Propriedades texturais e catalíticas de óxidos de ferro contendo cromo e cobre

Chromium and copper-doped hematites were prepared with the aim of studying the synergistic effect of these dopants on the textural and on the catalytic properties of the iron oxides towards the high temperature shift reaction. It was found that the most active catalysts were those with the highest amount of copper. They had the Fe(II)/Fe(III) ratio near the stoichiometric value of magnetite, the highest surface areas under the reactional atmosphere and the greatest tendency to produce the active form; they also were poorly crystalline solids. The best performance was shown by the catalyst with Fe/Cu=10, heated at 300ºC. It can thus be concluded that copper acts both as textural and structural promoter in these catalysts.

Uso de irradiação de microondas na determinação espectrofotométrica de cromo com EDTA

Cr(III) slowly forms a violet complex with EDTA at pH 2.5-5.0 under normal conditions. The complex formation can be accelerated by irradiating the reacting mixture with microwave energy. The complex Cr(III)-EDTA is completely formed within 3 minutes of microwave irradiation and followed by a simple and rapid method for spectrophotometric determination of chromium. The method may be successfully applied to determination of chromium in catalyst.

Efeito do cromo nas propriedades catalíticas da MCM-41

The effect of chromium on the catalytic properties of MCM-41 was evaluated in order to develop new catalysts for the trimethylbenzene transalkylation with benzene to produce ethylbenzene, a high-value aromatic in the industry. It was found that chromium decreases the specific surface area but increases the acidity, turning MCM-41 into an active and selective catalyst for ethylbenzene and toluene production. The coke produced on the catalyst is hydrogenated and mainly located outside the pores and thus can be easily removed. The catalyst is more active and selective than mordenite, a commercial catalyst, and thus more promising for commercial applications.

Avaliação das técnicas de precipitação química e encapsulamento no tratamento e destinação conjunta de resíduos líquidos contendo cromo e vidrarias de laboratório

In this paper, we present procedures for the treatment and final disposal of residual solutions containing chromium, in order to evaluate the effectiveness of chemical precipitation of the metal and the potential of the glass encapsulation technique, using broken laboratory glassware. The results demonstrated that pH-values convenient for chemical precipitation are between 10 - 11. With regard to Cr(OH)3 encapsulation, the leaching and solubilization tests allowed to classify the waste as non-dangerous and non-inert. Finally, it is pointed out that the adoption of waste management practices in universities should be encouraged, helping to train professionals skilled in good laboratory practices.

Especiação redox de cromo em solo acidentalmente contaminado com solução sulfocrômica

Determination of Cr(VI) and Cr(III) was studied in soil samples accidentally contaminated with sulphochromic solution. Molecular absorption spectrophotometry based on the diphenylcarbazide method was used for the determination of Cr(VI) after its alkaline extraction. The total chromium concentration was determined using ICP OES. The quantification of Cr(III) was accomplished by subtracting the Cr(VI) concentration from the total chromium concentration. Regardless of the known contamination of the soil samples by sulphochromic solution, concentrations of Cr(VI) were below the detection limit. Addition and recovery experiments for Cr(VI) in soil samples with and without organic matter indicated its influence on the reduction of Cr(VI) to Cr(III).

Farmacologia i Toxicologia en R+D+i: adquisició de competències a través d'un exemple de desenvolupament d'un fàrmac

La implementació de l’assignatura en elGrau de Farmàcia ha suposat pensar en una nova estratègia per tal de desenvolupar algunes competències transversals de laUniversitat de Barcelona i afavorir en els alumnes la integració dels coneixements.Els professors, de les unitats i grups d’innovació docent de Farmacologia i de Toxicologia, vam estimar quins continguts eren imprescindibles, constatant que alguns d’ells s’impartien ja en altres assignatures, i vam adoptar la següent estratègia: 1) re-elaborar els continguts ja impartits i emmarcar-los en l’entorn de la indústria farmacèutica; 2) presentar nous continguts; iprincipalment, 3) elaborar una bateria d’activitats centrades en el procés de R+D+i d’un fàrmac concret, el dabigatran. El disseny i el desenvolupament de les activitats s’han elaborat en base alEuropean Public Assessment Report (EPAR) per el dabigatran i l’NDA (New Drug Application) a la FDA per la seva autorització.

Farmacologia i Toxicologia en R+D+i: adquisició de competències a través d'un exemple de desenvolupament d'un fàrmac

La implementació de l’assignatura en elGrau de Farmàcia ha suposat pensar en una nova estratègia per tal de desenvolupar algunes competències transversals de laUniversitat de Barcelona i afavorir en els alumnes la integració dels coneixements.Els professors, de les unitats i grups d’innovació docent de Farmacologia i de Toxicologia, vam estimar quins continguts eren imprescindibles, constatant que alguns d’ells s’impartien ja en altres assignatures, i vam adoptar la següent estratègia: 1) re-elaborar els continguts ja impartits i emmarcar-los en l’entorn de la indústria farmacèutica; 2) presentar nous continguts; iprincipalment, 3) elaborar una bateria d’activitats centrades en el procés de R+D+i d’un fàrmac concret, el dabigatran. El disseny i el desenvolupament de les activitats s’han elaborat en base alEuropean Public Assessment Report (EPAR) per el dabigatran i l’NDA (New Drug Application) a la FDA per la seva autorització.

Especiação de cromo em cimentos e derivados de cimento brasileiros

A method for determination of Cr(III) and Cr(VI) in cement and cement-related materials was studied. Molecular absorption spectrophotometry based on 1,5-diphenylcarbazide as chromogenic reagent was used for determination of Cr(VI) after alkaline extraction. The total chromium concentration was determined using flame atomic absorption spectrometry (FAAS) after complete sample decomposition by fusion. The quantification of Cr(III) was accomplished by subtracting the Cr(VI) concentration from the total chromium concentration. The concentration of Cr(III) in the samples ranged from 10.9 to 88.0 mg kg-1, whereas only in few samples the Cr(VI) concentration was higher than the value established by the European Community to this type of sample [2 mg kg-1 Cr(VI)].

Pré-concentração de Cr(III) e análise de especiação de cromo empregando montmorilonita saturada com íons potássio

The clay mineral montmorillonite-K10 (MT), treated under acidic medium and saturated with potassium ions (MTK), was employed in sorption and desorption studies aiming the preconcentration of Cr(III) and the speciation analysis of chromium. The sorption process of Cr(III) was close to 100%, suggesting that MTK was a good material for Cr(III) preconcentration, although, the maximum recovery in HNO3 solution was near 89%. On the other hand, Cr(VI) practically was not retained in MTK, suggesting this material as an appropriate mineral phase to be used in speciation analysis of chromium in aqueous medium.

Avaliação de métodos de extração para a determinação de cromo e níquel em formulações farmacêuticas e em matérias-primas usadas na fabricação de medicamentos à base de cefalexina e ciprofloxacino

This paper reports the evaluation of extraction strategies for the treatment of medicine samples to determine chromium and nickel by GFAAS. Different approaches for extraction were evaluated and the most efficient involved magnetic stirring. The metals were quantitatively extracted by stirring 0.20 g samples with 25 mL of 2.0 mol L-1 HCl solution for 60 min. The developed method was successfully applied for the determination of Cr and Ni in tablets containing antibiotics and raw materials, with cephalexin and ciprofloxacin as active ingredients.

Remoção de cromo (VI) de soluções aquosas utilizando o compósito magnético calcinado hidrotalcita-óxido de ferro: estudo cinético e de equilíbrio termodinâmico

In this work, hydrotalcite, a layered double hydroxide, had its ion exchange properties combined with the magnetic properties of iron oxide to produce a magnetic adsorbent, HT-Fe 500. These magnetic composites can be used as adsorbents for anionic contaminants in water and subsequently removed from the medium by a simple magnetic process. Removal of chromium (VI) from aqueous solutions using HT-Fe 500 was achieved using batch adsorption experiments. The adsorption capacity, calculated with the Langmuir-Freundlich model showed to be dependent on temperature, reaching values of 25.93 and 48.31 mg g-1, respectively, for temperatures of 25 and 30 ºC.

Desenvolvimento de um método analítico baseado em microextração líquido-líquido para a determinação de cromo (VI) em amostras aquosas com detecção por espectrometria de absorção atômica em chama

In this study, a method for determination of hexavalent chromium in aqueous samples using liquid-liquid microextraction (LLME) and detection by Flame Atomic Absorption Spectrometry (F AAS) was developed. The LLME procedure was based on the extraction of Cr (VI) by acetone at a sample pH of 1.2. The use of saturated ammonium sulphate solution allowed effective separation of the aqueous and organic phases and acetone extracted chromium. The sample pH, acetone volume and stirring time were optimized by a full factorial design.

Biossorção passiva de cromo (VI) através da microalga Spirulina platensis

Effluents containing toxic metals are dangerous and more economical, efficient and environmentally friendly treatments must be studied, with the biosorption process with microbial biomass constituting an efficient solution. Thus, the ability of Spirulina platensis biomass for removing chromium (VI) using passive and active biosorption was evaluated. Inactive microalgae biomass and synthetic solution containing chromium (VI) were used to evaluate important factors in the process and biomass biosorption ability. Results of the experiments showed that microalgae have potential for biosorption of chromium (VI), attaining removal of 100.39 mg g-1, and that pH was the variable with the greatest influence on the process.

Modificação e caracterização do resíduo pó de aciaria elétrica (PAE) para aplicação em reações de redução de cromo (VI)

In this study, electric arc furnace dust (EAFD) was thermally modified at different temperatures under H2 flow or charcoal in order to obtain reduced iron phases (Fe3O4, FeO and Fe0). The formation of these phases was confirmed by powder X-ray diffraction. The tests performed for reducing Cr (VI) using resultant materials obtained after thermal treatment of the EAFD showed excellent results, with PAE600H (EAFD reduced at 600 ºC under H2 flow) decreasing around 100% of the Cr (VI) in only 10 minutes of reaction. These results indicate the possibility of adding value to the residue, obtaining materials that offer great potential for environmental applications.

Oxidação de ciclohexano em fase gasosa catalisada por argilas pilarizadas com ferro e cromo

Argilas pilarizadas formadas pela intercalação de óxidos de metais de transição, capazes de prevenir o colapso da estrutura, constituem materiais micro- e mesoporosos com diferentes atividades catalíticas e estabilidades. Argilas pilarizadas com cromo e com ferro foram utilizadas como catalisadores em reações de oxidação do cicloexano em fase gasosa. Os resultados indicam que os catalisadores são ativos e seletivos na produção de cicloexanona e cicloexanol. Entretanto, especial atenção deve ser dada à acidez superficial dos sólidos, responsável pela formação de cicloexeno no meio reacional, com conseqüente redução dos produtos de interesse.