Trace-element contents in ash samples from DSDP Leg 19 sediments

The Sr, Rb, Ti, and Zr concentrations of 16 volcanic ash samples from Leg 19 of the Deep Sea Drilling Project were determined by X-ray fluorescence. The age of each ash sample had been established previously by faunal criteria and had been confirmed by fission-track dating. Variations in the trace-element concentrations through the past 8 m.y. are clearly seen. Seven of the ashes are older than 4 m.y., have low TiO2 contents, and have Sr concentrations of less than 200 ppm; they are thus similar to tholeiitic basalts of island arcs. Nine ashes are younger than 4 m.y. and are similar in trace-element content to andesite. Magmatic evolution of the Aleutian arc over the past 8 m.y. is clearly shown.

Composition of bentonite-, smectite-rich- and ash beds from DSDP Leg 19 holes

Late Cenozoic ash deposits cored in Deep Sea Drilling Project Leg 19 in the far northwest Pacific and in the Bering Sea have altered to bentonite beds. Some bentonite layers were subsequently replaced by carbonate beds. A significant part of the Neogene volcanic history of land areas adjacent to the far north Pacific is represented by these diagenetic deposits. Bentonite beds are composed of authigenic smectite and minor amounts of clinoptilolite. Authigenic smectite has fewer illite layers than detrital smectite. Opal-A and opal-CT, abundant in Bering Sea sediment, are not found in ash or bentonite layers. The percentage of smectite in the total clay-mineral assemblage of ash beds is greater than that for adjacent terrigenous sediment, but the total amount of clay minerals in ash sequences is less than in surrounding deposits. Morphology of the 17-Å peak of smectite found in ash may represent newly formed, poorly crystalline smectite. Smectite becomes better crystallized as bentonite layers form. The percentage of smectite of the total clay-mineral assemblage in bentonite beds is greater than that in surrounding sediment, and, in contrast to ash beds, the total amount of clay minerals (mostly smectite) in bentonite layers is greater than in adjacent terrigenous sediment. Apparently, silica is not mobilized when volcanic ash layers transform to bentonite beds. Saponite-nontronite varieties of smectite and high Fe/Al and Ti/Al ratios distinguish bentonite beds derived from basaltic parent material from those beds formed from more silicic volcanic ash. These silicic ash beds produce bentonite composed mostly of montmorillonite. The basal sediment section at site 192 is rich with bentonite beds. Smectite in the upper part of this section (Eocene) was formed by low-temperature diagenesis of volcanic debris of intermediate or more silicic composition derived from arc or Pacific volcanoes. In contrast, smectite from the lowest 10 to 20 m of the sedimentary section (Cretaceous) is formed from either low-temperature or hydrothermal alteration of the underlying basaltic basement and associated pyroclastic debris. This near-basement smectite contains Mg and K acquired from sea water and Si, Al, Fe, Ti, and Mn released from the volcanic material.

(Table 2) Compressional and shear wave velocites from basalts and sediments of the Atlantic and Pacific Ocean

Compressional (Vp) and shear (Vs) wave velocities have been measured to 1.0 kbar for 14 cores of well-consolidated sedimentary rock from Atlantic and Pacific sites of the Deep Sea Drilling Project. The range of VP (2.05-5.38 km/sec at 0.5 kbar) shows significant overlap with the range of oceanic layer-2 seismic velocities determined by marine refraction surveys, suggesting that sedimentary rocks may, in some regions, constitute the upper portion of layer 2. Differing linear relationships between VP and Vs for basalts and sedimentary rocks, however, may provide a method of resolving layer-2 composition. This is illustra ted for a refraction survey site on the flank of the Mid-Atlantic Ridge where layer-2 velocities agree with basalt, and two sites on the Saya de Malha Bank in the Indian Ocean where layer-2 velocities appear to represent sedimentary rock.

(Table S1) Age determination of Emperor Seamounts basement

The Hawaiian-Emperor hotspot track has a prominent bend, which has served as the basis for the theory that the Hawaiian hotspot, fixed in the deep mantle, traced a change in plate motion. However, paleomagnetic and radiometric age data from samples recovered by ocean drilling define an age-progressive paleolatitude history, indicating that the Emperor Seamount trend was principally formed by the rapid motion (over 40 millimeters per year) of the Hawaiian hotspot plume during Late Cretaceous to early-Tertiary times (81 to 47 million years ago). Evidence for motion of the Hawaiian plume affects models of mantle convection and plate tectonics, changing our understanding of terrestrial dynamics.