Modeling and manufacturability assessment of bistable quantum-dot cells

We have investigated the behavior of bistable cells made up of four quantum dots and occupied by two electrons, in the presence of realistic confinement potentials produced by depletion gates on top of a GaAs/AlGaAs heterostructure. Such a cell represents the basic building block for logic architectures based on the concept of quantum cellular automata (QCA) and of ground state computation, which have been proposed as an alternative to traditional transistor-based logic circuits. We have focused on the robustness of the operation of such cells with respect to asymmetries derived from fabrication tolerances. We have developed a two-dimensional model for the calculation of the electron density in a driven cell in response to the polarization state of a driver cell. Our method is based on the one-shot configuration-interaction technique, adapted from molecular chemistry. From the results of our simulations, we conclude that an implementation of QCA logic based on simple ¿hole arrays¿ is not feasible, because of the extreme sensitivity to fabrication tolerances. As an alternative, we propose cells defined by multiple gates, where geometrical asymmetries can be compensated for by adjusting the bias voltages. Even though not immediately applicable to the implementation of logic gates and not suitable for large scale integration, the proposed cell layout should allow an experimental demonstration of a chain of QCA cells.

Hardware implementation of type-2 programmable fuzzifier

The design of full programmable type-2 membership function circuit is presented in this paper. This circuit is used to implement the fuzzifier block of Type-2 Fuzzy Logic Controller chip. In this paper the type-2 fuzzy set was obtained by blurring the width of the type-1 fuzzy set. This circuit allows programming the height and the shape of the membership function. It operates in current mode, with supply voltage of 3.3V. The simulation results of interval type-2 membership function circuit have been done in CMOS 0.35μm technology using Mentor Graphics software. © 2011 IEEE.

Tailoring, synthesis and structure-property relationships of 2,3-thienoimide based molecular materials

Organic molecular semiconductors are subject of intense research for their crucial role as key components of new generation low cost, flexible, and large area electronic devices such as displays, thin-film transistors, solar cells, sensors and logic circuits. In particular, small molecular thienoimide (TI) based materials are emerging as novel multifunctional materials combining a good processability together to ambipolar or n-type charge transport and electroluminescence at the solid state, thus enabling the fabrication of integrated devices like organic field effect transistors (OFETs) and light emitting transistor (OLETs). Given this peculiar combination of characteristics, they also constitute the ideal substrates for fundamental studies on the structure-property relationships in multifunctional molecular systems. In this scenario, this thesis work is focused on the synthesis of new thienoimide based materials with tunable optical, packing, morphology, charge transport and electroluminescence properties by following a fine molecular tailoring, thus optimizing their performances in device as well as investigating and enabling new applications. Investigation on their structure-property relationships has been carried out and in particular, the effect of different π-conjugated cores (heterocycles, length) and alkyl end chain (shape, length) changes have been studied, obtaining materials with enhanced electron transport capability end electroluminescence suitable for the realization of OFETs and single layer OLETs. Moreover, control on the polymorphic behaviour characterizing thienoimide materials has been reached by synthetic and post-synthetic methodologies, developing multifunctional materials from a single polymorphic compound. Finally, with the aim of synthesizing highly pure materials, simplifying the purification steps and avoiding organometallic residues, procedures based on direct arylation reactions replacing conventional cross-couplings have been investigated and applied to different classes of molecules, bearing thienoimidic core or ends, as well as thiophene and anthracene derivatives, validating this approach as a clean alternative for the synthesis of several molecular materials.

NOR network transduction procedures : "merging of gates" and "substitution of gates" for fan-in and fan-out restricted networks, NETTRA-G3-FIFO and NETTRA-PG1-FIFO /

"December 1974."--T.p.

Topics in MOSFET network design /

Thesis--University of Illinois at Urbana-Champaign.

Design of diagnosable MOS networks /

"UILU-ENG 79 1745"--Cover.

Program manual : NOR network transduction based on connectable and disconnectable conditions (reference manual of NOR network transduction programs NETTRA-G1 and NETTRA-G2) /

"UIUCDCS-R-75-698"

Network transduction based on permissible functions : general principles of NOR network transduction NETTRA programs /

Includes bibliographical references.

NOR network transduction based on error-compensation : principles of NOR network transduction programs NETTRA-E1, NETTRA-E2, and NETTRA-E3 /

Bibliography: p. 101-102.

A code for designing optimal networks by implicit enumeration using the all-interconnection inequality formulation : (a programming manual for ILLODIE-AIF) /

Thesis (M.S.)--University of Illinois at Urbana-Champaign.

NOR network transduction system : principles of the NETTRA system /

Bibliography: p. 209-212.

A study of certain factors affecting computation times in designing optimal NOR networks by the implicit enumeration method using the feed-forward formulation /

Bibliography: p. 27-29.

Program manual for the NETTRA system /

"UILU-ENG 77 1743."

Design of irredundant multiple-level MOS networks for multiple-output and incompletely specified functions /

Thesis (M. S.)--University of Illinois at Urbana-Champaign.

NOR (NAND) network design : error-compensation procedures for fan-in and fan-out restricted networks (NETTRA-E1-FIFO and NETTRA-E2-FIFO /

Thesis (M. S.)--University of Illinois at Urbana-Champaign.