Structural and physicochemical characteristics of lintnerized native and sour cassava starches

The comprehension of the structure of starch granules is important for the understanding of its physicochemical properties. Native and sour cassava starches after being analyzed with respect to their pasting properties and baking expansion capacity, were treated with 2.2 N HCl at 38 degreesC for a maximum of nine days. The starch granules remaining after lintnerization were analyzed for amylose content and intrinsic viscosity, by X-ray diffraction, scanning electron microscopy and chromatographic analysis. The results indicated that the acid hydrolysis on all starches occurred in two steps. The first one, with high hydrolysis rate, was characterized by a quick degradation of the amorphous part of the granules whereas the second step, with lower hydrolysis rate, was characterized by a higher resistance of the organized areas of the granules to acid treatment. Most of the amylose chains were found in the amorphous areas of starch granules only a small percentage was involved in the crystalline regions. The microscopic and chromatographic analysis demonstrated that the acid hydrolysis was not able to disrupt the entire granular crystalline structure. Fermented starch showed amylose and/or amylopectin chain fractions resistant to pullulanase, probably due to structural alterations during fermentation.

Influence of low and high levels of grain defects on maize wet milling

Yields and starch pasting characteristics obtained from wet milling of maize samples with low and high levels of defect grains were compared to those from sound samples. Defect grain groups ere established taking into account the defect degree. Thus the first group consisted of fermented, molded, heated and sprouted grains and the second of insect damaged. hollow, fermented (up to 1/4) grains and those injured by other causes. The grain groups, if present at low levels in the samples, 10% for first group and 17% for second group did not affect the chemical composition of starch and its pasting properties. obtained by the rapid visco analyser. Samples with high levels of grain groups (up to 100%). affected wet milling yields and starch viscosity. Samples with 100% of grains in the first group decreased starch, germ yield and peak viscosity and increased gluten yield. Samples with 100% of grains in the second group decreased germ and fiber yield but increased starch yield. (C) 2002 Elsevier B.V. Ltd. All rights reserved.

Efeito da hidrólise enzimática seguida da moagem em moinho de bolas sobre as características estruturais e físico-químicas do amido de madioquinha-salsa

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeito do tamanho dos grânulos nas características estruturais e físico-químicas do amido de trigo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito da modificação ácido-metanólica nas características estruturais e fisico-químicas de amidos de milho e mandioca

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Avaliação da qualidade industrial de linhagens de trigo por meio de métodos físico-químicos, reológicos e de panificação

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Efeitos de tratamentos hidrotérmicos nas propriedades viscográficas e amidos resistentes em féculas de mandioca

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Composição dos tubérculos, extração e caracterização de amidos de diferentes cultivares de batata

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Estudo das características estruturais de amidos: efeito do 'annealing', da hidrólise ácida e da hidrólise enzimática

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Características físicas, reológicas e sensorial de produtos extrusados de misturas de farinha de maracujá e fécula de mandioca

This research had as objective to evaluate the effect of extrusion temperature and screw speed on physical and rheological properties, as well as, the sensory acceptance of cassava and passion fruit snacks produced in single-screw extruder. A central composite design with 11 treatments was used, considering as dependent variables: expansion index (EI), specific volume (SV), water solubility index (WSI), water absorption index (WAI), color (L*, a*, b*) and pasting properties (RVA). The products were flavored and analyzed for global acceptance. The results showed significant effects of temperature and screw speed on the dependent variables. The chocolate flavored snacks obtained good acceptance.

Composição físico-química e propriedades tecnológicas da farinha de folhas de mandioca

Cassava leaves can be considered an important nutritional source when compared to other commonly consumed vegetables leaves. Cassava leaves have high levels of protein, fiber and minerals, and arestill underexplored due to the lack of information regarding the use of them as afood product, as well as, their use as an industrial raw material. The consumption of cassava leaves in fresh form is impractical due to the presence of cyanide, thereby it is required a pretreatment to be performed to reduce this component. The objective of this study was to produce and characterize the four made with cassava leaves as its chemical composition, color, indices of absorption and water solubility, and pasting properties, aiming to provide information of interest for possible application as an ingredient in the food industry. Cassava leaf flour showed low moisture content (6.6 %)and significant amounts of fiber (30.68 %), protein (23.00 %), and total carbohydrate (22.27%). Drying and milling processes allowed to obtain a flour with a low content of total cyanide (0.3 mg 100g-1 ), and the presence of vitamin C (56.6 mg 100g-1 ) and β –carotene (38 mg 100g- 1 ). The color analysis of cassava leaf flour showed low lightness with, predominantly, green and yellow pigments. The cassava leaf flour presented good solubility (14.85 %) and water absorption (6.87 g gel. g-1 ). Pasting properties showed a low peak of viscosity and a higher final viscosity with a retrogradation tendency, indicating a low capacity of this flour to form gel. The flour of cassava leaves can be a good source of nutrition when used as a food ingredient in soups and pasta. However, it is not indicated to products that require high gel formation.

Batata cv Pirassu como matéria prima industrial

The starch market has been growing and improving in recent years, leading to a search for products with specific characteristics that meet the industrial requirements. This work aimed to evaluate the centesimal composition of potato tubers cv Pirassu and its industrial potential. The potato cv Pirassu was cultivated in Pouso Alegre, mountainous region south of Minas Gerais state, with planting season in August and harvest season in November, 2011. The tubers were analyzed for color, pulp and centesimal composition. The starch extract was analyzed for centesimal composition, phosphorus content, apparent amylose, pasting properties and thermal properties. The results showed that the content of dry matter, total soluble sugar and starch of tubers, are compatible for processing for potato chips. The starch of this cultivate showed important viscosity characteristics for food industry such as: heat resistance and friction, good final viscosity and low granular organization.

Obtenção de amido resistente por intercruzamento e por tratamento hidrotérmico, e sua incorporação em bolos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeitos de modificações físicas sobre as propriedades de amido de tuberosas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Isolation and characterization of the flour and starch of plantain bananas (Musa paradisiaca)

Plantain bananas of the variety Terra (Musa paradisiaca) may have industrial value due to their high starch content. In this research, the flour and starch of such unripe fruit were isolated and their chemical, physicochemical, and structural characteristics were determined. Banana flour and starch had a dry basis yield of 50.6 and 28.5%, and an average granule size of 31.7 and 47.3?mu m, respectively. Both raw materials revealed a C-type pattern and high gelatinization temperatures. The peak viscosity was greater for flour (378.0 RVU) than for starch (252.6 RVU), although the final viscosity was lower. At temperatures above 65 degrees C, the swelling power of banana flour was lower than that of starch, while the solubility of flour was greater than that of starch at all temperatures. Furthermore, the presence of other components in banana flour influenced its physicochemical properties. In general, the flour and starch processed from unripe bananas have numerous possible uses as ingredients in food systems and for other industrial purposes.