Impact dynamics of high Weber number drops on chemically modified metallic surfaces

Hydrophobic/superhydrophobic metallic surfaces prepared via chemical treatment are encountered in many industrial scenarios involving the impingement of spray droplets. The effectiveness of such surfaces is understood through the analysis of droplet impact experiments. In the present study, three target surfaces with aluminum (Al-6061) as base material-acid-etched, Octadecyl Trichloro Silane (OTS) coated, and acid-etched plus OTS-coated-were prepared. Experiments on the impact of inertia dominated water drops on these chemically modified aluminum surfaces were carried out with the objective to highlight the effect of chemical treatment on the target surfaces on key sub-processes occurring in drop impact phenomenon. High speed videos of the entire drop impact dynamics were captured at three Weber number (We) conditions representative of high We (We > 200) regime. During the early stages of drop spreading, the drop impact resulted in ejection of secondary droplets from spreading drop front on the etched surfaces resembling prompt splash on rough surfaces whereas no such splashing was observable on untreated aluminum surface. Prominent development of undulations (fingers) were observed at the rim of drop spreading on the etched surfaces; between the etched surfaces the OTS-coated surface showed a subdued development of fingers than the uncoated surface. The impacted drops showed intense receding on OTS-coated surfaces whereas on the etched surface a highly irregular receding, with drop liquid sticking to the surface, was observed. Quantitative analyses were performed to reveal the effect of target surface characteristics on drop impact parameters such as temporal variation of spread factor of drop lamella, temporal variation of average finger length during spreading phase, maximum drop spreading, time taken to attain maximum spreading, sensitivity of maximum spreading to We, number of fingers at maximum spreading, and average receding velocity of drop lamella. Existing models for maximum drop spreading showed reasonably good agreement with the experimental measurements on the target surfaces except the acid-etched surface. (C) 2014 Elsevier B.V. All rights reserved.

Secondary breakup of a drop at moderate Weber numbers

We present volume of fluid based numerical simulations of secondary breakup of a drop with high density ratio (approx. 1000) and also perform experiments by injecting monodisperse water droplets in a continuous jet of air and capture the breakup regimes, namely, bag formation, bag-stamen, multibag and shear breakup, observed in the moderate Weber number range (20-120). We observe an interesting transition regime between bag and shear breakup for We = 80, in both simulations as well as experiments, where the formation of multiple lobes, is observed, instead of a single bag, which are connected to each other via thicker rim-like threads that hold them. We show that the transition from bag to shear breakup occurs owing to the rim dynamics which shows retraction under capillary forces at We = 80, whereas the rim is sheared away with flow at We = 120 thus resulting in a backward facing bag. The drop characteristics and timescales obtained in simulations are in good agreement with experiments. The drop size distribution after the breakup shows bimodal nature for the single-bag breakup mode and a unimodal nature following lognormal distribution for higher Weber numbers.

药蒲公英(Taraxacum officinale Weber)体外再生体系的建立、耐盐愈伤组织筛选和抗盐基因转化

药蒲公英(Taraxacum officinale Weber)是菊科蒲公英属的模式种，主要分布于欧洲和北美，在我国新疆也有少量分布。与Taraxacum mongolicum Hand-Mazz(我国中药市场的主流种和主要自然分布种)相比，药蒲公英的生物量更大，作为营养保健蔬菜具有更大的市场价值。药蒲公英的组织培养工作是开展基础研究的有力工具，本工作中，药蒲公英叶片外植体在含0.2mg/L IAA和1.0mg/L TDZ的MS培养基中培养2周后便产生大量的丛生芽，在含有0.5mg/L 2,4-D和2mg/L6-BA的MS培养基中培养30天后，形成明显的愈伤组织，愈伤组织块在含1.0mg/L 6-BA的MS培养基中成功再生。 体细胞无性系变异是植物愈伤组织培养中的普遍现象，我们将继代6次的愈伤组织接种于含盐培养基，得到了能够耐受1.0%NaCl的细胞系。耐盐细胞系在含盐培养基中的相对生长率和细胞活力明显高于对照（非耐盐细胞系接种于含盐培养基），由耐盐细胞系在含盐培养基中获得再生植株的工作正在进行。 直接不定芽再生途径对遗传物质具有高度保真性，是遗传转化的理想体系。我们利用此再生系统，将来源于耐盐植物山菠菜(Atriplex hortensis L.)BADH基因通过农杆菌介导的叶盘转化法导入药蒲公英，获得了PCR检测成阳性的转基因植株5株，从而建立了药蒲公英的转化体系。转基因植株的其他分子检测和耐盐性鉴定工作正在进行。

药蒲公英（Taraxacum officinale weber）耐盐变异体的筛选及其耐盐性分析研究

以药蒲公英（Taraxacum officinale Weber）叶片外植体为材料诱导愈伤组织。以NaCl作为选择因子，从愈伤组织直接筛选。在选择培养基上，大部分愈伤组织褐化死亡，在一些褐化死亡的愈伤组织周围有少量新的细胞团生长，挑选生长存活状况好的细胞团转接到新鲜培养基上，每3周继代一次，经3个月继代筛选获得了耐1.5% NaCl的药蒲公英细胞团。以普通愈伤为对照，发现随着NaCl浓度的升高，耐盐愈伤的相对生长率下降但显著高于对照;且随着盐胁迫处理时间的延长持续升高，而普通愈伤对照几乎停止生长，说明耐盐愈伤具有相对稳定的耐盐性。在蛋白水平上，耐盐愈伤与对照愈伤差异明显，SDS-PAGE分析显示：耐盐愈伤比对照多出一条34 KD大小的蛋白带，且30 KD，18 KD左右的蛋白带明显上调。相同处理条件下耐盐愈伤脯氨酸的增加幅度高于对照。盐胁迫条件下，耐盐愈伤的超氧化物歧化酶（SOD）、过氧化物酶（POD）和过氧化氢酶（CAT）活性明显高于对照，且随着处理时间的延长和盐浓度的增加呈现升高的趋势，而对照则呈现先升高后下降的趋势。1.5% NaCl处理前后，耐盐愈伤的总黄酮含量显著高于对照。结果说明耐盐愈伤一方面通过积累蛋白和其他小分子有机溶质的方式调节其渗透平衡，另一方面还可通过提高抗氧化能力降低盐分造成的次级伤害。 将耐1.5% NaCl的药蒲公英愈伤组织接种在分化培养基上分化出芽，之后将再生芽转接到生根培养基中进行生根培养，经4个月得到了12株耐1.5% NaCl的药蒲公英再生植株。与野生型相比，耐盐植株叶片宽大、叶柄粗短、叶表面覆盖白色细毛，根粗壮较短，花茎中部具有2 cm左右的苞叶。RAPD和SDS-PAGE检测表明，耐盐植株与对照植株在DNA及蛋白水平上均存在明显差异。1.5% NaCl处理后，与普通再生植株相比，耐盐株系的抗氧化酶活性明显提高，脯氨酸含量上升幅度更为显著，而丙二醛含量降低，其主要药用成分黄酮的含量显著增加。这些结果说明耐盐植株的抗氧化防御能力明显增强。以上结果表明耐1.5% NaCl的药蒲公英再生植株为耐1.5% NaCl药蒲公英变异体，这些耐盐变异体有望成为抗盐耐海水蔬菜家族的新成员。同时，这些耐盐变异体植株比普通植株具有更高的医用商业价值。耐1.5% NaCl的药蒲公英再生变异体遗传稳定性的研究正在进行中。

Max Weber and the First World War: Protestant and Catholic living standards in Germany, 1914-1919

We assess informal institutions of Protestants and Catholics by investigating their economic resilience in a natural experiment. The First World War constitutes an exogenous shock to living standards since the duration and intensity of the war exceeded all expectations. We assess the ability of Protestant and Catholic communities to cope with increasing food prices and wartime black markets. Literature based on Weber (1904, 1905) suggests that Protestants must be more resilient than their Catholic peers. Using individual height data on some 2,800 Germans to assess levels of malnutrition during the war, we find that living standards for both Protestants and Catholics declined; however, the decrease of Catholics’ height was disproportionately large. Our empirical analysis finds a large statistically significant difference between Protestants and Catholics for the 1915–19 birth cohort, and we argue that this height gap cannot be attributed to socioeconomic background and fertility alone.

Max Weber and the First World War: Protestant and Catholic living standards in Germany, 1915-1919

We assess informal institutions of Protestants and Catholics by investigating their economic
resilience in a natural experiment. The First World War constitutes an exogenous shock to living standards since the duration and intensity of the war exceeded all expectations. We assess the ability of Protestant and Catholic communities to cope with increasing food prices and wartime black markets. Literature based on Weber (1904, 1905) suggests that Protestants must be more resilient than their Catholic peers. Using individual height data on some 2,800 Germans to assess levels of malnutrition during the war, we find that living standards for both Protestants and Catholics declined; however, the decrease of Catholics’ height was disproportionately large. Our empirical analysis finds a large statistically significant difference between Protestants and Catholics for the 1914-19 birth cohort, and we argue that this height gap cannot be attributed to socioeconomic background and fertility alone.

Mémoires de Weber : frère de lait de Marie-Antoinette, reine de France / avec avant-propos et notes, par M. Fs. Barrière

Collection : Bibliothèque des mémoires relatifs à l'histoire de France pendant le 18e siècle ; 7