On the performance of near-far resistant CDMA detectors in the presence of synchronization errors

Little has so far been reported on the performance of the near-far resistant CDMA detectors in the presence of the synchronization errors. Starting with the general mathematical model of matched filters, this paper examines the effects of three classes of synchronization errors (i.e. time-delay errors, carrier phase errors, and carrier frequency errors) on the performance (bit error rate and near-far resistance) of an emerging type of near-far resistant coherent DS/SSMA detectors, i.e. the linear decorrelating detector (LDD). For comparison, the corresponding results for the conventional detector are also presented. It is shown that the LDD can still maintain a considerable performance advantage over the conventional detector even when some synchronization errors exist. Finally, several computer simulations are carried out to verify the theoretical conclusions.

Near-far resistant detection of CDMA signals via isolation bit insertion

This paper presents a novel scheme for near-far resistant CDMA detection: isolation bit insertion (IBI). At the transmitter, isolation bits are inserted into the information bit sequence before modulation, and a practical linear decorrelating detector (LDD) is obtained at the receiver. All the advantages that an LDD theoretically offers are retained and realised in practice.

One-shot near-far resistant CDMA detection in multipath fading channels-an O^3 BPSK based system

This paper applies O3BPSK (orthogonal on-off PSK) signaling scheme to multipath fading CDMA channels, for the purpose of near-far resistant detection in the reverse link. Based on the maximum multipath spreading delay, a minimum duration of “off” is suggested, with which the temporally adjacent bits (TABs) from different users at the receiver are decoupled. As a result, a Rake-type one-shot linear decorrelating detector (LDD) is obtained. Since no knowledge of echo amplitudes is needed, a blind detection can be realised.

A study on the performance of the partial PIC CDMA detector in the presence of time offset errors

This paper investigates the effect of time offset errors on the partial parallel interference canceller (PIC) and compares the performance of it against that of the standard PIC. The BER performances of the standard and partial interference cancellers are simulated in a near far environment with varying time offset errors. These simulations indicate that whilst timing errors significantly affect the performance of both these schemes, they do not diminish the gains that are realised by the partial PIC over that of the standard PIC.

A new signaling scheme for one-shot near-far resistant detection in DS/CDMA

This paper proposes a new signaling scheme: orthogonal on-off BPSK (O3BPSK), for near-far resistant detection in the asynchronous DS/CDMA systems (up-link). The temporally adjacent bits from different users in the received signals are decoupled by using the on-off signaling, and the original data rate is maintained with no increase in transmission rate by adopting an orthogonal structure. The detector at the receiver is a one-shot linear decorrelating detector, which depends upon neither hard-decision nor specific channel coding. Some computer simulations are shown to confirm the theoretical analysis.

Performance analysis of near-far resistant CDMA detectors-influence of system parameter estimation errors

Little has been reported on the performance of near-far resistant CDMA detectors in the presence of system parameter estimation errors (SPEEs). Starting with the general mathematical model of matched filters, the paper examines the effects of three classes of SPEEs, i.e., time-delay, carrier phase, and carrier frequency errors, on the performance (BER) of an emerging type of near-far resistant coherent DS/SSMA detector, i.e., the linear decorrelating detector. For comparison, the corresponding results for the conventional detector are also presented. It is shown that the linear decorrelating detector can still maintain a considerable performance advantage over the conventional detector even when some SPEEs exist.

Results from the HST/COS FUV detector "lifetime move"

We describe the planning, implementation, and initial results of the first planned move of the default position of spectra on the Hubble Space Telescope's Cosmic Origins Spectrograph (COS) Far Ultraviolet (FUV) cross-delay line detector. This was motivated by the limited amount of charge that can be extracted from the microchannel plate due to gain sag at any one position. Operations at a new location began on July 23, 2012, with a shift of the spectrum by +3.5"(corresponding to ~ 41 pixels or ~ 1 mm) in a direction orthogonal to the spectral dispersion. Operation at this second "lifetime position" allows for spectra to be collected which are not affected by detector artifacts and loss of sensitivity due to gain sag. We discuss programs designed to enable operations at the new lifetime position; these include determinations of operational high voltage, measuring walk corrections and focus, confirming spectrum placement and aperture centering, and target acquisition performance. We also present results related to calibration of the new lifetime position, including measurements of spectral resolution and wavelength calibration, flux and flat field calibration, carryover of time-dependent sensitivity monitoring, and operations with the Bright Object Aperture (BOA).

Trasmission and Reflection (ATR)Far-Infrared Spectroscopy Applied in the Analysis of Cultural Heritage Materials

FIR spectroscopy is an alternative way of collecting spectra of many inorganic pigments and corrosion products found on art objects, which is not normally observed in the MIR region. Most FIR spectra are traditionally collected in transmission mode but as a real novelty it is now also possible to record FIR spectra in ATR (Attenuated Total Reflectance) mode. In FIR transmission we employ polyethylene (PE) for preparation of pellets by embedding the sample in PE. Unfortunately, the preparation requires heating of the PE in order to produces at transparent pellet. This will affect compounds with low melting points, especially those with structurally incorporated water. Another option in FIR transmission is the use of thin films. We test the use of polyethylene thin film (PETF), both commercial and laboratory-made PETF. ATR collection of samples is possible in both the MIR and FIR region on solid, powdery or liquid samples. Changing from the MIR to the FIR region is easy as it simply requires the change of detector and beamsplitter (which can be performed within a few minutes). No preparation of the sample is necessary, which is a huge advantage over the PE transmission method. The most obvious difference, when comparing transmission with ATR, is the distortion of band shape (which appears asymmetrical in the lower wavenumber region) and intensity differences. However, the biggest difference can be the shift of strong absorbing bands moving to lower wavenumbers in ATR mode. The sometimes huge band shift necessitates the collection of standard library spectra in both FIR transmission and ATR modes, provided these two methods of collecting are to be employed for analyses of unknown samples. Standard samples of 150 pigment and corrosion compounds are thus collected in both FIR transmission and ATR mode in order to build up a digital library of spectra for comparison with unknown samples. XRD, XRF and Raman spectroscopy assists us in confirming the purity or impurity of our standard samples. 24 didactic test tables, with known pigment and binder painted on the surface of a limestone tablet, are used for testing the established library and different ways of collecting in ATR and transmission mode. In ATR, micro samples are scratched from the surface and examined in both the MIR and FIR region. Additionally, direct surface contact of the didactic tablets with the ATR crystal are tested together with water enhanced surface contact. In FIR transmission we compare the powder from our test tablet on the laboratory PETF and embedded in PE. We also compare the PE pellets collected using a 4x beam condenser, focusing the IR beam area from 8 mm to 2 mm. A few samples collected from a mural painting in a Nepalese temple, corrosion products collected from archaeological Chinese bronze objects and samples from a mural paintings in an Italian abbey, are examined by ATR or transmission spectroscopy.

The new bern PET cyclotron, its research beam line, and the development of an innovative beam monitor detector

The new Bern cyclotron laboratory aims at industrial radioisotope production for PET diagnostics and multidisciplinary research by means of a specifically conceived beam transfer line, terminated in a separate bunker. In this framework, an innovative beam monitor detector based on doped silica and optical fibres has been designed, constructed, and tested. Scintillation light produced by Ce and Sb doped silica fibres moving across the beam is measured, giving information on beam position, shape, and intensity. The doped fibres are coupled to commercial optical fibres, allowing the read-out of the signal far away from the radiation source. This general-purpose device can be easily adapted for any accelerator used in medical applications and is suitable either for low currents used in hadrontherapy or for currents up to a few μA for radioisotope production, as well as for both pulsed and continuous beams.

"Over The Hill" is not so far away : crossing teaching contexts to create benefits for all through rural teaching experiences.

Attracting and retaining quality teachers to rural and remote areas has been a challenge over the last decade. Many preservice teachers are reluctant to experience a rural and remote practicum and may not consider applying to teach in such areas when they graduate. Education departments and universities need to explore innovative ways that will encourage graduates to consider undertaking a teaching position in the bush. As a way forward, preservice teachers from a regional campus of a Queensland University were invited to participate in a six-day rural experience entitled ‘Over the Hill’ that included being billeted with local families, participating in community activities and observing and teaching in classrooms. Fifteen preservice teachers were accompanied by two university academics who returned to work in a classroom as teacher for their own rural and remote professional experience. The aim of this qualitative study was to explore and describe the perceptions of a rural and remote teaching experience from the perspectives of the preservice teachers, the accompanying academics and the school staff hosting the program. Data were collected from the preservice teachers and accompanying academics in the form of written reflections while fourteen school staff completed a related questionnaire. The results indicated that a six-day rural and remote teaching program can provide professional benefits for all involved, preservice teachers, accompanying academics and the school staff hosting the program. Indeed, this study indicates that short experiences such as “Over the Hill” not only assist preservice teachers to make informed decisions about teaching in rural and remote areas but can provide professional benefits for accompanying academics and the schools.

Listening, sharing understanding and facilitating consumer, family and community empowerment through a priority driven partnership in Far North Queensland

Objectives: This paper provides an example of a mental health research partnership underpinned by empowerment principles that seeks to foster strength among community organizations to support better outcomes for consumers, families and communities. It aims to raise awareness among researchers and service providers that empowerment approaches to assist communities to address mental health problems are not too difficult to be practical but require long-term commitment and appropriate support. Methods: A collaborative research strategy that has become known as the Priority Driven Research (PDR) Partnership emerged through literature review,consultations, Family Wellbeing Program delivery with community groups and activities in two discrete Indigenous communities. Progress to date on three of the four components of the strategy is described. Results: The following key needs were identified in a pilot study and are now being addressed in a research-based implementation phase: (i) gaining two-way understanding of perspectives on mental health and promoting universal awareness; (ii) supporting the empowerment of carers, families, consumers and at-risk groups through existing community organizations to gain greater understanding and control of their situation; (iii) developing pathways of care at the primary health centre level to enable support of social and emotional wellbeing as well as more integrated mental health care; (iv) accessing data to enable an ongoing process of analysis/sharing/planning and monitoring to inform future activity. Conclusion: One of the key learnings to emerge in this project so far is that empowerment through partnership becomes possible when there is a concerted effort to strengthen grassroots community organizations. These include social health teams and men’s and women’s groups that can engage local people in an action orientation. Key words: Aboriginal, empowerment, Indigenous, mental health.

Urban network travel time estimation from stop-line loop detector data and signal controller data

This paper presents a model to estimate travel time using cumulative plots. Three different cases considered are i) case-Det, for only detector data; ii) case-DetSig, for detector data and signal controller data and iii) case-DetSigSFR: for detector data, signal controller data and saturation flow rate. The performance of the model for different detection intervals is evaluated. It is observed that detection interval is not critical if signal timings are available. Comparable accuracy can be obtained from larger detection interval with signal timings or from shorter detection interval without signal timings. The performance for case-DetSig and for case-DetSigSFR is consistent with accuracy generally more than 95% whereas, case-Det is highly sensitive to the signal phases in the detection interval and its performance is uncertain if detection interval is integral multiple of signal cycles.