Bulk and clay mineralogy of ODP Leg 110 holes

The mineralogy of both bulk- and clay-sized fractions of samples from Sites 671, 672, and 674 of ODP Leg 110 was determined by X-ray diffraction. The major minerals include quartz, calcite, plagioclase feldspar, and the clay minerals smectite, illite, and kaolinite. The smectite is a dioctahedral montmorillonite and is derived primarily from degradation of volcanic ash. Percentage of smectite varies with sediment age; Miocene and Eocene sediments are the most smectite-rich. High smectite content tends to correlate with elevated porosity, presumably because of the ability of smectite clays to absorb significant amounts of interlayer water. Because of a change in physical properties, the decollement zone at Site 671 formed in sediments immediately subjacent to a section of smectite-rich, high-porosity, Miocene-age sediments. Sediments above the decollement at Site 671, as well as all sediments analyzed from Sites 672 and 674, contain nearly pure smectite characteristic of the alteration of volcanic ash. Within the decollement zone and underthrust sequence, however, the smectite contains up to 65% illite interlayers. Although the illite/smectite could be interpreted as detrital clay derived from South America, its absence in the sediments stratigraphically equivalent to the decollement and underthrust sequences at Sites 672 and 674 favors the interpretation that it originated by diagenetic alteration of pre-existing smectite similar to that in the overlying sediments. A significant percentage of the freshening of the pore waters observed in these zones could be due to the water released during smectite dehydration.

Magnetic susceptibility anisotropy in deformed sediments of ODP Leg 110

The anisotropy of magnetic susceptibility documents the generation of tectonically produced fabrics in sediments that macroscopically show no evidence of this disruption. The fabric observed in initial accretion is largely produced by overprinting of the original sedimentary susceptibility anisotropy by an E-W horizontal tectonic shortening and vertical extension. The response of the sediments to stress during initial accretion is variable, particularly near the sediment surface, and appears to reflect the inhomogeneous distribution of strain rate in the overthrust sequence. The susceptibility anisotropy of sediments possessing scaly fabric is consistent with the strong orientation of Phyllosilicates seen in thin section, producing a Kmin normal to the scalyness. The slope sediments deposited on the accreted sequence are also affected by tectonic shortening. The accreted sequences at Sites 673 and 674 show a complex history of fabric modification, with previous tectonic fabrics overprinted by later fabric modifications, pointing to continued tectonic shortening during the accretion process. The form of the susceptibility anisotropy axes at Sites 673 and 674 is consistent with NESW shortening, probably reflected in the NW-SE surface expression of the out-of-sequence thrusts. The susceptibility anisotropy appears to document a downhole change in the trend of shortening from E to W at the surface to more NESW at depth, probably as a result of the obliquely trending basement ridge, the Tiburon Rise.

Interstitial water chemistry of ODP Leg 110 holes

Major-element compositions (Cl-, SO4[2-], Ca2+, Mg2+ , Li+ , K+, Na+ , Sr2+) of interstitial waters obtained from sediment cores along the ODP Leg 110 transect across the Northern Barbados accretionary prism have shown that a complex set of geochemical processes are of importance in this area. In the volcanic ash-rich Pleistocene-Pliocene sediments, alteration reactions involving volcanic ash lead to depletions of Mg2+ and K+. This process is confirmed by the much lower than contemporaneous seawater values of the 87Sr/86Sr ratios of dissolved strontium. In the deeper sediments recovered below the zone of decollement (Sites 671 and 672) large increases in Ca2+ and gradual decreases in Mg2+ , Na+, and d18O (H2O) indicate a potential contribution to the interstitial water chemistry by exchange with underlying basement rocks. This process has been hard to confirm because the drill holes were terminated well short of reaching basement. However, the concentration gradient pattern is consistent with observations in a large number of DSDP drill holes. Finally, but most importantly, low Cl- concentrations in the decollement zone and underlying sand layers, as well as in fault zones at Sites 673 and 674, indicate dilution of interstitial waters. The potential origins of the low Cl- concentrations are discussed, though we are not able to distinguish any mechanism in particular. Our evidence supports the concept of water migration along the decollement and through the underlying sandstones as well as along recent fault zones in the accretionary complex. Interstitial water concentration depth profiles are affected by faulting, thrusting, and overturn processes in the accretionary prism. These processes have caused a diminished diffusive exchange with the overlying ocean, thus explaining increased depletions in Mg2+ and SO4[2-] in sites farther onto the accretionary prism.

Stable isotope ratios of interstitial fluids from ODP Leg 110 sites

Delta18O values of pore waters from the northern Barbados accretionary prism range from -0.3 to -3.6? and reflect pervasive reaction of volcanic ash to form smectite within the sedimentary sequence and continued low temperature alteration of basalt in the underlying ocean crust with the overprint of diffusive exchange between water in the sediment pores and the open ocean. Delta D values of pore waters in sediments sampled seaward of the deformation front drop from +5? at the sediment surface to -6? at the deepest levels sampled. These changes may also be related to alteration processes but remain largely enigmatic. Sediment deformation caused by impingement of the Caribbean plate on the Atlantic plate has instigated migration of chemically and isotopically distinct fluid along faults and coarse-grained sedimentary beds; delta18O values of pore waters are also locally affected by thrust stacking which increases diffusive pathlengths and possibly modifies diagenetic reaction rates in Pleistocene sediments. Migrating fluids are distinguished by anomalous delta18O values that are as much as 1? higher than those of surrounding fluids. Uncertainties in hydrogen isotope fractionation resulting from processes occurring under these conditions hinder identification of the hydrogen isotope composition of expelled fluid. Stable isotope analyses of pore waters help constrain the fluid migration history of the accretionary prism by limiting the source of fluids, the paths along which fluid flows, and the timing of faulting and subsequent fluid flow.