deprotonation to the corresponding cluster monoanion [Os6(µ-H)(CO)21(µ3-PH)]–(5) occurs. Treatment of (5) with a weak acid regenerates (3) in quantitative yield. Thermolysis of (3) leads to a closing up of the metal framework, affording the cluster [Os6(µ-H)(CO)18(µ6-P)], which readily deprotonates to give the anion [Os6(CO)18(µ6-P)]–(7) in the presence of [N(PPh3)2] Cl or [PPh3Me]Br. The same anion (7) may also be obtained by direct thermolysis of (5). An X-ray analysis of the [PPh3Me]+ salt of (7) confirms that the phosphorus occupies an interstitial site in a trigonal-prismatic hexaosmium framework, and co-ordinates to all six metal atoms with an average Os–P distance of 2.31 (1)Å. Proton and 31P n.m.r. data on all the new clusters are presented, and the position of the phosphorus resonance in the 31P n.m.r. spectrum is related to the changes in the environment of the phosphorus atom.